HT1414 how do I enable my ipod. I tried to put my password and it locked it. its telling me to connect to itunes and its not working. what do i do

Can someone helpme pleaseeeeeeeeeeeeeee

Place the iOS device in Recovery Mode and then connect to your computer and restore via iTunes. The iPod will be erased.
iOS: Wrong passcode results in red disabled screen                          
If recovery mode does not work try DFU mode.                         
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings

Similar Messages

  • HT1414 my ipad shut off while using my battery is charged and i did itunes restore did not work what now

    itunes restore did not work what do i do now

    Error 13, 14, 35 and 50 (or -50)
    These errors are typically resolved by performing one or more of the steps listed below:
    Perform USB isolation troubleshooting, including trying a different USB port directly on the computer. See the advanced steps below for USB troubleshooting.
    Put a USB 2.0 hub between the device and the computer.
    Try a different USB 30-pin dock-connector cable.
    Eliminate third-party security software conflicts.
    There may be third-party software installed that modifies your default packet size in Windows by inserting one or more TcpWindowSize entries into your registry. Your default packet size being set incorrectly can cause this error. Contact the manufacturer of the software that installed the packet-size modification for assistance. Or, follow this article by Microsoft: How to reset Internet Protocol (TCP/IP) to reset the packet size back to the default for Windows.
    Connect your computer directly to your Internet source, bypassing any routers, hubs, or switches. You may need to restart your computer and modem to get online.
    Try to restore from another known-good computer and network.
    The copy above was copied from this website.
    http://support.apple.com/kb/TS3694#error14

  • TS2771 i am trying to fix my ipod touch tryed password to many times the problem is my usb port on my computer does not work what else can i try?

    my sons ipod is disabled from trying password to many times my usb port on my computer does not work. what else can i do to get this disabled off my sons ipod please help!!!

    The only thing you can do is place the iPod in Recovery mode and restore via iTunes on a computer. It is a good security feature.

  • Ipod touch stuck on 'connect to itunes' - Restore is not working

    We've got an Ipod touch (no idea on generation) that we were trying to sync some apps to from a laptop (not mac), they wouldn't sync so we tried resetting the ipod and syncing everything together. After resetting when we tried to access the ipod on itunes it just came up with 'could not connect to itunes store' (where we are it is currently blocked) which meant that we could not access the ipod via itunes in any way and then ipod was then stuck on the 'connect to itunes' screen.
    We tried turning both it and laptop off and on again, disconnecting etc. Then tried the restore using the home and on/off button which triggered the restore via itunes by putting it into recovery mode and it downloads everything fine but the ipod still remains on the connected to itunes screen - we've now tried restoring it 4 or 5 times.
    I was confused as to why the ipod wanted to connect to the itunes store in the first place because it has never asked to do so before and as it is blocked here then for every sync before this it has not been connected nor has it wanted to be. Perhaps it's to do with the apps? But there are apps already on the ipad. Perhaps taking the laptop and ipod to somewhere with wireless where the itunes store isn't blocked will allow us to access the ipod and restore/reset/sync and that will fix the issue?
    We're loathe to take it all the way to the nearest apple shop, especially on a wet Sunday, just for them to tell us that their only advice is to trigger the recovery mode which we know doesn't work! So any other advice is much appreciated.
    Just to clarify, we have been through recovery mode 4 or 5 times and done a full restore on it, with it downloading all the software and firmware and it hasn't worked.

    To restore an iPod an internet connection to the iTunes store is is required. iTunes on the computer has to g to the Apple server to verify that it is using the latest firmware update.

  • My Ipod touch is disable and i tried to connect to itunes however still not working i tried to do exactly what you guys instruct to do that didn't help my Ipod still disable

    my Ipod touch is not working my sister tried to find out my password now its lock and disable i tried to follow the instruction to connect to Itune however that didn't help at all is there anyway to call and get help to restore my Ipod

    What happens when you connect to the computer and try to restore via iTunes?
    Have you tried placing the iPod in recovery mode and then restoring? For recovery mode see:
    iPhone and iPod touch: Unable to update or restore
    You can call Apple but if you are not within 90 days of purchasing the iPod they will charge you.

  • HT4623 um i updated my ipod just now and now it says that i have to connect to itunes and it is not lsetting me at all i am really mad because i can not scses my ipod  or anything  on it so could u please help me get myipod back up and running

    please help me  with this im very upset and need help figuering out what im supposed to do anmd i need to get all of my music and every thing back sooo plesae help me
    it would be  amzinfg and if u could email me at [email protected] and help me fix my iopd please pleas ethis is very upsetting or call me at 1715 455 1315 that would be amazing if u could help me fix this asap

    Try:
    - Reset the iOS device. Nothing will be lost
    Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - On a computer with iTunes verion 11.1 sing into iTunes with your account and agree there. Then try another reset on the iPod
    - Restore from backup. See:                                 
    iOS: How to back up                                                                
    - Restore to factory settings/new iOS device.             
    If still problem, make an appointment at the Genius Bar of an Apple store since it appears you have a hardware problem.
    Apple Retail Store - Genius Bar                       

  • How can I enable an ipod?

