WLC 4402 + Ssid Override

Question

hi!
I have little problem with the Ssid Override. I think it is a liitle problem but i do not find the solution.
when i try to enable ssid override i do not see the them. I have completed all steps: create wlans, enable wlan override, select the aps and the radio interfaces and check the ssid to be transmitted.
As said before, the problem is that i can not connect to them, even loading the profile.
Checking the 1242ag i see that the mbssid is 8, so i think i can broadcast multiple ssids.
May be i forgot one step but i do not what.
Any suggestions?
thanks in advance.

Answer 1

Hi Falque,
If I am following along here correctly, have a look at this info;
Enabling WLAN Override
By default, access points transmit all defined WLANs on the controller. However, you can use the WLAN Override option to select which WLANs are transmitted and which ones are not on a per access point basis. For example, you can use WLAN override to control where in the network the guest WLAN is transmitted or you can use it to disable a specific WLAN in a certain area of the network.
From this doc;
http://www.cisco.com/en/US/products/ps6366/products_configuration_guide_chapter09186a008076cbfd.html#wp1114777
Once you create a new WLAN, the WLAN > Edit page for the new WLAN appears. In this page you can define various parameters specific to this WLAN including General Policies, RADIUS Servers, Security Policies, and 802.1x Parameters.
**Check Admin Status under General Policies to enable the WLAN. If you want the AP to broadcast the SSID in its beacon frames, check Broadcast SSID.
Note: You can configure up to sixteen WLANs on the controller. The Cisco WLAN Solution can control up to sixteen WLANs for Lightweight APs. Each WLAN has a separate WLAN ID (1 through 16), a separate WLAN SSID (WLAN name), and can be assigned unique security policies. Lightweight APs broadcast all active Cisco WLAN Solution WLAN SSIDs and enforce the policies that you define for each WLAN.
From this good doc;
http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a0080665d18.shtml#c3
Hope this helps!
Rob