CiscoWorks and Parameterized templates ERROR - Help Joseph:-)

Question

Hi,
I am using CiscoWorks RME 4.3.1 I am trying to use Parameterized templates as explained in this document:
http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_resource_manager_essentials/4.3/user/guide/netcfg.html
Here is my XML file located in the right place: NMSROOT\files\rme\netconfig\cmdFileson the CiscoWorks server:
<DEVICE NAME = 10.60.131.1>
<CMDPARAM NAME = ConfigFile>
<value>TST4CUPE10-Confg-PV.txt</value>
</CMDPARAM>
</DEVICE>
Then in RME I creat a user-defined task  as the one you can see there:
Then I create a new job on a device with the parameterized file:
Actually if I put a tick in the Check Syntax I got the following error message:
I don't understand as the value is configured in the xml file as you can see above!
When the job is done I get a status: successful:
But the problem is that nothing has changed on the device cause of the following error:
configure replace bootflash:$ConfigFile force
Error: Could not open file bootflash:$ConfigFile for reading
Here is the result on the screen:
Does anyone knows what could cause this error?
Best regards,
Laurent

Answer 1

Hi Joe,
I have a good news. It is working now after I changed the IP to the hostname as you suggested.
But it was not working even with the hostname because I had a “<” too much.
bootflash:TST4CUPE10-Confg-PV.txt<
So now the file look like that:
bootflash:TST4CUPE10-Confg-PV.txt
Thank you so much for your help! That is fantastic
Best Regards,
Laurent