Zen V lighting is red.. and very d

I had had my Zen V for about 3 weeks, and I have been very happy with it's performance. But today I was using my Zen V and the light went dim and it turned red. The battery says it's charged. What do I do to change it's

Hi, Ken: Normally the recovery drive is almost full because HP creates a partition just large enough to store the recovery image on. You should get a warning message if the recovery drive is accumulating too many files (that don't belong on it). Please see the info at the link below for further guidance. http://support.hp.com/us-en/document/c03736755

Similar Messages

  • MacBook not charging. Charging light blinks red and green (very low) than green in normal charge.

    My MacBook's battery is dead. When I plug the charge the charging indicator blinks with dim red and green light instead of bright green light. Please help anyone has a solution to it. Last time I remember tye battery was 46%. I plugged in charger and put my iPhone and power bank in charge in Mac USBs. After hours I found that neither phone and power bank was charged nor Mac. Instead Mac's battery was also empty.

    Hi harry.ptk,
    Welcome to the Apple Support Communities! I understand that you are experiencing issues charging your MacBook Pro. The following resource may provides steps for these sort of issues:
    OS X Yosemite: If your battery won’t charge
    http://support.apple.com/kb/PH18601
    - Reset the battery:
    If you have a Mac with a removable battery, remove it and install it again, to make sure it’s properly installed. Refer to the manual that came with your Mac for more information about properly installing the battery.
    - Reset the SMC:
    Reset the System Management Controller (SMC), which controls how your Mac manages power. For more information, see the Apple Support article Resetting the System Management Controller (SMC).
    - Get your Mac serviced:
    If the battery still won’t charge, your Mac may need to be serviced. Take your Mac to your local Apple Store or contact AppleCare.
    - Matt M.

  • The sys light blinks red and the GPS light is solid red even though the antenna is at a window.  Wan light is blue.

    My extender work fine for the last 8 months but now the system light just blinks red and the GPS is solid red even though the antenna is next to a window?

    See the Network Extenders User Guide:
    http://www.verizonwireless.com/support/pdf/network_extender_user_manual.pdf
    There is a page dedicated to the light codes this device will display along with instructions on how to handle each situation.

  • T61 Battery light flashes red and green

    Hello:
    My T61(type 8891) won't start. I'm getting a series of flashes from the battery and power lights:
    A/C power connected: power light flashes green alternately and battery light flashes green then red/green.
    AC off, battery installed: power light flashes green at the same time as the battery light flashes red/green.
    This happened twice before in the past 2 weeks. After about an hour, it booted up - no problem. This time, nothing.
    Thanks in advance for any assistance.

    It started about one month ago - no known cause. The problem happened 3 times since then but each time it booted up by itself  after a half hour or so. A new motherboard is going to set me back plenty but f it's needed, I guess I must get it repaired. I'm quite handy at taking the laptop apart. I've replaced the hinge, and bezel.
    Maybe the fan is inoperable which may cause it to not boot up. Lately, I've been feeling exhaust air much warmer than before even if it's not being used. I blew the dust off it 3 weeks ago.

  • Internet light is red

    When I connect my Westell 6100 directly to the computer the power light,ethernet light,DSL and Internet light are all green on I am connected to the internet. When I connect my Linksys WRT54G router to the modem the Internet light turns red and goes on and of periodically but I can still get on the internet.

    I am suggesting that you follow the info that is at
    http://www.dslreports.com/faq/13600
    If you have any questions, please ask.
    If you are the original poster (OP) and your issue is solved, please remember to click the "Solution?" button so that others can more easily find it. If anyone has been helpful to you, please show your appreciation by clicking the "Kudos" button.

  • HT3371 When I plug in the computer to charge, the light is green for a minute and then turns red and the plug gets very hot.  It's not the plug as it works on other computer.  Why won't my computer charge?

    When I plug in my MacBook Pro to charge, the light is green for a minute and then it turns red and the plug gets very hot.  The plug works fine on another computer and charges it.  Why won't my MacBook Pro charge?

