Why does my iPad reset itself all the time?
Why does my iPad reset itself all the time?
Hello!
The same happened to my yesterday night when I was charging my iPhone 5 with iOS 6.1. My first impression was that could it be and auto update (to install iOS 6.1.2) however I'm still on 6.1.
It erased ALL my info and shows the initial configuration wizard......this is totally a mega ***!!!!!!
Similar Messages
-
my iphone gets warm all the time, and i shouldnt be doing this, im sure there is a fault or something wrong with it, and i would like to know what to do and how to stop it, it gets really hot when i charge my phone and when im just on apps aswell, it shouldnt be doing this surely.. and it stops me from being able to charge my phone, as im worried its a hazard
My wife is having the same problems as a reciever. She works in a school as a teaching assistant and her teacher sends messages that are mixed with previous texts from ages ago.
Can anyone shed some light on this problem or is it only her and this poster?
2m42s -
Why does iTunes use 100% CPU all the time, hogging my Macbook Air?
Decided to post this here instead of the iTunes forum, since it might be related to hardware too.
New owner of a 2011 13" Macbook Air, core i5 based.
My problem started about 1 week ago, after it had run out of power completely one day. At the first boot after that it was incredibly sluggish, totally unusable. After waiting for 5 minutes and still being unresponsive, I turned it off and then back on. Then it booted fine. HOWEVER, ever since that time I noticed the following behavior:
- iTunes stays at 100% + CPU all the time, mostly between 100-120%. Even if it's not playing. Even when I deleted the entire library and left it empty.
- iStats reports CPU idle between 50-65%. However, CPU temperature is still about 55 degrees C (which, I think, is far less than what it should have been with 50% idle cpu). I can confirm the low temperature by touching the chasis.
- the cursor freezes and jumps every few seconds, making the mac kind of unusable with iTunes open.
This has been going on for 2 weeks now. The problem goes away every now and then (iTunes sometimes goes back to regular CPU usage of 3-5%), but most of the time it's there.
Help!
P.S.
Mac OX X 10.7.2
iTunes 10.5.2Cee Pee You, is a OS modification. Apple recommends that you un-install these prior to a OS update because Apple makes changes to the OS all the time which breaks programs like these.
I avoid Unsanity LLC products like the plague. Notice the company is a Limited Liability Corporation (LLC), which makes it difficult to sue the company in case of a defective or malicious product. So the risk using their products is all yours. Their APE framework modules have been used for malicious purposes because anyone can write a module that uses the APE framework.
I also avoid installing anything that requires a administrative password unless I completely trust the source, like Apple mostly. That admin password is the key to the security of our machines, not to be given out lightly or carelessly.
You'll have to contact Unsanity's [email protected] because what I'm reading online is it's very difficult to remove as it doesn't "exist".
http://forums.macosxhints.com/archive/index.php/t-3616.html -
Why does my line attenuation change all the time?
Why would my line attenuation have gone from 65dB to 72.3dB? I think there is a bad connection on my line, but BT's test equipment says my line is fine.
1st ADSL Line Status
Connection Information
Line state:
Connected
Connection time:
0 days, 00:52:21
Downstream:
1.372 Mbps
Upstream:
659.6 Kbps
ADSL Settings
VPI/VCI:
0/38
Type:
PPPoA
Modulation:
G.992.5 Annex A
Latency type:
Interleaved
Noise margin (Down/Up):
6.2 dB / 5.8 dB
Line attenuation (Down/Up):
65.0 dB / 43.9 dB
Output power (Down/Up):
15.0 dBm / 12.4 dBm
FEC Events (Down/Up):
113157 / 9145
CRC Events (Down/Up):
421 / 240
Loss of Framing (Local/Remote):
0 / 0
Loss of Signal (Local/Remote):
0 / 0
Loss of Power (Local/Remote):
0 / 0
HEC Events (Down/Up):
1850 / 810
Error Seconds (Local/Remote):
169 / 215
2nd ADSL Line Status
Line state
Connected
Connection time
2 days, 12:34:52
Downstream
928 Kbps
Upstream
446 Kbps
ADSL Settings
VPI/VCI
0/38
Type
PPPoA
Modulation
G.992.5 Annex A
Latency type
Interleaved
Noise margin (Down/Up)
6.2 dB / 11.9 dB
Line attenuation (Down/Up)
72.3 dB / 44.0 dB
Output power (Down/Up)
1.4 dBm / 0.8 dBm
Loss of Framing (Local/Remote)
0 / 0
Loss of Signal (Local/Remote)
0 / 0
Loss of Power (Local/Remote)
0 / 0
FEC Errors (Down/Up)
5666 / 0
CRC Errors (Down/Up)
442 / 0
HEC Errors (Down/Up)
2257 / 0
Error Seconds (Local/Remote)
87 / 0I got a reply from the chairmans office
I’ve spoken with BT
Wholesale again today and I’m waiting on a report coming in from the Chief
Engineers Office.
