Why does my iPhone 4 intermitently stop ringing even though it is not switched to silent?

Every now and then my iPhone 4 stops making any noise. My alarm will still go off but no sound comes out. When called the phone vibrates but again no sound.
If I switch the phone off totally and switch on again it will work fine again for a while but all of a sudden it will stop working again without warning?

Have you tried using a different USB port?

Similar Messages

  • Why does my iphone 4s gets really hot even though im not using it, battery drain's 2% every 5 minutes.. and its just in my pocket,. what will i do?

    why does my iphone 4s gets really hot even though im not using it, battery drain's 2% every 5 minutes.. and its just in my pocket,. what will i do?

    some thing is runnng in the back ground. Or your email is struck. Deleted all emails and reboot phone and add them one by one. Or your sim cards has problem. Replace sim card. If nothing works drain battery then recharge battery to 100% full charge.

  • Why does my iPhone 4S ios7 sometimes brick even though it has battery life?

    I know it sounds weird, but I have had this problem more than a few times since I upgraded my 4S to iOS 7. It will be working just fine, and then it will die. Kaput. Nada. Dead
    It just did it within the past few hours. It was registering a 70% charge while I was taking pictures, and then it suddenly just bricked on me. I put it back on an AC charger as soon as I could (actually, the closest one was the one for my iPad Air), but it wouldn't even acknowledge that it was on the charger. No beep. No vibration. Nothing. I let it sit for about 10-15 minutes and then finally just held the power button down, and eventually after about a minute the bleeping thing gave me a white apple screen. FINALLY!! When the Apple screen went away, I looked at my home screen, and the battery was down to 40%. Really?? I didn't do anything!! It was freaking dead!!
    Am I the only one with a psycho phone? Please, someone, say I'm not alone.

    I usually hear about this when the user has done an over-the-air iOS update.  The only way to back out of it is through a firmware update or "DFU."
    Connect to a computer with internet access and the latest version of iTunes.  Perform a backup first and you should be able to restore from the backup after DFU.
    Press and hold both the sleep/wake button and the home button for ten seconds.
    After ten seconds, continue holding the home button, but let go of the sleep/wake button.
    The iPhone should go dark and you should see a popup on the computer.  It should say, "iTunes has detected a device in Recovery Mode. . ."  If there is no popup and the iPhone shows the Apple logo, you can immedeately try again.  It often takes an experienced user two or three attempts before the device successfully enters recovery mode.
    Follow all of the popups and a new version of iOS will be installed.  If your issue was firmware, you should feel free to restore from the backup.  If the issue returns, that means it was a software issue.  In that case, you'll need to do another DFU and restore the iPhone as a new device.

  • Why does camera roll show last photo taken even though it was trashed ?

    Why does camera roll show last photo taken even though it was sent to trash ?

    http://support.apple.com/kb/HT4486

  • Why does acrobat reader 10 keep re-installing even though acrobat pro 11 installed

    I have Acrobat Pro 11 installed, and even though I keep uninstalling (Windows 7, Programs and Features) Acrobat Reader 10, it keeps re-installing it.
    How to I stop this from happening?

    No, acrobat pro isn't doing it, it looks like updater is doing it.  It's as if updater still thinks acrobat reader 10 is installed and tries to update it for me.
    And yes I am on a corporate network, but there are no 'AD policies' in place to install reader or update it.  And other users with Pro on their system don't have this issue.

  • Why does my iphone 5 charger stop working?

    I have had my iPhone 5 since the beginning of October. I have been through numerous chargers and a couple adapters. After having them about a week, they just stop working. What's going on??

    - Make an appointment at the Genius Bar of an Apple store. If the cable (assuming it is a Apple cable) has not been abused Apple will exchange the cable at no cost.
      Apple Retail Store - Genius Bar                 

  • Why does my Iphone 4s keep shutting down on me? Its not just the apps shutting down, its the whole phone. Is there a fix for this? Or has this happened to anyone else?

    I need help figuring out why my phone keeps shutting off. Has this happened to anyone else? How can i fix it?

