Whenever I use the trackpad on my 17" Macbook Pro (2010 model) there is a small, trebly processor sound coming from within the enclosure.

Whenever I use my trackpad, there is a whirring, trebly sound coming from within the computer itself. It happens also when webpages are loaded or programs are compiled, but not when I use the keyboard or when the computer is in disuse. It has become louder over time, and it is obvious that when the computer senses input from the trackpad and must translate it, the sound is produced. Is there any way to reset the firmware or an option on the Settings menu that could perhaps help? I am concerned that it is a symptom of a larger problem. Thanks.

The question mark means the computer cannot find a bootable volumes so can;t do anything, That, combined with annoying sounds, strongly suggests a failed hard drive.
You can ask a "genius" at an Apple Rtail Store to test it but I'm pretty sure the drive is kaput. I'm hoping you had your data backed up.

Similar Messages

I want to remove the monitor from my 17" Macbook Pro 2008 to use as an external for my Macbook Pro 15" 2012. How can I convert lvds to Thunderbolt and power the monitor?

I want to remove the monitor from my 17" Macbook Pro 2008 to use as an external for my Macbook Pro 15" 2012. How can I convert lvds to Thunderbolt and power the monitor?

It's almost impossible. The new iMacs have a Target Display Mode, but it's built to do that. Without ripping your screen out, finding an acceptable power supply, frame, and whatever electronics to convert a Thunderbolt signal to the screen, the cost will be much larger than buying a cheaper HiDef monitor that runs with an HDMI to Thunderbolt cable to your MacBook 15. In fact, you can sell your 17" MBP for a lot of money, unless it's broken or something, buying you a really sweet monitor.
By the way, I found your answer by searching this forum. I would suggest using the search function here in the futuere.

The logic board on my MacBook Pro has failed. How do I retrieve all my data from the hard drive?

The logic board on my MacBook Pro has failed. How do I retrieve all my data from the hard drive?

Remove the drive and put it in an external enclosure. Backup the drive completely. Repartition and format the drive. Replace the drive into the computer. Take the computer in for the logicboard replacement.

I just changed the hard drive on my macbook pro 13" and it won't turn on. I need to put the latest operating system on it.

i just changed the hard drive on my macbook pro 13" and it won't turn on. I need to put the latest operating system on it. It had OS8 on it

dtrewitt wrote:
It had OS8 on it
Ummmm no it didn't. iOS only runs on iPhones, iPads and iPods.

Just bought a Mac but music on my MacBook Pro, iPhone and iPad which all sync together is not coming up on the new Mac - help please

ust bought a Mac but music on my MacBook Pro, iPhone and iPad which all sync together is not coming up on the new Mac. I think I have turned on iCloud but still nothing.

It does not magically appear, unless iTunesMatch is turned on.
Copy the media (the ENTIRE iTunes folder) from the old computer to the new computer

The trackpad of my 13" macbook pro (mid 2012) has geen going nuts for about a week now. It randomly clicks and drags the cursor to all places on screen, it randomly clicks, selects and swipes. Have tried spm reset and pressure on whole trackpad. Help?!

It goes nuts for hours and the next day it acts completely fine. My macbook is impossible to work with when the problem is active; it randomly clicks, drags, selects and even selects words (in a yellow colour) to come up with latin(?!) translations.
Ive tried the reset (option+cmd+r+p) and it seemed to work at first but now it doesnt seem to have any effect whatsoever.
Also tried to apply pressure to the entire surface of the trackpad or just the top corners; no effect whatsoever.
It's been quite an expensive purchase for a young student like me and i've really enioyed it until last week.
I'd be relieved if someone came up with a solution; especially since its warranty has expired for half a year now.

Hi there Bram3,
You may find the troubleshooting steps in the article below helpful.
Portables and Magic Trackpad: Jumpy or erratic trackpad operation
http://support.apple.com/kb/ts1449
-Griff W.

How do I backup the files on to my Macbook Pro 2010 from a damaged external hard drive?

