What`s the mean by this messages?(about soarise install) please hlep ~

Question

6 Configuring Kernel Parameters
Verify that the following kernel parameters are set to values greater than or equal to the recommended value shown:
Parameter Replaced by Resource Control Recommended Value
noexec_user_stack NA 1
semsys:seminfo_semmni project.max-sem-ids 100
semsys:seminfo_semmns NA 1024
semsys:seminfo_semmsl project.max-sem-nsems 256
semsys:seminfo_semvmx NA 32767
shmsys:shminfo_shmmax project.max-shm-memory 4294967295
shmsys:shminfo_shmmin NA 1
shmsys:shminfo_shmmni project.max-shm-ids 100
shmsys:shminfo_shmseg NA 10
Note:
If the current value for any parameter is higher than the value listed in this table, then do not change the value of that parameter.
To view the current value specified for these kernel parameters, and to change them if necessary, follow these steps:
To view the current values of these parameters, enter the following commands:
# id -p // to verify the project id
uid=0(root) gid=0(root) projid=1 (user.root)
# prctl -n project.max-shm-memory -i project user.root
# prctl -n project.max-sem-ids -i project user.root
If you must change any of the current values, then follow these steps:
To modify the value of max-shm-memory to 6 GB:
# prctl -n project.max-shm-memory -v 6gb -r -i project user.root
To modify the value of max-sem-ids to 256:
# prctl -n project.max-sem-ids -v 256 -r -i project user.root
Note:
When you use the prctl command (Resource Control) to change system parameters, you do not need to restart the system for these parameter changes to take effect. However, the changed parameters do not persist after a system restart.
quesiton:
how can i setup it??this message what`s mean?

Answer 1

Use the section immediately after that Note in the documentation (Configuring Kernel Parameters on Solaris 10) to ensure the values remain in affect after a restart of the server.