Whenever I go to a site or click anything, I always have to move my mouse for the page to load, why is this happening? (When I go to a site full of images, I move my mouse a little bit at a time and it loads one image at a time)

Hi, Tom.
FYI: You've not stated which of your listed Macs is having the problem. However, the following may help in any case:
1. Did you install Front Row using the Front Row hack on a Mac that did not ship from the factory with Front Row installed? If so, See my "Uninstalling the Front Row hack" FAQ. This has been known to cause a variety of problems, including the menu bar (Clock, Spotlight) issues you noted.
2. If you did not install the Front Row Hack, an incompatible or corrupted Startup or Login Item may be partly to blame for the problems with the menu bar. My "Troubleshooting Startup and Login Items" FAQ can help you pin that down if such an item is causing the problem.
3. As a general check, run the procedure specified in my "Resolving Disk, Permission, and Cache Corruption" FAQ. Perform the steps therein in the order specified.
4. Re: Safari and Mail, if not sorted by any of the above, see also:• "Safari: Blank icon after installing Security Update 2006-002 v1.0."
• My my "Multiple applications quit unexpectedly or fail to launch" FAQ
Good luck!
Dr. Smoke
Author: Troubleshooting Mac® OS X

Similar Messages

HT2500 I sometimes get e-mails where the sender sends me several PDF's attachments. These attachments appear already opened on the e-mail unlike most PDF's which I open by clicking on the PDF icon. Why does this happen?

I sometimes get e-mails with pdf attachments. However instead of opening a PDF icon the body of the e-mail message has the PDF's already opened. Why does this happen? Is there anything I can change on my mac book pro to make these PDF's come thru with their individual icons which can then be opened.

This is a long-standing design flaw in Apple Mail.
Prior to Mavericks, this command in Terminal would stop the annoying behavior:
defaults write com.apple.mail DisableInlineAttachmentViewing -bool yes
This Terminal command stopped working in Mail 7.1 under Mavericks. I have reported this to Apple as both a feature request and a bug. You should too.
http://www.apple.com/feeback

In firefox, whenever i have my mouse over the page (not the toolbar section), any selection i have moves. For example - a text entry box and the cursor keeps returning to the start of the box. This is only in firefox, everything else works fine (IE and Ch

I have an issue with FF. Whenever I have my mouse on the page (not the toolbar area) any selection I make gets altered in the following way:-
Text boxes - The cursor keeps moving to the left.
"Radio" buttons - Selection keeps moving up.
This is only happening in FF, I am not seeing this behaviour in Chrome or IE.
== This happened ==
Every time Firefox opened

Start Firefox in [[Safe Mode]] to check if one of your add-ons is causing your problem (switch to the DEFAULT theme: Tools > Add-ons > Themes).
See [[Troubleshooting extensions and themes]] and [[Troubleshooting plugins]]
If it does work in Safe-mode then disable all your extensions and then try to find which is causing it by enabling one at a time until the problem reappears.
You can use "Disable all add-ons" on the [[Safe mode]] start window to disable all extensions.
You have to close and restart Firefox after each change via "File > Exit" (Mac: "Firefox > Quit"; Linux: "File > Quit")

I click on one song and another one starts playing. Cover art for one artist shows up on another album. All of my music isn't showing up. Please help. Why is this happening? How can I fix it?

I click on one song and another one starts playing. Cover art for one artist shows up on another album. All of my music isn't showing up. Please help. Why is this happening? How can I fix it?

Sorry for not getting back with you...
That moves only the iTunes media, not the iTunes library (which is really kinda nebulous).
iTunes library = iTunes folder and all the media, wherever it is located.
The /Music/iTunes/ folder contains the iTunes library.itl file, which keeps track of everything in iTunes.
I do however still have the original MAIN startup drive still in the computer, it's just not the startup.
This is good you still have it.
Try this...
Hold Option and launch iTunes.
Select Choose library... and select the /iTunes/ folder on the original drive. It should be in /Users/your_user_name/Music/.
Don't mess with anything. We can get it cleared up.
Does everything work okay?