Awhile ago my macbook pro crashed and I had to make a bootable disk of Mountain lion no problem here but I accidentallly deleted all the files off of my hard drive from which i recovered using a PC computer and disk drill. After it had recovered all my files i later tried to put these files on to my macbook computer and disk utility views the drive as damaged and needs to be repaired but in order to do this i have to format it and change the partition and what not. When i try to copy/burn to a CD the finder stops the operation and says that "finder cannot complete the operation because file _catalog cannot be moved" and just recently when i plugged my drive into my computer the sharing permissions say read only. I know that my files are there because when i right click and press get info i see that 5 gb are used but the folder is only showing me 2gb what do i do to get my files onto my computer?
My external hard drive is a WD 1 TB my passport and the partition thats givving my this trouble is formatted to be MS DOS FAT32
I have parallels Windows 8
I am running Mountain Lion on my Macbook Pro Mid 2010 model

Use Data Rescue on the Mac and out the recovered files to another external drive.
Just grab your users files, the rest you trash. That's all you can do.
Good Luck

There is a very loud, distorted sound coming from my Ipod Nano 7th generation no matter what headphones i use. Any fixes?

I bought an Ipod Nano 7th generation and out of the box, there was a really loud distorted sound as soon as i pressed play. When i press pause, it stops. If i use a different pair of headphones is does it. So, i exchanged it, and all was good for about three weeks, now even the new one is doing it. The sound is so loud and fuzzy that i cant even hear what the song is supposed to be.

First, ipod nano 7th gen does not have a built-in speaker. Second, a brand new nano jack is sometimes ifficult to insert, make sure it is fully inserted or flushed to the ipod body. Cheers!

What is the max amount of ram can I put in my Macbook Pro (2010 Model)?

I was wondering what is the max amount of ram can I put in my Macbook Pro?
Here is some specs of my macbook pro:
Version: 10.7.4 (Lion)
Processor: 2.66 Ghz Intel Core i7
Memory: 4 GB 1067 Mhz DDR3
Also I bought my macbook pro in 2010 when I had Snow Lepoard on it.

MacBook Pro
https://discussions.apple.com/community/notebooks/macbook_pro
https://discussions.apple.com/community/mac_os?view=discussions
http://www.apple.com/support/macbookpro

Using Photoshop Elements 12 on my MacBook Pro laptop, when saving a file I have been working on I get the following message although there is at least 50GB free space on the hard drive: Could not save because the disk is full.

I have been making Christmas Cards, working in layers and then flattening the image. However, I am unable to save the final image as I get the following message: Could not save because the disk is full. Looking at the system report for my laptop shows there is 52GB of free space.

Well, running on a 2006 model. I did not have a startup disc. Initially, it booted up on original software in 2006. Since then, I've upgraded to 10.6 via a box set. And, since then I think I popped it up to lion.
All I have on a disc is snow leopard. And, I can't get farther than the setup screen due to hard drive. I'm taking to a apple authorized repair store right now. We'll see what they tell me . I'm just going to weigh the cost of repair vs. buying new.
Another bad, stupid thing is I had no means of backing up my stuff. So, I might have lost things like music, vids, etc. we'll see if they can recover. If the cost is too much for repair I might just forget it and start over with a new system. Just not sure at this point.

Will Apple take the responsibility? My retina macbook pro (late 2013) seems to be damaged after I received it from the Service Center.

Two months ago, I had some problems with the hinges of the display screen I used to make weird sounds and I was finding it very hard to open and close the display. The Service Center guys said there was a problem with the hinges so, they replaced it. But after I received my macbook back, I noticed that one of the screws was not properly fitted but, I thought that it was not such a big deal and I would take it to the Service Center sometime later to get the screw fitted properly as was not a hinderance with my daily work. When I took my Macbook finally to the service center after 3 weeks, they tried to fix it and there were some problems. According to them the screw was somehow jammed in its place but they at the end fixed it. But, after I reached home, I noticed they applied too much pressure and the bottom of my laptop was bent from one edge and also the screw was in place but the the chassis was still loose and was coming out.
Need Help. What can I do.

Take it back and ask them. No one here can speak for Apple. This is a user forum.

I have a macbook pro 2010, And my display will show up as blue until i tap the back of it excessively. I dont know what the problem is. Any ideas?

