How can I use USB camera with NI cRIO 9022, please see my strange problem.

Question

Hi,
        I would like to use a USB camera with NI cRIO 9022. I used the same USB camera with NI USB 6216 DAQ device and developed a VI(within a PROJECT and outside it). So, It is working fine with NI USB 6216 device when I use the Vision Assistant Express VI and gets detected in its Initialization Window.  Please see JPEG File 3 where I get NO ERROR.
        I am facing a problem when I want to use it with NI cRIO 9022. What exactly I am doing in this case is:
1) Create a NEW PROJECT
2) Add Targets and Devices(NI cRIO 9022)
3) Use the Scan Interface mode
4) Create a NEW VI under the cRIO 9022 device 
5) Use a Timed Loop(Synchronized with Scan Engine) for continuous Data Acquisition and Sending from the Analog I/O modules.
6) Use the Vision Assistant available through the NI Vision Acquisition 2010 Module(I get STUCK HERE! The Express VI opens the Initialization Window, but I don't see the USB camera like in JPEG File 3)
I am facing difficulties with this HOST COMPUTER, cRIO implementation differences. On my host computer I have the software packages as shown in JPEG File 1, and on my cRIO 9022 as shown in JPEG File 2.
Can someone guide me how to overcome this and get the USB camera detected when I am using NI cRIO 9022?
NOTE: If this is a problem with software mismatches on HOST and NI cRIO 9022 device, please see JPEG Files 1 and 2 for available software and Host and cRIO 9022.
Thanks.
Amar.
Attachments:
Host Computer Image or Vision Acquisition Software Installed.JPG ‏91 KB
IMAQ and dx Modules Installed on my NI cRIO 9022 hardware(No NI Vision Acquisition 2010 SP1).JPG ‏82 KB
NI Vision Acquisition Express NO Error for NI cRIO 9022.JPG ‏48 KB

Answer 1

When you select My Computer, you are running the program on the PC.  In this case, the camera works because it is connected to the PC.  The scan engine doesn't work because it needs to run on the cRIO, not the PC.
When you create the program on the cRIO, you can use the scan engine because the program is on the cRIO.  You can't use the camera because it is back on the PC, and can't be found on the cRIO.
The project is a wonderful tool, but it may be making the programming seem too simple.  It may not be clear to you that by moving a program to a different location (PC or cRIO), it is running in an entirely different environment on a totally different machine, even though it is just a little further down in the project.  You can't easily access the hardware on one machine while running the program on the other.
So the summary is:  The camera is attached to the PC.  The scan engine runs on the cRIO.  Never the twain shall meet.
Bruce
Bruce Ammons
Ammons Engineering