What happens when the light goes off on an express airport router?

I was on the internet using a wireless connection with an express airport and suddenly I heard a sound and the light on the router went competelly off. I would like to know what happened. I unplugged the airport and plugged in again on another outlet but nothing happens. The airport has about 3 or 3.5 years.

It's not possible to know exactly what happened within the AirPort Express unless you carefully saw the case open along the seams to examine the internal components.
It's likely that something in the power supply section has failed since the device will not power up. Repairs...if possible.....would likely cost more than the cost of a replacment Express, but if you are handy with small electronics repairs, you could poke around a bit to take a look for something obvious.

Similar Messages

Lost my iPod, remotely locked it through iCloud. What happens when the battery goes out?

Hello!
I lost my Ipod, but managed to locate and lock it remotely through Find my iPod and iCloud. It was located once, but hasn't been located again in the last four days. I think the battery may have run out. What happens when the battery is charged and the iPod turned back on? Does the lock and everything else that can be controlled with Find my iPod still apply?
Thank you!

Yes, because when you remotely lock the iPod via Find my iPod, the lock code is set as the lock code that you would use to unlock the iPod if you used a passcode normally. As long as the iPod is still connected to your Apple ID, Find my iPod should work as log as the iPod is connected to wifi.

IPod switches off when the light goes off.

When I play music in the car on my Nano, I switch it on, using shuffle. After 40 seconds or so the light of the Nano goes off and the music switches off. I restart it sometimes 8 or 9 times. Suddenly it continues to play, also for a 3 hour drive and doesn't switch off again.
I can find no explanation for this. Any ideas?

Hi Jackie 1,
Since I'm not sure which iPod nano you have, you might want to start here:
iPod troubleshooting basics and service FAQ
http://support.apple.com/kb/ts1382
which has a link to more specific help at:
iPod Support
http://www.apple.com/support/ipod/
Selecting the iPod nano (7th generation) for example, then the troubleshooting section shows this article:
iPod nano (6th generation): Music stops when display turns off
http://support.apple.com/kb/TS3700
Verify that you have firmly connected the headphones to the headphone jack on your iPod nano. The cable should be flush against the iPod with no visible gap.
Hope that works for you,
Nubz

What happens when the screen goes white in the iphone?

My i phone 3G was working fine, suddenly the screen went white and stop working. I managed to turn it on again and see the it was almost out of battery, so I charged it all night long, however it is completely blank and I can't even turn it on. After the screen went white, It has not shown any signs of charging, nor working. Has any body experience something similar? Please help

My i phone 3G was working fine, suddenly the screen went white and stop working. I managed to turn it on again and see the it was almost out of battery, so I charged it all night long, however it is completely blank and I can't even turn it on. After the screen went white, It has not shown any signs of charging, nor working. Has any body experience something similar? Please help

My iPOD classic (last generation) shuts off when jostled--like what happens when the headphones come out. Any fix for this?

My iPOD class (last generation) shuts off when jostled--like what
happens when the headphones come out. Is there any fix for this?

I finally resolved my problem after spending way too much time on it. I simply handed my 160GB iPod to my husband to put his fav Stones & Beatles songs on and I went back to my 80GB Microsoft Zune which has never disappointed me.
After spending so much time trying to figure this out I did finally take it back to Apple Store who performed a diagnostic and found there was a problem with the device. They replaced it with a refurbished one which has similar issues. All I wanted to do was listen to my music. Was that too much to ask? So I am happy to be free of this problematic device. No more Apple for me!!

What happens when the CC trial ends? What happens when offline?

I need Lightroom to work offline on my laptop. What happens if I need to sign in to CC when there is no interned connection and what happens when the CC trial ends on both my laptop and desktop?

