Why does my Iphone 4S drop in and out of charging?

Every time I charge my phone it drops in and out of charge. Can someone help me.......

Yes, as paulcb says, it's most likely because coverage inside the building stinks. You're lucky you can get the EDGE signal inside. The last place I worked, AT&T had to come out and place an antenna inside the building. Largely because we threatened to cancel our contract of over 500 phones with them if they didn't fix it.

Similar Messages

  • Why does my iphone 4 go in and out of charging when plugged in?

    I have an iphone 4 with the recent ios8 update installed but for some reason recently it does not charge right away when plugged in, and when it finally does charge it can blink on the screen in and out of charging like the cable is not supported.  It is the same iphone 4 lightning cable that I bought with it so that can't be the issue right?  I restarted the phone today as well and that still didn't fix it.  It will charge the battery all the way when it connects properly but the connection is the problem.  Is this a hardware or battery issue that can be fixed easily? 

    Yes, as paulcb says, it's most likely because coverage inside the building stinks. You're lucky you can get the EDGE signal inside. The last place I worked, AT&T had to come out and place an antenna inside the building. Largely because we threatened to cancel our contract of over 500 phones with them if they didn't fix it.

  • Why does my iPhone 4S go in and out of 3G service?

    I have the iPhone 4S on verizon and when I'm at work it goes in an out of 3G service (it's usually out).  It will say 3G and have a few bars though but will still be painfully slow.  My boss and supervisor all have the same phones and have the same problems.  When I look on the verizon network coverage map it says that we should have full 3G.  Anyone know why this might be happening and/or any way to fix it?  It only happens at work so its not the phone.  Thank you for the help.
    Message was edited by: AJFA4444

    Yes, as paulcb says, it's most likely because coverage inside the building stinks. You're lucky you can get the EDGE signal inside. The last place I worked, AT&T had to come out and place an antenna inside the building. Largely because we threatened to cancel our contract of over 500 phones with them if they didn't fix it.

  • Why does my iphone says its blocked and nothing appears on the screen

    why does my iphone says its blocked and nothing appears on the screen

    Its completly black on the screen and there is a voice saying the screen is blocked nothing seems to work to put the screen on it asks for a code but i cant see any numbers on the screen

  • HT5781 why does my iPhone 4 ping constantly and not connect to my macbook air

    why does my iPhone 4 ping constantly and not connect to my macbook air in itunes

    Hi, pinkshaz. 
    You may find this article helpful when troubleshooting iTunes not recognizing your iPhone.  If you have any security software, disable this software and test the results.
    iOS: Device not recognized in iTunes for Mac OS X
    http://support.apple.com/kb/TS1591
    Cheers,
    Jason H.

  • Why does my sound keep cutting in and out?

    Why does my sound keep cutting in and out?

    Yeah Kase12 I was just wondering if you ever figured out what was making this happen...I have tried replacing all the cables and it still does it...Every couple minutes the sound will cut out for a few seconds then come back on and it might be 30 miniutes before it does it again or it might do every 4 minutes theres no pattern to it
    .If you figured it out could you please shoot me an email at [email protected] thanks

  • Why does my iphone keep dropping calls

    Why does my iphone4 keep dropping calls??? It has been doing it for over a week. Does anyone have an answer.... AT&T says they are not having any problems and I have done everything but restore my phone.

    Unfortunately, this has plagued the AT&T iPhone since the original model came out. It's most likely a dead zone causing the issue (I have the sameissue from time to time). You can also get a Micro Cell from AT&T, it's basically just an access point that allows you to pick up a cellular signal at home or work (where ever you set it up).
    To eliminate any hardware issues, make sure you're on the latest build of the OS (4.3.3 for the AT&T iPhone 4) - I noticed you're still on 4.3.2. If you don't have a case, I suggest the Apple bumper or any case that covers the metal bezel on your phone, that will help as well.
    Also, you can "reboot" your phone. To do this, hold down the metal sleep button on the upper-right corner of your phone until the "slide to power off" slider is displayed, then power off the phone. Wait a few minutes and turn it back on.
    Hope this helps!

