Why will my Airplay will not connect to macbook pro?

My apple tv connects to my ipad via airplay easily.  Yet my macbook pro continues to get a error message "Could not connect ot apple tv".

This is a network issue, troubleshoot the network.

Similar Messages

  • HT203646 Blue tooth will not connect to macbook pro

    Since mavericks my iPhone 5 bluetooth connects for a second then disconnects for good. I have tried several recommendations including taking the apostrophe out of my computer's discoverable name. Turning bluetooth on and off and a host of other suggestions. I don't have usb devices as suggested to disconnect. Airdrop works so I can use that but bluetooth should work unless apple says it is not required and should not work.

    The phone and computer are only BT supported for tethering.
    Barry

  • IPhone 4 will not connect to macbook air via bluetooth. Message " not supported"

    iPhone 4 will not connect to macbook air via bluetooth

    Try the suggestions here >  iOS: Device not recognized in iTunes for OS X
    If nothing helped, repair permissions.
    Disconnect the iPhone.
    On your Mac open Disk Utility located in HD > Applications > Utilities
    Select the startup disk on the left then select the First Aid tab.
    Then select: Repair Disk Permissions
    This process can take a few minutes.
    When it's done, restart your Mac and connect the iPhone.
    If that doesn't help, reset the PRAM >  About NVRAM and PRAM

  • GarageBand 10.0.2 will not open on MacBook Pro 15-inch, Early 2011 running OSX 10.9.5. w/ 8 GB RAM and 1 TB SSD Samsung 840 EVO.

    GarageBand 10.0.2 will not open on MacBook Pro 15-inch, Early 2011 running OSX 10.9.5. w/ 8 GB RAM and 1 TB SSD Samsung 840 EVO.
    Have deleted (secure delete) and reinstalled several times. Got it to open once right after download... Usually crashes/hangs upon attempted start-up, then shows as "Application unresponsive".   Must be forced to quit.
    No other audio interfaces or drivers installed that I am aware of. Playback through onboard audio interfaces, sometimes routed to Apple TV via Cat 5 cable, out to receiver via fiber optic SPDIF, or to Panasonic HDTV via HDMI cable through Thunderbolt port.

    When you see a beachball cursor or the slowness is especially bad, note the exact time: hour, minute, second.  
    These instructions must be carried out as an administrator. If you have only one user account, you are the administrator.
    Launch the Console application in any of the following ways:
    ☞ Enter the first few letters of its name into a Spotlight search. Select it in the results (it should be at the top.)
    ☞ In the Finder, select Go ▹ Utilities from the menu bar, or press the key combination shift-command-U. The application is in the folder that opens.
    ☞ Open LaunchPad and start typing the name.
    The title of the Console window should be All Messages. If it isn't, select
              SYSTEM LOG QUERIES ▹ All Messages
    from the log list on the left. If you don't see that list, select
              View ▹ Show Log List
    from the menu bar at the top of the screen.
    Each message in the log begins with the date and time when it was entered. Scroll back to the time you noted above.
    Select the messages entered from then until the end of the episode, or until they start to repeat, whichever comes first.
    Copy the messages to the Clipboard by pressing the key combination command-C. Paste into a reply to this message by pressing command-V.
    The log contains a vast amount of information, almost all of it useless for solving any particular problem. When posting a log extract, be selective. A few dozen lines are almost always more than enough.
    Please don't indiscriminately dump thousands of lines from the log into this discussion.
    Please don't post screenshots of log messages—post the text.
    Some private information, such as your name, may appear in the log. Anonymize before posting.

  • CD will not eject and MacBook Pro won't restart

    CD will not eject and MacBook Pro won't restart.

    Do a SMC reset, that hopefully should get you booting and while booting, hold the option/alt and trackpad button down at the same time. Once a row of icons appears and if the disk hasn't ejected via the trackpad method, then press the eject key on the keyboard until it does.
    Click the arrow to boot up OS X.
    http://support.apple.com/kb/HT3964
    If this doesn't work, then take the machine in for service.

  • IPhone 4s bluetooth not connecting to macbook pro

    My iPhone 4s bluetooth is not connecting to macbook pro.  My 3Gs has always worked perfectly fine.  Is there a problem with the 4s hardware or iOS 5?  Anyone have any ideas?

    I'm trying to connect using Bluetooth to use my iPhone as a remote for keynote while on the go (no network to connect to.) maybe it can't be done with the new iPhones but it seems like we should be able to. Thanks for the snarky and super helpful answer though.

