When i plug my ipod in it doesn't charge or connect to itunes, or sometimes it says it isnt charging then i restart it and it will have full battery?
i plug my ipod in and the lightening icon doesn't pop up on the battery but that never appears. then i look later on and i will have full battery, but my ipod isnt charging at the moment and it doesnt connect to my computer?????????
Try:
- Reset the iOS device. Nothing will be lost
Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Reset all settings
Go to Settings > General > Reset and tap Reset All Settings.
All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
- Restore from backup. See:
iOS: How to back up
- Restore to factory settings/new iOS device.
- Make an appointment at the Genius Bar of an Apple store.
Apple Retail Store - Genius Bar
It also could be due to a defective Lightning cable. Other uses have had problems with the cable.
Similar Messages
-
When I plug my ipod in it doesn't say "do not disconnect". I cant add music
When I plug my ipod in it doesn't say "do not disconnect". I cant add music. Please help me!
Dell Windows XPFirst of all, try another port on your computer. Some ports are not connected direct to the motherboard and do not recognize the iPod as well as those that are. Reset the iPod each time you connect it to another port.
Still no joy, see these.
Your Windows PC doesn't recognize iPod.
iPod appears in Windows Explorer but does not appear in iTunes.
iPod does not appear in iTunes.
Fast user switching in Windows XP is not supported.
Strange iPod behavior.
When restoring the iPod, put it into disk mode first.
Putting iPod into disk mode. -
I just bought a philips fidelio docking speaker and when I plug my iPod touch 4th gen it charges but dosent play music through the speaker.
Does Phillips say it will work with a 4G iPod with 6.1.5?
Have you went to their support site?
Which dock did you get?
This one
http://www.usa.philips.com/c-p/DS8500_37/-/specifications
says only compatilbe with the 1G, 2G and 5G iPod tpouchs (as well as some other iOS devices) -
The cord works, theusb port works, and when I plug my ipod into the wall charger it works, but when I plug it into the computer, nothing, not even charging. P.S. it worked before I updated it to iOS 6.1.5
You do have iTunes 10.7 or later on the computer, right?
See:
iOS: Device not recognized in iTunes for Windows
I would start with
Removing and reinstalling iTunes and other software components for Windows Vista, Windows 7, or Windows 8
or
Removing and Reinstalling iTunes, QuickTime, and other software components for Windows XP
Run this to help if it identifies the cause
iTunes for Windows: Device Sync Tests
Have you tried on another computer to help determine if you have a computer or iPod problem? -
Obviously not too smart with all this technology. I puchased a Blackberry Playbook Tablet and wanted to sync my itunes music, so following directions on the Playbook, I downloaded this app - Daniel Bingham Itunes sync - and when I went to my pc, I pulled it up, plugged in my Playbook and it did sync all my music from my Itunes library to the Playbook. However, now when I plug an ipod in my pc to charge or sync more music, my pc is not showing it recognizes any of my ipods being plugged in. It makes no mention of any of my ipods being connected! I also keep getting this "Found New Hardware Wizard" box that keeps popping up everytime I plug an ipod in - it originally showed up when I had Playbook plugged in to download all its info (I think) but it never completes, saying not compatible - so I click cancel. I have since clicked on remove New found hardware but it still pops up. Why does it continue to show with every Ipod now? Any idea on what I can do to repair this situation? Please help!
You performed all of the steps outlined in this link?
http://support.apple.com/kb/TS1567
You uninstalled and reinstalled iTunes?
GB -
Ipod classic has been wiped saying 'no music'etc.
Cannot see it on the 'device list' in my itunes. I have tried restoring to factory settings and reloading...it reloads some of the music, but when I plug the Ipod back in, it wipes it again. Ocassionally Itunes freezes when I plug in the Ipod.Make sure your headphones are plugged in all the way, meaning you cannot see any of the silver still showing from the headphone's plug.
A feature of the Nano is to put it to sleep when the display goes out and it does not detect any headphones.
B-rock -
I keep authorizing my pc, but when I sync my IPod touch, it doesn't want to sync because "Your computer is not authorized.". Any help?
Click here and follow the instructions.
(92988) -
When i plug my ipod into my computer it is not recharging. The computer doesn't even acknowledge that it is plugged in. Any ideas why? It does have power left so i can use it but i want to recharge it of course. Any input is appreicated.
Plug it into the wall using the supplied charger.
Barry -
My iPod doesn't turn on anymore. Even when I plug it into the computer or a charger, nothing happens. What's wrong with my iPod?
