Where do I find my playing lists that were next to the library?

Where will I find all my playing lists that were next to my libray?

Hello Bob,
Open iTunes> View > Show sidebar will restore your traditional playlist view in the window. or press (Ctrl + S key)
If you can't find View Tab then press (Ctrl+B)

Similar Messages

ITunes Match only plays songs that were uploaded to the Cloud

I posted this once before back a couple of months ago and never did get it working.
I have an iPhone 4s and I purchased iTunes match about a year ago. My library was about 5,000 songs. I was able to use iTunes Match flawlessly on cellular or WiFi and play any of my music. Then I upgraded to iOS7, big mistake. Ever since that upgrade back in September, when I am on cellular I can only play music that was not matched but uploaded to the cloud. For example, when in my car I can play a live Phish show that I added to iTunes and that was uploaded to the cloud when I updated iTunes Match from my laptop, but I can't play the Rolling Stones Sticky Fingers because it was matched and not uploaded.
I have reset the phone to factory and manullay installed my apps again. I have turned off match and reset my phone, crossed my fingers, etc...
What happens when I try to play a "matched album" on cellular, it acts like it is going to play but sits at 0:00 for about 20 seconds and then skips ahead and attempts to play the next track. Everything plays fine on WiFi.
Has anyone lese had this issue and if so any suggesttions? I am so frustrated with the whole experience right now. I just went to the support page to submit a ticket to Apple and apparently I don't have support anymore because I have the phone for a year. I don't what to do.

Another oddity I just discovered is that if I turn on wifi hotspot on my phone and connect my iMac to my phone's 3G service then iTunes on my iMac will stream music just fine from iTunes match (yes, the music was only in the cloud, not on my drive).
I've tried everything I can think of to get iTunes Match to play tracks over cellular.. including totally deauthorizing all my computers and devices, totally removing all tracks my itunes match in the cloud and re-scanning/uploading everything. Purchased new tracks, and they won't play unless they are downloaded. But they will play just fine when previeing them for purchase in iTunes app.

Can anyone recommend recovery software to find photos and videos that were taken on the iPod touch before resetting back to factory setting?

My iPod touch was Connected to the computer to sync, but somehow ended up resetting everything to factory settings. When I checked contents, everything after the last date I synced is gone. I am most upset about photos and pictures taken on our vacation.
How can I get all my photos back?
Thanks.

I don't know -- scams? You should always keep a backup of photos and data elsewhere; did you not do this? Photo Stream is the easiest way, in which case they should have been on your PC waiting for you.

Where can I find a full list of the Logic Pro X Software Instruments?

Where can I find a full list of the Logic Pro X Software Instruments (the ones you can play with a MIDI keyboard)? From what I've read so far, there are a number of new software instruments in the LPX additional content (as well as loops, etc, but I'm looking for the software instruments). I cannot seem to find this information in the product pages or documentation, though.
With older versions, I was able to find a list of all of the software instruments that came with the software, and all of the software instruments that came with the Jam Packs. Is that list available from Apple, or does anyone have one from somewhere else?

Hi Guys,
I exported my folders from a clean LPX install, does this give you what you want?
First one is the Patch instruments:
http://www.supportat.net/forumfiles/LPX_PatchInstruments.txt
This one is the sampler Instruments:
http://www.supportat.net/forumfiles/LPX_SamplerInstruments.txt
This is all the files:
http://www.supportat.net/forumfiles/LPX_AllFolders.txt

Where can i find a fix list of Reportviewer.msi (version 11.0.3436.0)?

Where can i find a fix list of Reportviewer.msi (version 11.0.3436.0)?
I just downloaded it from microsoft.com/en-us/download/details.aspx?id=35747
But I cannot find a list of what it fixes?
Can anybody tell me where I can find those?
Regards,
Jan van den Berg.

Hi Jan,
Generally, we always search the update fixes list in the Microsoft Support site:
http://www.microsoft.com/en-us/search/SupportResults.aspx?q=report%20viewer%20Redistributable
Based on my search, I also couldn’t find the KB that describes the details update fixes list about the Reportviewer.msi (version 11.0.3436.0). As per my understanding,
maybe the product team haven’t publish an article about this. I suggest you update to the latest version of this control.
Thank you for your understanding.
Regards,
Katherine Xiong
Katherine Xiong
TechNet Community Support

Where can I find a document listing the instructions one can give the DAQCard-6024E card via the drivers?