  • External keypad will not connect to MacBook

    I have an external Samsonite Comptuer Keypad and it will not connect to my macbook. It is saying to press the key next tothe shift key, but there is not shift key, because it's only a keypad.
    If anybody knows what to do..please help!
    Also, there is not "Num Lock" but a "State Lock"
    Thanks!

    I am having a similar problem with using an external HD and timemachine for backups.  When I first connect the HD with a USB cable timemachine "sees" the drive and allows the backup to start.  The backup fails after about 5gb and says that the drive was "disconnected" and then drive is no longer recognized by timemachine and does not show up in Finder.  I also did not have an issue until I installed Mt. Lion.

  • TS1363 iPod Classic 160gb will not connect to Macbook.

    My iPod classic will not connect to my macbook. It is recognized by my wall charger, speakers, and FM transmitter in my car. I've had this trouble for some time, but before I attributed to my previous Macbook which had a few other problems. However I just got a new macbook, and it is still not coming up in Finder nor iTunes. Any advice is much appreciated!

    What have you tried so far in terms of troubleshooting this issue? Are you plugging the iPod into a high powered USB 2.0 port on the back of your Mac?  Have you tried another USB cable just in case?
    What happens if you try to reset the device with it still connected to the Mac?
    How to reset iPod
    Have you carefully worked through each and every single suggestion in this Apple support document?
    iPod not recognized in iTunes and Mac desktop
    B-rock

  • PhotoshopElements_11_WWEFDJ.dmg will not open on MacBook Pro

    PhotoshopElements_11_WWEFDJ.dmg will not open on MacBook Pro

    https://discussions.apple.com/thread/3712370?start=0&tstart=0
    if you can't mount the image, you probably have a corrupt download.

  • Airport extreme will connect to some iPhones and iPads, but not all, and will not connect to MacBooks.

    Why will the airport extreme not connect internet to macbook or some iPhones? It will connect to all our iPhone 6's and iPads but not to the MacBooks. The macbook says wi-fi has the self assigned ip address of ___,____,____,___ and will not be able to connect to the internet,

    Have you done a full restart of the network in correct order?
    Shut down everything.. OFF not standby.
    Power on in order.
    Modem.. wait 2min
    Router.. (Extreme??) wait 2min
    Macbook.. Only the Macbook.. do restart anything else yet.
    Any luck??
    No luck reset the Extreme to factory and redo the setup.. this time use all short names, no spaces and pure alphanumeric. Bonus for names <10 characters.
    Use passwords with the same rules.. only can be 8-20 characters.. mixed case and numbers.
    Try again with the Macbook..
    No luck give explicit details of the setup of the whole network.

  • Iphone 4s will not mount on MacBook Pro (Via USB)

    My iphone (6.1.3) won't connect to computer (Macbook pro (10.7.5). I rarely do this, so perhaps have inadvertantly turned off an important setting? But typically iphone is accessible from desktop, itunes and iphoto. Not visible anywhere currently. I performed a restart on iphone (apple logo visible) but still won't mount. I am using an Apple USB cable as always, and have also tried the backup cable -both of which will charge the phone pefectly. I did hear the connection sound when cable was attached.
    I have wifi & phone works perfectly on that, but I typically use cable connection for computer access.
    I have not "upgraded" to ios 7 as I'm not to fond of its current UI. But perhaps this is the problem? Until now this phone was fully compatible w the laptop & 10.7.5 OS.
    Suggestions? Thanks

    Hello JazzJunkie,
    I would be concerned as well if my iPhone was not recognized by iTunes.  Thank you for providing all the information with the steps you took in regards to this issue.  I recommend continuing with these steps:
    Follow these steps to resolve your issue:
    Ensure that your Mac meets the minimum system requirements for your iPhone, iPad, or iPod touch.
    Install software updates on your Mac.
    Note: If an iTunes update is available, apply the update.http://apple.com/itunes/download
    Check USB connections. iOS devices require USB 2.0 to function properly. If you're not sure your Mac has USB 2.0 ports, refer to the computer's specifications.
    Disconnect other USB devices and connect your device directly to a USB port on your Mac.
    Restart your Mac.
    Additional Information
    In rare circumstances, your device may be recognized after reinstalling iTunes, but after you restart your Mac, the device may not be recognized again. If this happens and you're using Mac OS X v10.6 Snow Leopard, please follow these steps.
    iOS: Device not recognized in iTunes for Mac OS X
    http://support.apple.com/kb/TS1591
    Thank you for using Apple Support Communities.
    Best,
    Sheila M.