    You performed all of the steps outlined in this link?
    http://support.apple.com/kb/TS1567
    You uninstalled and reinstalled iTunes?
    GB

  • My ipad is having something wrong in the screen pixels the screen is having an error it is giving a red and baby blue lights all over the screen (invert colours is turned off)

    My ipad is having something wrong in the screen pixels the screen is having an error it is giving a red and baby blue lights all over the screen (invert colours is turned off)

    Try Recovery Mode.
    Read this: http://support.apple.com/kb/ht1808
    Follow the instructions very carefully.

  • Hi guys well huge issue my Ipod 4th generation shuffle died and I tried to chrge it I plugged it into the USB port and the red light came on and after 5 seconds  turned off the whole Ipod is dead and I've tried in wall chargers as well that doesn't charge

    Hi guys well huge issue my Ipod 4th generation shuffle died and I tried to chrge it I plugged it into the USB port and the red light came on and after 5seconds turned off the whole Ipod is dead and I've tried in wall chargers as well that doesn't charge what should I do is there a solution or should I claim my warrenty and have it fixed??

    Also my Itunes and computer won'r reconize it

  • My iphone 6plus not working not charge but when i run it the first time working half an hour  when you attempt to run it again light up thr screen and showws the apple logo and after the pice screen illuminates red and does not work what do i do now

    My iphone 6plus not working not charge but when i run it the first time working half an hour  when you attempt to run it again light up thr screen and showws the apple logo and after the pice screen illuminates red and does not work what do i do now

    Hello Nadersalah,
    It seems you're experiencing multiple issue with your iPhone. Based on the information you have provided, it appears your iPhone needs to be serviced. The following link should help you get started with the process and has links with additional information on topics such as warranty and service pricing, battery replacement, and express replacement service.
    iPhone Repair and Service - Apple Support
    Thank you for contributing to Apple Support Communities.
    Cheers,
    Bobby_D

  • My Curve 9220 has a black screen and the LED light blinks red every 5 seconds

    The phone won't come on and the light blinks red. I dont know what to do 

    Hi there,
    If you have a good battery or the batttery is good enough then try those steps , it may help :
    ( Credit JSanders )
    1) Make sure you have Blackberry Desktop Manager installed. BlackBerry desktop software
    2) On your PC, go to Start > Run and copy and paste the following line exactly (meaning with the quotation marks):
    "c:\program files\common files\research in motion\apploader\loader.exe" /nojvm
    3) The Application Loader Wizard will appear -- click "Next."
    4) In the "Connection:" drop-down menu, you should see "USB-PIN: UNKNOWN". Click the "Next" button.
    5) You should then see a list of applications ready to be installed for your Blackberry. Hit Next and Finish and you are well on your way to getting your Blackberry back to life. Congrats! Just don't disconnect anything and let the lengthy process finish completely.
    NOTE: If you do not see a list of applications mentioned in step 5 and instead see the message "The Blackberry Desktop Software does not have Blackberry Device Software for the device that you have connected to the computer. Contact your wireless service provider or system administrator," then you must download Blackberry's Operating System for your carrier and device.  BlackBerry Software Download Site
    Just select the appropriate carrier and network type, select your Blackberry model from the list and download the latest version. Install this download and follow the above steps again and you should be on the right path.
    Good luck.
    Click " Like " if you want to Thank someone.
    If Problem Resolves mark the post(s) as " Solution ", so that other can make use of it.

  • Impressionist brush only changes white and very light colours

    I'm new to Photoshop Elements and am trying to grapple with the Impressionist brush.  It seems to function like CS5's Art History brush except that I cannot get it to affect mid and dark value areas.  It appears no matter what the area or tolerance settings to change only whites and very light colours.  Is this a known issue or am I missing something?
    Thanks.

