Can't get IVI Power Meter error query to work properly.

Question

I have been trying to use the IviPwrMeter Error-Query.vi to read possible errors coming from the Power Meter.  However, I have found that no errors can be detected using this vi.  This is because the returned value 'status' is wired over to the 'error code' input of 'IviPwrMeter Error Converter.vi' and the status value will always be equal to VI_SUCCESS as the attached code signifies.
All of this code was generated by either LabWindows/CVI and/or LabView.
If I wire the error code output of 'IviPwrMeter_error_query' function to the error code input of 'IviPwrMeter IVI error converter.vi', the errors on the Power Meter is at least detected.
Am I doing something wrong here or are there other work arounds?
Source listing of driver call:
ViStatus _VI_FUNC age4418b_error_query (ViSession vi, ViInt32 *errCode,
                                        ViChar errMessage[])
    ViStatus    error = VI_SUCCESS;
    checkErr( Ivi_LockSession (vi, VI_NULL));
    if (errCode == VI_NULL)
        viCheckParm( IVI_ERROR_INVALID_PARAMETER, 2, "Null address for Error Code");
    if (errMessage == VI_NULL)
        viCheckParm( IVI_ERROR_INVALID_PARAMETER, 3, "Null address for Error Message");
 if (!Ivi_Simulating(vi))                /* call only when locked */
     ViSession   io = Ivi_IOSession(vi); /* call only when locked */
     checkErr( Ivi_SetNeedToCheckStatus (vi, VI_TRUE));
     viCheckErr( viPrintf(io, "YST:ERR?"));
  viCheckErr( viScanf (io, "%ld,\"%256[^\"]", errCode, errMessage));
 else
         /* Simulate Error Query */
     *errCode = 0;
     strcpy (errMessage, "No error.");
Error:
    Ivi_UnlockSession(vi, VI_NULL);
    return error;

Answer 1

Dennis,
I get the same results as you if I don't have a power meter connected.  However, this doesn't supprise me because the session handle is probably checked at a higher level.
The calling hiearchy is as follows (I think, because I don't have all of the code)  IviPwrMeter Error Query.vi -> IviPwrMeter_error_query (IviPwrMeter.dll) ->age4418b_error_query (age4418b.dll).  I would guess that the session is validated in the second layer and not the bottom layer where the actual instrument error query is happening.
Something you may try.  If you have any instrument, write a simple program to get a valid handle then call the error query using the error cluster to link them together.  Set a breakpoint before the error query, run the program, use MAX to send an invalid command and create an error.  Then resume your original program and see if an error is reported in the error cluster after executing the IVI error query.
Bob