Hi
We have bought the DAQcard-6024E card with it's drivers. (for PCMCIA)
I need a list of the instructions for setting up and reading the card using C++.
Where can I find such a list or document?
Thanks!

Hi eben,
I would recommend taking a look at the DAQ Getting Started Guide. This should have all the information you need. The location of the examples are listed on page 11.
Regards,
Kent
Digital Multimeter Home

Where can I find a full list of FRM Errors for forms 9i?

Where can I find a full list of FRM Errors for Forms 9i?
I have installed Forms 9i + the documentation CD but it has very little documentation on forms, just lots of J2EE stuff.

Look in the Forms - Builder help. There you find a lot about Forms - Error.

Where can I find a docking station that supports the new 7th generation Nano?

Where can I find a docking station that supports the new 7th generation Nano?

I am not sure if there is a lightning docking station. But you can buy a lightning-to-30-pin adapter for typical docking station.

Where do I find a full list of Skype calling rates?

I can only find a country dropdown but I will need a full one page rate card with all countries displayed at the same time. Where do I find a full list of Skype calling rates?

kozo wrote:
Where do I find a full list of Skype calling rates?
Hello and welcome to the Skype Community.
Unfortunately a full list isn't available any more. It was withdrawn some time ago as it's viewing volume was very low.

Where can i find a Free Compiler that runs in Dos or something

Where can i find a Free Compiler that runs in Dos or something

Where can i find a Free Compiler that runs in Dos or
somethingDos or something? Well why not use Windows XP. It's certainly something and Java can be freely downloaded from the Sun site.

Where I can find Camera RAW upgrade that supports Nikon D600 ?

Where I can find Camera RAW upgrade that supports Nikon D600 ?

mmeles wrote:
I omitted to mention I have CS5 version of Photoshop. Using a new camera Nikon D600 produces "Nikon Electronic File" (.NEF) this is my RAW file I need to process.
Uh huh...and you'll need to convert those NEF files to DNG files using the free DNG Converter in order to use them with Photoshop CS5. Either that or upgrade to Photoshop CS6. BTW, it's prolly not a great idea to post your personal information on a forum...you might want to edit that out.

Where can I find a printable list of my saved login Id's and passwords in safari?

Where can I find a printable list of my saved login Id's and passwords in safari?

SafariPreferences>Passwords>Tick Show Passwords>Enter Password when prompted>
Then, as as the system will not let you print the result directly,
Go to Applications>find GRAB>Go to Tool bar > Grab>Capture selecton>Make your selection>then print selection
This works for me and I keep GRAB in my Dock.
Silverfoxx

Where can I find a detailed list of purchases from the App Store?

Where can I find a detailed list of purchases from the App Store?

Launch iTunes. From the iTunes menu bar click Store > View My Account then click Purchase History.

Where do I put a workflow so that all users on the Mac can access?

Where do I put a workflow so that all users on the Mac can access it from Automator?
Also. why does the search pattern "users" AND "workflows" return results whitch math "and" (lowercase)? I thought "AND" (in caps) is for boolean searches.

Hi, Mike.
1. You wrote: "Where do I put a workflow so that all users on the Mac can access it from Automator?"Either:
• Macintosh HD > Users > Shared
• Macintosh HD > Applications (if you're the Admin user).
All users (unless restricted by Parental Controls) have access to those folders.
2. You wrote: "Also. why does the search pattern "users" AND "workflows" return results whitch math "and" (lowercase)? I thought "AND" (in caps) is for boolean searches."It's unclear as to what search facility you are referring, and a bit hard to follow given the spelling errors in your question.
Do you mean Discussions search? If so, have you reviewed the Search Tips? They're also available from the search page, where one can click "Tips" under the Search Terms field.
Good luck!
Dr. Smoke
Author: Troubleshooting Mac® OS X

The old Apple TV had a port for Analog the new one does not. Where do I find a (TosLink), Optical to Analog Audio for the Optical Output on the Apple TV so I can run my Analog outside speakers?

Where do I find a TosLink, Optical to Analog Audio for the Optical Output on the Apple TV 2?

click here for information.

Where do I find my playing lists that were next to the library?

Similar Messages

Maybe you are looking for