Whenever i open itunes after installation it says error 7 itunes was not installed correctly
whenever i open itunes after installation it says error 7 itunes was not installed correctly
For general advice see Troubleshooting issues with iTunes for Windows updates.
The section Install missing components may allow you to install Apple Application Support.
The steps in the second box are a guide to removing everything related to iTunes and then rebuilding it which is often a good starting point unless the symptoms indicate a more specific approach. Review the other boxes and the list of support documents further down the page in case one of them applies.
Your library should be unaffected by these steps but there is backup and recovery advice elsewhere in the user tip.
If the advice above doesn't resolve things you could try this alternate version:
iTunes 12.1.0.71 for Windows (64-bit - for older video cards) - itunes64setup.exe (2015-01-28)
which is a 64-bit installer for the 32-bit version of the core application, similar to previous 64-bit releases.
Or roll back to the previous build:
iTunes 12.0.1.26 for Windows (32-bit) - iTunesSetup.exe (2014-10-16)
iTunes 12.0.1.26 for Windows (64-bit) - iTunes64Setup.exe (2014-10-16)
tt2
Similar Messages
-
when I install the program, all go good but when i open the program, it say: iTunes was not installed correctly, Please reinstall Itunes Error 7 (windows 193), After i do this but the same
Howdy Allux345.
After multiple installations of iTunes it can be frustrating when the issue isnt resolved. I was able to locate the following knowledge base article that specifically addresses the "Error 7" you are recieving.
iTunes for Windows: "Error 7" message when opening iTunes
http://support.apple.com/kb/TS3074
The Resolution section has different steps depending on what version of the Windows Operating System you're using. Since it can be a bad installation of these Windows files, pay close attention to the instructions on repairing if the file already exhists.
Thanks for reaching out to Apple Support Communities with your question.
Cheers,
Pedro D. -
I tried to update iTunes to version 10.5.2 and now I can't open it. After it said it was successfully downloaded, it tried to open iTunes and it said iTunes was not installed correctly. Please reinstall iTunes. Error 7 (Windows error 127). I unsitalled iTunes and tried again, and nothing works. Help.
Doublechecking first:
I unsitalled iTunes and tried again, and nothing works
Where you using the following document as a guide for that? (The 7 can be produced by damage to the related software components, so the Verify iTunes and related components are uninstalled step is quite important.)
Removing and reinstalling iTunes, QuickTime, and other software components for Windows Vista or Windows 7 -
my itunes has gotten error 7 (windows error 14001) itunes wont even open it just says itunes was not installed correctly. someone help please
For general advice see Troubleshooting issues with iTunes for Windows updates.
The steps in the second box are a guide to removing everything related to iTunes and then rebuilding it which is often a good starting point unless the symptoms indicate a more specific approach. Review the other boxes and the list of support documents further down the page in case one of them applies.
The further information area has direct links to the current and recent builds in case you have problems downloading, need to revert to an older version or want to try the iTunes for Windows (64-bit - for older video cards) (not for XP) release as a workaround for installation or performance issues, or compatibility with QuickTime or third party software.
Your library should be unaffected by these steps but there are also links to backup and recovery advice should it be needed.
tt2 -
Unable to install iTunes after converting from Windows Vista to Windows 7. Am told installation was successful, then "iTunes was not installed correctly", followed by "Error 7 (Windows error 193). I have my iPod plugged into my computer via USB port. What am I doing wrong?
i have the only account on my laptop so have checked and am the account administrator
i run windows 7 home premium
I have the same problem and
have followed the link uninstalling in the correct order,
then restarted as per instructions,
went to Apple to download itunes,
hit download now,
Visit the iTunes download page. Click Download Now to download the iTunes installer. When prompted, click Save (instead of Run).
did not get a save instead of run prompt
Right click on iTunesSetup or iTunes64Setup (the installer you downloaded in step 3).
