Which HDD size is compatible with my Satellite A100-771

Hey Guys,
is there a limit of HDD size for my A100-771?
And which type of HDD I need? IDE or SATA?
Thanks a lot.
Eathen.

Hi Eathen,
> And which type of HDD I need? IDE or SATA?
You should check the preinstalled HDD. So you can identify if your notebook has IDE or SATA interface. That takes only few minutes. ;)
On SATA interface there is no capacity limit. That means you can use every HDD that you want. I can recommend a model with 5400rpm. This is a good compromise between performance and noise/power.

Similar Messages

  • Is this RAM module compatible with my Satellite A100-033?

    http://www.maplin.co.uk/module.aspx?ModuleNo=217969&doy=4m12#overview
    Hey, would just like to know if this is compatible with my laptop? I think my laptop supports DDR2, but im not sure? Do i have to get anything specific just for laptops?
    Thank you

    Dont think that the memory module mentioned in your post above will be compatible with the Satellite A100-033.
    What you need is something like this:
    http://www.orcalogic.co.uk/asp/prodtype.asp?prodtype=28381&ft=m&st=3
    You need a module which supports this spec:
    DDR2 533MHz (PC2-4200) 200-PIN SODIMM
    Bye

  • Which HDD can I use on my Satellite A660-13T?

    Hi,
    I am looking for any compatible Hard Disk Drive for a Toshiba SATELLITE A660-13T as the one inside is dead now.
    Such model shipped with the laptop is a TOSHIBA MK6465GSX 640 GB, SATA 2.6 Revision 3Gb/seconds 5400 rpm
    Offical Toshiba vendors quoted me 130 euros por the same model.
    I cannot get such model through any other shop or internet.
    There are lots of different new TOSHIBA HDD in the market with bigger capacity and much cheaper than the MK6465GSK.
    Can I install any new toshiba HDD on my SATELLITE A660-13T ?
    Is there any toshiba page where I can find out which toshiba HDD are compatible with my SATELLITE?
    Thanks in advance for your reply.
    Fernando

    Fact is that notebook supports SATA controller.
    This is the main and important information.
    > newer drives have a higher comsumption of power....which could cause some problems
    SATA controller is compatible with different kinds of SATA interfaces (SATA I, II or even SATA III).
    This means that even if you would use an SATA II/III compliant HDD, the notebook should be able to handle such device.
    Therefore you will not find any information about supported HDDs because most 2.5 SATA HDDs are supported and the list providing all compatible HDDs would be too long.

  • How do I go back to Firefox 5.0? I need to use Selenium IDE, which is not yet compatible with 6.0.

    How do I go back to Firefox 5.0? I need to use Selenium IDE, which is not yet compatible with 6.0.

    The link is to the latest update to 4.o which was 4.0.1
    The 4.0.1 and 5.0 are two separate versions as installing 4.0.1 over 5.0 will just give you the old 4.0.1 as the end result.
    The 5.0 is partially as a security update in place of 4.0.2.
    The Skype extension was only for to make it so you can dial phone numbers on a web page in the separate Skype program right so if you were not using it then no need for the Skype extension for the separate Skype application to work.

  • I want to start my Time Machine. I bought a Goflex Home which says it is compatible with my iMac but it refuses to download an update of the software. This means the Time Machine will not operate. What is the problem?

    I want to start Time Machine. I bought a Goflex Home netwrork storage system, which says it is compatible with Imac. Each time I go online to try to get any updates, it always comes back saying Error. In other words, I can't start Time Machine because I can't get any software updates. Anyone else experiencing problems with Seagate software updates?

    If you want to use Time Machine the Seagate software is unnecessary. The drive is probably ntfs format which is not for the Mac.
    Manually preparing a new disk for Time Machine
    If you want to erase a disk before using it with Time Machine, follow these steps:
    Open Disk Utility (located in the Utilities folder).
    Connect the disk if it isn't already attached.
    In the left side of the Disk Utility window, select the disk you want to use with Time Machine.
    Optional: If you want to partition the disk, click the Partition tab and select a layout. Make sure "Mac OS Extended (Journaled)" is selected in the Format menu for the partition that will be used for backups. Click Apply.
    Click the Erase tab.
    Optional: If you want to securely erase the disk, click Security Options to configure, then click OK.
    Click Erase.
    After erasing, open Time Machine preferences in System Preferences and configure as described in the section above.
    Reference:  http://support.apple.com/kb/HT1427

  • I had an early version of photoshop (2.0 I think) that worked perfect on windows vista. I bought a new laptop with windows 8.1 and the photoshop won't install. Which version of Photoshop compatible with Windows 8.1 is closest to the older photoshop?

