WRT160N mac address to use for dhcp reservation

I have to reserve this one router's MAC address in the main router for the building. Both routers in question are WRT160Ns. The router I have to reserve's MAC address ends in 5A (on the bottom of the router, and in the ARP table when connected via wifi), but it's 5B that is listed in the DHCP resrvation table for the main router. Why is this? What should I do? I am trying to reserve it in order to keep the nettalk voIP adaptor connected to the network.

How about if you access the setup page of the 2nd router then go to the status and check the local mac address under the local network subtab. From there you will be able to compare if you have the right mac address.

Similar Messages

I installed Mountain Lion so that I could sync my notes with my iPhone that already syncs notes with a specific email address I use for school, but during the install it automatically set up Notes to sync w the wrong email addy. How can I fix it?

I installed Mountain Lion so that I could sync my notes with my iPhone that already syncs notes with a specific email address I use for school, but during the install it automatically set up Notes to sync w the wrong email addy. It looked in Mail, which had 5 email accounts set up in it, and for some reason picked the only one that I no longer use because it is for a school that I no longer attend. How can I fix it so that it syncs with the correct email account for notes and calendar? There don't seem to be any settings available other than to check if you want to use the basic features. It also said during the set up that it was setting up 'find my mac' but if I look on the iCloud website there is nothing showing there for finding my mac.
At this point I feel like I wasted my money paying for this supposed upgrade. I got nothing for it but frustration. It even automatically set my security settings to allow only downloads from the Mac store so the first time I went to download something I had to stop what I was doing and go correct settings first. I feel like there should be a security setting to block downloads from the Mac store so I don't accidentally end up clicking the wrong thing and being charged.

iCloud isn't syncing them on your phone. You simply added the email account to your phone and enabled calendar and notes syncing with the email provider, and the calendar and notes appear in the calendar and notes apps on your phone. You can do this with Gmail, Yahoo and other IMAP account. iCloud email is just another IMAP account, but syncs notes with Apple's iCloud server just as Gmail syncs notes and calendars with Google's server.
iCloud didnt' set up a non-iCloud account on your Mac. When you check Mail in System Preferences>iCloud, it only creates an iCloud email account. You can also add other email accounts to your Mac by going to System Preferences>Mail,Contacts,Calendars and clicking on the "+" sign on the bottom of the left sidebar. If you added these other email accounts to your Mac before you upgraded to Mountain Lion, these were simply maintained on your Mac after you upgraded.

The hotmail address i use for my apple ID was hacked and i no longer have access to it, this is stopping me from accessing any of my icloud or itunes. how can i fix this?

The hotmail address i use for my apple ID was hacked and i no longer have access to it, this is stopping me from accessing any of my icloud or itunes. how can i fix this?

Thanks, I appreciate the help. I think this is one of the problems Apple is creating by changing the OS so often. I had fomer colleagues at [a major aerospace contractor] who told me that so many original files were ultimately lost because of the deadly change in the "Save As" operation that they are now afraid of every OS update. Apple has badly damaged their support base with that very prominent company (they won't update now until they've fully examined and understand changes in the pre-conditioned nature of OS computer functions), and they are a whole lot less enthaled with Mac-related equipment/software. Can't blame them, I too used orginal files that way (as easy-to-use templates), and lost some important files before I realized what was happening (to late to revert). Companies should not have to retrain employees each time an OS gets an update, it's can be very expensive several different ways. They learned a painful lesson with that one. And because I'm now retired and don't use multiple devices, I need iCloud like I need a hole in the head... but I'm told there's no way to keep Apple out of my computer. Fortunately, because of major problems when initially installing Mountain Lion, one hold-over of the hardware/software damage I experienced was that iCloud can no longer access my computer even though everything else is working fine again. That was the only "good luck" I had as a result of that expensive nightmare.

Controlling which email address is used for group members?

Howdy Folks,
Is there a way to control which email address is used for contacts that you have put into a group in Address Book?
For example, say John Smith is a member of an Address Book group I have created. John's Address Book entry contains two email addresses for him, one for work and one for home.
When I send an email to the group I want to have it sent to John's work email address.
I have experimented by editing the entry and making sure the desired address is the first one listed for the individual in question, but that doesn't do the trick.
Thanks in advance for any tips!
--gordon
15" PowerBook Mac OS X (10.4.6)

Launch Address Book, choose Help > Address Book Help and type "group addresses" in the search box. Read the article titled "Selecting which addresses to use for members of a group". Does that solve your problem?

HT5622 We are a family of 4, each with their own apple device. Is it best for us to set up individual apple ID's for things like ITunes? If we do can the same e-mail address be used for all of them or do we need to create e-mails for the kids? Thank-you

We are a family of 4, each with their own apple device. Is it best for us to set up individual apple ID's for things like ITunes? If we do can the same e-mail address be used for all of them or do we need to create e-mails for the kids?
Thank-you

1. Yes, it is.
2. You may be able to use the same address by adding a plussed suffix to it, such as [email protected] If that doesn't work, create separate emails.
(103279)

Boost the speed of my Mac or be used for the RAM?

HI
is there any way that i can use my 8GB memory stick to boost the speed of my Mac or be used for the RAM?

MBA has RAM soldered to logicboard. No upgrade possible.
Sorry.

How can I obtain my licenses if another email address was used for the purchase?

How can I obtain my licenses if another email address was used for the purchase?

