What do you do when the fingerprint id just turns off and there is no start backup
it just turned off and wont start back up. and wish for it too work again.
Thanks for reporting back.
I was thinking earlier today that when you delete a cookie in Firefox, Firefox directs a database engine to delete that row of data, and the database engine modifies the cookies.sqlite file so that Firefox no longer sees that cookie. However, for efficiency, database files are not constantly resized like regular document files; the space is retained to reduce the overhead of requesting space from the operating system. Therefore, some pieces of the cookie may remain in the file until it is cleaned out or overwritten by the database engine. There are some utilities to "vacuum" these database files, which should clean up the unused space. If you see this problem in the future, where a cookie you removed and which is invisible in Firefox can be found using an external utility, it would be interesting to "vacuum" the file instead of deleting it to see that cleans up the cookie crumbs.
Similar Messages
-
HT4528 what do you do do if your phone randomly turns off and won't turn back on?
Is there anything that you can do when your iphone randonly turns off and it won't tuen back on? i have tried charging and pugging it into my itunes, but nothing is happening, it's not even making that noise when you plug it in.
Smash it with a hammer.
Haha, seriously now, did you try taking out the battery for 20 minutes and putting it back in? -
my iphone 5 suddenly turned off then it turns on by itself then freezes then turns off and on again??????????????? it temporarily works for now but the backlight is flickering. what should I do?
iriz14 wrote:
my iphone 5 suddenly turned off then it turns on by itself then freezes then turns off and on again?
Make sure you have the Current Version of iTunes Installed on your computer
iTunes free download from www.itunes.com/download
Then See Here > http://support.apple.com/kb/HT1808
You may need to try this More than Once... Be sure to Follow ALL the Steps...
Take your time... Pay particular attention to Steps 3 and 4
After you have Recovered your Device...
Re-Sync your Content or Restore from the most recent Backup...
Restore from Backup > http://support.apple.com/kb/ht1766 -
What do i do when my macbook air suddenly turns off and i can't turn it back on
my macbook air just suddenly turned off and i cannot turn it back on no matter what i do, any suggestions?
Try a SMC reset.
http://support.apple.com/kb/HT3964
If no success, bring the MBA to an Apple store genius bar for a FREE evaluation.
Ciao. -
What do you do when the system crashes ?
hi experts,
i want answers for the following questions..
1.What do you do when the system crashes in the middle of a BDC batch
session?
2.What do you do with errors in BDC batch sessions? and how to proceed further..
with regards ,
James...
valuable answers will be rewarded...HI,
There are two ways to tackle this issue.
<b>Method..1</b>
Thru se16 check the table(s) being updated, preferably the last table as per your code. If you have say 1600 records in the flat file check for the upload of the 1600 th record.. If not ok, check for the upload of the 800 th record(N-N/2), if OK go & check
N+(N/2) th record if not ok goto N-(N/2) th record where N is the curent record number in the flat file . In about 4 or five checks you will converge on the last uploaded record.
Now from the flat file, remove the lines till the upload is ok & then re-run BDC.
Even here a record may be uploaded partially which has to be manually edited thru se16.
<b>Method..2</b>
Have a zee table for uploads. Just after uploading a record into the sap table, fill this zeetable with few fields of each the records. In an abort situation this table will tell the story of the update status. Take care to empty this table occasionally.
Regards
Gaurav -
HT201210 what do you do when the 'cord' and the 'itunes' symbol come up on your screen?
what do you do when the 'cord' and the 'itunes' symbol come up on your screen?
Connect to iTunes on the computer you usually Sync with and “ Restore “...
http://support.apple.com/kb/HT1414
If necessary Place the Device into Recovery mode...
http://support.apple.com/kb/HT1808
Note on Recovery Mode.
You may need to try this More than Once...
Be sure to Follow ALL the Steps... -
my iphone came up with that timing circle and just turned off and did not come back on ? even when i charge it now it still wont turn on ,do you know the problem?