What I’ve
been doing
I’ve also gone
through all the history available of the work that has been done on your line
and can confirm the following:
Your line is
all copper and is on the best E and D side cables available.
We have changed
the network equipment in the exchange on multiple occasions.
And it doesn’t
look like there is any more physical work can be carried out.
The report I’m
waiting for from BT Wholesale is about a known issue that we have had with
certain exchange equipment which is used to make the phone ring when it is
being called and causing the broadband connections to drop, I need this to
confirm if your line is affected by this specific issue.
I think you
have spoke with Donal earlier today and discussed the option of moving onto an
8meg service instead of the upto 20meg, and you told him this has been tried
before and did not work, can you remember roughly when this was so I can check
it with BT Wholesale?
What happens
next
There is still
an engineer on his way out to you tomorrow between 1pm and 6pm. I’m not sure
what this engineer will be able to do given that we have had it confirmed that
you are already on the best lines available but we will see how he gets on and
take it from there. (Might get a nice surprise!)
I’ll give you a
call tomorrow to confirm the update from the chief engineers office and also
see if the engineer has been out on site with you.
Best Wishes
Chris
My reply
Hi,
Thanks for the reply, some of the information in your email isn’t correct.
The D-side is only the “best lines available” because it’s the only one available!
I had the BB disconnecting when the phone rang, long before going on the new equipment.
They have exchanged the network equipment on “multiple occasions”, even though I told them not to bother because I knew it would make no difference.
The facts are:
NO WORK has been done on my D-side (apart from the connections directly outside my property)
Many people that have had the same fault have told me it turned out to be the D-side
I was told by a BT Openreach engineer that they would not do any work on my D-side because part of it was aluminium. But this now turns out not to be true, so I have no idea why they will not do any work on my D-side.
At the cab, the broadband is the correct speed and works fine.
My caller display, often doesn't work. I think this is the same line fault that causes this.
A leakage to earth was detected on my line, but was never fixed.
My phone often rings 2 or 3 times, when I finish a call. I think this is the same line fault that causes this.
When the BB speed goes up, the router records a huge amount of errors.
A few years ago my BB failed altogether, it turned out to be the connection outside my property. The connection was green and in bad condition. There are loads more of these connections between my house and the cab, they will be just as old or older.
A BT engineers test equipment detected a change in resistance somewhere on my D-side, I haven’t heard if that was ever looked into.
Every piece of evidence points at a bad connection on my D-side, so you can see why I will not rest until I know that all the connections have been replaced. BT wholesales answer of “that there is nothing wrong with your line” just isn’t good enough because the fault still exists. -
Why does you tube freeze up all the time?
Why when I'm trying to watch You Tube does it constantly freeze up making it useless to me?
I get the same problem and also when I'm trying to watch a preview of films or tv shows on iTunes via my Phone. Drives me mad.
-
Why does a colored wheel spin all the time
Why is there a colored wheel spinning and my computer freezes
Have no clue as you provided no details what-so-ever!
It would help us to know which comp model you have, which OS & version you're using, how much RAM, etc. You can have this info displayed on the bottom of every post by completing your system profile and filling in the information asked for.
This will help in providing you with the proper and/or correct solutions.
Please detail ALL you have done so far in the way of troubleshooting? Need this info to avoid the been there done that scenarios.
Check out: Troubleshoot the spinning beach ball/freezing & crashing and Troubleshoot the spinning beach ball -
Why does my mail beach ball all the time
Is there a conflict or bug in my new Lion?
Hello!
