What will happen if i upgrade ram to 4GB which is more than system spec....

Hi,
I have a macbook with following specs:
core 2 Duo
1 Gb stock ram 667MHZ DDR2
Model No: A1181
Part No: MB061X/A
i have found that my macbook only support total of 2GB memory with 1GB memory at each module. i was just wandering what will happen if i put 4GB (2 x 2GB sticks) memory kit in my macbook.
At some forums i have found that it may support upto 3 or 3.3GB memory but will putting extra memory have any kind of negative effect ???
and does any one know what is the supported memory limit of my macbook ???
Cheers,
Sohaib

sohaib zahid wrote:
Thanks for reply...
got 1 more question.... If i'll put 2 x 2GB RAM then still i'll be utilizing the dual channel ??? though only 3GB memory is being used by the system....
I'll start by saying that I've read Intel's chipset datasheets, including their sections on memory controllers, dual-channel, memory speeds, etc. With Intel's memory controller chipsets, they don't access two modules in parallel as an effectively doubled-width data bus. They still only perform read/writes data one module at a time. What you might get with "dual channel" operation is that it can get a small head-start when "ping-ponging" from one module to the other. It anticipates when it will be over, and will start off the other module to get a head start on the latency before data is available. Overall the advantage is small. In fact, Intel does do this when the memory modules aren't even matched for size - they call this "Dual Channel Asymmetric". It's supposed to perform dual-channel up to the high address of the smaller module. If you match sizes (doesn't even have to be identical modules or even speeds) Intel calls this "Dual Channel Interleaved", with the advantage throughout the entire address range.
For your application, some benchmarks suggest a small increase in graphics performance. However - having more memory almost always wins out over trying to achieve "dual channel". Check these tests:
http://eshop.macsales.com/shop/apple/memory/MacbookMemoryBenchmarks
n if RAM meets the specs of my macbook it won't panic kernel ???
Not likely although poor quality memory could do that when it reaches marginal conditions (i.e. high heat).

Similar Messages

  • What will happen if I upgrade my icloud storage?

    I have a 16gb ipad that I have for already a year and 3 months in IOS 7.1.0 . Since my ipad is only 16gb, I already used a lot of storage and it's only 1.2 gb left. I maintain my storage like that for about a month already but I'm afraid that it will all be used up in no time because my family always go on trips which means we have to take pictures. But, I was looking around in the settings and I saw an icloud storage plan. I'm really convinced to upgrading my icloud. But, what will happen if I upgrade my icloud storage? Will my storage increase? Or something else will happen

    Upgrading icloud storage WILL not upgrade storage on ipad. Buying another ipad of larger size will.

  • What will happen if skip upgrading iPhone 3G & then restore to iPhone 4?

    Character limit in the subject line made it hard to get my point across, so I'll expound...
    I've got an iPhone 3G running iOS 3.1.3, and also have my reservation in to get the iPhone 4 on Thursday. In light of lots of people talking about performance troubles with iOS 4.0 on the iPhone 3G, I'm thinking I might skip the upgrade.
    Normally, when I've gotten new iPhones, I do a full backup right before I go to the Apple Store, and then when I get home I plug the new phone in and let it restore all of my data. But, what will happen when I plug in my iPhone 4 if my 3G backup has everything coming from a 3.1.3 image? Is it going to end up "downgrading" my iPhone 4 to iOS 3.1.3, forcing me to then run an OS upgrade? Is the restore going to outright fail?
    Wondering if I don't just need to bite the bullet and upgrade my iPhone 3G to make Thursday that much easier...

    It will work, It will use the apps and data from the old backup, but will not change the operating system version.

  • What will happen with my installed softwares?

    Hi I am using MacBook Pro with C2D and having latest version of SL. But I have installed lots of software useful for my business including virtual machine and I am using Windows 7 ultimate on it. So I am wondering what will happen if I upgrade this to Lion? Do I need to install everything again or it will be as it is like on my snow leopard?

    I don't know about VMware, but I can tell you that when I opened Windows XP the first time in Parallels after upgrading to Lion, I had to re-setup the virtual machine. Other than this, no problems. CS3 and older WILL NOT run in Lion, but CS4 and newer run without problems.
    Go to About this Mac > applications, and here you can see which of your applications are PowerPC, thus not compatible with Lion.
    Cheers

  • My macbook pro has service battery, what could happen if i upgrade the ram to 8gb

    My macbook pro has service battery, what could happen if i upgrade the ram to 8gb

    "Service Battery" means just that - you need to make an appointment with your local Apple Store or AASP and have the battery checked out and, likely, replaced.
    If you upgrade to 8GB it will have no effect on the battery. 8GB is sort of the minimum that I would shoot for.
    Clinton

  • I have a Power Mac G5 Dual 2.3 running 10.5.8, I understand that I can not upgrade to Lion, so what will happen to my Mobile me, which I can not live with out?

