Wierd!!! wireless router toasted when connecting to ipod touch...

this is sooo wierd... everytime when i connect my ipod touch to my wifi , it toasted my wifi router and i have to reboot the router to get it to work again. And if i connect my ipod again, my router will go dead again. (it said it can't release an ip address).
Also same thing happened if i connect my ipod via USb cable.
any ideas???

it happens if you connect your ipod touch to your computer using usb ?
sounds very strange as connecting it to usb should not affect tcp/ip to the router at all
but i would try upgrading the firmware of the router anyway

Similar Messages

  • Does anyone Know how to fix error 0xe8000065 when connecting the ipod touch 4g

    does anyone Know how to fix error 0xe8000065 when connecting the ipod touch 4g

    See:
    iPhone, iPad, iPod touch: Unknown error containing '0xE' when connecting

  • When connecting an iPod touch 4g to an accessory (car radio) can be heard crackling (cliping)

    When connecting an iPod touch 4g to an accessory (car radio) can be heard crackling (cliping), as if listening to an old record, but via headphones everything is ok. So where is the problem?

    All I can suggest are the standard fixes:
    - Reset the car system/contact the manufacturer
    - Reset the iOS device. Nothing will be lost
    Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Reset all settings      
    Go to Settings > General > Reset and tap Reset All Settings.
    All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
    - Restore from backup. See:                                 
    iOS: How to back up           
    - Restore to factory settings/new iOS device.

  • ITunes won't automically update to IOS 5 when connecting to iPod Touch

    I followed the directions to connect my iPod to iTunes and it won't initiate the upgrade to IOS 5.  When I clicked on the check for updates button, I get a message that I am current.  Being that I am on version 4.2.7 I find that hard to believe.  I also tried a Manual download of IOS 5 and that did not work either.

    Do you mean iOS 4.2.1?  If so, it means you likely have a 2G iPod Touch, which can only go as high as iOS 4.2.1.  See this article to help you determine what generation of your iPod Touch is.
    http://support.apple.com/kb/ht1353
    B-rock

  • Error 0xE8000084 when connecting my ipod touch to itunes

    I recieve this error message when I plug in the ipod touch (2G).  Does anyone know why?  My other ipod, iphone and ipad all work fine with it.

    iPhone, iPad, iPod touch: Unknown error containing '0xE' when connecting

  • HT1386 I keep getting error code OxE8000084 when connecting my ipod touch to iTunes?

    Does anybody know what error code OxE8000084 means?

    iTunes - Error codes and messages - http://support.apple.com/kb/TS3694.

  • No photos tab when connecting my ipod touch to itunes

    hey guys im finding it difficult to transfer photos to my itouch. am i supposed to have a photos tab? any advice on how to overcome this???????????

    you tried reinstalling itunes?

  • How to set up 6th Generation AirPort Extreme to cable modem as a wireless router and then connect my 3rd Generation Time Capsule to AirPort Extreme as a wireless extender?

    What is the best way to set up my 6th Generation AirPort Extreme (A1521) to my cable modem as a wireless router and then connect my 3rd Generation Time Capsule (A1355) to my AirPort Extreme as a wireless extender? I live in a small 1 story house and I currently have the Airport Extreme connected to my cable modem in the living room and the Time Capsule plugged into the wall in my bedroom. I am able to wirelessly connect to the internet using the AirPort Extreme as my router and I can also do wireless back ups to my Time Capsule. My problem is that my connection seems to be really slow! My 1TB Time Capsule back up is only half way complete and it has been 3 days! My computer has been backing up all day and night for almost 72 hours and its still not even 75% complete. I have backed up to this Time Capsule in the past and it never took this long. I am thinking that when I set up my AirPort Extreme and Time Capsule using AirPort Utility I must have set it up incorrectly or something.
    How do I set up my Airport Extreme and Time Capsule for the fastest possible internet speed and back up speed?
    Thank you,