    How can i enable an ipod?  I'm going through a school lost and found trying to figure out who this belongs to along with a bazillion flash drives.

    By placing the iPod in Recovery mode and then connecting to a conouter with iTunes and restore the iPod. However, that erases the iPod and will not provide any more information than you have now. The serial nuber is engraved on the back of the iPod.
    Apple will not help even with the serial number.

  • How do I enable my ipod touch if I have forgotten my passcode?

    How can I enable my ipod touch if I have forgotten my passcode?  I can't restore it from itunes because it is locked.

    Hold down the sleep/off button for three seconds. Then keep holding it, and push the home button and old both for 10 seconds. The screen should go black about 6 seconds into that. After that, let go of the sleep button and keep holding the home button for 10 seconds. This will force the iPod into DFU mode, and you can restore it in iTunes. If at first you don't succeed, try again, because the timing can be tricky.

  • How do i enable my ipod touch if i dont have the orginal itunes

    how do i enable my ipod touch if i dont have the orginal itunes?

    iOS: Forgotten passcode or device disabled after entering wrong ...

  • How can i enable my ipod so that when i double press the home button i can play music?

    how can i enable my ipod touch so that when i double press the home button i can stop and start music?

    After you double click the home button, Swipe the list of active apps to the right and you will see the music controls and the screen rotation lock.

  • TS1567 how do i enable my ipod

    how do i enable my ipod

    If screen shows disabled then
    Place the iOS device in Recovery Mode and then connect to your computer and restore via iTunes. The iPod will be erased.
    iOS: Wrong passcode results in red disabled screen        
    If recovery mode does not work try DFU mode.
      How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    Otherwise what is disabled?

  • HT201210 How do i enable my ipod?

    How do i enable my ipod touch?

    Place the iPod in Recovery mode and connect to your computer and restore via iTunes.
    This assumes your problem is:
    iOS: Wrong passcode results in red disabled screen

  • My ipod touch is not connecting to itunes and wont turn on all i get is the apple logo when i turn it on. how do i fix this?

    My ipod touch is not connecting to itunes and wont turn on all i get is the apple logo when i turn it on.
    How do I fix this?
    can anyone help?

    Start her:
    iOS: Not responding or does not turn on

  • I have a gen 3 ipod and can't get it into disk mode.  In itunes it does not have the option and I cant figure out how to do it on the ipod touch itself.  Any ideas?

    I have a gen 3 ipod and can't get it into disk mode.  In itunes it does not have the option and I cant figure out how to do it on the ipod touch itself.  Any ideas?

    Recovering your iTunes library from your iPod or iOS device: Apple Support Communities

  • HT1212 I just bought a new ipod touch from a friend but she didn't reset it and everytime that I try to rest it, it keeps saying "Ipod is disable, connect to Itunes" but I'am connected to Itunes and it also says put in correct passcode?? how do I reset it

    I just bought a new Ipod ios from a friend and she didn't reset it before she gave it to me and when I try to connect it to my laptop it keeps saying "Ipod is disable, connect to itunes"and it says to put in the correct passcode but I don't know what the passcode is and now I can't get ahold of my friend that sold it to me. So my question is: How do I reset the passcode and the Ipod touch so that I can sync it to my laptop and so that I can enjoy my new Ipod Touch?

    Place the iOS device in Recovery Mode and then connect to your computer and restore via iTunes. The iPod will be erased.
    iOS: Wrong passcode results in red disabled screen                         
    If recovery mode does not work try DFU mode.                        
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings        
    For how to restore:
    iTunes: Restoring iOS software
    To restore from backup see:
    iOS: How to back up     
    If you restore from iCloud backup the apps will be automatically downloaded. If you restore from iTunes backup the apps and music have to be in the iTunes library since synced media like apps and music are not included in the backup of the iOS device that iTunes makes.
    You can redownload most iTunes purchases by:
    Downloading past purchases from the App Store, iBookstore, and iTunes Store        

Maybe you are looking for

  • Lack of Contrast in Photos with Color Proof ON

    Hello, I never really worked with digital images inside Illustrator, so now that i have to prepare one for printing, I'm struggling with the following problem: All colors in CMYK; Document Color Mode - CMYK; and here we see that Color Proof results i

  • Set Tolerance Limits

    In this step, you specify the tolerance limits for each tolerance key for each company code. When processing an invoice, the R/3 System checks each item for variances between the invoice and the purchase order or goods receipt. The different types of

  • How can I get the Playlists in my iTunes Account on my Mac onto my iPhone?

    How can I get the Playlists in my iTunes Account on my Mac onto my iPhone? I have 5 or 6 different Playlists when I go to iTunes on my ac, but I have none on my iPhone. Why don't they synch?

  • MapViewer 9.0.4 Beta - queryWithinRectangle

    Hi, I am trying to use one of the MapViewer Beans' functions. So far so good. But as soon as I tried queryWithinRectangle I got an error message of java.sql.SQLException: ORA-00907: missing right parenthesis. I turned the log level to finest to see t

  • How to we run the command  Create Sdmkitjar

    Hii Ep Gurus             Pl let me know where do i run the command createsdnmkitjar Thanks In Advance Johny