When i connect my ipod touch it doesnt recognize it and cant sync
when i connect my new ipod touch to my computer it doesnt recognize it and doesnt sync
Assuming you have a PC start here:
iPod not recognized in 'My Computer' and in iTunes for Windows
For Mac:
Mac OS X v10.6 or later: iOS device not recognized in iTunes after restart
iPhone, iPad, iPod touch: Device not recognized in iTunes for Mac OS X
Similar Messages
-
My ipod touch is not being recognize by itunes and windows recognizes it as a camera please help
Take a look at this link, http://support.apple.com/kb/TS2802
-
HT5925 when I connect my Ipod touch it doesnt show on my itunes screen
my ipod doesnt show on my itunes screen when I plug it
Hello alexglvn,
Thanks for using Apple Support Communities.
For more information on this, take a look at:
iOS: Device not recognized in iTunes for Windows
http://support.apple.com/kb/TS1538
1. Update iTunes
2. Check the USB cable
3. Verify that Apple Mobile Device Support is installed
4. Restart the Apple Mobile Device Service
5. Verify that the Apple Mobile Device USB Driver is installed
6. Check for third-party software conflicts
Best of luck,
Mario -
please help
iTunes could not connect to this [device] because an unknown error occurred (0xE8000065)
this is the error . -
I just switched from a PC to a Mac, and now when I connect my ipod, the computer doesnt recognize it. Any suggestions?
You probably need to move your ENTIRE iTunes FOLDER from your PC to your MAC...
You can do this via an External Drive...
Backup iTunes to an External Drive
http://support.apple.com/kb/HT1751
Move iTunes Library from PC to MAC
http://www.macworld.com/article/146958/2010/03/move_itunes_windows_mac.html -
Often, when I connect my iPod Touch 2G to the PC, instead of showing up as a device on iTunes, a pop-up appears that says I have connected a camera and asks what I want to do. This device doesn't have a camera in it. When this happens, (not always)I can't update my iPod, no matter how many times I try to connect it. I have an old Nano that has never had this problem at all. Can anyone tell me what to do about this?
Try here:
iPhone, iPad, iPod touch: Disabling digital camera notification in Windows XP -
When I connect my iPod Touch to a new laptop (Macbook Air) the "Info" tab won't appear and therefore I cannot sync it with my new iTunes. How can I sync this iPod with the iTunes on my new laptop?
There is no Info tab in Mavericks
if you use OS X v.10.8.5 or earlier. If you use OS X Mavericks v.10.9 or later, your contacts, calendars, and other info are updated on your computers and iOS devices via iCloud. For more information, see iCloud Help at icloud.com.
iTunes 11 for Mac: Sync contacts, calendars, and other info with iPod, iPhone, or iPad -
Hello! I have one iTunes library on my iPod and one iTunes library on my computer. When I connect my iPod touch to my PC, however, I cannot find any files in my iPod except for pictures. How can I find the music files so I can add them to my iTunes?
You can't do that.
And before you decide to store any music that you own on a computer at work, talk to your IT department. Many organizations do not permit it for legal reasons. Standard policies are that anything stored on company owned computers is the property of the company. It could not be legally stored on their machines unless you transfer the licenses and all copies, physical and digital, to the company, meaning you no longer own the music. If they were to be audited and could not prove that they own the music, they would be subject to copyright violation penalties. Just use your iPod when you're at the office if you want to listen to music. -
When I connect my iPod touch it tells me that I need a new version of Apple Mobile Device Support and to uninstall iTunes and then re-install it, I've done that twice with the newest version of iTunes and it still doesn't work?
Try:
Removing and reinstalling iTunes, QuickTime, and other software components for Windows Vista or Windows 7 -
Why does a meesage pop up when I connect my iPod touch saying that the device will not work because the Apple mobile device hasn't been activated?