  • Why does my iPhone 4S drop calls with good service

    Why when I have 3 or more bars does my iPhone 3S drop calls?

    Go to Settings > General > Accessability > Incoming Calls then set to default.

  • Why does my iphone have poor coverage and other phones work good

    i have two AT&T phones, 1 iphone 4 and the other a motorola tundra for work. My question is why does the Motorola tundra have 100% signal and my iphone go in and out of service continually....from 3g to no service and then to E network then back to O network and then to no signal at all. very frustrating

    Open the App, then try the settings and options within the Game.

  • Why does audio click/pop at in and out of any transition I apply?

    If it's not a pop or a click, after I apply a transsion for some reason the audio level drops during the transition and doesn't appear to be adjustable even with clicking the edit volume button. I have tried many many things and all that seems to work is extracting the audio from both clips that are next to eachother first, and then apply a transition and it seems to be ok but even doing this numerous times I have attempted to extract audio from one clip by pressing Command J or going through the menu and gotten a completely different clips audio when before I extracted the audio it was fine. Why does this happen? In addtion the titles I've added always appear pixilated? Any suggestions? I have read the entire tutorial and know how everthing is supposed to work but nothing seems to be doing what it's supposed to.

    You hear a pop or gap during a title or transition in iMovie
    http://www.info.apple.com/kbnum/n107945
    After applying a title or transition, you may sometimes hear a pop or brief period of silence between the transition and the next clip.
    A clip's volume is lower after you use an effect or title in iMovie 4
    http://docs.info.apple.com/article.html?artnum=107944
    For titles, they often look bad on the Mac. Will look fine on TV. You should use simple (sans-serif) fonts like Helvetica or Arial in large sizes.

  • Why does my iPhone 3GS turn off when the battery charge is only as low as 70%?

    After my iPhone 3Gs has been fully charged, whenever that charge drops to the 50% to 70% range, the phone turns off.  When I try to turn it on again, the Apple icon appears the first few times, followed only by a blank screen each time -- the home button does nothing.  Beyond those times, when I try to awaken it, I can see a faint design that includes a plug, a red battery and suggests it is out of charge.  This also happens if I depress the awake and home buttons concurrently.

    Let me know if I should start a new discussion instead of opening a new topic here.
    My wife's iPhone is the same vintage as mine 3Gs, but has never had the battery problem.  Its affliction instead is that it cannot detect WiFi networks unless it is quite close to the source.  Often, when my iPhone not only detects but shows a maximum cells connection with a network, hers cannot detect the network at all.  In contrast, her iPhone seems to detect ourcellular carrier just as well as mine does.
    Is there any help for this affliction?

  • Why does my i pod stop playing and go to charge mode

    why does my ipod stop playing and go to the charge mode?

    Hey there gillly,
    It sounds like your iPod Classic is not playing back your music correctly. You should use the following article to help resolve the issue here, named:
    iPod classic Troubleshooting Assistant
    http://www.apple.com/support/ipod/five_rs/classic/
    Start by resetting your iPod, and work your way through the article as needed:
    Reset
    To reset your iPod:
    1. Toggle the Hold switch on and off. (Slide it to Hold, then turn it off again.)
    2. Press and hold the Menu and Center (Select) buttons simultaneously until the Apple logo appears, about 6 to 10 seconds. You may need to repeat this step.
    Thank you for using Apple Support Communities.
    Take care,
    Sterling

  • Why does my sound keep cutting in and out on my tv when connected to Mac?

    I hooked up my Mac to my tv using a mini display port and changed to sound output so that I could get sound from my tv. The sound is coming from my tv, but it is cutting in and out. Is there a way to fix this? Is it the cables I'm using?

    Yeah Kase12 I was just wondering if you ever figured out what was making this happen...I have tried replacing all the cables and it still does it...Every couple minutes the sound will cut out for a few seconds then come back on and it might be 30 miniutes before it does it again or it might do every 4 minutes theres no pattern to it
    .If you figured it out could you please shoot me an email at [email protected] thanks

  • Why does my iPhone 4S keep freezing and crashing and throwing me out of things

    I've only had my phone for 2 months. About a week ago it started throwing me out of Facebook then my photos. Now I can't get online or go to settings or my photos, Facebook or anything else because it freezes and goes blank. What can I do?