    AirPort Utility 5.6 works with AirPort Extreme 802.11g base stations.
    It works with N version airports.
    It will also show details of the AC model but cannot be used for the setup.. mostly.
    I purposely got the new 6th Gen Airport Extreme so my internet connection would be a lot faster!
    Your network will be much faster when you have AC client directly connected to the AE. Older client will go no faster.. but what is worse.. extend wireless is mixing new and old wireless standards.. guess what one wins.. OLD.. So when you extend wireless.. you have no improvement whatsoever. This whole post is about extending wireless.. so you cannot extend to older equipment and do any better.. maybe slightly better signal although from your comments that isn't happening either.
    I would rather not have to use an ethernet at all with the TC and I don't know EOP adapters are!
    If you do not use ethernet then you are going to be forced to accept slow speed.
    EOP (ethernet over power). Also called homeplug in the US.
    http://en.wikipedia.org/wiki/HomePlug
    Provides a method of networking over power cabling that already exists in your house.
    So what your saying is for the fastest internet speed and back up speed possible I should keep my Airport Extreme plugged into my Modem and keep my TC set up as a wireless extender? Then when I want to do back ups I should plug an ethernet cable from my TC to my MacBook Pro?
    To spell this out.
    A wireless link to an extended device will go very slowly.. if it is not direct.
    So lets say you have a laptop sitting in the lounge.. Your connection goes.. Laptop- - - - - AE- - - - -TC.
    That means two wireless links.. wireless has this nasty half duplex and single channel nature.. it can send or receive (Tx or Rx) but not at the same time.
    Ethernet by contrast does both at once. It is full duplex.
    Wireless can talk to one client at a time.. so if there are multiple items using wireless lets say 4 devices.. then your computer gets a 25% time slice. Since wireless cannot handle multiple simultaneous connections.
    Ethernet by contrast can connect multiple computers to multiple destinations at the same time.. all transmitting and receiving at full speed.
    When you put all this together.. there are a couple of rules for fast connection.
    1. Use ethernet at all times. Where you cannot use ethernet use anything but wireless.. eg EOP (homeplug) at least to try and get rid of wireless.
    2. Where you must use wireless use it sparingly and make sure it is never more than one hop.. ie never have an extend wireless (repeater is more usual term). Repeater will cause instant slowdown of 50% and maybe up to 75% just because it is so inefficient.
    3. Fastest wireless is 5ghz but it has very short range.. you need to be up close and personal to get it working.
    Apple routers however unless you do manual setup I suggest are set to connect to best signal strength not best speed. It will therefore use 2.4ghz at 25% less speed than 5ghz because it is 1db better signal.. this madness means you need to setup manually for the best setup.

  • When try to connect my iPod touch 4th gen to my house Wifi it won't connect, it used to work fine but now it dosen't work, but it does say that the internet is available, but when I tap on it it just loads. all other devices work fine.

    When try to connect my iPod touch 4th gen to my house Wifi it won't connect, it used to work fine but now it dosen't work, but it does say that the internet is available, but when I tap on it it just loads. all other devices work fine.

    Does the iOS device connect to other networks? If yes that tend to indicate a problem with your network.
    Does the iOS device see the network?
    Any error messages?
    Do other devices now connect?
    Did the iOS device connect before?
    Try the following to rule out a software problem:                
    - Reset the iOS device. Nothing will be lost
    Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Power off and then back on your router
    .- Reset network settings: Settings>General>Reset>Reset Network Settings
    - iOS: Troubleshooting Wi-Fi networks and connections
    - Wi-Fi: Unable to connect to an 802.11n Wi-Fi network      
    - iOS: Recommended settings for Wi-Fi routers and access points
    - Restore from backup. See:
    iOS: How to back up
    - Restore to factory settings/new iOS device.
    If still problem and it does not connect to any networks make an appointment at the Genius Bar of an Apple store since it appears you have a hardware problem.
    Apple Retail Store - Genius Bar

  • HT4972 I AM USING WINDOWS XP. WHEN I AM CONNECTING MY IPOD TOUCH  MODEL NO. MC 008LL TO MY PC ,CHARGING INDICATION IS COMING BUT NEITHER THE WINDOWS NOR THE LATEST VERSION I TUNE DETECTING MY IPOD. IT IS ALSO NOT SHOWING IN I TUNE WINDOWS.

    I AM USING WINDOWS XP. WHEN I AM CONNECTING MY IPOD TOUCH  MODEL NO. MC 008LL TO MY PC ,CHARGING INDICATION IS COMING BUT NEITHER THE WINDOWS NOR THE LATEST VERSION I TUNE 10.6.3 DETECTING MY IPOD. IT IS ALSO NOT SHOWING IN I TUNE WINDOWS."DEVICE LIST" IS NOT DISPLAYING IN LEFT HAND SIDE WINDOW OF I TUNE. BEFORE IT WAS WORKING IN ITUNES 9 AND I WAS USING IT. BUT NOW IT IS  NOT DETECTIN AT ALL. SO PLEASE HELP ME WHAT TO DO?