    Welcome to the Apple Community.
    This isn't a Home Sharing problem, you will get better answers posting in the iPhone community.
    https://discussions.apple.com/community/iphone/iphone_hardware
    https://discussions.apple.com/community/iphone/using_iphone

  • IOS 7 - why does my iphone 4S say I have purchased items which have not been transferred?

    I downloaded iOS 7 to iTunes (11.1) and synced my iPhone (4S), but when I try to update, I get an alert saying that I have puchased items on my iPhone which are not in my iTunes library and that I should transfer them before upgrading.   I have synced several times, but I still get this warning.  Why is this happening, and what should I do about it?

    I found the answer here. https://discussions.apple.com/message/23036528#23036528

  • Why does my iPhone 5 show one specific contact's number only, & not their name? Help?

    I have an iPhone 5 and it will not show my girlfriend's name or info whenever she calls or texts oddly enough (as if I do not have her in my phone to begin with). She has an iphone so our messages are through iMessage. I have attempted to re-add her numerous times as well as resetting all settings.

    It has a 1 year warranty. Make an appointment at the genius bar and take it in for them to have a look at it. If it's defective, they'll replace it.

  • Why does my Galaxy s4 wifi turn on even though I have unchecked auto connect? (This happened starting with the latest software update).

    I also have wifi-matic app which should keep this from happening, but stopped doing so with the upgrade.

    Check sleep mode to be sure Wi-fi is off. Shut down your wifi matic app, clear system cache and do a soft reset of your device. power phone on and reset your personal settings. go into Wi-fi and do your setup again.

  • Why does a new Firefox 4.0 download even though I'm updated?

    Firefox 4.0 downloads every time that I open the program even when it is already updated. How can I get it to stop unless there is a real upgrade?

    Firefox 4.0.1, an update to your version 4.0, was released about a month ago.
    To update Help > About Firefox, click Check for Updates.
    See:
    *https://support.mozilla.com/en-US/kb/Updating+Firefox?bl=n&s=update%20automatically
    *http://kb.mozillazine.org/Software_Update#Software_Update_not_working_properly
    *http://support.mozilla.com/en-US/kb/Installing+Firefox+on+Mac
    <br />
    <br />
    '''You need to update the following.''' The Plugin version(s) shown below was/were submitted with your question and is/are out of date. You should update to avoid known security issues with the version(s) you have installed. Click on "More system info..." to the right of your question to see what was included with your question.
    *Shockwave Flash 10.2 r152
    #'''''Check your plugin versions''''' on either of the following links':
    #*http://www.mozilla.com/en-US/plugincheck/
    #*https://www-trunk.stage.mozilla.com/en-US/plugincheck/
    #*'''Note: plugin check page does not have information on all plugin versions'''
    #*There are plugin specific testing links available from this page:
    #**http://kb.mozillazine.org/Testing_plugins
    #'''Update the [[Managing the Flash plugin|Flash]] plugin''' to the latest version. See: https://support.mozilla.com/en-US/kb/Managing%20the%20Flash%20plugin#w_updating-flash

  • Why does iTunes keep sending songs to trash, even though I haven't deleted them?

    There is one specific album in my itunes library that itunes (on a daily basis!) deletes 4/5 songs from. It almost always deletes the same songs, I just don't understand why this would be happening? The only time I realise is if I happen to scan through the trash before emptying.
    Theres no alert regarding deletion or consolidation of files, in fact there have been times where some of these songs are on a playlist and when the playlist goes back to the start, some of these songs can't be located again, and are in the trash folder again.
    I should clarify that I keep my itunes library on an external harddrive, although I don't see how this would affect it.
    Has anyone else come across this problem before, and more importantly found a solution?
    Thanks,
    Daryl

    Turns out it was firewall related. Even when I turned the firewall off and rebooted, it didn't help. I finally had to uninstall Avast antivirus, and then everything worked great.
    To anyone else who has this issue with Avast and iTunes/Bonjour, I also found this thread that might be worth trying:
    https://discussions.apple.com/message/16897494#16897494

  • Why does Yahoo's pop-ups still popup even though pop up blocker is turned on and no exception for them?

