Yellow LED light Flashing on Back of Xserve

Hello I need every one's help on this issue. Some of you might know what thisissue is all about, if so would you please get back with me.
I have a G5 Xserve running 10.5.3, on the back of the server there is a yellow LED that is flashing on the back of the machine. I have checked the server monitor nothing comes up. This means something is up with the server. Any ideas? The battery might be four years old, not sure if that would cause the issue.
Please help me, PLEASE!!!
Dr. Phil

Here is an example:
Mon Jun 9 18:25:50 CDT 2008 - The enclosure has been opened.
Mon Jun 9 18:25:50 CDT 2008 - Service light has been automatically set to 'blink'.
Mon Jun 9 18:31:56 CDT 2008 - The enclosure has been closed.
Mon Jun 9 18:37:02 CDT 2008 - Number of drives change from 2 to 3.
Mon Jun 9 18:39:02 CDT 2008 - Number of drives change from 3 to 2.
Mon Jun 9 18:48:26 CDT 2008 - Service light has been manually set to 'off'.
Enclosure intrusions, along with other failures (such as mobo, blowers, etc. will be accompanied by a status summary which will show you the state of the system (voltages, rpm's, raid, ect.)
Hope this helps
Wolfman

Similar Messages

  • Front LED Light Flash Once Every 3 Seconds

    As what I read from the previous post, the front LED light flash once every 3 seconds meant that rams were not installed. However, I can turn on the G5 (Tower) couple days ago. After I came back from vacation, it did not allow me to turn it on. In addition, I have already tried to reseat the ram, and it did not work. Any suggestion to fix this problem?

    Hi Teddy, and a warm welcome to the forums!
    After I came back from vacation, it did not allow me to turn it on.
    If it was unplugged from the AC that could drain the PRAM Battery, 4 years is close to their lifespan...
    See which one your G5 has...
    http://eshop.macsales.com/item/Newer%20Technology/CR2032/
    http://eshop.macsales.com/item/Newer%20Technology/BAA36VPRAM/

  • I can't seem to make my led light/flash work on my iphone 4

    I  recently purchage a flashlight app for my iphone 4 and discovered that my led light/flash was not working.  In the flashlight mode I could not get the led to work.  I later found out the flash in the camera mode also didnot function.  I'm wondering is there a defect in the led/flash or is there a setting that I have omitted on the ipone itself.  I'm going to take the phone in to the local Verision store for evaluation and possible exchange.

    Unless Verizon has a special provision in this regard that ATT has never had, Apple handles all iPhone repairs and exchanges under Apple's warranty.
    There is a setting when capturing photos - Automatic, On, or Off for the flash when capturing photos.
    If there is no flash when set to On or Automatic in a dark setting and no change after the standard troubleshooting steps which in order are:
    Power your iPhone off and on.
    An iPhone reset.
    Restoring your iPhone with iTunes from the backup.
    Restoring your iPhone with iTunes as a new iPhone or not from the backup.
    Your iPhone has a hardware problem. You can call AppleCare or make an appointment at an Apple store if there is one nearby.

  • Dv3z black screen with caps lock and numlock led lights flashing

    dv3z boot with black screen and (screen) flashes every few seconds, cap and num lock led lights flashes every 2 seonds as well.  It boots eventually but takes forever.

    Hi,
    I your notebook still under warranty?  If it is, you will need to contact HP and arrange to have the notebook repaired under warranty.
    If you live in the US, contact HP Here.
    If you are in another part of the world, start Here.
    If you're out of warranty, I would suggest getting an estimate ( and a confirmation of the diagnosis ) from a local computer repair shop.  If the actual processor chip is faulty, this is far easier to replace than say a fault with the graphics chip ( which usually means a new Motherboard ) and so may well be worth the expense.
    Regards,
    DP-K
    ****Click the White thumb to say thanks****
    ****Please mark Accept As Solution if it solves your problem****
    ****I don't work for HP****
    Microsoft MVP - Windows Experience

  • SG 200-08 All LED lights flashing green after power failure

    Thinking back, about a month ago I updated the firmware (sorry I can't check version at the moment). The switch has been working fine since then. Today I needed to move some power cables and the switch lost power. Now ALL of the LED lights are flashing green and I can't access the switch. I've tried setting a static IP on my laptop to 192.168.1.20, mask 255.255.255.0, and accessing the switch on 192.168.1.254, but there's no response. I've tried holding in the reset button for at least 30 seconds while the switch is powered on, AND while powering it on. None of that has worked. Also when I first power it on, the system LED flashes orange very quickly for a second or so, then all of the LEDS start flashing green.
    What am I missing?