Thanks for answering. I have the standalone version of Lightroom 6 on my Windows 7 64 bit desktop. A number of times when have tried to open the program, the Adobe Application Manager has popped up requiring me to sign in even though I had not knowingly signed out. Lightroom will not launch unless I am signed in. Frequently when Lightroom launches, I see a "Server Busy" message telling me to "switch to the other program" without telling me which program to switch to. I have pinned the AAM to my notification area and have unchecked the "Show OS Notifications box" to see if the "Server Busy" message goes away. So far everything seems to be okay
Again, thanks for answering me

I have both the 250 gb high performance hard drive and a 1 ter byte hard drive. What happens when the 250 gb hardrive is full?

I have both the 250 gb high performance hard drive and a 1 ter byte hard drive. What happens when the 250 gb hardrive is full? This on Imac desktop

Never let a drive get more than 80% to 85% full.
AND keep 50-100 GB of free space on a startup drive to allow proper function of virtual memory in all OS X versions from 10.5x to current versions.
10.4x can get by with 20 GB of free space on the boot drive, but more is always better.
I try and keep all boot drives between 50 and 60% of capacity.
Beyond 60% and up to 90% capacity, seek times increase almost exponentially; performance suffers.

What happens when the multiply effect is applied to both the object and the graphic within?

Hi everyone,
I could really use some help with this...
I'm getting a booklet ready to be printed. Originally, half of the pages were to be printed on paper with a (physical) colour. For budget reasons however, I've now decided to print the paper colour, and have the content of the pages overprinted on the tint in the background, which I've applied to the pages in the background of an additional master page.
When I set the objects to multiply, they blend with the background colour, which is the effect I'm looking for, as there would be no 'paper white' on the pages that I want to appear as though printed on coloured paper.
There's something confusing me though; you can also set the graphic within the object frame to multiply. This makes the graphic appear darker, which I don't really understand, since there is no extra colour within the graphic that accounts for this. I've looked at the output in the resulting pdf, and it looks like it's not just an on-screen effect, but the extra amount of (in this case) yellow would also be visible in the printed result.
Does anyone have an explanation for this? Please see the graphic for a visual example.
Thanks in advance, kind regards
Robbin

Hi.
          Yes. There is a heartbeat mechanism between all cluster members so they detect when a
          member has left the cluster. The primary server recognizes when it's secondary server
          has failed, and then proceeds to search for another member of the cluster to make as
          it's new secondary.
          Regards,
          Michael
          David Whitehouse wrote:
          > I'm trying to figure out what happens when the server holding the replicated state
          > for an object fails.
          > Does the server with the primary object (or the replica-aware stub) recognize
          > the failure and select a new
          > server to hold the replicated state?
          >
          > For instance, Assume I have a cluster defined with three servers - 1,2,3 - with
          > an instance of object A on server 1
          > and the replicated state ino on server 2. What happens if server 2 fails? Is the
          > state now replicated to server 3?
          >
          > Thanks, David
          Michael Young
          Developer Relations Engineer
          BEA Support

What happens when the Time Machine drive is full?

I'm on my second iMac. My first one (G5, 1984) died, and I replaced it early 2010 with an Intel mac. The transition when exceedingly well largely due to Time Machine. I just hooked the Time Machine drive to the new system, and I was soon back up running!
My home folder has 70GB of data. The Macintosh drive has 105GB of data and 395GB free. The Time Machine drive has 220GB used and 30GB free.
1. What happens when the Time Machine drive is full?
2. Do I have control over what backups get deleted?
3. If lightning strikes twice, will I still be able to restore my Intel mac like my G5 mac, even if backups get deleted?
4. Is there anyway to control what backups/backup files get deleted?
5. Any other thoughts?
Thanks.

