While trimming a clip in my timeline, the entire timeline moves with my trim. How can I stop that and leave a gap in-between clips?

Question

While trimming a clip in my timeline, the entire timeline moves with my trim. How can I stop that and leave a gap in-between clips? Also when I use my blade it only leaves a dotted line in the clip. How can I make that a solid line? I do a lot of flickering in my videos and don't need that some what of a snapping effect while I edit. Please help me someone. I believe i upgraded from FCP 10.0.1 to 10.0.3 and before it never did this.

Answer 1

Mark an In point and an Out point (which creates a Range) and hit the forward delete key (Replace with Gap.) On a MacBook, you'll probably need to hold down the Fn key and type the Delete key (or, I think you might be able to use Shift-Delete as the same command). On an iMac/Mac Pro keyboard, it's the key just to the left of 'end' or the next key above the left arrow key.
You can use the Range tool (hold down the R key and click drag over your clip) or the Blade tool to cut at the in and out (then select the cut and replace with gap).
You can also go into Commands > Customize (command-option-K) and assign a different key to Replace with Gap.
If you need to ripple edit the ends (cut), create a small section that is Gap, and hold down the T key while you use the mouse to click drag both ends (double sided trim cursor) of the cut.
Don't worry about the dotted line blade... That just lets you know that the frames on either side of the cut are continuous, or sequential — nothing has been moved yet. Once frames from either side of the mark have been cut, it becomes a full fledged cut resembling a separate clip.