    Its been a few months, so I don't remember the details, but I think it was a combination of using the reset button and then opening a browser to the default IP address. If you look at the screenshot I posted it has the IP address I used. I downloaded the firmware again and the webpage in the screenshot is where the router is asking me for the location of the firmware I downloaded. After it finished reloading the firmware it worked again.

  • Extreme Base Station - green lights flashing in back, no light on front

    My Apple Extreme Base Station isn't broadcasting a WiFi signal and isn't creating a network for ethernet. The green lights on the back by each port are flashing about every second, but the front indicator doesn't show a light (no green, no amber, no nothin'). The base station doesn't show up on AirPort Utility, even though it's connected via Ethernet cable.
    I tried doing a hard reset (turning off station for a couple minutes, holding in reset button - plugging in power - and continuing to hold reset button) but nothing seems to be working.
    Is this dead? Or is there another solution to bring it back to life. Thanks if you have a fix!

    An internal power supply has failed on the AirPort Extreme. Unfortunately, Apple does not offer repairs or repair parts, so not much that you can do other than replace the device.
    The A1143 was discontinued in March 2009, so the device is at least 5+ years old, likely older. Unfortunately, 5 years....on average.....is about all that you can expect from routers designed for home use.

  • WhatsApp on BB 9360 - LED light flashing

    I have the BB 9360 for a week now, its all good but noticed that when i get a WhatsApp message the LED light will flash red (which i know is normal) however when i have read it the light will still be flashing red, this turns off automatically after around 4mins.
    Just wondering if anyone else gets this as this does not happen with Emails, SMS and BBM's.
    Thanks.

    This should not be. I just checked now...as soon as I read the new message the LED notification is turning off.
    Try below -
    When you device is POWERED ON, remove the battery for a minute, and then reinsert the battery. This make a reboot to your device which resolves minor issues with the BlackBerry device.
    To know more on LED behavior check the below knowledgebase article -
    KB21094 What is red LED indicator notification timeout for new email messages
    tanzim                                                                                  
    If your query is resolved then please click on “Accept as Solution”
    Click on the LIKE on the bottom right if the post deserves credit

  • HP 6735S LED Light Flashing 3 Times

    hello
    i have a HP 6735s with 4gb ram and the caps lock light is flashing 3 times have read on hp and its a memory issue i have tried the sticks of memory one at a time and both together in different memory slots and still the same led flashing 3 times, i have tried the memory in another laptop and they work fine so its not the memory and have tried brand new memory in the hp 6735s laptop and still the same problem so i think it maybe a motherboard fault can anyone help please
    Thanks Brent 

    I agree with you then brent_smith.  It would seem that the problem lies with the ports and would likely need to be replaced.  
    Here is a link to your notebook's Maintenance and Service Guide.  It covers the disassembly of the notebook as well as how to replace the parts.  This website has the various part number you'll need.  You should be able to order the parts from HP Parts Surfer.
    If you feel I've been helpful or want to say thanks make sure to click the white star under my posts to give me Kudos.  I really appreciate it!
    Have a great rest of the day.
    Please click the white star under my name to give me Kudos as a way to say "Thanks!"
    Click the "Accept as Solution" button if I resolve your issue.

  • What does this LED light do? ;) Flashing home with an "A" letter :))

    Can you please explain why is this led light flashing? What does it mean? Thanks! )
    Solved!
    Go to Solution.

    English Community   Deutsche Community   Comunidad en Español   Русскоязычное Сообщество
    Community Resources: Participation Rules • Images in posts • Search (Advanced) • Private Messaging
    PM requests for individual support are not answered. If a post solves your issue, please mark it so.
    X1C3 Helix X220 X301 X200T T61p T60p Y3P • T520 T420 T510 T400 R400 T61 Y2P Y13
    I am not a Lenovo employee.