    Have you tried here:
    iOS: Device not recognized in iTunes for Windows

  • Often, when I connect my iPod Touch to the PC, instead of it showing up as a device in iTunes, a window pops up that says I have connected a camera, and asks what to do.  It is really annoying when this happens, because sometimes I cannot update my iPod

    Often, when I connect my iPod Touch 2G to the PC, instead of showing up as a device on iTunes, a pop-up appears that says I have connected a camera and asks what I want to do.  This device doesn't have a camera in it.  When this happens, (not always)I can't update my iPod, no matter how many times I try to connect it.  I have an old Nano that has never had this problem at all.  Can anyone tell me what to do about this?

    Try here:
    iPhone, iPad, iPod touch: Disabling digital camera notification in Windows XP

  • When i connect my ipod touch to the computer and it brings up itunes, and it starts syncing, it just stays on the last step(6) and I can't download anything else to my ipod.

    I connected my ipod touch to the computer.  When it brings up itunes and start to sync, it stalls at the last step (6).  This keeps me from being able to add other songs from my library to my ipod.  I'm very new at this and maybe just don't understand how it works. 

    Try here:
    iPhone, iPad, iPod touch: Disabling digital camera notification in Windows XP

  • HT1386 When I connect my iPod Touch to a new laptop (Macbook Air) the "Info" tab won't appear and therefore I cannot sync it with my new iTunes. How can I sync this iPod with the iTunes on my new laptop?

    When I connect my iPod Touch to a new laptop (Macbook Air) the "Info" tab won't appear and therefore I cannot sync it with my new iTunes. How can I sync this iPod with the iTunes on my new laptop?

    There is no Info tab in Mavericks
    if you use OS X v.10.8.5 or earlier. If you use OS X Mavericks v.10.9 or later, your contacts, calendars, and other info are updated on your computers and iOS devices via iCloud. For more information, see iCloud Help at icloud.com.
    iTunes 11 for Mac: Sync contacts, calendars, and other info with iPod, iPhone, or iPad

  • Hello! I have one iTunes library on my iPod and one iTunes library on my computer. When I connect my iPod touch to my PC, however, I cannot find any files in my iPod except for pictures. How can I find the music files so I can add them to my iTunes?

    Hello! I have one iTunes library on my iPod and one iTunes library on my computer. When I connect my iPod touch to my PC, however, I cannot find any files in my iPod except for pictures. How can I find the music files so I can add them to my iTunes?

    You can't do that.
    And before you decide to store any music that you own on a computer at work, talk to your IT department. Many organizations do not permit it for legal reasons. Standard policies are that anything stored on company owned computers is the property of the company. It could not be legally stored on their machines unless you transfer the licenses and all copies, physical and digital, to the company, meaning you no longer own the music. If they were to be audited and could not prove that they own the music, they would be subject to copyright violation penalties. Just use your iPod when you're at the office if you want to listen to music.

  • I get "Reading Error" when using USB connection from Ipod Touch to car radio. Any ideas?

    I am trying to connect an IPOD Touch with my car radio via USB port.  Using proper cable which works.  When I connect the auto radio automatically tries to hook up with the Ipod but then displays "reading error"

    The the car-system manyfacturer say it will work with your model iPod and its iOS?
    Not all do.

Maybe you are looking for

  • Standard data sources for Delivery and Purchase order quantity.

    Hi gurus , Are there any standard data sources available for Delivery and Purchase Order quantity in Purchasing area . Thanks in advance .

  • Right PL/SQL approach? (thank you all)

    thanks to everybody then, I ll reflect on your advices. Alvaro Message was edited by: user632687

  • Could not start the oracleoradb10g_home1TNSLISTENER ON local computer

    Hi All, Oracle version---10.2.0 OS---windows xp i have installed oracle 10gr2 newly.but after that i am not able to start listener.I am getting below error could not start the oracleoradb10g_home1TNSLISTENER ON local computer Error 3:The system canno

  • ISight Updater 1.0.3

    I'm running OSX 10.4.3 on a dual 2 G5. When I try to run the iSight updater for 1.0.3 it won't update... saying can't do it on this computer. I currently have 1.0.2. My nephew, who has a G5 running 10.4.3. currently DOES have 1.0.3 as his iSight driv

  • Spry and Sitemaps?

    Hi, I used an external company to generate my XML Sitemap. It did not pick up the URL for the pages containing the data tables used in my Spry Regions. On the company's Forum they blame the use of Spry/Java. To be a little clearer. I have a table wit