Which HDD can I use on my Satellite A660-13T?

Hi,
I am looking for any compatible Hard Disk Drive for a Toshiba SATELLITE A660-13T as the one inside is dead now.
Such model shipped with the laptop is a TOSHIBA MK6465GSX 640 GB, SATA 2.6 Revision 3Gb/seconds 5400 rpm
Offical Toshiba vendors quoted me 130 euros por the same model.
I cannot get such model through any other shop or internet.
There are lots of different new TOSHIBA HDD in the market with bigger capacity and much cheaper than the MK6465GSK.
Can I install any new toshiba HDD on my SATELLITE A660-13T ?
Is there any toshiba page where I can find out which toshiba HDD are compatible with my SATELLITE?
Thanks in advance for your reply.
Fernando

Fact is that notebook supports SATA controller.
This is the main and important information.
> newer drives have a higher comsumption of power....which could cause some problems
SATA controller is compatible with different kinds of SATA interfaces (SATA I, II or even SATA III).
This means that even if you would use an SATA II/III compliant HDD, the notebook should be able to handle such device.
Therefore you will not find any information about supported HDDs because most 2.5 SATA HDDs are supported and the list providing all compatible HDDs would be too long.

Similar Messages

  • IMAC 2010 which HDD can I use to replace the malfunctioned Seagate Barracuda 7200.12 1TB?

    iMAC 2010 which HDD can I use to replace the malfunctioned Seagate Barracuda 7200.12 1TB?

    After doing a bit more research, the 2010 iMacs do appear to have a third cable connecting to the  hard drive, for the internal temp sensor.  This would appear to be the block of 8 pins that are on almost all drives, but they are normally intended for jumpers.  Unfortunately I was unable to find any documentation or specs that would indicate this pin block connects to the internal temp sensor on either standard (non-Apple) WD Black or Seagate 7200.12 drives.
    I did find some info that may be of some use:
    WD: Where to connect an external temperature sensor to a Serial ATA or EIDE hard drive.iFixit: Replace the hard drive, how do I connect the hard drive thermal sensor?
    Apple Technician Guide: iMac 2010 27" (mid-2010)
    Various discussion threads I found through google searching indicated some people succeeded with installing an external temp sensor on the body of the drive.
    Sorry I couldn't help more.

  • Satellite A210-ICO - Which HDD can I use?

    I'm getting bad sectors on my laptop's hard drive so I guess I should fork out for a new one - but which are suitable for A210-1CO?
    ta, M

    Hi
    The Satellite A210 uses SATA HDDs and you need a new HDD with SATA interface. You can buy every HDD that you want, for example 160 or 320GB. On SATA interface there are no capacity limits.
    Furthermore the most SATA HDDs have already SATA2 interface but its downgrade compatible to SATA1.
    I would prefer a HDD with 5400rpm. Of course you can buy a HDD with 7200rpm but they produces more heat and noise. For the most applications are 5400rpm enough.
    I have good experience with Hitachi and Seagate HDDs.
    Bye

  • Satellite A30 - which HDD can I use?

    Hi
    I have been given an A30-921. The last owner removed the hdd. Can I fit any 2.5" hdd to it?
    many thanks
    mcdodd

    Hi,
    yes you can fit a 2.5" HDD to it. It needs an ATA-5 interface and a maximum height of 9.5mm.
    I'm not sure what maximum capacity the BIOS can detect, the original drive had 40GB.
    Bye

  • In which trigger can i use go_item() in oracle forms 6i?

    Hi,
        I have a problem with go_item.
    I tried executing go_item() in triggers like key_next_item, pre_text_item, post_text_item & when_validate_item.
    But none of them seemed to be working.
    I searched for other possibilities in the site, where i found a solution of using trigger ' when_timer_expired ' with ' when_validate_item ' ,
    but when i tried to create trigger, i did not find that trigger (when_timer_expired)  in the list at all.
    I'm using oracle form builder 6i.
    Oracle9i Enterprise Edition Release 9.2.0.1.0 - Production.
    A trigger with go_item() must be created when tab is pressed.
    In which trigger can i use go_item() ??
    Thank You.

    from help:
    Restricted Built-in Subprograms
    Restricted Built-ins affect navigation in your form, either external screen navigation, or internal navigation. You can call these Built-ins only from triggers while no internal navigation is occurring.
    Restricted Built-ins cannot be called from the Pre and Post triggers, which fire when Oracle Forms is navigating from object to another.
    Restricted Built-ins can be called from the When triggers that are specific to interface items, such as When-Button-Pressed or When-Checkbox-Changed. Restricted Built-ins can also be called from any of the When-New-"object"-Instance triggers and from key triggers.
    Unrestricted Built-ins do not affect logical or physical navigation and can be called from any trigger.
    The Built-in descriptions include a heading, Built-In Type, that indicates if the Built-in is restricted or unrestricted.

  • Which cable can I use to connect my ipad to my iphone

    Which cable can I use to connect my ipad to my iphone when I need to connect to the internet when not in a Wi-Fi hotspot.?

    Your question has already been asked and answered in your duplicate post.