If you have Windows Vista, Windows 7, and Windows 8: Choose "Run as administrator."
i can only click run as administrator from right clicking the shortcut on my desktop screen
If iTunes fails to install or repair, it might be necessary to remove components left from a previous installation of iTunes and then reinstall.
sick of doing this
at least 7 or 8 times i have re installed itunes to no avail
troubleshooting no better
please help. pulling my hair out at this stage
it was working fine until 2 days ago when i opened itunes it offered to update to 12.1
not working since i clicked yes
also i have gone to restore previous point and ffs there are no restore points before my multiple reinstalls
really dont want to have to restore factory settings -
I have the latest version of iTunes and when I went to go open it, it can't! It says: "iTunes was not installed correctly. Please reinstall iTunes.Error 7 (Windows error 126)" What do I do now? Should I uninstall and try installing it again? I don't want to loose any of my music and info. PLEASE HELP!
Click here and follow the instructions. You may need to completely remove and reinstall iTunes and all related components, or run the process multiple times; this won't normally affect its library, but that should be backed up anyway.
(100023) -
iTunes was not installed correctly. Please reinstall iTunes. Error 7 (windows error 126). This message appears when attempting to open iTunes even after reinstall?
Repair Apple Application Support.
START/CONTROL PANEL/PROGRAMS N FEATURES/highlight APPLE APPLICATION SUPPORT, then click the REPAIR button -
When opening iTunes on my new Windows 7 PC I continue to get the same messages, 'The program can't start because AVFoundationCF.dll is missing' and 'iTunes was not installed correctly. Error 7 (Windows error 126)' I've uninstalled and reinstalled many times to no avail, even tried it on a different user account and still nothing. I recently installed Panda Internet Security 2012 (about 12 days ago), initially iTunes worked fine as usual but within the last few days I've been unable to open it with the same messages appearing. I've read through some of these pages and tried everything that's been advised, uninstalling and reinstalling while internet and laptop security is swithched off, downloading tools to completely remove anything related to iTunes, tried it in Safe Mode, nothing has worked. I've also noticed that in the start menu when I click on iTunes, it says '(empty)' where it should have the logo and ability to start the program, does this mean it doesn't download + install properly each time I've tried? Any help would be enormously appreciated.
Doublechecking. Have you also tried the following user tip?
Troubleshooting issues with iTunes for Windows updates -
I was today invited to upgrade my iTunes when I logged on. Update failed. Every time I now try to open iTunes I get error messages. Second message reads "iTunes was not installed correctly. Please re-install iTunes. Error 7. Windows error 126". I now can't sync my iPhoneand I am worried that if I re-install I will lose all my contacts,calendar, notes, etc.
I too had this problems (Windows 8.1). A few weeks ago after the previous update before this version of itunes, I'd had a problem with the itunes store crashing and at that time I followed instructions to copy QTMovieWin.dll to the itunes folder, which fixed the store crashing.
Today I fixed the problem by:
Delete QTMovieWin.dll from C:\Program Files (x86)\iTunes.
Uninstall ALL Apple Software using Control Panel / Programs and Features. I uninstalled:
iTunes
QuickTime
Apple Mobile Device Support
Apple Application Support
Apple Software Update
Bonjour
Delete the folders:
C:\Program Files (x86)\iTunes
C:\Program Files (x86)\Common Files\Apple
Restart the computer
Reinstall QuickTime
Reinstall iTunes
Everything works GREAT now, including the iTunes store. You will not lose your media files, I got everything back, all my settings, playlists, etc. -
My intunes stopped leting me connect my ipod or nconnect to the itunes store. So I uninstalled itunes and all apple software an tried reinstalling several times. After each instal I get the following error message.
"iTunes was not installed correctly. Please reinstall iTunes."
error 7 (windows error 126)iTunes for Windows: "Error 7" message when opening iTunes
For error 126: http://support.microsoft.com/kb/959077 -
Attempted to update iTunes on January 23rd and it appeared to install properly. When I tried to open iTunes on January 24th, it would not open and gave me an error message that said "iTunes was not installed correctly. Please reinstall iTunes. Error 7 (Windows error 126)" I then tried to reintall iTunes and it again appeared to install properly but when it attempted to open, I was given the same error message.
