Can I move audio in logic by the sample in the sample editor to compensate

Question

I wanted a final say on wether or not I can move audio with sample accurate percision by moving the anchor in the sample editor with update in arrange page turned off. i just need a verification of this.
Thanks guys

Answer 1

yes you can and should use the sample editor to make
such compensations. you do this by aligning the
anchor point to the sample or part of the wave form
that you want to correspond to a beat or subdivision
(ideally) though of course it can be any point you
want it to.
if you use 'pickup clock; move object or event to
SPL' KC the anchor point will jump to the SPL.
Philip K is right though; if your entire track is out
by the same amount that you can measure you could use
the sample delay (though of course that will only
delay it not move it forward in time). but you won't
see the waveforms align themselves to the beat
meaning you would have to be aware that that track
has been compensated for.
on balance i would edit with the sample editor.
I was thinking that you could delay the rest
of your tracks by however many samples thus
aligning by compensating everything else though
in real world situations I don't know how practical
this would be. I keep forgetting that you can measure
how many samples you select in the sample editor even
if you cannot see them individually. So I will defer
to the voice of experience on this. If Rohan would use
the Sample editor, then I would tend to agree