    I had an early version of Photoshop (2.0 I think) that worked perfect on windows vista. I bought a new laptop with windows 8.1 and the Photoshop won't install. Which version of Photoshop compatible with Windows 8.1 is closest to the older Photoshop?

    I think you mean Photoshop CS2.  Photoshop 2 is from around 1992.  The old Adobe activation servers were taken down. CS2 is about a decade old Adobe made a new download for old customers that legal customers can download and install. Download Acrobat 7 and CS2 products

  • HT4623 I want to change the laptop to which my iPhone is compatible with, help!

    I want to change the laptop to which my iPhone is compatible with, help!

    isshajal wrote:
    I have also similar prob. I want to change OS of my laptop.
    This is the iPhone Forum.
    Your Issue is unrelated and needs to be posted in the Appropriate Forum...
    Regards.

  • Which wireless mouse is compatible with my 2007 MacBook?

    Which wireless mouse is compatible with my 2007 MacBook?

    i have bought several wireless mouse for my macbook air, macbook and macbook pro - i have never had any issues with any of them - my niece has a macbook black and uses a $14 wireless mouse purchased from Wal Mart.

  • Which photoshop elements are compatible with windows 7 64-bit?

    Which photoshop elements are compatible with windows 7 64-bit?

    All Elements versions for Windows including PSE12 are 32 bits applications which can run without problems on Windows 64 bits.
    You can download the free 30 days trial version to see by yourself.
    (The 'Premiere Elements' for Windows is 64 bits. PSE12 for Mac is 64 bits)

  • Which iDVD version is compatible with OS X 10.7.4?

    Which iDVD version is compatible with OS X 10.7.4?

    Version 7.1.2 is.  This is the version bundled with the latest iWorks.  It has been around since 2011 as Apple has not updated the application.

  • Which inkjet printer is compatible with my iMac OS X version 10.8.5 computer?

    Hello:  I need some help.  Which inkjet printer is compatible with my I Mac OS X version 10.8.5 computer?

    puppadee wrote:
    I am confused. On the Apple KB article that you suggested, the Canon Pixma MX922 does not show that it is compatible with my computer.
    It is listed. It is shown as the MX920 series, because different countries have a different name for this model (it's known as MX926 in Australia).
    Are you wanting to connect the MX to your wireless network or direct to the Mac via USB cable? Either way, the supporting printer and scanner driver will be downloaded from Apple and installed on your Mac.

  • Which graphic tablet is compatible with Mac desktop

    Which graphic tablet is compatible with Mac desktop

    Wacom is a good one. Make sure that the one you get says it is compatible with the OSX version on your Mac

  • Which portable speakers are compatible with my Zen vision M

    can anyone tell me which other speakers are compatible with my Zen Vision M. other than the Z500thanks

    all speakers including other brands that has a Line-In will work with the player for audio....

  • Which MPEG4 flavours are compatible with iMovie 08?

    Hi there!
    I just tried out iMovie 08 and I like it quite a lot. But there is a problem with my videos, which seem to be incompatible. I record video with an Casio Exilim EX-S500 camera which produces in an Avi-container with tracks in this format:
    1. Video: M4S2 aka MS MPEG-4
    2. Audio: DVI ADPCM
    Ok, I found out that the sound format is kind of problematic, but I don't know what's the matter with the video stream. MPEG-4 should work. There is nowhere a list to be found exactly stating the video formats iMovie 08 likes. It would be nice to use my videos as they are, but if conversion cannot be avoided (arg!), I would like to know a good target format.
    *Which format*
    *a) works fluidly with iMovie 08 (skimming etc.) and*
    *b) preserves the visual quality of my movies without exploding file size?*
    I'm experimenting with MPEG-4 and H.264 encoding in MPEG Streamclip just now. I'm trying to find a suitable setting for the quality control.
    Best regards,
    Henry