If the battery was empty (and it may then take 10 to 15 minutes of charging before it will respond), then have you tried a reset ? Press and hold both the sleep and home buttons for about 10 to 15 seconds, after which the Apple logo should appear - you won't lose any content, it's the equivalent of a reboot.
-
when i active my mac pro all i get is a white screen and it loading and when it fully load its turn off , and it keep on doing the same thing for hours
Hi Shahenaz,
It's a little difficult to understand exactly what's going on with your mac based on the description you gave. Is there anything else you could add? Is it stuck in a reboot loop? Or is it just showing a white screen forever?
I had pretty much the same problem a few days ago, and was worried my mac was screwed permanently, but I got it fixed up no problem!
Follow these steps to try and troubleshoot/fix the problem.
1. Boot into OSX Recovery Mode
First, turn off your Mac. If it isn't responding, or is stuck in a reboot loop, just hold down the power button until it turns off, and you hear the fans stop. Then boot it while holding the Command and R keys. If it successfully boots into OSX Recovery Mode, continue with this step. If not, skip to step two. (My Mac couldn't successfully boot into the recovery mode, so I had to go to step 2)
Select "Disk Utility" from the list of options, and find your built in hard drive from the list on the left. Usually there are two listings/names for your drive. The first should be something like "500GB longchainoflettersnumbers Media". Then the one below will be a little easier on the eyes, named Macintosh HD, if you haven't changed its name. That's the one you want, click it.
Now go to the "First Aid" tab. Click on the "Verify Disk" button in the bottom right corner, and let it do its thing. Once that's done, hit repair disk, also in the bottom right corner. If your disk is corrupted, you may need to run the repair process several times, before it comes up completely clean.
Once this is done, select Shut Down from the Apple menu and, once your Mac is completely off, turn it back on like normal. If it works, great. If not, proceed to step two.
2. SafeBoot
Sometimes, when a mac is acting up and doesn't want to start, all it takes is a safe boot, followed by a regular restart. Or maybe you recently installed a program that either has malicious or errored coding that's causing your troubles. This is where Safe Boot comes in.
Turn off your mac, and reboot it while holding Shift. (If you want to see the process that's going on in the background, boot while holding Shift, Command, and V. This will enter something called Verbose Mode).
If it boots successfully into Safe Mode, great. If you believe that there's a particular program that you recently downloaded that might be causing your trouble, now's the time to delete it. If not, just reboot normally and see if it works! If it doesn't, or if your Mac didn't even Safe Boot like mine, proceed to step 3.
3. Fsck!
For this step, you're going to be booting your mac into Single User Mode. I'm not going to go into details as to what this step does, but it works for some people. Here are the steps.
Turn off your mac, and reboot it while holding Command and S. The screen should go black, and you'll see some white text run across the screen, wait a few seconds, until you see the command prompt. Now type
fsck -fy
and hit the Enter key. This will run a series of system checks, which could take a few minutes. Be patient on this part. Once it's done, it will show one of two messages:
1. "The volume (your Mac) appears to be OK
or
2. "File System Was Modified"
If you got message 1, type reboot and press Return. Hopefully your computer works after this - if not, proceed to step 4.
If you got message 2, run the same command again until you get message 1. If it doesn't seem to be working, turn off your system and proceed to step 4.
If you couldn't even boot into Single User Mode in the first place (like me), go to step 4 anyways.
Step 4: Reset the NVRAM
The NVRAM is another kind of RAM that stores data like the computer volume you had set before you turned it off, or the screen brightness, resolution etc. This memory is saved, unlike with regular RAM. Resetting it isn't harmful to your system, it will just put your screen brightness, volume, etc. to defaults.
Turn off your Mac, and reboot while holding Command, Option, P, and R, and continue holding them down until you hear the computer restart again.
I can't really explain why to do this step, I just know it works for some people, and seems to be what unbricked my MacBook Pro. If none of these steps, fixed your Mac, well the situation is looking pretty grim. Try setting up a meeting with a Mac Genius at your local Apple store. However, I know that many other people with these symptoms ended up having a logic board failure. Apple can swap out your logic board for a new one, but the price is pretty hefty, somewhere around $300 I believe.