    Hello Mia,
    Thank you for providing the details of the issue you are experiencing with your iPhone.
    I recommend following these steps for an issue like the one you described:
    If a single application is not responding or stops responding when it opens, you can force it to close.
    If the device is unresponsive or if certain controls aren't working as expected, restart your device.
    If the device remains unresponsive or does not turn on (or power on),reset your device.
    If there is no video or if the screen remains black, verify that the device has enough charge to turn on:
    If you are using an iPad, ensure that it's connected to the USB Power Adapter supplied with the device.
    Let charge for at least twenty minutes, then see if it starts normally.
    If there is no image on the screen, press the Sleep/Wake button to attempt to wake the device.
    If the screen displays a red battery icon, continue charging the device until the battery is fully charged.
    If the above steps do not resolve the issue, or the if the screen remains black or shows a persistent Apple logo, try restoring with iTunes:
    Connect the device to your computer and open iTunes.
    If the device appears in iTunes, select and click Restore on the Summary pane. Learn more about restoring iOS software.
    If the device doesn't appear in iTunes, try to force the device into recovery mode, and then restore it.
    If the above steps do not resolve the issue, contact Apple.
    You can find the full article here:
    iOS: Not responding or does not turn on
    http://support.apple.com/kb/TS3281
    If you get to step 5, I recommend backing up your iPhone before performing the restore:
    iOS: Back up and restore your iOS device with iCloud or iTunes
    http://support.apple.com/kb/HT1766
    Thank you for using Apple Support Communities.
    Best,
    Sheila M.

  • Why does my iPhone 3GS turn off and on after few minutes

    My iphone 3 GS has been turned off for a week. Now when I use it it turns off and on (by itself) every few minutes.

    The Basic Troubleshooting Steps are:
    Restart... Reset... Restore from Backup...  Restore as New...
    Restart / Reset
    http://support.apple.com/kb/ht1430
    Try this First... You will Not Lose Any Data...
    Turn the Phone Off... ( if it isn’t already )
    Press and Hold the Sleep/Wake Button and the Home Button at the Same Time...
    Wait for the Apple logo to Appear and then Disappear...
    Usually takes about 15 - 20 Seconds... ( But can take Longer...)
    Release the Buttons...
    Turn the Phone On...
    If that does not help... See Here:
    Backing up, Updating and Restoring
    http://support.apple.com/kb/HT1414
    If you try all these Steps and you still have issues... Then a Visit to an Apple Store or AASP (Authorized Apple Service Provider) is the Next Step... Be sure to make an appointment first...

Maybe you are looking for

  • Error while generating a flat file from oracle database

    i have imported three knowledge modules for the interafce. LKM SQL to SQL IKM SQL to FILE Append CKM oracle I have tried executing the interface in following ways 1. checked the staging area different from target and choosed SUNOPSIS_MEMORY_ENGINE. t

  • Can 1 iPhone use 2 Apple ID at the same time?

    My iPhone4s used to download Whatsapp and its chargable that time. So my friend use his Apple ID to download for me. Now i have to upgrade my Whatsapp version and this app already FREE. When try to upgrade it will request my friend Apple ID. And i lo

  • How do I embed an image in a SSRS report?

    I tried the instructions as per my book. The screenshot shows what I have done so far. Now the book says click on the Report menu item and from the drop-down, click on Embedded Imageswindow. Where is this "report" menu item ? The screenshot in the bo

  • Unknown error code (-1) help!

    ive restored my phone like 7 times and it keeps saying this code and my phone isnt recognized, also before this i kept losing service and then a notifcation on my phone said that it needed a restore so i plugged it in and it didnt get recognized ! wh

  • Bringing a JFrame to the front?

    i have already searched the forum, but i think i might not be using the right words.... anyways, i have a JFrame that is launched when a button is clicked on another JFrame. Initially it is created, which brings it to the front. However, for subseque