Where is the volume on the I Pad 2 ?

Side buttons on the ipad r go to settings and go to sound

Similar Messages

The volume in my I pad 4 keeps going to 0

the volume on my I pad touch 4 keeps going to 0 in between songs even when not touched. Is this a defect or a safety feature that can be disabled?

Try:
- Reset the iOS device. Nothing will be lost
Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Reset all settings
Go to Settings > General > Reset and tap Reset All Settings.
All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
- Restore from backup. See:
iOS: How to back up
- Restore to factory settings/new iOS device.
- Make an appointment at the Genius Bar of an Apple store.
Apple Retail Store - Genius Bar

I have a mid-2009 MBP and I've been using my BOSE Companion 20 with it for about half a year now. It was fine until recently, when i want to adjust the volume using the pod on the BOSE Companion 20, it will cause like a surge in volume, spiking it up

I have a mid-2009 MBP and I've been using my BOSE Companion 20 with it for about half a year now. It was fine until recently, when i want to adjust the volume using the pod on the BOSE Companion 20, it will cause like a surge in volume, spiking it up and down. It will not stablise itself! It's very fustrating. Anybody with the same issue?

I have the BOSE Companion 5 speakers and have had the same problem. I've searched everywhere and gotten nowhere. My speakers are way past their warranty, so calling Bose would probably get me no where either. Only thing I can think of is that the speakers overheat which causes the spikes in the volume. I've tried unplugging them for a few minutes and then plug them back on. The problem does go away, but after about 5 minutes, same problem.

I have iphone 4s 32GB ,the volume of the ringer and alerts can't be adjusted using the volume buttons and lock sounds and keyboard clicks available, but all not appear ??!!!!!!!

I have iphone 4s 32GB ,the volume of the ringer and alerts can't be adjusted using the volume buttons and lock sounds and keyboard clicks available, but all not appear ??!!!!!!!

Hi nitramred,
To start troubleshooting this issue where you are unable to adjust the volume after receiving a call, please go ahead and first force close all of the apps currently running on the device, and then reset it by following the steps in the articles below.
iOS: Force an app to close
Turn your iOS device off and on (restart) and reset
Take care,
Alex H.

When i make a call i can hardly hear the person on the other end ,how do i turn up the volume on the phone so i can hear them better pls help

when i make a call the person on the other end is hard to hear ,how do i turn up the volume on the phone so i can hear them better pls help

When on a call, press the round button with the + on the side of the phone until the volume is where you want it.

Is there a way to lower the volume on the themes with a soundtrack?

Hi,
Is there a way to lower the volume on the themes with soundtracks? The volume of my video is lower than the soundtrack on the theme.
Thank you

Which version of iDVD are you using? I see this is posted in the IDVD4 forum.
I have 6. Clicking the "Menu" button at the bottom of the window brings up a dialogue where you can adjust the Loop Duration and Menu Volume. Is that what you are looking for?
Ross Hunter
Orange, VA

My ipod 5th gen won't change volume when headphones are plugged in, but when they are not I can change the volume on the speaker. How do I fix this?

My ipod 5th gen won't let me adjust volume when headphones are plugged in, but when they are not I can adjust the volume on the speaker. How do I fix this?

Try a hard reset of the Nano. To do this, press and hold both the Select (Center) and Menu buttons together long enough for the Apple logo to appear.
I assume you have double checked to make sure you are plugging the headset all the way in meaning the white part of the headset is flush with the body of the Nano?
B-rock

We are recording 2 voices over an instrumental track. Every time there is a rest in the vocal part the volume of the instrumental track noticeable increases. Is this fixable? We are using Alesis multi mix 8 with 2 microphones.

We are recording 2 voices over an instrumental track. Every time there is a rest in the vocal part the volume of the instrumental track noticeable increases. Is this fixable? We are using Alesis multi mix 8 with 2 microphones.

Badger33rk wrote:
Every time there is a rest in the vocal part the volume of the instrumental track noticeable increases.
turn the Ducking menuItem off

How to find out the volume of the data updated in the custom table

Hi,
I need to find out the the volume of the data inserted or updated in the the custom table(Y tables).I have tried by the sm37.the job running in to update the table but i didnot get thde amount of the data.and if get the volume of the data which being updated in the custom table is there any option to control that amount to being updated?
Thanks in advance .....waiting for the respone.

Hi Sreenivas.
How did you find the solution to this? Trying to do the same thing!
Cheers,
Tom

The volume on the second half of my Quicktime slideshow fades out--and I don't want it to do that!

I used FotoMagico 4.0 to make a slideshow. There are options for exporting, and I chose the one called Custom, which makes a Quicktime movie. For some reason the volume in the second half of the show starts to fade out, and by the end I can barely hear anything. If I export to their Standalone Player, which allows the slideshow to play on a Mac computer, everything works just fine. I'm at my wits end trying to figure out how to fix this. I want to be able to export the slideshow to Vimeo so that people on Macs and Pc's can both watch it, but I can't do it with the volume the way it is.

