Wifi is connected but nothing loads

Off and on when using a Wifi in a hotel or at Starbucks etc., I have a strong network signal but nothing will load...my Touch checks for e mail but nothing happens, the weather application tries to update but nothing happens, internet errors with things like too many pages open so I close pages and nothing happens. Can someone help? Thanks

Open networks often require that you visit a Terms & Conditions page and agree prior to granting full network access. OS 3.x will normally pop up a Safari like page to allow you to do this. If not, you can go to Safari and refresh the page you are on to bring up the logon page for the network.

Similar Messages

  • Wi-Fi connected, but nothing loads

    Downloaded + installed (upgrade, not clean) ML on my iMac this morning to find that the internet isn't working properly; the computer seemingly connects to the network fine, but nothing will load. Not in Chrome, Firefox, Safari, Mac App Store, iTunes, etc. I restarted the computer a few times, and once, I was able to get sites to load (albeit slowly). Not really sure how to go about trying to solve this, so any suggestions would be great.

    Are you using Wi-Fi or Ethernet?
    Can you open a terminal and try to ping your router and then an Internet site (like www.apple.com)? What is the result?
    If you can ping both of the above, try this command in terminal:
    sudo scutil -r www.apple.com
    Does this command come back and say the site is reachable?
    A couple of things to try and fix this:
    1. trash the system config PLISTS and reboot (note you will loose your iMac's network settings, so if you are using static entry's IP address, DNS, etc be sure to write them down before attempting this).
    Open a terminal and do the following commands:
    mkdir ~/Desktop/old_sys_configs
    sudo cp -pR /Library/Preferences/SystemConfiguration/* ~/Desktop/old_sys_configs
    cd /Library/Preferences/SystemConfiguration/
    rm -rf *.plist
    The above commands will save a copy of your current network settings to a folder on the Desktop. Reboot your iMac. When your Mac comes back, try to connect to your Ethernet network or Wi-Fi network and see what happens.
    If this fails, then I would suggest to reboot holding command r to get into the recovery partition so you can re download and re install ML.
    Hope this helps.

  • Connected but nothing loads fully except AOL

    While still using Panther, I left town for a week and when I came back I had problems getting online with my G4 which is connected to the Internet via cable modem. I also have a router. I switched to Tiger and the problems continued. The Tiger Network Diagnostics tell me that my Internet connection is fine. But when I try to go to most websites, generally I get no part of the web page. When the website has a symbol, such as Yahoo, Google, Amazon, etc., the symbol will appear in the web address line which by the way, stays red unless I go to it and hit the return at which point it turns blue. Sometimes (but not on every try), I'll get the Google homepage and if I put in a search term, I'll get the search results. But if I click on any of the search results, I can't connect through to the underlying web page. I am an AOL subscriber and I can connect to AOL and get access to my mailbox with normal speeds. However, if I try to click on a news or other item on the AOL home page, I can't connect through. I also must almost always try twice or even more often before I connect with AOL. I talked with the Support Department of my ISP and was told that from their end my connection was normal and I should get some spyware because my computer might have been turned into a drone. Because AOL mail works at regular speeds, I doubt that this is the case. I will appreciate any suggestions that might help get me out of this mess.
    G4   Mac OS X (10.4.7)  
    G4   Mac OS X (10.4.4)  

    Since it is highly doubtful that your Mac has been
    turned into a drone which is commonplace with a
    Windows PC, have you tried connecting direct to the
    cable modem bypassing the router to check if the same
    occurs when not connected through the router?
    Thanks for suggesting I take the router out of the equation. When I bypassed the router my Internet connection was fully restored. I initially thought the router had gone bad but when I re-connected it, everything still worked fine.
    G4   Mac OS X (10.4.4)  
    G4   Mac OS X (10.4.4)  

  • Wifi is connected but i cannot access websites can you help?

    Hello - My wifi is connected but my ipod will not load any web sites.  Can someone help?

    - Reset the iPod. Nothing is lost
    Reset iPod touch: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    = Power off and then back on your router
    - Reset network settings: Settings>General>Reset>Reset Network Settings
    - iOS: Troubleshooting Wi-Fi networks and connections
    Other devices successfully connect to the network?

  • My mini Ipad says I haven't backed it up to iCloud for 2 weeks.  Back ups happen when this ipad is plugged in, locks, and connected to wifi.  The ok button doesn't work, I can't open settings to make sure wifi is connected. Nothing works!!!

