I have an IPad2. I've received two different ideas on charging the battery. One person indicates I should let the battery run almost down before recharging; another person indicated I should keep it charged closer to 100% . What is the best process?
I have an IPad2. I've received two different ideas on charging the battery. One person indicates I should let the battery run almost down before recharging; another person indicated I should keep it charged closer to 100% . What is the best process for the best battery life over time?
I do exactly as Thomas Reed does. Always have from day one. Going on 15 months now and I get at least 10 hours of use out the battery every day. No matter how much juice is left on the device when I go to bed - I put the iPad on the charger - doesn't matter what the battery gauge says - I plug it in and let it charge all night.
Similar Messages
-
Why will my iPad 2 not recognize any iPod cables? I have tried two different cables in both the wall and in my laptop, but it will not register that it is receiving power, nor will the laptop recognize that they are connected.
Crizzo is right, the best way to charge is with the included power block. That said, the USB cords are interchangable as far as an of us know. (just not power bricks, iPhone and iPod bricks put out 5W of power, the iPad wants 10W and will always say 'not charging' if plugged into less power than it requires even though it will charge, just very slowly)
If you have tried to charge your iPad - with the iPad charger - with multiple cables and multiple computers and get no joy then it's time to head to the apple store and have them check it out. The 30 pin USB port can go bad - mine did - and it's a manufacturer's defect (unless there's any sort of obvious damage) and should be covered under the warranty; -
Hi, i bought a ipad2 3mos. ago and every time i full charge it to 100%, i only get around 4 to 6hrs. out of it! our friends from Apple said 9 to 10hrs. is there any way this could be remedy? hope you guys understand getting short handed by 3 to 4hrs.
It depends on how you are using your iPad. If you are streaming videos or music, or playing interactive games which require internet access a lot, you may not get a full 9 hours from your battery. In addition, have you closed unused apps? To do so, double tap your home button to bring up the Task Bar (most recently used apps). Hold your finger on any of the apps on the Task Bar until they all start to jiggle and you'll see a sign on the upper left corner of each app. Tough the to fully close them.
Finally, location services, push for mail and it's frequency can have a dramatic effect on battery usage. Turning them off, as well as not using your screen at 100% will help reduce battery usage. -
If I have set up my Mac with two different users, can I use two different Apple IDs on the same Mac?
Each user account may have its own Apple ID.
-
Can we have two different itunes accounts on the same mac?
Can we have two different itunes accounts on the same account? I am having trouble accessing mine from my sons.
Yes you can.
The fact you cannot access your son's library from your User account is intentional. User accounts on your Mac are nearly as separate from each other as your Macs are from anyone else's on the planet. To copy music from his account to yours, first copy it to the Shared folder, then log into your account and import the music. Then, you can erase it from Shared.
The Shared folder exists at /Users/Shared.
Read
iTunes: How to share music between different accounts on a single computer
OS X Mavericks: Set up users on your Mac -
I have "chatted" with customer service 5 different times. I was sent here. I have activated Photoshop Elements 9 on two different iMacs. They are both dead and I am unable to get it to activate on my newest computer. iMac. Can anybody help me?
Unfortunately, only adobe can help you with that, as most people here are just posters such as your self and don't work for adobe.
If you go here and use the Chat now button (bottom of page), they should get you up and running by resetting your activations.
http://helpx.adobe.com/x-productkb/policy-pricing/activation-deactivation-products.html -
Is there a way that you can have two different text fields (email, phone) that one at least one of them must be completed before submitting the form? Can it be done using javascript in the validation tab? if so, how?
Here is one solution:
// mouse up action for submit button;
function GetField(cName) {
// get field object for cName field with error checking;
var oField = this.getField(cName);
if(oField == null) app.alert("Error accessing field named " + cName + "\nPleae verigy field name, spelling and capitalizeation.", 1, 0);
return oField;
} // end GetField function;
var oPhone = GetField("phone");
oPhone.required = oPhone.value == oPhone.defaultValue;
var oEmail = GetField("email");
oEmail.required = oEmail.value == oEmail.defaultValue;
if(oPhone.required && oEmail.required) {
app.alert("Missing required fields.", 1, 0);
} else {
app.alert("Submitting form", 3, 0);
// additional code for submission; -
Hello. I have an iPad2, and iMovie software. My main problem, for the moment, is the length of the videos: I can´t create a video with more than 56 seconds. When I try, the app shuts off... Can anyone help me?
Sorry. We can't help you. It's no longer an iPhone. Apple won't touch it.