Is there any easier way to edit imovie files that have been exported as mov file then added to FCE 4?? As every move I make has to be rendered and takes forever??? Also my recording is going out of focus without me touching the camera, why has this happen

Is there any easier way to edit imovie files that have been exported as mov file then added to FCE 4?? As every move I make has to be rendered and takes forever??? Also my recording is going out of focus without me touching the camera, why has this happened any idea what causes this??
iMovie '08, Mac OS X (10.5.8), FCE 4

My daughter has had her Razr for about 9 months now. About two weeks ago she picked up her phone in the morning on her way to school when she noticed two cracks, both starting at the camera lens. One goes completely to the bottom and the other goes sharply to the side. She has never dropped it and me and my husband went over it with a fine tooth comb. We looked under a magnifying glass and could no find any reason for the glass to crack. Not one ding, scratch or bang. Our daughter really takes good care of her stuff, but we still wanted to make sure before we sent it in for repairs. Well we did and we got a reply from Motorola with a picture of the cracks saying this was customer abuse and that it is not covered under warranty. Even though they did not find any physical damage to back it up. Well I e-mailed them back and told them I did a little research and found pages of people having the same problems. Well I did not hear from them until I received a notice from Fed Ex that they were sending the phone back. NOT FIXED!!! I went to look up why and guess what there is no case open any more for the phone. It has been wiped clean. I put in the RMA # it comes back not found, I put in the ID #, the SN# and all comes back not found. Yet a day earlier all the info was there. I know there is a lot more people like me and all of you, but they just don't want to be bothered so they pay to have it fix, just to have it do it again. Unless they have found the problem and only fixing it on a customer pay only set up. I am furious and will not be recommending this phone to anyone. And to think I was considering this phone for my next up grade! NOT!!!!

I am having trouble watching videos and movies. I have updated Adobe Flash Player and Microsoft Silverlight but each time I try to watch something I get the message that I have to install or update these programs... Why is that happening? Can it be fixed?

I have updated Adobe Flash Player and Microsoft Silverlight but each time I try to watch something I get the message that I have to install or update these programs... Why is that happening? Can it be fixed? How do I fix it? PLEASE HELP!

Please post a screenshot that shows what you mean. Be careful not to include any private information.
Start a reply to this message. Click the camera icon in the toolbar of the editing window and select the image file to upload it. You can also include text in the reply.

What do i do if my internet is wep and i need it to be wpa2 because my ipod touch 4th gen connects to the internet but when i click on safari or itunes it says safari cannot open the page because its not connected to the internet

what do i do if my internet is wep and i need it to be wpa2 because my ipod touch 4th gen connects to the internet but when i click on safari or itunes it says safari cannot open the page because its not connected to the internet. i have contacted apple support and they said to change from wep to wpa2 but when i change it to wpa2 and type in password and connect on my laptop it says the saved setting on this computer for the network do not match the require ments of the network

My 2nd gen works fine with WPA2 and AES encryption.
You may need to go back and start over. Reset the router back to factory defaults, log on as the admin, set up security, DHCP, and make sure the IP address pool has enough IP addresses to lease to ALL of the computers/devices that will connect to that the router.

Hi, I'm in Nova Scotia, Canada and when I try to use Siri it loads and loads and then says, "I'm really sorry about this, but I can't take any requests right now. Please try again in a little while." I rebooted and it didn't fix the problem. I just got

Hi,
I'm in Nova Scotia, Canada and when I try to use Siri it loads and loads and then says, "I'm really sorry about this, but I can't take any requests right now. Please try again in a little while."
I rebooted and it didn't fix the problem. I just got my iPhone 4s (unlocked right from Apple) several weeks ago.

Siri has been a bit more erratic than usual in the last week or so. Apple has announced a major announcement for 9/12. Conclusions are left to the reader.
Best of luck.
(Occasionally from Lower Economy, Colchester County).

How can i control what images load on my project to save preload time and avoid loading all images, elements, divs not yet visible?