  • Why is First Generation iPad not connecting to MacBook Air?

    We received our daughter's first generation iPad. Whenever I connect it to the new MacBook Air the iPad will keep beeping, and give a message that "this iPhone is not longer connected to itunes" The beeping continues.
    It connects OK to my Macbook Pro, but I don't want to sync it with the MacBook Pro.
    I re-installed iTunes on the MacBook Air and then plugged in the iPad and got the message that the USB port was being disconnected because there was too much power draw on that port. The only USB connection is the iPad.
    Any ideas on what this could be? I'm using a newer cable, the iPad was 45% charged. Is there some limitation of the power draw on the MacBook Air? Is this older iPad drawing more power than the MacBook Air is capable of?

    - Macbook Air is plugged into external power
    - I cleaned the connections on the iPad and on the cable
    - Nothing changed, still get the USB power message and/or the message from iTunes that the device is no longer connected.

  • Photoshop CS6 will not launch on MacBook Pro. Adobe icon appears then disappears.

    On a macbook pro.photoshop will not open. i've tried everything all that happens is an adobe icon appears and then quickly disappears. i have photoshop cs6 suite for a little over a year now. no problems until today. please help - i have a project due tomorrow.

    Hello:
    I am sorry but I am a Windows user and so I am not sure I can help you. I do not know if you have enough time before your project is due but if you do not get an answer here you may want to just call Adobe. They have techs that can walk you through everything. They can take over your computer and fix it for you. They have done this for me many times when I have had problems and I have always been helped.
    I do not know if Mac is the same but have you tried going to your Program Files? Like... your C drive > whatever > whatever > program files? and then right + click to open it from there ...?? does Mac have something similar??
    I totally wish that I could help you more than this!! Best of luck and I really do hope you can get your project done or an extension!!

  • Word document will not open on macbook pro?

    Hi- a Word document (2007- docx) will not open on my macbook pro. Any tips?

    It's possible the file is corrupt. However if you have verified (tried on another system using Office for Mac 2011) then repost your question on the Office for Mac Product Forums

  • ICal posts from iPhone 4s will not sync onto Macbook Pro iCal

    I have a MacBook Pro version 10.6.8 and an iPhone 4s iOS 6.1.3
    I cannot seem to transfer the events that I add to my iPhone's iCal to my MacBook's iCal.
    I have all the calendars synched to my iPhone, but can't figure out to get the stuff from my iPhone to MacBook Pro.
    Any suggestions?
    Thanks.

    When you say "I have all the calendars synched to my iPhone," what is on the other end of that synch? iCloud? Google? Something else?
    If it's iCloud, you have a problem. 10.6.8 doesn't really play well with iCloud, which did not exist when 10.6.8 was created. (10.6 was built to use MobileMe, which was replaced by iCloud.) iCloud was one of the new features announced with 10.7, and it didn't really come into its own until 10.8.
    At one time, I would have recommended that you purchase BusyCal 1.6, which could run on 10.6.8 and could synch with iCloud. Unfortunately, BusyMac no longer sells BusyCal 1.6 or any other version that runs on 10.6.8.
    There may be other products with similar capabilities, but I never tried them, so I cannot recommend one. Maybe somebody else will come along with a recommendation.

Maybe you are looking for

  • FI Partially cleared document which table get saved

    Hi, I want to know in which table partially cleared documents regarding G/L , vendor and customer is saved? Thanks Parag

  • Count before and after to certain occurance.

    I am trying to count the amount of units  studied before and after a certain Course was taken. So ID 1 did PREP in 2013 in the first period and has and also had done a unit in 2009 so reult be before prerp count 1 ID 2 did PREP in 2012 first period a

  • Revise credit limit of several customers

    Is there any mass change on credit limit? Is there any simple way to change the credit limit of several hundreds/thousands customer at a time? I have tried f.34, but I can only change the "next int. review" date only. Besides, is there any direct rel

  • Application crashing even before entering main

    my application is built using QT 4.7.2 with webkit. It results in segfault on running. Debugger shows that it crashes before entering main. where command of dbx shows the following info: (dbx) where current thread: t@1 =>[1] _memcpy(0x6e2000, 0xfffff

  • FM  CS_BOM_EXPL_MAT_V2

    hi, i have to show active as well as inactive BOM but FM CS_BOM_EXPL_MAT_V2 is only allow active BOM  to read and discard all inactive BOM .... for that i am changing Tcode cs12 to zcs12 for our requirement becasue Tcode cs12 only show active BOM ...