maxseven wrote:
i have deleted the time machine folders and they are now in my trash. when i try to secure empty my trash it will delete everything but the t/m folders. how do i delete them?
Do you mean all of them? The entire Backups.backupdb folder?
That's a large mess. First, even a normal delete will take a very long time, as there are probably hundreds of thousands, or even millions, of files. Your best bet by far is to simply erase them with Disk Utility -- that will only take a few moments. If your TM drive has a single partition, see #1 in [Formatting, Partitioning, Verifying, and Repairing Disks|http://web.me.com/pondini/AppleTips/DU.html]. If there are other partition(s) on the drive, see #2 there.
If not, and you only deleted some of the folders, you have a different, worse problem. Unfortunately, Apple doesn't do a very good job of warning folks: +*Never move, change, or delete anything in your backups via the Finder or Terminal.+*
You shouldn't have to delete backups at all, since Time Machine will do that automatically when the disk/partition gets full. But you can do it without harm via Time Machine. See #12 in [Time Machine - Frequently Asked Questions|http://web.me.com/pondini/Time_Machine/FAQ.html] (or use the link in *User Tips* at the top of this forum).
A normal delete will take a very long time, as there are probably tens or hundreds of thousands of items, each of which must be individually deleted. A secure delete will take much, much longer, as each deleted file must be overwritten with zeros.

What happens when the iphone app won't open on iphone 4?

what happens when the phone does not open and automatically shuts down the phone?

Basic troubleshooting from the User's Guide is reset, restart, restore (first from backup then as new). Try each of these in order until the issue is resolved.

TS3092 My Apple bluetooth wireless keyboard caps lock keeps changing so that sometimes the caps are on when the lights on and sometimes the caps are on when the light is off. How do I control this?

My caps lock keeps changing. That is, sometimes the caps are locked and the light is on the key and sometimes the caps are on when the light is off. It changes without my knowing it. Also when I hold the shift key down I hear a double click noise which changes the keys in some way. How do I get it to not change?

Try resetting SMC and NVRAP and then reboot.
http://support.apple.com/kb/HT3964
http://support.apple.com/kb/PH4405
Try booting the Recovery Partition. Power off, boot and then hold down the Command and R keys. Is the screen still black? If so it is not a software problem so take it in for diagnosis and repairs. Make a Genius Bar reservation http://www.apple.com/retail/geniusbar/ or find an Apple Authorized Service Provider https://locate.apple.com/country .
If you are running Mavericks try upgrading to 10.9.2. It has a fix for black screen problems.

TS3694 What happens when the iPhone needs an activation and it doesn't respond? Then it asks me to restore it but due to an unknown error (-1) the iPhone can't be restored.

What happens when the iPhone needs an activation and it doesn't respond? Then it asks me to restore it but due to an unknown error (-1) the iPhone can't be restored.

Thank you for your response. However, I have done that plenty of times and each time I try to restore my phone, it extracts the software and then when it says restoring with the loading bar, an error message comes up saying an unknown error has occurred.

What happens when the computer get too full of e-mails? Will it automatically start deleting ... or give you some kind of warning?? I never delete personal mail right away since I might want to refer back to it, and then the first thing I know, I've got

What happens when the computer get too full of e-mails? Will it automatically start deleting ... or give you some kind of warning?? I never delete personal mail right away since I might want to refer back to it, and then the first thing I know, I've got a big backlog.

It will not automatically delete any emails; you will need to do that. You may suffer performance issues in Mail if you let your mailboxes become too bloated. And, aside from Mail, the files take up a lot of room are photos, videos, and music, so you might want to watch those - every once in a while, check how much hard drive space you have and make sure you empty the trash regularly. Checking your hard drive space: highlight your Macintosh HD icon on the desktop; hit Command + I and check the total capacity, and how much is left.

What happen when the bill from buying iPad is missing do they need it if something happen to iPad or not... (urgent)

What happen when the bill/warranty is missing...do they need it

Where did you buy the iPad? (What store, and was it in person or online?)
Matt

I want to know what happens when the iphone heats up by itself? Do i need to bring it in?

i want to know what happens when the iphone heats up by itself? Do i need to bring it in?

Basic troubleshooting is covered in the User's Guide, you should read and follow the steps provided.

What happens when the light goes off on an express airport router?

Similar Messages

Maybe you are looking for