Hi 79bison,
Welcome to Adobe Forum,
You will have to log in with to www.adobe.comfor retail purchase or licensing.adobe.com if Volume licenses with the E-mail with which it is registered
Then you can retrieve the serial number, you can opt for transfer of license to get it registered with your Email, if applicable & eligible.
You can contact Adobe Support for further assistance at http://adobe.ly/yxj0t6.
Hope it helps you.
Rajshree

I don't remember the email address I used for my apple ID

I don't remember the email address I used for my apple ID. I got locked out of my iPod, cause I didn't remember the four-digit code.
Now its asking me to enter the ID and password. I can't even remember the password either. I think I remember the questions/answers. I can't start over and get a new account.

angelrose
go here > https://iforgot.apple.com/appleid
this should get you going again.
ÇÇÇ

Deny Mac address cannot use client ip address

Dear Team
How I can restrict Mac address in the denied list ,cannot use ip address.
Regards
Njsingh

Hi,
If you want to filter DHCP client by MAC address in order to prevent some device from obtaining IP address. You may enable Deny Filters on DHCP console first, and then New Filter by MAC address. Detailed steps you may reference the link below:
http://technet.microsoft.com/en-us/library/dd759190.aspx
Windows Server 2008 R2 or above system version has this function. Reference:
http://blogs.technet.com/b/teamdhcp/archive/2009/02/26/new-features-in-dhcp-for-windows-server-2008-r2-windows-7.aspx
If there is any misunderstanding about your question, please correct.
Best Regards,
Eve Wang
Please remember to mark the replies as answers if they help and unmark them if they provide no help. If you have feedback for TechNet Support, contact [email protected]

Mac-Address Filtering using more than one SSID

Hey All,
I've been asked to configure mac-address filtering on our WLC 4402 and it was basically straight forward. however i noticed that in creating the filter you can only choose 1 SSID or the other option would be to choose all? My question then is what happens if i need a user one 2 specific SSIDs? can i create separate filters for each SSID but using the same mac?

No you only can have one MAC address filter. You should only have a device associated to one SSID. So as you know, you either choose one WLAN or choose all.
Sent from Cisco Technical Support iPhone App

I have one apple ID for my MAC and another used for both my iPhone and IPad. Purchases from iTunes don't appear on either my iPhone or iPad only only the MAC. How do I sync the two IDs?

I have one Apple ID for my MAC and iTunes account and another that is used for both my iTunes and iPad. When I purchased music from iTunes using the Mac ID, the music isn't available on my iTunes or iPad. Neither lets me change my ID so how do I fix this issue so I can play the music on all three?

Hello chlanli
You would need to use one Apple ID for purchases in order to get them across all of your devices and computer. If you want you can use one Apple ID for purchases and the other one to sync personal data. The article below will explain further.
Using your Apple ID for Apple services
http://support.apple.com/kb/ht4895
Regards,
-Norm G.

Mac OS X will not install as it states Mac HD is used for Time Machine backups?

I'm not sure what is happening?! I wanted to connect my new wireless trackpad but could not as my mac said I needed 10.6 or later. I checked my mac which I thought had snow leopard on but it states it has 10.5.8? I am now trying to re-load mac OS X from my disc as it states it is 10.6 but it will not load as the installer gets to a point where it states that the Macintosh HD is used for Time Machine backups and consequently will not move on to the next stag? Now I cannot even get out of installing or eject the disc! Can anyone help with what I am doing wrong? VMT

The installer won't load on any HD that contains a Backups.backupdb (used for Time Machine/Backup) folder on it. If the backup isn't in use, delete that folder and 10.6 will install.
Regards,
Captfred

MAC Address Vendor Codes for Apple?

Does anyone know if there's a current list of MAC address vendor codes that have been assigned to Apple? I've found a few by searching but I'm not sure how recent they are.

Go to this page and browse or search the OUI listing for Apple.
(13628)

Mac-Address Different format for Authorization on Cisco ISE

Dear All,
I have problem with my Cisco ISE,
This is the design :
ISE ---- Core Switch ---- 3Com Switch --- PC User
My Case:
Authorization is based on Mac-address and Active Directory,
But user with PC that connect to 3Com swtich is Deny by ISE because the Format Mac-address is different with Cisco,
Mac-address Cisco format : XX:XX:XX:XX:XX:XX
Mac-address 3Com format : XXXX-XXXX-XXXX
3Com Switch type is TRICOM 4210 26-PORT.
Anyone have experience with this? and how change the mac-address format in 3Com so user can authorized by Cisco ISE.
note:
authorization based on Active Directory is not problem with 3Com Switch.
Based on my experience, Different product is different format mac-address, so this case not only for 3Com Switch.
Thanks,
Arika Wahyono

I do not think Cisco will add these vendors to the supported switch matrix because then it would be a support issue that cisco would have to deal with, much like most of the AD issues I experienced when I worked in TAC. Your best bet would be to run the evaluation license instance in a lab and have a 3com switch point against that.
Other than that I do not recommend upgrading to 1.2 without validating that the new "multi-vendor" MAB support will work on your switch.
PS- Keep in mind that my comments is just my opinion so you may need to open a TAC case for an official answer.
Tarik Admani
*Please rate helpful posts*

Email address being used for somebody elses accoun...

For the last couple of months I have been getting emails (on a different email adress than the one I use for skype) for another person, saying that the payments to skype hasnt been made and that his account is going to expire, how do I unlink my email address from his account? It really annoying!!!!

contact customer service to report that user and to request to unlink your email address from their account - you can send an email to [email protected]
CONTACT SKYPE CUSTOMER SERVICE | HOW TO RECORD SKYPE VIDEO CALLS | HOW TO HANDLE SUPICIOUS CALLS AND MESSAGES | WINDOWS PROBLEMS TROUBLESHOOTING | SKYPE DOWNLOAD LINKS
MORE TIPS, TRICKS AND UPDATES AT
skypefordummies.blogspot.com

WRT160N mac address to use for dhcp reservation

Similar Messages

Maybe you are looking for