The same happened to my yesterday night when I was charging my iPhone 5 with iOS 6.1. My first impression was that could it be and auto update (to install iOS 6.1.2) however I'm still on 6.1.
It erased ALL my info and shows the initial configuration wizard......this is totally a mega ***!!!!!! -
When I double click Firefox to open it, 3 Tabs automatically open. One is my home page but the other 2 are about plug ins being successfully installed. I want for only my home page to open. How do I make this stop?
But there aren't any symbols. It's just set to http://www.yahoo.com
And every time I open Firefox, it opens with 3 Tabs, one of which IS Yahoo but the other 2 a regarding plug ins being successfully updated. I've even gone as far as to uninstall those plug ins and it still opens with 3. About ready to uninstall Firefox and stay with IE -
My IPad sound keeps turning off. I have checked all the settings nd they are ok. I have to reset it all the time. It is very frustrating as I use it as an alarm, need I say I've waken late a few times.
I'm having the same problem?
-
Why does my iPad Air takes a long time to charge?
Why does my iPad Air takes a long time to charge?
You need to provide more detail. What do you mean by "a long time?" Are you charging it plugged into a wall socket?
Barry -
Does Apple TV stay on all the time? If not, how do I turn it off?
Does Apple TV stay on all the time? If not, how do I turn it off?
You can put it in standby via the settings.
-
Why is my screen zooming in all the time? and what can I do to prevent it?
Why is my screen zooming in all the time? and what can I do to prevent it?
Press the key combination option-command-8 to disable Zoom. If you're using an Apple wireless mouse, open theMouse pane in System Preferences and uncheck the box marked Smart zoom.
-
Does leaving macbook air on all the time (while plugged in) to download torrents degrade battery life?
You have a lot of things going on here...you are keeping the Air plugged in all the time, you should run on the battery periodically to give it some exercise, you are keeping it on all the time which may be keeping it under constant or near constant load, and you are doing all of that to download pirated content, for which you will get no help on here.
-
My iphone 4 contantly has no service and turns off by itself all the time?
my iphone 4 contantly has no service and turns off by itself all the time?
Hi hqhair@aol,
If you are having unusual service and shut off issues with your iPhone, you may find the following articles helpful:
iPhone: Troubleshooting No Service
http://support.apple.com/kb/ts4429
iPhone: Hardware troubleshooting (under the Power/Battery section)
http://support.apple.com/kb/ts2802
Regards,
- Brenden -
HT4108 Why does an iPad (1st gen) and the Photos app using VGA adapter
Why does an iPad (1st gen) using iOS 5.1 and the Photos app not send a single photo to a projector while a slideshow is sent photo by photo?
I am not 100% sure, but i believe the iPad only does mirroring when connecting with AppleTV. AV cables will output audio and video out the bottom of the iPad (30-pin connector) to a TV/monitor, but the iPad screen itself will only show video controls (play/pause, FF, RW, Done, Progression bar). If your cables say otherwise I am interested to know what brand they are and where you got them. If you are not getting any video at all the cables are probably not Apple approved and dont have the special chip in the 30-pin connector that allows for video transition.
Maybe you are looking for
-
What do you suggest how to handle images?
Hello, I would like to develop a book administration program in web dynpro but I have no clue how to handle the images. There are several points I would like to take care about. The frontend is wd4a and the backend is abap. There will also be an iPho
-
Discount for online number available?
Hello, I am thinking about purchasing a Skype online number for my UK business. At the moment, it says on Skypes website that there is a 50% discount for existing subscribers. I think this does not apply to me because this would be my first online nu
-
The mechanism of DBCascade Delete is controlled by Application server or Application server use Database "DBCascade Delete" mechanism to do this action. Because I use WLS6.1 "Create Default DBMSTables" mechanism to create two tables which the relatio
-
Map im fails to load on iPhone 4
Greetings, I updated my iPhone 4 to iOS 6 today, and everything went pretty smoothly. However, I have discovered that the map application refuses to load map images. Suffice to say, the GPS is functioning and finding my location, but I have no maps t
-
ITunes Music Store Search ERROR?.
Everytime i search for an artist in the search window of iTunes music store i get this error; ??? "iTunes has encountered a problem and needs to close. We are sorry for the inconvenience." I've tried the program repair & running QT stand alone 7.1 &