If you get an network timed out error, try disabling the security software on your computer.
-
I plugged in my ipod touch 4g to sync with my macbook pro and itunes sent an error saying itunes cannot read your ipod please reset your ipod, so as suggested by itunes i reset my ipod and now when i plug my ipod in itunes doesn't even recognise it and doesnt sync with it
Hello frankini
Continue your troubleshooting with the article below to resolve issues with your iPod touch not being seen in iTunes. It will walk you through checking the drivers as well as any security software that may be blocking it.
iOS: Device not recognized in iTunes for Windows
http://support.apple.com/kb/ts1538
Regards,
-Norm G. -
When i plug my ipod into my car radio it doesn't work
when i plug my ipod nano 7th generation into my auto stereo it doesn't work. Is there a switch i need to turn on
Start here:
iPhone, iPad, or iPod touch: Device not recognized in iTunes for Windows
However, recently some or all of Apple support article pages do not work and you might get a page that says Apple is performing maintenance. -
I have my entire music library (purchased and burnt CD's) on my iPod Touch from one computer and I wanted to sync it all to my new computer. I was hoping it would all transfer via sync when I plugged it in but it doesn't seem to work. Please help?!
Ok, I had a glitch, forced to restart, and lost my train of thought.
Reinstalling iTunes should fix the major issue that might have gone wrong, perhaps your explaination points will disappear and everything will be peachy again.
But if they don't, you can open the XML file in iTunes Folder using a Text edit program to see what the common pathname is to the iTunes Music folder or where your content is located.
If you moved the itunes folder, it needs to go back.
I can't download iTunes to my Vista virtual machine to test it out right now because iTunes is down, so I can't verify the pathname, perhaps your issue and the iTunes being down are related somehow?
You don't want to import all your music again, but it's a option, but you lose all your playlists, that's what I'm trying to recover.
If oyu don't have a whole lot of playlists, then simply select all the explaimation point music and delete, select File from the menu and import your itunes folder again. -
I have an IPOD Tough and a MAC. When I plug my IPOD into the MAC, no IPOD device icon appears on the MAC. Additionally when I go to Itunes, there is no IPOD device listed. How can I get the MAC to recognize the IPOD?
See this article for some solutions:
iOS: Device not recognized in iTunes for MAC OS X, http://support.apple.com/kb/TS1591 -
When I plug my iPod classic (only three months old) into iTunes, it doesn't show up as a device on iTunes. I plugged it in to update last nightm, but all my music was erased and now it isn't even recognized. The iPod itself shows it being connected, but nothing on iTunes. Any ideas would be appreciated. eta2359
Have you carefully worked through each and every single suggestion in this Apple support document?
iPod not recognized in 'My Computer' and in iTunes for Windows
B-rock -
When I plug my ipod shuffle into my usb port, it no longer shows as a "device" over to the left. This makes it impossible to to transfer a new playlist to my ipod. Any suggestions?
Hi deaconspeaking,
Welcome to Apple Support Communities.
Try looking for the iPod below the Search field in iTunes. If it doesn't show up below search, the second article provides troubleshooting tips that should help you out.
iTunes: Syncing media content to iPod
http://support.apple.com/kb/ht1351
Click the button with your device's name, below the Spotlight window.
In the main iTunes browser window, select Music.
iPod not appearing in iTunes
http://support.apple.com/kb/ts3716
-Jason
Maybe you are looking for
-
Reconnectin Media only works for one file at a time...
Hi, After having many times relinked hundreds of off-line media files in one go, FCP now doesn't want to reconnect more than one file at a time. Although all other files are in the relative path, it seems as if I have to relink 1200 files one by one.
-
HT1222 It's asking for a 4 digit pass code don't have one that I'm aware of so what t
It's asking for a 4 digit pass code and I'm unaware of a pass code so how do I go about updating my soft ware please help
-
Workbook Header Format Problem
Dear all, I have a workbook in BI 7.0, What i need is to add a logo and make headers of the query bold. as i save my workbook and run again, i can see the logo, however my format changes in query (that is header color change font change) disappears.
-
I love being able to sync my iCloud content so easily from my iPhone to my Mac (contacts, calenders, notes, etc.), but since I updated to Mavericks (at least I'm almost sure that's when it started), the Notes app on my Mac has shown duplicates of eve
-
How to use g_update_totals FM?
Hi all, How to use this FM for loading data into SAP. I know the t-code for loading that data manually is Fse5n. Thanks, Charles.