    I have a Power Mac G5 Dual 2.3 running 10.5.8, I understand that I can not upgrade to Lion, so what will happen to my Mobile me, which I can not live with out? Also will I be able to get Icloud to work?

    Hi Mary, the other so called "Features" of iClound will not work for like Syncing, but eMail will.
    MobileMe & dot Mac will still work last I heard.
    iCloud Mail setup, even in 10.4/10.5…
    Don't delete your old account yet. Just setup a new one in Mail>Preferences>Accounts, little plus icon. Choose IMAP as account type, not ,mac or MobileMe.
    IMAP (Incoming Mail Server) information:
              ▪          Server name: imap.mail.me.com
              ▪          SSL Required: Yes
              ▪          Port: 993
              ▪          Username: [email protected] (use your @me.com address from your iCloud account)
              ▪          Password: Your iCloud password
    SMTP (outgoing mail server) information:
              ▪          Server name: smtp.mail.me.com
              ▪          SSL Required: Yes
              ▪          Port: 587
              ▪          SMTP Authentication Required: Yes
              ▪          Username: [email protected] (use your @me.com address from your iCloud account)
              ▪          Password: Your iCloud password

  • What will happen if you don't upgrade your ipad 2  ios5.1.1 to ios6?

    hey guyz can u plz give some advice if what will happen to your ipad if you don't upgrade your ipad 2  ios5.1.1 to ios6?is there a chance to have a virus if you dont upgrade it.?tnx so much.

    Whether you Upgrade or Not is your Choice...
    rhpz18 wrote:
    ...is there a chance to have a virus if you dont upgrade it.?..
    There are No Viruses for iOS at this moment in time...
    So all should be Fine.

  • What will happen if ipod touch previous generation cannot be upgrade anymore?

    What will happen if ipod touch previous generation cannot be upgrade anymore?

    It will continue to operate, play music and so on.  It just will not be able to update apps that rely on later iOS versions.

  • Acer Predator running win 8.1 which I wish to upgrade to win 10. What will happen to recovery discs?

    I have a two year old Acer Predator with Win 8.1 installed. I wish to upgrade to Win 10 but I'm concerned about what will happen if I get a hard drive failure at some point. Will I need to pay for another set of recovery discs? Or will I have to install Win 8 from the discs I already have, then upgrade to 8.1, then to Win 10?

    if your HDD will die, you can use your windows 8 recovery disk and then upgrade to 10 without passing by 8.1but.....i can suggest an easy way. You can create a system image just after upgrading to windows 10, having your drivers updated to windows 10 version too and check that your system is stable. after that, with windows tool you can create that system image on DVD or external HDD and use it to re-install your windows 10 copy as you just upgraded. http://www.cnet.com/how-to/how-to-create-a-system-image-in-windows-10/ to use a windows system image, you need a bootable windows 10 installation media but this is easy to have it from microsoft:http://www.microsoft.com/en-us/software-download/windows10download the .iso file and burn it on a DVD. so....at the end, you will boot from the DVD and choose to repair your PC and selecting to load the system image.

  • I have macbook pro 15 inch that i upgraded recently. i have been so frustrated because my internet keeps dropping out constantly. when will apple fix this? and if they don't what will happen to other people that are having wifi problems

    i have macbook pro 15 inch that i upgraded recently. i have been so frustrated because my internet keeps dropping out constantly. when will apple fix this? and if they don't what will happen to other people that are having wifi problems?

    Have a read through one of the many threads already going on this subject
    https://discussions.apple.com/thread/3190651?start=0&tstart=0

  • If I upgrade from iMovie08 to iMovie 11 what will happen to my already existing iMovie projects?

    I need to create a final prodcut for a grad school class and I would like to use some of the features on iMovie 11. I, however, already have begun creating some video clips. I want to know what will happen to my existing projects that are not yet published when I upgrade from iMovie08 to iMovie11. Thanks!

    iM11 doesn't hurt your older projects, nor events.
    keep in mind: iM11 Projects are not compatible with iM09

  • If I upgrade to Lion what will happen to my VMware Fusion & content?

