White screen with no response to any input or hard reset.
I recently tried using my iPhone, and shortly after using it the screen began to malfunction, it stopped responding to touch, froze entirely, then did some of the normal LCD breaking stuff (strobes of colours, etc).
it is now stuck on a pure white screen, I cannot get any form of response from it, or even restart it, the entire system has frozen up. After a quick Google I found most people with this problem have dropped their phones in water or another fluid, and checked the water sensor they mentioned, just to see if anyone had dropped it in water and not told me, it does not seem to have been triggered (or even exist on this model from what I saw).
I am worried about leaving it on overnight as it won't shut down and seems to be putting off a small amount of heat (minuscule amounts). I know Apple have a habit of using batteries that like to go out in style, so I'm hoping this doesn't use on of those batteries.
Does anyone have any ideas of what could be the cause and any possible solutions? iTunes won't pick the phone up, my PC cannot either, not even in a Linux distribution (and that has picked up many devices Windows won't).
I would rather not have to send it in to be repaired or replaced as there are files on the phone I need but cannot access thanks to this problem.
Message was edited by: hexpunK
Sorry, never heard of a blue water sensor. I'd plug your phone in to mains, leave it overnight and try again tomorrow.
There are many places other than Apple that repair iPhones. Here are a few...
http://www.iresq.com/iphone-repair.html
http://www.ipodjuice.com/apple-iphone-repair.htm#iphone-repair
http://www.drcellphone.com/
Similar Messages
-
help me
Hello Apple3041
That error usually relates to security software blocking access to the iTunes servers. Check out the articles below for more info and what to do to resolve the issue.
Resolve specific iTunes update and restore errors
http://support.apple.com/kb/ts3694
Resolve issues between iTunes and security software
http://support.apple.com/kb/TS3125
Regards,
-Norm G. -
My apple TV displays an apple screen, and blinking white LED, only LED responds to remote inputs. I reset with remote ...same result....Any ideas?
If they are the instructions I think you might have seen, they are for the Apple TV 2.
Unfortunately I think your Apple TV may have failed.
You might try removing ALL the cables for a while and trying again, but I think you may be out of luck. -
my i phone 5 was dropped, didn't break but went completerly black screen and nonresponsive. I pushed both the home button and top button no response. I plugged it to the computer it gave me white screen with black apple. I pushed the home and the top went black then gave the itune and the charging plug picture. I tried to download and update, the message came as couldn't restore due to unknow error. Any help??
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
Hi
My Ipod nana...has frozen up and working. It shows a white screen with the wrong time and a lock symbol. When I connected it to my computer, it didn't show up. Back of Ipod gets really warm..Any ideas on how to fix it? Than YouIf it happens again and the reset (home + power buttons) doesn't work, just let the battery drain; you'll know when the screen shuts off. Charge it back up and it should be fine. Frankly, I'm surprised this worked for you. Usually I hear people with this problem say that holding both buttons doesn't work, and they have to do the battery drain.
If the issue is incurable next time, you have a one-year warranty from the date of purchase. -
MacBook Pro won't boot at start. I get a white screen with a blinking folder with a question mark in the middle. Any ideas?
Read this article...
http://support.apple.com/kb/TS1440?viewlocale=en_US&locale=en_US -
Hi Everyone, I have tried all the solutions mentioned by apple and still have a white screen with a blinking file folder with a question mark in the center, anyone have any ideas or experienced this?
Nooo or you would use OS X Recovery Mode: Disk Utilty and then Startup Disk.
Mac OS X & Mountain Lion Community
https://discussions.apple.com/community/mac_os
https://discussions.apple.com/community/mac_os/os_x_mountain_lion?view=discussio ns
Recovery Mode
http://support.apple.com/kb/HT4718
ExpressLane
https://expresslane.apple.com/
Mac OS X Help
http://www.apple.com/support/macbasics/
Isolating Issues in Mac OS
http://support.apple.com/kb/TS1388
https://www.apple.com/support/osx/
https://www.apple.com/support/quickassist/
http://www.apple.com/support/mac101/help/
http://www.apple.com/support/mac101/tour/
Get Help with your Product
http://docs.info.apple.com/article.html?artnum=304725 -
I installed itunes upgrade (10.7, I think) today but the restart is frozen at the white screen with the revolving wheel. Any suggestions?
Thanks for your reply
I tried Disconnect devices and network cables nothing
I can't Perform a Safe Boot i press shift key but nothing
I tried Reset the NVRAM / PRAM nothing
Now i am downloading lion os again "god help me"
For this step Start from your Mac OS X Install disc; use Disk Utility
(why apple stop Mac OS X Install disc ??? it is not a good idea )
Check your cables and power source
It is ok
Remove third-party RAM and internal hardware
Did not upgrade
Is there another fixes in case i couldn't download Lion os -
My mac book pro on start up shows a white screen with a folder with a question mark in it then switches to the apple symbol with the loading bar under it but it freezes about half way. Only started to have problems since upgrading to yosemite any ideas.
I do hope you have recent backup, because it look like your hard disk is failing. You can start up in Recovery Mode, and run Disk Utility to see if the disk can be fixed: OS X: About OS X Recovery - Apple Support
-
I have a mid-2011 iMac running Mavericks. When I click restart the computer goes to a white screen with a spinning circle and does not go any further until I hold down the power button to turn it off. What do I do?
