While i was charging my ipod a image of a wire and the itunes logo popped up..what do i do?
while i was charging my ipod a image of a wire and the itunes logo popped up..what do i do?
iPod touch User Guide (For iOS 5.1 Software)
Similar Messages
-
I couldn't sync my Ipod touch, and kept getting an error message. So, I did a restore. Now my touch is stuck on a screen showing a white usb cable and the ITunes logo, which I assume is telling me to connect my Ipod to the computer. But I did that (obviously) or I wouldn't have been able to do the restore in the first place! I tried starting over and held the power and home button until I got a message on ITunes that the device needed restoring - I went through the steps again and am right back at the same screen. Any ideas??
Make sure you are following the instructions in this procedure to the letter.
Here they are, with emphasis on some easily overlooked requirements:
Disconnect the USB cable from the iPod touch, but leave the other end of the cable connected to your computer's USB port.
Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the device to turn off.If you cannot turn off the device using the slider, press and hold the Sleep/Wake and Home buttons at the same time. When the device turns off, release only the Sleep/Wake button.
Continue pressing and holding the Home button while you reconnect the USB cable to the device. The device should turn on.
Note: If you see the "low battery" screen, let the device charge for at least ten minutes to ensure that the battery has some charge, and then start with step 2 again.
Continue holding the Home button until you see the "Connect to iTunes" screen. When this screen appears (iTunes icon and USB connector) release the Home button.
If necessary, open iTunes. You should see the "recovery mode" alert ("iTunes has detected a phone in recovery mode").
Use iTunes to restore the device.
If you do not see the "Connect to iTunes" screen, try these steps again. Be patient since it sometimes takes several of these attempts before you are successful.
If you see the "Connect to iTunes" screen but the device does not appear in iTunes, see this article and its related links.
Select the device in iTunes and choose "restore from backup". This assumes you have a backup. If you do not, you will have to download all your purchased iTunes content again. You do not have to pay for anything you already purchased.
If you still can't get it to work, you have done all you can and only Apple will be able to help. -
What is the problem when all you get is a picture of a charging cord and the itunes logo? I tried hooking up to my computer and itunes and it said I could not download the new software while it was in recovery mode but it won't let me do anything else. Any ideas?
I hope you have a backup if you don't want to lose your iPad contents. You have to restore the iPad now using iTunes on your computer. That's what the message on the screen means.
Take a look at this.
http://support.apple.com/kb/ht1808 -
My iPhone 4s is stuck on a black screen that shows a USB cable connecting to iTunes. The phone will not turn on and the iTunes logo as I described only shows up when I plug the phone into the charger or my computer. I have tried the reset in restore mode as well as the DFU? mode and it still will not work. I have the latest version of iTunes on my Mac. My error code was 2002. I also tried it on my laptop (windows 8.1) and none of the above worked. My error code on my laptop was 02. The phone is through Verizon and it has absolutely no damage. It was working fine up until this and I have been trying to fix it for 2 days. Please help! I am unsure of what version the phone was currently running on before this because I have another iphone that's my primary phone and have not used this one in about a month. I do not believe it was updated to IOS 7.
Your iPhone is in recoverty mode at the moment so to possibly get it back up and running you would need to do a restore as you have been trying. Follow the steps in the article below for the specific error messages you have been receiving. If after following all steps the issue remains book an appointment at a local Apple Retail Store to have the iPhone evaluated.
Resolve specific iTunes update and restore errors -
My ipod displays an icon of a cable and the itunes logo but when plugged in, my mac says that it can not verify my device. I have a backup saved on my mac but it won't let me open it up or sync my ipod with my mac.
Hi crcascio17,
Thanks for visiting Apple Support Communities.
You may want to try some of the suggestions in this article:
iPod not recognized in iTunes and Mac desktop
http://support.apple.com/kb/ts1410
Best Regards,
Jeremy -
I tried to restore my ipod touch 2nd generation and now it won't sync to itunes. On the screen is the USB end of the cord and the iTunes logo over it.
I have turned it off and on, held the off button down and the select button down but it still comes up with that picture on the screen. Have I broken it?
Please help.
MimiIt means the device is in recovery mode. You'll need to reconnect it to iTunes and restore it again.
You may need to connect it in recovery mode manually using the instructions in this Apple support document.
iOS: Unable to update or restore
B-rock -
I can't open my ipad now. It is stuck with the picture of the usb cord and the itunes logo on the front.