Sup buddies,
How can I control what images load on my project to save preload time and avoid loading all images, elements, divs not yet visible?
As the project grows in size the load time increases. How does one control not loading all images ,divs,elements etc. until they're
needed on the timeline? For example some sections are off and only become visible when recalled. My projects slowly grow in size so loading
all images , is counter productive . My other option would be to create separate htmls but that breaks the seamless user experience .
TY...Over N Out...

hello, kiwi
quote: "Is there an easy way to burn a completed project to DVD, but keep only the (lo res, lo size) previews on my hard drive?"
yes.
maybe,...
1. you might think of making DVD backups first prior to importing the photos into Aperture. "Store Files: In their current location" once in Aperture make low rez Previews, and export finished Project.
or,
2. bring in the photographs to hard drive first prior to importing the photos into Aperture. "Store Files: In their current location" once in Aperture make low rez Previews, and export finished Project.
the low rez Previews will stay in Aperture but the high quality Versions will be exported onto DVDs and gone from the hard drive (if you delete the originals).
another way would be to export small about 50-70 pixel wide high quality jpegs to a folder on your Desktop and import & keep these in Aperture Library as a reference. make metadata to show where the original Project DVDs are stored and DVD filing system used.
victor

I have just clicked on my iTunes desktop icon and got the following message "The file iTunes Library.itl" cannot be read because it was created by a newer version of iTunes. Why has this occurred when it working fine?

I have just clicked on my iTunes desktop icon and got the following message "The file iTunes Library.itl" cannot be read because it was created by a newer version of iTunes. Why has this occurred when it working fine? Is it best to update iTunes to 10.2 to attempt to resolve? Initially I got the prompt Quicktime was out of date so I updated that successfully in all programs. I do not want to lose my iTunes library.

Sorted problem updated and reinsatlled and restarted computer.

Ive just signed up for the adobe photoshop pack, i use a mac, when i click download, nothing is happening.. Am I doing something wrong?? When I try and open the software I already had from trial it says its expired, or i need to use a serial number... H

Ive just signed up for the adobe photoshop pack, i use a mac, when i click download, nothing is happening.. Am I doing something wrong?? When I try and open the software I already had from trial it says its expired, or i need to use a serial number... HELP Anyone else experienced this?

If there is an option to "license this software", and it takes you to a sign-in page with username and password (not a serial number) - then just go ahead and sign in.
If it insists on a serial number you need to uninstall the trial. Then try to download again.

TS3989 I can't view the photos in photo stream. When i click on the photo stream, automatically it goes back to home. Why is this happening? How do i resolve?

I can't view the photos in photo stream. When i click on the photo stream, automatically it goes back to home. Why is this happening? How do i resolve?

If older photos are missing it may be because photo stream photos are only held in iCloud for 30 days. After that they are removed from iCloud but will remain (up to 1000 photos) on your device until deleted. Also, only photos taken after enabling photo stream are added to your photo stream, and only when the camera is closed, your device is connected to wifi and you have at least 20% battery life remaining.
To transfer the missing photos you can either create a shared photo stream containing them and invite yourself to it (see http://help.apple.com/icloud/#mmc0cd7e99), import the photos to your computer and sync them to your iPad, or use an app like PhotoSync to transfer them to your iPad over wifi.

Keyboard and a mouse for the ipad

hi,i do know that there is a keyboard for the ipad that works by bluetooth, but i want to know if there is also a
mouse for the ipad (by bluetooth or usb) and how could i get one and configurate it.

In terms of a mouse then no, they are not supported on iPads

I have bought new iPad air for the new app I book apple charged 1$. On the web sit it's say free .

I have bought new iPad air for the new app I book apple charged 1$. On the web sit it's say free .

If you have recently created a new iTunes account, the $1 charge will most likely be for account verification. The money will be refunded shortly.
http://support.apple.com/kb/HT3702

When attempting to go to my Cox Web Mail account I receive at the top of the page. "Firefox is preventing this page from redirecting to other page, so I have to click on the top right ALLOW for it to redirect to my Cox Webmail sign in page. Why?

When using my Cox e-mail shortcut to go to the sign in page why does Firefox prevent the current page from redirecting to the Cox web mail sign in page?
What settings do I change so I don't have to go to the top right of the page and click on ALLOW?

@Steve_Clairman, if you are looking for the orange Firefox button (abbreviated menus), it will appear if you turn off the classic menu bar:
View menu > Toolbars > ''uncheck'' Menu Bar

Whenever I go to a site or click anything, I always have to move my mouse for the page to load, why is this happening? (When I go to a site full of images, I move my mouse a little bit at a time and it loads one image at a time)

Similar Messages

Maybe you are looking for