Ok, sounds like the safe mode boot worked... You probably don't want to always be in safe mode though (some reduced functionality) so does it do a normal boot now? If not, you should then reboot into safe mode and run Disk Utility. Then select Macintosh HD on the left hand side, and click the Verify Disk button. If needed, it will ask you to Repair Disk. If there are errors found, Repair Disk again until there are none. Then try another normal boot and reply with result, wether good or bad.
-
My MacBook Pro won't turn on, only a white screen with spinning circle, I've only had it a few weeks! Any ideas what is going on?
Mac OS X: Gray screen appears during startup
-
my mac won't boot up, just has a white screen with a blinking ? mark, any suggestions?
this usually means the software and hardware can't find each other for whatever reason the following article addresses this issue:
http://support.apple.com/kb/TS1440
can also do apple hardware test, following article on that:
http://support.apple.com/kb/HT1509
if you can't access the apple hardware test in the above article you can also do fsck command to check the hardware as well, following article tells how to do that:
http://support.apple.com/kb/HT1782
hopefully one of these articles helps w/ resolution!! -
my imac won't boot up. I get a white screen with the apple logo and the spinning spiral--any ideas?
I have started having trouble since i had to upgrade OS the latest in July 12.http://support.apple.com/kb/TS2570 Follow this article and when it gets to the part where you go into disk utility using your install disc, you'll actually boot up holding down Command and R
-
My 3rd generation ipod touch has white screen with lines. Can't access anything. Any ideas?
Have you tried connecting the device to iTunes in recovery mode and restoring it? See this article for instructions on getting your iPod into recovery mode.
iOS: Unable to update or restore
B-rock -
My daughters blackberry tour suddenly stopped taking a charge and would not power on. It just shows a white screen, with a battery shaped icon & lightning bolt through it. Went to our local cell store and they did a battery swap for us. The phone worked for about 2 hours then did the same thing. After a couple more swaps with no change, they un installed and re-installed the software. This again fixed it temporarily. When it quit again, we were sent a replacement phone. The replacement did the same thing. We were sent a 2nd replacement, but in the meantime, the first replacement started working. It worked for about a week then did the same thing. Now we have attempted to activate the 2nd replacement and it gets the same screen and will not charge enough to even activate it. I'm working with the customer support (phone is under warranty still), but so far no solution. Anyone else experience this? I find it strange that we now have a 3rd phone, doing the same thing and we have tried new batteries and an new charger.
Here are some good charging tips, please read and you'll see that many of them will apply to you.
http://www.blackberryfaq.com/index.php/Maximum_Battery_Life
And here: http://supportforums.blackberry.com/t5/BlackBerry-Community-Post/Power-Saving-Tips-for-your-BlackBer...
Leave the device to charge 2-3 hours, and then, still connected to the USB cable, remove the the battery from the device a few seconds and reinsert it. If it boots--leave it to charge to 100% (check Options > Status for the percentage).
If it doesn't boot--try using a wall outlet charger if you are not. If you are connected via USB to the PC, make certain that you have Desktop Manager (or the USB device drivers) installed, which you can download below.
Make certain your USB cable is connected to one of the PC's main rear USB ports. Not a USB hub, nor a monitor USB port, nor a USB port on the front of the PC.
Read this article also: http://www.blackberry.com/btsc/dynamickc.do?externalId=KB18223&sliceID=1&command=show&forward=nonthr...
Download Desktop Manager from here:
https://www.blackberry.com/Downloads/entry.do?code=A8BAA56554F96369AB93E4F3BB068C22
1. If any post helps you please click the below the post(s) that helped you.
2. Please resolve your thread by marking the post "Solution?" which solved it for you!
3. Install free BlackBerry Protect today for backups of contacts and data.
4. Guide to Unlocking your BlackBerry & Unlock Codes
Join our BBM Channels (Beta)
BlackBerry Support Forums Channel
PIN: C0001B7B4 Display/Scan Bar Code
Knowledge Base Updates
PIN: C0005A9AA Display/Scan Bar Code
Maybe you are looking for
-
I want to install my licensed copy of CS4 (from the CD--Windows version) onto a new computer that I recently purchased. My OLD computer died in July. I cannot deactivate the CS4 software on that computer. It has now been gutted (because a local tech
-
Disorder condition in Billing Plan
Hello, export. Some strange things happened in my system. The scenario is: A sales order was created,after billing,the customer want to cancelled the order. So we should go to VA02 to change the order in billing plan tab.I changed the END DATE 1 day
-
Hi, Is there a way to wrap words the way gnome-terminal does in urxvt ? If so I would really like to know how. Thanks
-
Make facebook stop replacing contacts photo ?
Hello When i use facebook on my n8 it replace my contacts photo with very low quality pictures from facebook, how i make it stop ? I have to re change more than 100 pictures all the time it's a hell...
-
Icon background in the Tab Bar
I have placed a 'Close All Tabs' button in the Tab Bar. I'd like it to have the same background as the default 'New Tab' gray tab-shaped background. Do I have to change the following code in the xul file? toolbarpalette id="BrowserToolbarPalette" cla