Taken at face value, you're having trouble with an Apple Application Support program file there. (Apple Application Support is where single copies of program files used by multiple different Apple programs are kept.)
Let's try something relatively simple first. Restart the PC. If you're using Vista or 7,now head into your Uninstall a program control panel, select "Apple Application Support" and then click "Repair". If you're using XP,head into your Add or Remove Programs control panel, select "Apple Application Support", click "Change" and then click "Repair".
If no joy after that, try the more rigorous uninstall/reinstall procedure from the following post. (If you've got XP, although the procedure is for Vista and 7, just read "Computer" as "My Computer", read "Uninstall a program control panel" as "Add or Remove programs control panel" and assume the system is 32-bit, and you'll be doing the right things.)
Re: I recently updated to vista service pack 2 and I updated to itunes 10.2.1 and ever -
I have had problems with iTunes lately it says iTunes was not installed correctly and to reinstall. I tried 3x and still will not. Now I get a message it can not start because MSVCR80.dll is missing reinstall to fix??
See Troubleshooting issues with iTunes for Windows updates.
tt2 -
I have been having this problem since the 4th of this month. I tried to open iTunes and this error message came up: "iTunes was not installed correctly. Please reinstall iTunes error 7 windows error 126". There is nothing else that comes up but if anyone can help or know anything about it I will greatly appreciate it.
Have you tried google for this Error Message...
http://support.microsoft.com/kb/959077 -
I was cleaning up my laptop to free up some disk space. I now can't get into my itunes ??? It's saying Itunes was not installed correctly error 7 (windows error 14003)
What do I need to re-install to get my itunes back?Is there also another message, Rob, citing a particular file? If so what is the name of the file? (Precise spelling, please.)
Are you running XP, Vista or 7? (I'm assuming 2000 must have just been a slip of the fingers.) -
I run Windows 8.1. I have received the result after several attempts uninstalling and reinstalling iTunes, "ITunes was not installed correctly. Please reinstall iTunes. Error 7 (Windows error 127)" What can I do? to solve the problem. Tried to clean the windows registry, no change. Very frustrating. Any advice is much appeciated.
Thanks.Try the following user tip:
Troubleshooting issues with iTunes for Windows updates -
Did latest update for itunes and now can't open Itunes. Get pop of :itunes was not installed correctly.Please reinstall itunes. Error 7 (Windows Error 126). Have reinstalled various times and still can't open itunes. Please help.
Repair Apple Application Support.
START/CONTROL PANEL/PROGRAMS N FEATURES/highlight APPLE APPLICATION SUPPORT, then click the REPAIR button
Maybe you are looking for
-
AU plug-in, in Components folder, not in GarageBand
I've been searching through forums for an answer to this, but so far, no luck: I've installed MOTU Symphonic Instrument v1.1.3, which is a stand-alone app as well as an AU plug-in. The plug-in is now in Library>Audio>Plug-ins>Components, but in Garag
-
How to find the name of the block and yours items at runtime
Hi, everybody. I wonder if there is any way to list the name of a block and their respective items that forms at run time. for example, using a loop in wnfi. Since already thank you. Sorry for my bad English.
-
Joining, NOT extending, a non-apple network
I just bought an Airport Express (N) for the purpose of using it to do Airplay. Just Airplay, no extending networks. I have a not-Apple network (ASUS router running Tomato), so I do not expect "extend" to work easily. When I ask airport utility (6.3
-
Connect to ServerSocket of codebase host fails thru proxy since 1.6.0_03
hi there, I have an applet that connects to a server-socket of it's code-base host (i.e. the server it has been loaded from) and loads additional data. since 1.6.0_03 the connection fails with a SecurityException when there is a proxy server in betwe
-
Hi, I have to upload and Download the scanned images using my Webdynpro Abap application.Please send anybody having sample app document for this. Regards, KumarL K