    Try resetting the impressionist brush tool by clicking on the
    little downturned arrow and choose reset tool.
    It's somewhat similar to photoshop except, you can't choose
    a history state to paint from, so make sure your not painting
    on a blank layer. To effect the photo, you have to paint on the actual layer
    that photo is on.
    MTSTUNER

  • My 13.3" macbook pro will not power up.The battery indicator light does not come on.The Mag safe charging light flickers green and red dimly.I had a cell phone connected to the USB port.

    My 13.3" macbook pro will not power up.The battery indicator light does not come on.The Mag safe charging light flickers green and red dimly.I had a cell phone connected to the USB port.

    This didn't work for me, so I did a bit of searching and TONS of pages later in google, I found an answer. Here are the steps for people who also were in my situation:
    1. Take off bottom case
    2. Unplug battery - blurry image here: http://i.ytimg.com/vi/03cC79r5Dx4/0.jpg
    3. Press and hold power button for 5 seconds
    4. Plug a charger in, and it should start booting up
    5. After shutting down again, reconnect the battery and close the case up
    6. It works! (hopefully, if you guys had the same situation I did)

  • I am using apple iPod-suffle model and I am unable to upload music into iPod and 3 lights(green,orange and red) keeps blinking for few seconds when I connect my iPod to my PC and after few seconds its turn to unresponce mode,Plz help to find out solution

    I am using apple iPod-suffle model,I am unable to upload music into iPod and 3 lights(green,orange and red) keeps blinking for few seconds when I connect my iPod to my PC and after few seconds its turn to unresponce mode,Plz help to find out solution.

    Try:                                               
    - iOS: Not responding or does not turn on           
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try another cable       
    - Try on another computer                                                       
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
      Apple Retail Store - Genius Bar

  • Light colored text and highlighting is very difficult to see.

    Light colored text and highlighting is very difficult to see.  How can I make it darker or more pronounced?  It seems to get darker if I push the screen as far back as it goes.  MacBook 5.2 OSX 10.6.8

    A problem for many of us.
    You can change the highlight colour in System Preferences > Appearance
    For awkward choices of text colour, you can either zoom to see it larger (hold 'ctrl' and scroll forward), or reverse the colours by holding dwn the ctrl, opt and command keys and typing 8 (⌃⌥⌘8). The same key sequence will toggle it off again.

  • Red light stops blinking and then stays solid

    This one is strange. I open an email on my BB and the red light stops blinking and then stays solid for about 5 minutes. It doesnt go off when I close the email either.
    Took the battery out to see if that would clear it but it still doing it.
    Any thoughts ?????

    Hi Willsie,
    Sounds like when the red light is solid, the device is still usable? Assuming this is correct, I have three questions for you:
    1. Can you you confirm this problem ONLY happens when you open up emails in the Messages application?
    2. Can you tell us the application version you are running from (OPTIONS > ABOUT)?
    3. Also, which third party applications do you have installed?
    tnx

Maybe you are looking for

  • Best way to install an OS in this situation - and which OS anyhoo?

    I have an early 2008 Mac Pro that's new to me, it doesn't have a Mac OS installed (the previous owner just had Windows installed - BOO!). I've installed a new blank HD in this 2008 Mac Pro for a system drive, and it's jsut sitting there ready for a s

  • Smart Cover Functioning IOS7 to IOS8

    I'm a 30+ year software professional, and use Windows, Linux, MacOS, and IOS on a daily basis. I bought my wife a 64 GB iPad Air2 (I'll call it iPad4) with wifi/wireless for Christmas.  I bought her an iPad2 many years ago (16GB, no wireless), and sh

  • Compaq Presario CQ56 laptop - Headphone input broken?

    Sound still plays from the speakers even when I have headphones plugged in. What do I do?

  • Need Help --- Pending Approvals in OIM 9X

    HI, I'm working with OIM api's where I need to find pending approvals for a user.I found two methods getPendingApprovalTasksAssignedToUser & getPendingApprovalTasksAssignedToUserPaged to fetch records. But the problem is the returned resultset rows a

  • Creating array of hash maps

    hi, I tried creating an array of hash maps in my application . but it continued to give me problem can any of u help me in this regard. thank you