Well I wish you luck, I hope this helped you! -
I was charging my iPad2 and when reaching 90% it just went black and can't be started again. Anyone that have had this problem and know what to do?
I have had this problem several times. The iPad comes off charging with a black screen and only a hard reset works to get it back. Then you have to go to settings to be sure nothing changed there.
I have had serveral hard resets and three restore operations and the problem recurs. I am not sure if it is the iPad2 or an app that is causing the problem. So far I can live with it as is.
Jay -
what do I do when my macbook pro just shuts down and when I plug my charger in, it faintly blinks green and yellow and doesnt charge?
Hi aaliyafrommarkham,
In order to troubleshoot this, I would recommend that you start with an SMC reset. Information on this procedure can be found here:
Intel-based Macs: Resetting the System Management Controller (SMC)
http://support.apple.com/kb/HT3964
Thanks for coming to the Apple Support Communities!
Cheers,
Braden -
my iphone I fell to the ground yesterday, from a height of approximately 1 meter. after this I trailed off, now only turns on when I plug the usb but the apple appears and just turn off and turn back, there is nothing more that I recommend doing?
With that behavior you need to take the iPhone to an Apple store genius bar for an out-of-warranty replacement. In the US that is $269 for the iPhone 5.
-
often my iphone4 just got off and it doesn't start for 2/3 day what is the problem and how can i fix it?
The Basic Troubleshooting Steps are:
Restart... Reset... Restore from Backup... Restore as New...
Restart / Reset
http://support.apple.com/kb/ht1430
Backing up, Updating and Restoring
http://support.apple.com/kb/HT1414
If you try all these Steps and you still have issues... Then a Visit to an Apple Store or AASP (Authorized Apple Service Provider) is the Next Step...
Be sure to make an appointment first... -
What does it mean when my Mac won't turn on and it's charging low?
My MacBook suddenly just turned off and won't turn on anymore. There's just a blank screen and when I charge it, the green light is low.
Resetting SMC could solve the problem.
Intel-based Macs: Resetting the System Management Controller (SMC) -
HT1414 when i do the restore my iphone turn off and the itunes tell me eeror 1011 !!
when i do the restore my iphone turn off and the itunes tell me eeror 1011 !!
see error code here http://support.apple.com/kb/TS3694 follow instructions to resolve.
-
i have an iphone 4s and it just turned off and wouldnt turn back on until i got home and plugged it in to the mains. however it wont connect to my carrier and wont let me turn wifi on or use the internet. all my data is still in place. however when i disconnect from the charger it switches straight off immediately. it also just flashes up the apple icon (on 10 seconds, off 10 seconds.......) when i connect to either car charger or computer. it also resets itself every single time i turn it back on using the mains charger. please help me understand what is happening to my phone
is there anything apple could do if i took it to one of their main shops???
Kris (bulzy_23)Sounds like a hardware failure.
Make an appointment at the genius bar and take it in for them to look at. It will probably need to be replaced.
Maybe you are looking for
-
hi to all i m beginner in java programming and i want to do event handling on mouse click. i have a button and i want if i click that button a new window open can anyone help me
-
Hello, little question, is it possible to have an online folder synced with an 'on my mac' folder? I explain. I have a Gmail account and have a folder/label where I put a bunch of emails I want to keep. Is it at all possible to have a 'copy' of this
-
Hi All, Can I know how to split the text as below example which may contain chinese text , special chars or text in alphabet? These text may contains double-byte chars and single byte char. How I split out the text if I need to display 11 chars in fi
-
Hello, I have an Air Port Extreme 802.11n 1Gigabit MB053LL/A I am wondering if it is possible Upgrade the Firmware with a new version of Air Port Extreme. I am interesting to create two Wireless network. Private an Guess. Thank you Giorgio
-
I want to add one field for my existing cube which already consists of data ,I have used remodelling option for this i can see the added fields in my cube but my transformation rules became inactive & even there is no mapping for 0fiscper if I want