    My mini Ipad says:   I haven't backed it up to iCloud for 2 weeks.  Back ups happen when this ipad is plugged in, locks, and connected to wifi. 
    The ok button doesn't work, I can't open settings to make sure wifi is connected. Nothing works!!!  I have it pluggled into my computer but apparently it isn't backing up since nothing has changed.  it is unuseable!

    Reset iPad
    Hold down the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears
    Note: Data will not be affected.

  • WRT54GS and MAC OSX "has internet connection, but cannot load page"

    Ok, I have skimmed through the threads here and the FAQ and still am having troubles. I amt trying to connect a MacbookPro to this wireless router. I have had it connected before which adds to my frustration. I ran all the system diagnostics and come to a point where it says, "This device has an internet connect but cannot load __________. Make sure you have the address typed in correctly." My MAC picks up the router signal, but in the diagnostics it goes as follows. AirPort - Yes Airport Settings - Yes Network Settings - Yes ISP - Yes Internet - No Server - No Please, any help is very appreciated.

    Also tried the factory reset and starting from scratch and nothing...

  • Using the mini hdmi cord to connect the macbook air and my tv I cannot seem to have anything appear or be heard on my tv.. the MacBook air will flash blue like it is connecting but nothing will seem to work Any advice?

    Using the mini hdmi cord to connect the macbook air and my tv I cannot seem to have anything appear or be heard on my tv.. the MacBook air will flash blue like it is connecting but nothing will seem to work Any advice?

    Hi kxh3011,
    Thank you for using Apple Support Communities.
    This feature is called closed clamshell mode.  To learn more about using closed clamshell mode with an external display and how to set it up, please take a look at the article below.
    Mac notebooks: How to use your computer in closed clamshell (display closed) mode with an external display
    Cheers,
    Alex H.

  • My wifi is connected but when i try to connect to safari it tells me its not connect it says safari cannot open the page because it is not connected to the internet.. but the wifi is on and connected, i have tryed resetting the network settings

    my wifi is connected but when i try to connect to safari it says the internet is not connected, i tryed resetting network system but still no luck.

    Your iPad sees the WiFi network signal but obviously it is not connected to the network. Try rebooting your router - unplug it for about 30 seconds and then plug it in again.

  • My ipad2 's wifi is connected but i can't go internet. who can help me

    my ipad2 's wifi is connected but i can't go internet. who can help me

    Check the IP address assigned to your iPad (touch the ">" next to your network name in Settings > WiFi). If it starts with 169 then your router has not assigned a valid LAN IP address to your iPad. It might appear to be connected but you will have no success on the internet.
    Sometimes restarting your router by temporarily (30 seconds) removing/restoring power to it will solve this problem. If it doesn't check that your router has up-to-date manufacturer's firmware and test your iPad on some other networks to see if it works properly there.

  • My bluetooth seems to have stopped working in my car. Both phone and car audio says it is connected but nothing comes through car speaker.  I no longer have screen on iphone that says to choose audio source.  How do I get that screen back?

    My bluetooth seems to have stopped working in my car. Both phone and car audio says it is connected but nothing comes through car speaker.  I no longer have screen on iphone that says to choose audio source.  How do I get that screen back?

    Thanks, this was the clue I needed to figure it out.
    From Settings you can pull up Control Center.
    In Control Center you can enable "Access from within Apps" (also "Access from Lockscreen")
    Now when I'm playing music, I can swipe up from the bottom and a little control center window slides up. Neat - this is new since my old iPod. On this window, the name of the current Bluetooth connection appears. Tap on that, and a list of connected Bluetooth items appears. I just tap on the one I want to connect to and I am now playing through the speakers I want.
    Jimmy

  • I have windows 8 and I have the most updated version of Itunes, my iphone 4s connects, but nothing plays from my itunes all items have the cloud next to it, and they are dithered out

      I have windows 8 and I have the most updated version of Itunes, my iphone 4s connects, but nothing plays from my itunes all items have the cloud next to it, and they are dithered out

    In the course of your troubleshooting to date, have you worked through the following document?
    No content shows up in iTunes after updating

  • I bought elements 13 and downloaded it , but when asked to sign into my adobe account as requested at initial set up of elements 13 , I know my correct password etc and i have a good internet connection But nothing happens even if i wait an hour or so. An

    i bought elements 13 and downloaded it , but when asked to sign into my adobe account as requested at initial set up of elements 13 , I know my correct password etc and i have a good internet connection But nothing happens even if i wait an hour or so. Any help would be appreciated.