  • I m havind 15inch 2011 late macbook pro lap i7 processor 8gb ram 1tb hdd can i use avid media composer and final cut pro in this specifications?

    i m havind 15inch 2011 late macbook pro lap i7 processor 8gb ram 1tb hdd can i use avid media composer and final cut pro in this specifications?

    Can't speak about avid, since I am not familiar with the software.
    You can certainly use FCP X on that machine. It should work better if you use a fast external drive for your media and projects.
    There is a free trial, so try it out and see how it goes. You should also follow some good video tutorials, if you are not familiar with the application. FCP X is a lot different from Avid, Premiere or even Final Cut Pro 7.

  • I have a 3.06 Ghz Intel cor 2 duo 4GB 1067 Mhz DDR3. Which update can i use.

    I have a 3.06 Ghz Intel cor 2 duo 4GB 1067 Mhz DDR3. Which update can i use.

    Yosemite. Back up your data, check your applications for compatibility, and download it from the Mac App Store.
    If desired, you can instead buy a download code for Lion or Mountain Lion from the online Apple Store.
    (123967)

  • If I need to burn multiple audio CDs which software can I use?

    If I need to burn multiple audio CDs which software can I use?

    Personally I use the freeware SimplyBurns or Burn for all burning
    http://www.macupdate.com/find/mac/Burn

  • Which software can i use for recovery management that will allow me to use DVD's instead of Flashdsk

    which software can i use for recovery management that will allow me to use DVD's instead of Flashdisk? I find DVD's easier to use. i am using windows 10

    As the other posters wrote in order to take a movie file and turn it into a DVD that can be played in standard DVD players you need a DVD authoring application. That you need a separate program to create the DVD is standard procedure and has been that way since the beginning. All Apple produce that can produce video files require an external authoring program. iMovie, iPhoto and Final Cut all do this.
    One other thing I will comment on is your choice of output format. You will almost certainly be disappointed with the video quality of your finished DVD if you put a HD video on a SD DVD. Unless you plan to burn a bluray disk you will get a better quality video if you output as SD if you plan to burn to an SD disk.
    regards

  • Which iMovie can i use on a g5 dual processor

    which iMovie can i use on a g5 dual processor

    According to this: 
    http://www.macrumors.com/2013/10/22/some-users-with-older-copies-of-ilife-and-iw ork-having-difficulties-upgrading-to-new-versions/
    it is available from the App Store for $15.  It doesn't show when I launch AppStore but that may be because I already have later versions.  You will have to search for it on the web.   As part of iLife '09 its pretty old now but Ebay appears to have some copies available.
    Best of luck!
    Geoff.

  • AppleCare for Macbook - Which one can I use M8852LL   /A  or  /B ?

    AppleCare for Macbook -
    Which one can I use M8852LL /A or /B ?
    /A is older version /B newer version , I think both are good for Macbook, but can't get a definite answer from Apple. Anyone here know ?
    Macbook 1.83   Mac OS X (10.4.7)   Combo Drive, 2G, 120G HD

    more to say...
    Deciding factor should be price.I've found these folks have the best price on AppleCare.
    http://lacomputercompany.com
    Jim
    PowerBook G3 500 Mhz "Pismo"/ 2.0Ghz BlackBook 2GB OWC RAM   Mac OS X (10.4.7)  

  • BT is not working on Satellite A660-13T

    Hello,
    I have a Toshiba Satellite A660-13T and since few days Bluetooth is not working.
    In device manager it tells me everything is running, but BT will not open.
    Can someone help me with this?
    Message was edited: posting has been translated

    First of all please post in English because this is only English language community.
    Back to you issue.
    From my point of few you have to check some essential points:
    is BT enabled using function key
    is Toshiba BT stack process (TosBtSrv.exe ) running. You can find in in task manager under “Processes tab”
    If it doesn’t run, reinstall the Toshiba BT stack which you should find on the Toshiba driver page.

  • Satellite A100 - Display damaged, which PN can I use to replace it?

    Hi
    I have a Satellite A100-151 (PSAA9A-01Z01DGR). The display is damaged. Which Part-Numbers can I use to replace it? Exact PN please. Thank you in advance

    You can buy a display from the ASP in your country.
    The guys could order compatible Satellite A100 parts directly from the Toshiba head stock.
    I have goggled a little bit and found these useful details about Toshiba Satellite A100 LCD screens:
    http://www.screentekinc.com/toshiba__Satellite__A100-series-laptops-lcd-screens.shtml
    Maybe this short info helps.

  • What PCI card to USB adapter can I use on my Satellite C

    Hi
    My remaining working USB port has now deceased and I am stuck as I can no longer print (more importantly the kids can't print their homework!!) From the little understanding I have found out that I can either get the mother board replaced (expensive so not an option!) or get a *card adapter with USB ports* on it that goes in the card reader at the front of the laptop??
    Does anyone know exactly what I am to buy as it all looks rather complicated to me!!!!
    Any help would be greatly appreciated! many thanks, Kerry.

    Hi Kerry
    Can you please tell us more about your Toshiba notebook?
    Which model do you have exactly?
    Have you tested functionality of all USB ports?
    How old is your notebook?
    I mean if the warranty is still valid contact nearest Toshiba service and ask for help?
    Do you have new printer with WLAN inside. If yes you can print using WLAN connection.

Maybe you are looking for