    Ok, I found out that the sound format is kind of problematic, but I don't know what's the matter with the video stream. MPEG-4 should work.
    MS MPEG-4 is a proprietary, non-standard MPEG-4 compression format. While you may have the appropriate QT component installed that will allow you to play these files back in the QT Player, I am not sure the codec will allow iMovie '08 to import/edit the video natively. And, as you previously indicated, the DVI ADPCM audio is known not to be compatible. Best approach would be to convert files to a fully supported (i.e., QT playback, conversion, and edit compatible format) manually or simply import them to iMovie '06 if your QT components support conversion to DV by iMovie '06.
    There is nowhere a list to be found exactly stating the video formats iMovie 08 likes. It would be nice to use my videos as they are, but if conversion cannot be avoided (arg!), I would like to know a good target format.
    For the most part, users here are still learning which compression formats are compatible and which aren't. I like AIC/Linear PCM (Apple Intermediate Codec with "Big Endian" audio), H,264/AAC, MJPEG/Linear PCM, DV, and MPEG4/AAC formats when proper data rates are used to preserve maximum quality. Would also like to use Apple Animation/Linear PCM which is import/edit compatible but it has an output bug which renders all video as a "black" display. Apple Video does the same thing but has less color depth so I would avoid it anyway. At least one individual has indicated Photo-JPEG video may have the same "black" display problem but I was not able to confirm this. Other formats will likely remain a questionable until somebody tries them and reports back. I suspect there may be other, less commonly used formats that also may be compatible.
    I'm experimenting with MPEG-4 and H.264 encoding in MPEG Streamclip just now. I'm trying to find a suitable setting for the quality control.
    H.264 usually works best if you simply do not limit the video data rate. However, to give you an idea of the data rates involved, this usually requires a video data rate on the order of 18-20 Mbps for VGA SD dimensions. MPEG-4 video data rates usually need to be 2.0-2.5 times as great. Total AIC audio + video is about the same as H.264/AAC, DV usually about 55 Mbps, and MJPEG/Linear PCM only about 12.5 Mbps (which is why I suspect iMovie '08 uses it for thumbnails and storage of photos used in a project).

  • How to specify the AI version which file shall be compatible with?

    With AI 12.0.0 I need to save AI files so that they are compatible with AI version 10.
    Adobe help Center says:
    "Illustrator format options: When you save artwork to Illustrator format, you can set the following options: Version
    Specifies the version of Illustrator with which you want your file to be compatible."
    However, when I try to save the AI file I see no format options at all, so I cannot specify the desired AI version.
    How do I get access to the saving options?
    Arnold

    In AI 12 (CS2), you do not
    export, you
    save as. (The 'export' dalliance was instituted for v11 and abandoned for V12 as too confusing.)
    At the first save dialog (wherein you give your file a name), hitting 'Save' should get you to a second dialog. Choose the version you desire from the dropdown at top:

Maybe you are looking for

  • Error while trying to access Admin console in OIM

    Hi all, I have installed OIM 9.1.0.1 in windows machine and it was workig fine till y'day. All of sudden today when i start the jboss sever it was started perfectly without any error messages and when i try to acces Administrative Console its throwin

  • PL/SQL Callback notification with aq$_jms_text_message

    Hi, i want to set up a notfication for a pl/sql callback procedure. The message in my queue is enqueued via propagation from another instance. This is my setup (using oracle 10.2.0.3): -------- the queue (multiconsumer): -------------- begin dbms_aqa

  • Is there any way to sync individual songs to your iPhone?

    I have iTunes 11.1.2 and a 4s iPhone. I cant seem to sync individual songs. You would figure Apple would make improvements with new iTunes instead of horribly regress backwards. Any help is greatly appreciated.

  • Batch file to start and stop services

    I've setup a CF Probe on my Development Server to ensure my CF Production server is up and running (services = Apache and CF Application Server). It checks the PROD login page and if it times out in 30 sec the probe fails. I understand I can execute

  • Issue out despite Expiry Date is over

    Dear all, We have maintained the minimum remaining shelf life as 100 days for the materials . It prompt us to key in the Shelf Life Exp. Date during MIGO but during Good Issue, even though the expiry date is over, the system still allow us to issue o