    Hi Michael,
    Thanks for posting on the Adobe forums.
    Please follow these steps :
    Go to following location:
    for Win
    C:\Program Files (x86)\Common Files\Adobe
    C:\Users\username\AppData\Local\Adobe
    for MAC
    Finder> Go > Go to Folder
    \Library\Applicaiton Support\Adobe
    ~\Library\Applicaiton Support\Adobe
    Locate folder OOBE and rename it OOBE.old
    Download and install�
    Adobe - Adobe Application Manager : For Windows : Adobe Application Manager
    Adobe - Adobe Application Manager : For Macintosh : Adobe Application Manager
    After the installation
    Try to Open Adobe Application Manager / Creative Cloud App.
    Log in that with Adobe ID and Password.
    If it does not work first try couple of times more.
    Let me know if this resolves the issue.
    Regards,
    Sandeep

  • I'm not a "Cloud" member.  I just upgraded to Lightroom 6 from Lightroom 5.  All was working well yesterday.  Today Lightroom will not open (Windows 7).  I see the logo photo over my Lightroom platform but nothing loads and I see "Lightroom not responding

    I'm not a "Cloud" member. I just upgraded to Lightroom 6 from Lightroom 5. All was working well yesterday. Today Lightroom will not open (Windows 7). I see the logo photo over my Lightroom platform but nothing loads and I see "Lightroom not responding." I checked the catalogs and see that lrcat-Journal and lrcat-Lock have been created every time I try to open. I have a backup from the first day I upgraded, but Lightroom doesn't want to access it. Should I reinstall?

    Well, is the catalogue (and the folder it is in) writable? Have you actually checked the permissions? Lightroom won't be spitting out the error just to tick you off, and - computer wizard or not - this sounds very much like something you'll have to fix at the OS level: it's probably nothing to do with Lightroom or those funny lads at Adobe.
    Some light reading for you, courtesy of the site search: https://forums.adobe.com/search.jspa?q=%22+not+writable+and+cannot+be+opened%22&place=%2Fp laces%2F1383621&depth=ALL
    It would help to know your OS.

  • I have an iPhone 3G and want to upgrade to i OS 5. Mac says to simply connect but nothing happens, help please

    I have an iPhone 3G and want to upgrade to i OS 5. Mac says to simply connect but nothing happens, help please

    The iPhone 3G(not 3GS) is incompatible with iOS 5.
    (61400)

  • Opened Firefox as usual. This time a small window opened but nothing loaded. Downloaded newest version. Updated same thing. Uninstalled the old version. sme thg

    Opened Firefox as usual. This time a small window opened with a tab that says "connectiing" but nothing loaded.
    Downloaded newest version. Updated. Same thing.
    Uninstalled the old version. Installed again. Same thing.
    After installs it has two tabs that say "connectiing" but nothing loaded.
    Toshiba Satellite running Vista

    A possible cause is security software (firewall,anti-virus) that blocks or restricts Firefox or the plugin-container process without informing you, possibly after detecting changes (update) to the Firefox program.
    Remove all rules for Firefox and the plugin-container from the permissions list in the firewall and let your firewall ask again for permission to get full unrestricted access to internet for Firefox and the plugin-container process and the updater process.
    See:
    *https://support.mozilla.org/kb/Server+not+found
    *https://support.mozilla.org/kb/Firewalls

Maybe you are looking for

  • Error encountered during provisioning of user to SAP CUP in OIM 11g R1 BP07

    We recently updated our environment from 11.1.1.5 BP05 to 11.1.1.5 BP07. We are facing an issue with provisioning users to SAP CUP system. We receive an error specifying : Response: oracle.iam.connectors.sap.cup.ws.submitreq.ObjectFactory Response De

  • New airport extreme wireless faster than ethernet

    I just bought a new Airport Expreme 802.11n for my network at home. My daughters computer in the other room gets a faster wireless connection than my wired ethernet connection to my iMac. Both running ML both fairly newish computers. thanks for any a

  • How can I install a search bar

    How do I install a search bar or engine. I don't have a Google search bar

  • TOC scrambled with headings from anchored objects

    I have a book design with first-level headings in the main text flow and second-level headings inside of anchored objects in the left margin of the pages. When I generate a TOC the headings used to be in the correct order, precisely as intended. Afte

  • Database Adapter and SQL Server procedure issue

    Hello, I am using Jdev 11.1.1.7.0 and SQL Server 2005. In the Database Adapter configuration wizard, Specify Stored Procedure step, I choose the "GEACupax" schema and got the following error after a click on "Procedure Browse" button: com.microsoft.s