Why won't my MN 5.5 see my 2 Repeater Bridge routers and there IP adresses on Map or Status?

Question

Hi all,
My network is up and running awesome !!   I have a home router/gateway with several wired and wireless clients and 2 routers  I have programed to Repeater bridges. All 3 units run DD-WRT. I have as my homeunit an E3000,  1 RP is a E2000 and the last RB is a WRT160nV3. The system is cool.  
However,,,,,    MN 5.5 sees the units on the E3000, but does not see anything else. Status page the same....
Am I not setup right or perhaps MN is/was not ready for something like this?
PS       I have to connect 300 ft to the 160n and about 150 to the E2000.  This is why I needed to setup my this way.
Thank you in advance for any reply.  Perhaps there might just be a newer version that I do not have to make this work.
Jeff

Answer 1

In order to get the spriteNum sent to the frameScript, try altering your mouseUp handler to:
on mouseUp me
  --  tell the frame script that this sprite was clicked
  sendAllSprites(,#dialogEngine, me.spriteNum)
  put "dialog behavior executed"
end
Your other problem/s I suspect are related to the tight repeat loops you involve in the #countTime and #loop handlers (I would suggest renaming your 'loop' hander to something that isn't a Director keyword). Altering your code to avoid these loops won't prove easy but is something you should try in a limited fashion to see if it helps.
Also, the updateStage() command is broken on the Mac platform - I forget details (whether only SW or projectors too) and this isn't documented in a TN anywhere either.