Go to System Preferences. Then under the General tab, there is a tick box saying "Restore windows when quitting and re-opening apps." Un tick that box. Once you start and quit Safari again, it will go back to your home page.

How do you lower the volume on the dictation beep sound?

Hi there,
I like using the new iPad's built in dictation feature. But when I use it, I find that the alert beep it makes when you start and stop is quite loud, and I don't know how to turn the volume down. All of the other sounds on the my iPad are turned down.
Thanks!

I've tried this, but it doesn't work. Does anyone not notice the disparity in the volume of the dictation beep and all other alert sounds on your iPad? It's a loud beep. I have my alert sounds turned right down (still audible, but very low.)
(But thanks Diavonex!)

IPad is connected to a stereo installation - no control of the volume by the iPad

When my iPad is connected to a stereo installation, there is no possibility anymore to control the volume by the iPad.
'the volume control' is replaced by 'dock connector' on the iPad

This issue manifests as The volume control shows sound effects on screen or phantom docking no volume slide control.
For the beginners, the issue is often the side switch is set to mute on off and not screen rotation lock. The switch is off. (see settings)
Other issues around software and airport use can be resolved by hard reset, or reset options inside the settings. I use AIRPORT all the time.
You may have even tried the re-installing the firmware/ios
So when all has failed to work, the you may have dock connector PIN 21 problem.
I had an issue that started with the ipad whe it was on USB cable to PC.
No drop, no sudden cable movements. Just gone....
No volume slider. IPAD behaves as if it was docked when not.
Slight movement when usb cable is in occasionally brings the volume control back but only for a few seconds then it disappears.
Mine is going back for repair/replacement.
cheers Phil

The volume has the wrong case sensitivity for a backup

Updated to OS X Yosemite 10.10.1 and when trying to restore my backup (using TM) into my iMac (27-inch, Mid 2011) get the following message: "The volume has the wrong case sensitivity for a backup."
Any help would be appreciated!

That's not how you restore.
Move your data to a new Mac - Apple Support
OS X Yosemite: Recover your entire system

How do you control the volume to the earphones?

How do you control the volume to the earphones?

Apple Support Communities updatesActually I knew that part of it, but I had to go to Settings to correct something. They are working now that I fixed something that I have no recollection that I altered in the first place, nor do I now know what in heaven’s name I fixed this time. All I know is that I must have gone to setting a million and one times and the last time was the one I did something right.
Thank you for your help however.
Nan
From: Apple Support Communities Updates
Sent: Monday, July 07, 2014 10:43 PM
To: nandave
Subject: - How do you control the volume to the earphones?
                                                                                You received a reply
                                petermac87 has replied to your question. You can view the full discussion in Apple Support Communities.
How do you control the volume to the earphones?
                                With the volume up and down keys unless you purchase a set with a volume control connected to the chord.
                                Pete
                                                                                Correct Answer Helpful Answer
                              Use the buttons above to tell petermac87 and the rest of the community if this reply solved your question or helped you get closer to finding a solution.
                              To reply to petermac87, go to the discussion in Apple Support Communities.
                              You are receiving this email from Apple Support Communities. You can change your email preferences in your Apple Support Communities Profile.
                              TM and copyright © 2014 Apple Inc. 1 Infinite Loop, MS 96-DM. Cupertino, CA 95014.
                              All Rights Reserved | Privacy Policy | Terms of Use | Apple Support

How do you create additional free space on the volume containing the iPhoto library? I have plenty of HD space.

How do you create additional free space on the volume containing the iPhoto library? When attempting to import images from a CD I get an "Insufficient Disk Space" message albeit there is plaenty of additional space on the hard drive.

How much free space do you have on your hard drive? Try the following:
1 - delete the iPhoto preference file, com.apple.iPhoto.plist, that resides in your
User/Home/Library/ Preferences folder.
2 - delete iPhoto's cache file, Cache.db, that is located in your
User/Home/Library/Caches/com.apple.iPhoto folder (Snow Leopard and Earlier).
or with Mt. Lion from the User/Library/Containers/com.apple.iPhoto/
Data/Library/Caches/com.apple.iPhoto folder
3 - launch iPhoto and try again.
NOTE: If you're moved your library from its default location in your Home/Pictures folder you will have to point iPhoto to its new location when you next open iPhoto by holding down the Option key when launching iPhoto. You'll also have to reset the iPhoto's various preferences.
NOTE 2: In Lion and Mountain Lion the Library folder is now invisible. To make it permanently visible enter the following in the Terminal application window: chflags nohidden ~/Library and hit the Enter button - 10.7: Un-hide the User Library folder.

Where is the volume on the I Pad 2 ?

Similar Messages

Maybe you are looking for