Wifi not working - iPod touch 4th gen.
Hi, recently I have been experiencing difficulty joininh my home wifi on my iPod touch 4th gen. I have turned my iPod off and then on again three times, reset the network settings twice and checked the wifi works on other devices, please help! Has this happened to anyone else?
Does the iPod Touch see your home Wi-Fi network? If so, what happens when you try to connect to it? Does you have security enabled on the router/modem such as WEP or WPA/WPA2?
B-rock
Similar Messages
-
I Moved From New York To Florida, But Kept The Same WiFi/Router, But The Maps App and My iPod Touch(4th Gen. & iOS 6) Is Still Registering My Location In New York.
For location the iPod uses the location of nearby routers that are in Apple's database of routers and their location. Thus it appears that Apple's database is incorrect. You do not have to be connected to the router, just within range.
Apple periodically updates their database based on information they obtain from iPhones, The iPhone has to have turned on the option to send info to Apple. no one has found another way to get the location of a router added/corrected.
You can confirm that by going to well-know place with wifi like Starbucks or McDonalds -
When try to connect my iPod touch 4th gen to my house Wifi it won't connect, it used to work fine but now it dosen't work, but it does say that the internet is available, but when I tap on it it just loads. all other devices work fine.
Does the iOS device connect to other networks? If yes that tend to indicate a problem with your network.
Does the iOS device see the network?
Any error messages?
Do other devices now connect?
Did the iOS device connect before?
Try the following to rule out a software problem:
- Reset the iOS device. Nothing will be lost
Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Power off and then back on your router
.- Reset network settings: Settings>General>Reset>Reset Network Settings
- iOS: Troubleshooting Wi-Fi networks and connections
- Wi-Fi: Unable to connect to an 802.11n Wi-Fi network
- iOS: Recommended settings for Wi-Fi routers and access points
- Restore from backup. See:
iOS: How to back up
- Restore to factory settings/new iOS device.
If still problem and it does not connect to any networks make an appointment at the Genius Bar of an Apple store since it appears you have a hardware problem.
Apple Retail Store - Genius Bar -
My ipod touch 4th gen shows that it is connected to a wifi network but when i try to browse safari it doesnt work.please help me out.
I am using wifi from a mobile by using the tethering option.Hi there amalrockzz,
You may find the troubleshooting steps in the article below helpful.
iOS: Troubleshooting Wi-Fi networks and connections
http://support.apple.com/kb/TS1398
Follow these steps to troubleshoot the above issues:
Be sure you're in range of your Wi-Fi router (access point).
Tap Settings > Wi-Fi and turn Wi-Fi off and on. If your Wi-Fi setting is dimmed, follow these steps.
Confirm that your Wi-Fi router and cable or DSL modem are connected to power, turned on, and connected to the Internet. If not, refer to your network administrator or Internet service provider (ISP) for assistance.
Restart your iOS device.
Tap Settings > Wi-Fi and locate the Wi-Fi network to which you're connected.
Tap and Forget this Network.
Try to connect to your desired Wi-Fi network.
Note: You may need to enter your Wi-Fi password again if your network requires one.
Turn your Wi-Fi router off and on2. If your ISP also provides cable or phone service, check with them before attempting this step to avoid interruption of service.
Update your device to the latest version of software.
Update your Wi-Fi router to the latest firmware2. For AirPort Base Stations, install updates using the AirPort Utility.
Unable to access the Internet while connected to Wi-Fi
If you're using a public or commercial network, you may need to log in or subscribe.
Check to see if you have a self-assigned IP address:
Tap Settings > Wi-Fi and locate the Wi-Fi network to which you're connected and tap .
If your IP address is 169.254.xxx.xxx, you may not be able to access the Internet.
If you do not have a self-assigned IP address, see if other Wi-Fi devices on your network have Internet access.
If they do not, consult with your network administrator or ISP for further assistance.