Is this a fixable problem that wont cost more than the computer is worth?

It may be a faulty display connection cable. Only an Apple store genius bar will be able to definitively diagnose the issue and provide you with the actual repair costs.
Ciao.
If it is the cable, that should be relatively inexpensive. If it is the display, that will not be inexpensive.
Message was edited by: OGELTHORPE

Using System.err.println() from within the classes of WAS ?

hi,
I am using admin.jar,a jar file which is being used by Web Application Server in my own class.
I am referencing some of the classes from admin.jar from my class.
I tried to print some trace statements,using System.err.println() from within the classes in admin.jar but they did not reflect in defaulttrace0.trc.
I made these changes in the admin.jar being used by WAS.
I restarted the server and even restarted the machine but without success.
I want to know how to print System.out.println() statements from within the classes in admin.jar.
Also, am i looking for these statements in the right file for eg. defaulttrace0.trc. or is it some other file that i need to look into.
I need urgent help on this.
Reward points assured.
thanks a lot.
Saurav

thanks craig,
ur answer has helped me a lot.but it didnt quite help me.
nevertheless i am trying to set different levels of severity.
Is there anything else that i can do.
Also,i commented out a line of code today in one of the class DataSourceManagerImpl.java in sapj2eenginedeploy.jar
for eg. temp.delete in it deploy method.Buth that line still executed.
I m totally lost as to wht to do.
I m trying to create a datasource from my application in WAS.For that i m using the WAS APIs.But its not working completely.
I am using the above jar and its method createdatasource.
I am callin it from my application's class.
It creates a datasource and i can see it in JDBC Connector list in Visual Administrator.But it appears with red sign meaning its not started.When i start it from the tool then it starts.
But in defaulttrace.trc file it shows an error "FileNotFindException". This happens,and i am very much sure, in the deploy() of DataSourceManagerImpl.java class of sapj2eenginedeploy.jar.
i want to apply println inside this method so i may know where exactly i ma getting the error and get so more info so i may solve my problem.
pls help me.
its really urgent.
thanks again
saurav

I have a 13 inch macbook pro 2010 I want to switch the hard drive wat hard drive can i use i know i need a 2.5" but i dont know the dimensions of which one will fit?

Can someone tell me if anyone of these will fit with my 13 inch macbook pro 2010 model
http://www.memoryexpress.com/Products/PID-MX33160(ME).aspx
http://www.memoryexpress.com/Products/PID-MX31974(ME).aspx
Thanks everyone

The only thing is someone told me the max height for a hard drive for the macbook pro is 9.5mm and some other people tell me is 9mm but both drives are over 9 but the seagate one is 9.5 do you happen to know the max height thats my only concern really?

Trackpad Fix for All Macbook Pro and Macbook Models.

Apple has issued a update for the Trackpad but the update is only compatible with the newer unibody Macbooks and Macbook Pros.
I have made the following patch that is compatible with all Macbook Pro and Macbook models with trackpad issues. Don't forget to run the registry patch last.
Download it here:
http://www.megaupload.com/?d=SNIG71OI
This should fix the trackpad issues for all Macbook Pro models.
1. Go to Device manager and go to the "Apple Multitouch Mouse Properties."
2. Go to the driver tab and click on Update Driver.
3. Click on "Browse my computer for driver software".
4. Click on "Let me pick from a list of device drivers on my computer".
5. Click on the "Have Disk" button.
6. Browse to the location of the included "Apple Multitouch Mouse Driver" folder and hit OK.
7. Click on next and it will update the driver.
8. Double-Click the included "MouseFix" registry file.
9. Restart and enjoy!

Thanks a lot for the effort you made. Rightclick/Scroll problem is not as bad as before, but its still there. What exactly did you change in the driver files? I'm very interested in this.
I think about programming my own drivers. A good base for that will be perhaps the source code for this linux demo:
http://www.youtube.com/watch?v=MeLUxsvIVuU&feature=related

Whenever I use the trackpad on my 17" Macbook Pro (2010 model) there is a small, trebly processor sound coming from within the enclosure.

Similar Messages

Maybe you are looking for