Refer to this article to restart AMDS:
How to restart the Apple Mobile Device Service (AMDS) on Windows
http://support.apple.com/kb/TS1567 -
When I connect my iPod touch to my stereo, I cannot change tracks using the iPod or the stereo controls. I did not have this problem with my iPod nano. I have the software update 4.2.1 installed. Is it a problem with the software or the stereo? Please help.
Here:
iPhone, iPad, iPod touch: How to restart the Apple Mobile Device Service (AMDS) on Windows -
When I connect my Ipod touch, the device dosent show up
When I connect my Ipod touch to my computor. The Device from itunes dosn' t show up. So I cant really sync my music or other stuff that I want to put on my Ipod. Please help me!.
Ok, there can be several reasons an iPod will do this:
1.) The device may have a hardware issue, such as the 20-pin connector's connection to the logic board of the device is faulty, etc.
2.) A software/firmware issue is restricting the device from connecting with the computer properly.
Here are a few things to try:
1.)
1. Restart your computer
2. Power off your device
3. Plug in your device
4.) Launch iTunes if it does not automatically launch
if that does not work:
2.)
1. Keep your device plugged into your computer.
2. Power off your device while it is connected.
3. Disconnect your device
4. Begin holding the home button of your device
5. While holding the home button down, plug your device into your computer
6. Continue holding the home button until iTunes pops up (if it takes more than, say, 1 minute, it is not working). iTunes will say it detected a device in recovery mode, and that you will need to reinstall your software. Do so by clicking the button 'Restore' under the picture of your device in iTunes (when you are on the page of your device inside of iTunes).
if that does not work:
3.)
1. Power on your device while connected to your computer
2. Leave your device connected to your computer and power off your device by pressing the home and power buttons down
3. After 10 seconds from the time you started holding the buttons, release the power button, but continue holding down the home button
4. Stop holding the home button down once iTunes launches and says that your device is in recovery mode, then proceed to do a software restore by clicking on your device in iTunes, then clicking the button that says 'Restore'. -
When I connect my iPod touch to my computer, I have a list of Events on my iTunes-iPod-Photos. I want to erase these Events. However, the photos are NOT on my MacBook Air-iPhoto. When I check one of the Events and then hit Apply, the photos appear on my iPod. And one last thing: When I connect the iPod and open iPhoto, iPhoto tries to load New Photos (I think), but nothing happens. Any ideas?
Resolved.
-
when I connect my iPod touch to your computer, itunes does not detect it ... but in My computer is detected as an external disk why?
See:
iOS: Device not recognized in iTunes for Windows
IOt is normal and expected for the iPod to appear in My Computer -
So, when I connect my ipod touch to my mac, iPhoto opens it and shows the pictures I have on my ipod. But the thing is, my ipod is not showing in iTunes. How can I change the settings so I could see my ipod touch in itunes?
Let's start by disabling the camera nofication.
http://support.apple.com/kb/ts1501
If your iPod still does not appear in iTunes, see this article for assistance.
http://support.apple.com/kb/TS1591
B-rock
Maybe you are looking for
-
AutocapitalizationType only has effect on the first set??!
Anyone encountered using autocapitalizationType or autocorrectionType? It seems that setting of these properties of a UITextField only has effect on the first set. Once you start typing, you can't stop it. I'm not sure what is required to reset the b
-
Retro Billing for Multiple invoices (in case of supplementary billing)
Dear Sirs, Can you pl suggest me step by step usage of Retro Billing. I would like to use it for supplementary billing for the 1 customers with multiple invoices. For one invoice, I used invoices correction request. But for multiple invoices, I guess
-
How do I get the top links in the search results page to display the folder?
In the search results page, if you click on the top link from each result, it only brings up the description. Not much use as a link, so was wondering how you display the folder from this link.
-
How to validate table entries for that table
i hav created one ztable se11.how to validate table entries for that table
-
Read positions of Objectid with function module
Hi experts!, I would like to read User Id, First name and position number fields by ObjectId. RH_READ_INFTY only show part of data. Could you say me another Function Module to do this? A lot of thanks in advance. Best Regards.