If they do, reset network settings on your device by tapping Settings > General > Reset > Reset Network Settings. Note: This will reset all network settings including:
previously connected Wi-Fi networks and passwords
recently used Bluetooth accessories
VPN and APN settings
Additional Information
Find information on connecting to a Wi-Fi network.
Some third-party routers may not be compatible with all iOS devices, even after updating to the latest firmware. If your iOS devices can successfully connect to other Wi-Fi networks, contact your router's manufacturer to ensure that your router is compatible with your iOS device.
See recommended settings for configuring your Wi-Fi router for use with iOS devices.
-Griff W. -
I want to reset my ipod touch 4th gen but i have forgotten the restrictions passcode and for some reason its not working on my laptop on itunes and the restore thing wont work! any help?
Make sure you have the Current Version of iTunes Installed on your computer
iTunes free download from www.itunes.com/download
Then See Here > http://support.apple.com/kb/HT1808
You may need to try this More than Once... Be sure to Follow ALL the Steps...
Take your time... Pay particular attention to Steps 3 and 4.
After you have Recovered your Device...Re-Sync your Content
Note:
To remove a forgotten Restrictions passcode you will need to Restore the Device as New...
OR... From a Backup created Before the Restrictions Code was set.... -
We just purchased an ipod touch 4th gen 8 gb from Wal Mart. OUt of the box the right headphone is not working. Tried numerous pairs of headphones..tried the mono settings and nothing is working. Is there a setting we are missing or should we just return it?
If the headphone plug is fully inserted, I would return the iPod for a replacement
-
after updating iOS on my iPod touch 4th gen my Philips speaker dock DC290B/37 no longer charges the iPod. It will play music but not charge, is there anyway to find out if Apple is working on an update/fix?
Try:
- Reset the dock
- Reset the iOS device. Nothing will be lost
Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Reset all settings
Go to Settings > General > Reset and tap Reset All Settings.
All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
- Restore from backup. See:
iOS: Back up and restore your iOS device with iCloud or iTunes
- Restore to factory settings/new iOS device.
Otherwise you are out of luck. Apple is not making any more update for the 4G.
Also check with Phillips. Maybe they have an firmware update available -
I got my screen fixed and the day i got my ipod touch 4th gen back the wifi doesnt work unless i hold it right up to my router. Roughly every foot I move back it loses a bar and if i leave the room it doesn't even have a signal completely. Could the screen replacement have tampered with the wifi capability? Also if it helps I switched internet providers and during the time when my ipod was being fixed a new router was installed and it doesnt seem to work unless directly infront of my ipod.
Take it back to where you had the screen replaced. They messed up the connection to the wifi antenna
Installing iPod Touch 4th Generation Wi-Fi Antenna - iFixit -
my ipod touch 4th gen home button has stopped working i have taken of the screen and tried pushing the button underneath and still not working please help
Try a reset:
Hold the Sleep and Home button down until you see the Apple logo. -
my ipod touch 4th gen isnt work after a long time with 0 percent battery power.Then its not working. computer doesnt respond to my ipod .only black screen is appearing it even not wake up after reset it what can i do please help me
After being connected to a charging source overnight try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
I'm lost with my new "used" iPod touch 4th gen. Just downloaded iOS 6; seems to be trying to access a WIFI signal but I have it hard wired into my MAC and I do not have WIFI. Need iPod for dummies - very basic and simple help.
On the computer you should be able to go to the network properites. Go to the TCP part and unchec the line that says obtaind DNS automatically and check the one that says use the following. Add the 8.8.8.8 and Google other 8.8.4.4.
For more info see:
https://developers.google.com/speed/public-dns/ -
I purchased a used Ipod touch 4th gen and my computer (Windows XP) recognizes it as a camera but Itunes will not recognize the ipod. Old ipod works and connects fine. Any suggestions?