Recovery Mode
1. Disconnect the USB cable from the device, but leave the other end of the cable connected to your computer's USB port.
2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the device to turn off.
3.While pressing and holding the Home button, reconnect the USB cable to the device. The device should turn on.
4. Continue holding the Home button until you see the "Connect to iTunes" screen. When this screen appears, release the Home button. iTunes should alert you that it has detected a device in recovery mode. Click OK, and then click Restore to restore the device.
Note: Data will be lost. You may have to repeat the above many times. -
I got a new Ipad 2 and I am trying to get it work in vain. I have downloaded the iTunes on my PC, but even after executing the program nothing happens to the IPAD. I still get the image of the USB cable and the iTunes logo. What am I doing wrong?
You know that you have to connect the iPad to your PC with the cable that came with it - and then iTunes should start automatically and it will guide you through the set up process?
If you have already tried to connect the iPad - and you have launched iTunes - and you still have no luck - reboot your PC and then begin the process again. -
while trying to update my iphone 4 last night, it froze with the itunes logo and a plug underneath. Can I fix this? How?
See: http://support.apple.com/kb/HT1808
-
My ipad is frozen with an image of the power plug and the itunes logo. It won't move off this screen even if I restart/reset it.
marloyee wrote:
... if i am going to restore my device to factory settings, application data will be lost ...
To minimise loss... Once you have Reovered your Device...
Restore from the most Recent Backup...
Restore from Backup > http://support.apple.com/kb/ht1766 -
I just bought an ipad 2. When I turn it on the screen has a picture of the usb charger and the itunes logo. Any ideas?
tc777 wrote:
I just bought an ipad 2. When I turn it on the screen has a picture of the usb charger and the itunes logo. Any ideas?
Connect the iPad to iTunes on your Computer...
See Here for Getting Started...
http://www.apple.com/support/ipad/
And Here...
iPad User Guide iOS 5
http://manuals.info.apple.com/en_US/ipad_user_guide.pdf -
i tried to reset my ipod 1st gen and its stuck on the screen where it has a pic of a usb cord and the itunes logo what do i do???????
Connect the iPod to your computer and restore via iTunes
iTunes: Restoring iOS software -
my ipod is a older generation...when i turn it on the screen popps up with a usb cord and the itunes logo.which i assume means it needs to be linked...my issue it wont link
What happens when yo connect to computer and restore via iTunes
iTunes: Restoring iOS software -
I was updating my ipod touch and the updation had an error and it froze at the apple logo with the loading bar underneath. How do I fix it? I tried the turn off button home screen button and even the volume buttons. I cant get anything to work. Please help me.
Connect to itunes and retore.
-
can anyone please tell me how the **** am I suppose to take care an issue on line or my cell phone if no one at the apple store or what ever if all u do is keep getting a machine, my issue is that i bought $50.00 dollar itunes card and then i went to the apple store to redeem my card at witch time i had $50.00 on my account. so i go to itunes to download some music on itunes so i buy the album Blackstreet/ another level For $ 8.65 and was asked for my credit card infor and was charged the same amount of $ 8.65 toi my card.how can I go about getting that money back on my card?
Go here:
http://www.apple.com/support/itunes/contact/
and follow the instructions to report the issue to the iTunes Store.
Regards.
Maybe you are looking for
-
Business address points to wrong location on map
When entered into the Apple maps app, the address of my business sends my customers 15 miles away into the boonies. I have done the report a problem and moved the pin in the app NUMEROUS times over the last 6 months. Is there any way to contact someo
-
XML parse Exception when running when dynpro
Hello, When I try to run my web dynpro I get the following error. org.xml.sax.SAXException: Fatal Error: URI=:main: Line=7: Fatal Error: com.sap.engine.lib.xml.parser.ParserException: = expected in attlist(:main:, row:7, col:50) The error occured aft
-
Although i delete an imessage it keeps the time the imessage was sent
in ios 8 imessage when you delete an individual msg it the application keeps the time of the deleted message and does not sort the list accordingly
-
Show/hide HTML Region with click on a Button
Hi, is it possible to Show or hide a HTML Region if o want to use a Button for hide or show the region? Can everyone explain it to me? Thx for all René
-
My ipod screen is frozen with yellow and grey on the screen how do i fix it???
I was listening to music and on facebook and all of a sudden my ipod went black and then got frozen on a yellow and grey screen and i have no clue what happened. This was a replaced ipod and now it isnt working the screen is staying on and it wont t