    If I upgrade to Lion what will happen to my VMware Fusion & content?

    Possibly nothing
    Make a backup before upgrading.

  • What will happen to my purchases (esp the songs) if I upgrade to a new iPhone device considering same apple ID?

    What will happen to my purchases (esp the songs) if I upgrade to a new iPhone device considering same apple ID?

    The same purchases will be available on the new iPhone using the same Apple iD.
    Tap Settings > iTunes & App Store then switch Music ON.

  • I'm worried about what will happen if I delete my recent backup data from the phone I still own? Will I lose any progress in games that was saved in the backup?

    I'm worried about what will happen if I delete my recent backup data from the phone I still own? Will I lose any progress in games that was saved in the backup?
    I have an iPhone 4S and I keep getting those irritating notifications that tell me I need to upgrade my storage or free up space. I've deleted all I can from my music and photos without losing too many precious memories, but it's come to the point where I think I need to delete backups. However, I'm just worried that I will lose all and any log-in information that I don't remember and app/game progress that was saved to the iCloud. Please Tell me what will happen/what I can do?

    If you are asking what happens when you delete an iCloud backup, it only deletes the backup from your account.  It won't do anything to the data on your phone or in your iCloud account.  If you don't need to backup you can delete it.  (If you no longer want to back up your phone to iCloud, turn iCloud backup off in Settings>iCloud>Backup.  Then your phone will back up to your computer each time you sync it with iTunes.)

  • I support a very large school district currently running Firefox 3.6. What will happen at end of life date? We're in the middle of online testing this week.

    I run the test center for a very large school district with over 120k students. We've got a current deployed base of 54k client machines using Firefox 3.6. We haven't upgraded due to multiple reasons, the most important of which is removing the possibility of using In Private Browsing from the students, and dealing with plugin-updates for the non digital natives (read dumber than a bag of hammers users) that make up the majority of the client base.
    We're testing ESR now, but just found out that end of life for 3.6 is tomorrow, 4/24. We are currently in the middle of statewide online testing. The question is, what will happen tomorrow when the browser goes end of life. The ESR wiki mentions that "an update to the current version of Desktop Firefox will be offered through the Application Update Service"
    So the main question is, are my students/teachers going to get a popup telling them they have to update the browser if we have the updates already turned off? If so, can I turn it off remotely using SCCM, because it will cause all kinds of havoc.
    Please advise asap, and thanks in advance.

    We had to do some serious gymnastics to remove at least most of the ability to use IPB. We removed it from the gui, but unfortunately, if they know the hotkey, they can still bring it up. Security has some serious headaches with this, as by law they have to be able to track where students go, and going with private browsing removes their ability to do forensic work they're required to be able to do. Not a very well thought out feature from Mozilla in my opinion, but it is what it is. Successive versions have made it even more difficult to remove even the gui portion.
    We do plan to release ESR due to the aforementioned security issues, but testing has been slow.
    But thanks for the reply. I think we can turn off the updates if it isn't already done.

Maybe you are looking for

  • AE CS6 bug: Can't use any shortcut that includes the C in it

    A while ago I started having some issues In Illustrator CS6, where I couldn't copy and paste from one document/application to another, the issue later ported itself to AE and not much after that anything including the C key stopped working. For examp

  • Error in the Standard MSS iview?

    Hi, I am using "startprocess" mss iview from Content Provided By Sap,when click on preview it shows bellow error.But same iview is working in my Development System. Error com.sapportals.portal.prt.runtime.PortalRuntimeException: Failed in WD JNDI loo

  • Run same vi multiple times simultaneously

    Hi, First post here on the forums and I was curious if someone could help me out with a problem I have been searching on for a while now. I'm making a project for calculating GPS location based on an incoming signal. This signal is analyzed to see wh

  • Flv and mcLoader Class

    Hi, Does somebody knows what is happening? I'm using the mcLoader class to load all my external swf files, everything worket perfectly until I decided to use flvPlayBack on one of those external files. If the player is on my main stage it works great

  • Conversion of MilliSeconds to Timestamp

    Hi, I'm using Oracle 10g. I want to convert a millisecond value to its corresponding Timestamp. For a millisecond value of 1093853934771 I get the corresponding unix timestamp as 2004-08-30 04:18:54 in mysql using the function FROM_UNIXTIME. I tried