Well, there is always the possibility that it's been jailbroke, in which case, you're out of luck. However...
http://support.apple.com/kb/TS1369
There have been some problems accessing pages on the Apple web site. If the hyperlink gives you a "We're sorry" message, try again. -
Why is my wifi on my ipod touch 2nd gen not working?
Can someone help with the wifi on my ipod touch 2nd Gen? Yesterday it suddenly stopped connecting to anything wifi. No settings were changed. The only thing I did was go to itunes for the first time in well, forever. I always use it on my computer to go in itunes, not my ipod. Anyway, I'm pretty sure I could still get on Safari after that but I don't really remember. At some point in the evening it stopped connecting. I can't get on Safari, my mail won't refresh, it would connect to the app store, nothing. Sometimes a message does pop up saying there was a problem connecting to the server. I can't figure this out, internet on my computer is running perfectly fine. My ipod wifi is on, airplane mode off. When I go into my settings it shows my network and that it's connected. I haven't connected it or synced it to the new itunes. I actually haven't downloaded the update yet. Ipod is up to date though without the new sync. Can anyone help me out? I'm very confused.
ThanksDoes the iPod connect to other networks?
Try:
- Reset the iPod. Nothing will be lost
Reset iPod touch: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Power off and then back on the router
- Reset network settings: Settings>GeneralReset>Reset Network Settings
- iOS: Troubleshooting Wi-Fi networks and connections
- iOS: Recommended settings for Wi-Fi routers and access points
- Restore from backup
- Restore to factory settings/new iPod.
- Make an appointment at the Genius Bar of an Apple store.
Apple Retail Store - Genius Bar -
Trying to upload to youtube a 16:9 video through my ipod touch 4th gen and its not working.
Hey i have managed to download the Imovie for the Ipod touch 4th Gen, I can't seem to export or upload to youtube a 16:9 screen just a very thin screen. I don't have a apple mac, I have windows vista. I realise for some features you have to use a apple mac. So is there anyway that I can fix this problem, thank you for your time and patience.
-SpiritualperformerSee:
fix for Home button
Fix a broken, unresponsive or sticky iPhone Home Button
You can also go to Settings>General>Accessibility and turn on Assistive Touch It adds the Home button to the iPod's screen.
Yes, if you get it fixes, the iPod will likely be erased. Apple will not repair your old iPod, they exchange it for a refurbished one and do not transfer data. -
I know it's a tad late, but I recently updated my iPod touch 4th gen to iOS 6 and now it won't play any of my music. It will play Spotify and YouTube just fine, but it won't play my music. It will just skip to the next a d the next and the next after a second or two without any sound. Please help! Thank you.
Try:
- Reset the iOS device. Nothing will be lost
Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Unsync all music and resync
- Reset all settings
Go to Settings > General > Reset and tap Reset All Settings.
All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
- Restore from backup. See:
iOS: How to back up
- Restore to factory settings/new iOS device.
Maybe you are looking for
-
I purchased a movie from those online "movies to ipod" sites (buyimovies.com) and put it on my 80g video ipod. the movie worked fine as i would watch about a half hour each night before bed. one night, the screen went dark and the ipod froze. i tried
-
hi i m trying to connect to mysql database through java. i have mysql-java-connector jars file placed in the JAVA_HOME\jre\lib\ext directory. now when i try to run this file its starts givin me this error............... Exception in thread "main" jav
-
EEM policy: Syslog ED & logging Discriminator = Crash
Hi everyone! I found a new bug in cisco IOS 15.1(4)M3 when running EEM script with syslog event detector. If system logging performed using the "logging discriminator" and run concurrently EEM script with syslog event detector, then Cisco router cras
-
Hello All, I have following question about how to handle fund changes at the installment. 1) At first i created document as follows. Tuition fee : 100 USD Fund was 0A00 . 2) I also created installment for qbove document. Installment 1
-
Hi SAP Gurus, Can any body help me out how to run the payroll , i created Payroll area, ABKRS, Control record, after this what should i do, how to run the confgration , i configared, pls let me know Thanks Manju20099