Take it to whoever replaced the screen and see if they can help you.
iPhones are not user servicable and Apple does not sell iPhone parts at all. I'd be surprised if you were actually able to back it up at this point. It sounds like it's completely borked. -
I have 2 copies of Firefox open (two different windows with lots of tabs), if I reboot can I restore both sessions? I am familiar with clicking history/ restore previous session, but don't want to reboot to let windows update to do it's thing unless I can restore both sessions.
If they are running different profiles, then yes.
-
I have a L7680 All in with two new print heads but the new cyan/magenta shows yellow monitor status. Ink status, cyan more than 50% and magenta is a 25% w/no low ink warnings... Just ran a clean print head again, print out looks good now but the status of the new cyan/magenta shows yellow monitor status. Is it time to buy another..When I purchased this printer it had to be replaced 3 times because of problems... Just a lemon?
thx for your help in advance...
JimCould you share a link to the page?
Seeing it in context and in our browsers is much easier to debug.
If not, make sure to run the validator here The W3C Markup Validation Service and clear out any problems. HTML errors, especially structural ones, will cause all kinds of display problems in various browsers/versions/platforms. -
Can we have two different logon screen for the Portal
Can we have two different logon screens for the Portal?
We should split the Logon application in two different applications:
Login # 1
should be read a DataSource.XML reading the Active Directory (Microsoft), to read-only the profiles from the AD, and block some IP address range.
Login # 2
should be read a DataSource.XML reading the Portal user only
Is this possible?Hello Developer,
Did you find an answer to this problem. I also have a similar issue at hand and am wondering if anybody has a solution for this.
Thanks, Akhilesh -
I have a IPad2 with a smartcover but it fits not in the IPad dock. Thus sombody Know if the IPad2 with smartcover fits in an IPad 1 dock?
No, it won't fit in the older dock either. You'll have to remove the Smart Cover to use either dock.
Regards. -
I have copied my music library from two different files from extewrnal hard drive into the Itunes folder. I tunes only recognizes some of the songs. I have reloaded 5 times and can't get intunes to recognize all my songs? HELP!
" When I did this, my library showed all the music I have "purchased" from itunes but did not have the music that I downloaded a long time ago through itunes from my old CDs."
Correct.
" How can I get that music to show up in my library now on my new computer? "
Copy it from your old computer or your backup copy of your old computer.
The sync is one way - computer to ipod. -
WD My Passport 1TB USB external drive randomly ejects from my iMac and MacBook Pro.
The drive is approximately 4 years old. When the drive is plugged in, I can see the data. It appears to be working properly. The only problem is that everyone of my Apple Machines are ejecting it. Several years ago, this drive connected to Mac machines with no problems. I have tried two separate USB cords. I have updated the firmware. I have tried it on my MacBook, two different Macbook Pro's, and my iMac.
All give the same result of random ejection of the drive and the error message of:
Disk Not Ejected Properly
Eject "1TB Passport HD" before disconnecting or turning......
Searching through the web, it seems this is an common/known problem. Does anyone know the solution?
Thanks,Send Apple feedback. They won't answer, but at least will know there is a problem. If enough people send feedback, it may get the problem solved sooner.
Feedback -
How does one set up two different iTunes accounts on the same computer so that they do not merge into one?
mparker402 wrote:
So, when the other iTunes account needs to be used, I should log out of Windows and have the other user log in under a different Windows account, correct?
M Parker,
Yes, since you are trying to keep things separate, that is exactly what you would do.
Maybe you are looking for
-
hi, I am trying to make a login program that connects to an access database with table 'PASSWORD' containing the username and the password. I have written the program but i could not continue as i am in fix with few errors which it is giving can anyo
-
Can someone please help .. I am trying to display a clob field that contains just random text but when i run my xml definition on concurrant manager xdodtexe the field is displayed as blank, Does anyone know how i can display this clob field on my re
-
Webi Intelligenct processing servers doesn't start. BO 4.1
BO 4.1 SP1 Patch 8. Cluster. OS: Linux RHEL 6.x On one of our environments WIPS (webi processing services) suddendly stopped working. We did no change. These are the errors I see every time I try to restart/start (just an excerpt) /build/psbuild/a41p
-
How to find out where used list of Table or T-code
Dear ABAP gurus I know many of you have done this several times. wish to find out which Transaction code INSERTs the data into the table IHPA. I did the where used list - SE11 ( for specific key work called INSERT ). Used the Table called D010TAB wh
-
URGENT: Replication of Session Data doesn't work properly
We have an envirnoment that consist of 2 physical machine, two wls-server instances on each of these, and two wls-clusters. One of the clusters have light workload, the other that are our problem have a heavy workload. We