    On Yahoo's page two thing happen... 1.) Ad will all of a sudden become whole page ad and 2.) continually get a facebook for yahoo pop up usually upon opening a yahoo related news link

    try disabling the pop-up blocker entirely and then see if you are able to bring up your contacts.
    In order to turn your Pop-Up Blocker on and off in Mozilla Firefox, please do the following:
    1. In Mozilla Firefox click on the Tools menu, then select Options.
    2. Click on the Content tab at the top of the "Options" window.
    3. Then go to the Block pop-up windows option, and remove the check mark.
    4. Click the OK button at the bottom of the window.
    If it permits then it will mean that the problem is indeed with the Firefox pop-up blocker only.
    In case it still does not permit opening on contacts then the issue is because of something else (do you have any toolbar installed eg yahoo toolbar)
    Try and let us know what were the results ...

  • Why does Indesign say I have missing fonts even though they are in my packaged document?

    I use CS4 on my pc at work, and always package my files, as I have always done on my mac at home, to keep the links and fonts together so that when I send someone a folder, all of the fonts and images work.  For some reason, the packaged graphic designs (created on a mac) that are being sent to us from our graphic designer, all of my fonts are lost - even after having purchased the main one that we use - Gotham - to prevent this from happening.  This also occurs with any designs that I package and send out to others in our office.  I always have to relink the Gotham fonts, and I cannot retrieve the formatting for the fonts that we don't have, even though they are packaged. 
    We are considering purchasing a mac for me to use in the office, but I'd like to make sure that it is not user error before we proceed.
    Any ideas would be wonderful.  I never had this problem with my mac at home with packaging, and it has me confused and frustrated at work.
    Thanks!

    Since CS6 is the current release, upgrading to CS5 is a near impossibility, and EVERYONE will need to upgrade in lockstep or you'll be worse off than you are now with users of your newer version creating files that cannot be opened by users of CS4 (and your CS4 packages won't automatically install the fonts in the documents in the later versions without manually changing the names of the packaged fonts folders).
    As far as font formats, if you are going to collaborate cross-platform, the font of choice is OpenType, which is 100% cross-platform compatible, and second choice is Windows TrueType which also can be installed on Mac OS X (so, essentially, also cross-platform). Last choice would be to use Windows Type1 which can be installed in the private InDesign Fonts folder in the Mac applications folder and will work in ID, but nowhere else. Any of these would allow everyone to use the same fonts, presuming you all purchase the same versions. Purchasing Windows versions and Mac versions of the same font usually works, but there may be little surprises, and you probbly don't want that.

  • Why does my iPhone only ring once?

    Why does my iPhone only ring once or not at all on incoming calls?

    It is probably because you have switched off the notifications alerts.
    Check in settings-notifications center-message and there select the alert sound.
    Reply if it helps out

Maybe you are looking for

  • Very important and urgent - i need info regarding a function module

    hi all, can any one suggest me a function module which calculate the difference in two dates and give answer in days. some one suggest me the following function m odule   CALL FUNCTION 'HR_SGPBS_YRS_MTHS_DAYS'        EXPORTING             beg_da    

  • Office 2010 unstable

    L.S.  I've recently acquired an Acer laptop running Windows 8.1. I installed Office 2010 (as I already had a license for it). At first. Word, PowerPoint and Excel would continuously lock up after only the slightest of work performed. I killed an Acer

  • 79 Service Error Message on the LaserJet Pro 200 color M251 Series printer

    I've been using this printer with the Mac OSX 10.9.4 OS for about 9 months. I'm now getting a 79 Service Error message. I've tried to turn the printer Off and On several times to no avail. Strangely enough, when I try to print a new document, a messa

  • Startup -apple plus spinning wheel - no further

    Hello there, I have an old G4 laptop. Recently installed Airport Extreme card, started it up, no worries! Then was prompted to download updated software from Apple. Did so. But then when I tried to restart it all I get is the Apple chime, then the sc

  • Running web forms6 with designer Vs IE5

    Hi every one i am running forms 6 with oracle 8.0.5 and OAS 4.0.7 on windows NT 4.0 with SP3. when i try to run froms6 on the web through the designer for testing purpose some of the forms run with out a problem and some of them with errors specially