  • My LED light turns on and off on its own, how can I fix this?

    I dropped my phone today and my LED light on the back by the camera turns on and off randomly. I've dropped it before today and it just now started doing this. How can I fix it or do I have to bring it in to a Apple store?

    The phone is probably broken. You will have to take it to an Apple store for repair or replacement.

  • LED Lights on R6970 Lightning (Twin Frozr 3)

    Is it possible to turn off the row of LED lights on the back of the card? Sometimes I inevitably leave my computer on at night and I believe these lights would be super distracting, considering I have a windowed case.
    This is the only thing keeping me from pulling the trigger on it.
    Thanks!

    Yes:
    Quote from: Svet on 17-April-11, 16:06:44
    its normal, its APS feature,
    dynamic adjust phases[14 (for gpu) monitored from total 18(remaining are: 3 for memory + 1 for PLL)] depend of load to save power
    4 burning reds means that currently VGA is in full load [Phases: 11,12,13,14 light in red and 1-10 light in green]

  • I have an Apple TV .. have continous flashing white LED light... tried holding menu   back for 10 seconds as suggested .. didn't work

    I have an Apple TV ... it flashes continuously a white LED light... I tried the hold menu + back simultaneously for 10 seconds as recommended, but it didn't work. What other options are there?

    Hey there earlmesy,
    Welcome to Apple Support Communities.
    Take a look at the article below, it provides information that should help you resolve the issue with your Apple TV continuously displaying the white LED light.
    Apple TV: About the status light - Apple Support
    Ciao,
    -Jason

  • Blackberry LED light keeps flashing red

    Yesterday Vodacom Care gave me a new Q5 device - i had a Q5 for 2 months and the phone just went dead - so they replaced  it . Now  my Q5 LED light keeps flashing red and it's a NEW PHONE ??? - make it stop please !

    Hello,
    Welcome to the BlackBerry Support Community Forums.
    Thanks for the question.
    Follow the steps below to try and bring the BlackBerry Q5 back to life:
    Ensure that BlackBerry Link is installed on the PC or Mac OS
    Ensure the computer has an internet connection.
    Launch the BlackBerry Link Software.
    Note: A backup of the BlackBerry device should be tried before a reload.
    Turn off the BlackBerry device. Make sure there are no flashing LEDs and that the LCD is not still being lit by the backlight. If there are any flashing LEDs, hold the power button for 15 seconds until the LEDs stop.
    Connect the BlackBerry device to the computer.
    When prompted with Cannot communicate with device, click Restore and then click yes allow the update to be downloaded and installed on the BlackBerry device.
    If the restore button is not seen press the vertical dots in the lower right corner of BlackBerry Link and select disconnected device.  Highlight the disconnected device you are working with and attempt steps 4 to 6 again.
    If the issue still persists, then I suggest contacting your network service provider for repair options. 
    Let me know if you have any more questions.
    Cheers.
    VIA | ViciousFerret
    http://supportforums.blackberry.com/t5/BlackBerry-Z10/BB-Z10-Died/m-p/2230087#M10125
    Please thank those who help you by clicking the button.
    If your issue has been solved, please resolve it by marking "Accept as Solution"

  • Can the HOME BUTTON(the circular button under the screen) or any other button on the front of the phone flash an LED light on notifications

    pls reply and if it is 'no' then pls advice the apple company to do this in the next iPhone.

    Please don't post the same question multiple times. Your question was answered here: Can the back button of an iPhone 5s flash an LED light on any notification
    Not on the front, only the LED flash.

  • Blue operating light flashing yellow,/seems to be no video/

    Pavillion P7-1297cb  QZ233AA  HP2711xmonitor
    My logitech mouse stopped working on programmable keys so I rebooted.  The normal blue operating light flashed yellow three times, went back to blue but no boot.  Tilted box and checked cables, retried and then everything normal.  Computer 1 1/2 years old.
    What's wrong?

    Unfortunately, you never know what's gonna happen if you drop a phone.  You could try holding the power and volume down buttons simultaneously for about 30 seconds and see if that will reboot the phone.  If the phone seems to be working ok after that, a screen replacement might work.  Otherwise, you may have to replace the phone.

Maybe you are looking for