HT5361 Mac OS X Mail 4.6 sends emails that other email clients don't recognize as attachments, but as embedded pictures. Mail 6.6 does not have this problem.
My Mac OS X (with 10.6.8 software) Mail 4.6 sends emails that other email clients don’t recognize as attachments, but as embedded pictures. When I receive emails from others, I do not see whole image either. I did change "rich text" to "plain text" in message format - no results.
My daughter has Mac (10.8.5) with Mail 6.6, which does not have this problem. Can I install 6.6 instead of 4.6 or do you know other fix?
Help, please?
Thanks,
Andrew
I've been having the same problem now for several months (at least 3-4 if not more). And the frequency of Mail quitting is increasing, several times in a few hours. And as with you, no particular message pops up before hand or not even the beach-ball spinning first and then quitting.
I too have been sending Apple the crash reports. However, I have not contacted Apple Support yet. Hoping to find the answer in this forum, but again, no luck.
If you have found a solution since then, please advise. Or if anyone else out there knows of this issue and can help, that would be greatly appreciated.
Similar Messages
-
My new macbook pro (Mountain Lion 10.8.1) will not log into my 1and1 outgoing mail server. ( It will receive mail - but does not send)My old Snow Leopard macbook does not have the same problem ( server settings etc. are identical) . Apple Support say its a 1and1 problem , 1and1 say it is an operating System prob - I have tried changing port numbers.
My eyes just glazed over...Please in the future break down each of your issues with paragraphs separated by two carriage returns. It would be much easier when trying to address your issues.
Go to Apple menu -> System Preferences -> Keyboard and Mouse -> Mouse
And edit your mouse settings to do what you want it to do.
Secondly, this is not the place to vent. If you have a complaint, there is:
http://www.apple.com/feedback/
or http://www.apple.com/contact/
We are just end users here helping other end users.
Third, from my understanding, it would appear you are concerned about the noise the hard drive makes when it falls asleep? Why not put your machine in screen saver mode instead? Apple menu -> System Preferences -> Energy Saver turn off all Energy Saver settings, or set them to run Never.
Fourth, if your machine was purchased just a few days ago, you may still be able to get an exchange from the store, quicker than you can get a repair done. You may want to look into that possibility.
Fifth, it does appear you found the Logic forum. I would persist in asking there how to solve your technical issue with Logic regarding the audio. It may be you don't have to do anything special to the hard drive. Remember audio can be transmitted by wire, avoiding ambient sounds.
Good luck! -
Until recently I was able to send images in the body of my Yahoo emails. Now, I am getting the message "This message has been truncated", and the email does not go through. I do not have this problem using IE. Could you please help? Thank you.
Try this -> http://support.apple.com/kb/TA38632?viewlocale=en_US
-
I have a mac OS X and when I close it and reopen my screen opens and then shuts down for an instant and then reopens. Does anyone have this occur?? I have shutdown and restarted often.
A Safe Mode boot might help ..
Startup your Mac in Safe Mode
A Safe Mode boot takes much longer than a normal boot so be patient.
Once you are in Safe Mode, click Restart from the Apple () menu.
See if the problem persists. -
How do I send files from my IMAC via bluetooth to my new Ipad? They will not "pair" but they are connected and discoverable. I send a file from Imac snow leopard OS X 10.6 to the ipadusing bluetooth, but the failure message says the ipad does not have the necessary services. What are these? Do I neeed to have iphoto and ms word to send pix and .doc files?
File Sharing over Bluetooth is not a feature of iOS devices. iOS does not include the required Bluetooth profiles to allow this. You cannot add this feature, so you may as well stop trying.
-
Clicking on "Compose", "Reply" or "Forward" in Yahoo Mail does not do anything. I troubleshot the problem with Yahoo directly and they feel that the issue is with Mozilla Firefox. I do not have this issue when using Internet Explorer. Other buttons in Yahoo Mail, such as "Delete" and "Move" do work.
I had the same problem and discovered it went away when I disabled the AVG Do Not Track extension on firefox.
-
When I copy a URL and go to paste it in an e-mail, it won't paste. Some other box opens. I can paste the URL in the subject line, but doesn't hyperlink it. (blue) When using Internet Explorer, I don't have this problem. I'm new to FF with a new computer.
Did you try to use the keyboard to paste?
* Copy: Ctrl+C or Ctrl+Insert
* Paste: Ctrl+V or Shift+Insert
* Cut: Ctrl+X or Shift+Delete
Just above the textarea that you use to enter the message text on the "Compose New Mail page" there is usually a button bar with buttons to add text formatting like Bold and Italic.<br />
That toolbar may also have a button to turn a text link into a clickable hyperlink (look for a chain like button).<br />
You can select the text and click that button to turn the link into a clickable hyperlink.<br />
If you can't find the button then hover them all to check the tooltip of each (e.g. Insert hyperlink).<br /> -
When a external application tries to send an email via Thunderbird i get an error message, roughly translated it says: "Something went wrong with PostMail, error number 2"
My collegues have the same setup, they have no problem what so ever when sending mail via this way. Any tips would be most welcome. Thanks for your time.Continue at your other thread.
https://support.mozilla.org/en-US/questions/1053959 -
When I click on Yahoo in FF, the page is slow to load. When it does, the e-mail is even slower to load. When it does load and I click on an e-mail, the e-mail does not open. Any suggestions? If I delete FF and reinstall it, will I lose all the information in FF (e.g. Book marks or preferences)? Thanks in advance for your help.
HI afirst,
Just in case [[Back up and restore information in Firefox profiles]], but before that you can clear the cache for a specific site in the about:permissions page.
Select Yahoo mail on this page and forget the site. This will remove cookies and active logins for mail. Please then restart Firefox and relogin to Yahoo mail.
If there are any other questions, happy to help. -
How do i get itunes 10.5 to my new iphone 4s? I have downloaded it to my mac, but when i open my itunes there is no device loacated on the left hand side of my screen? please help.
Which Mac OS X do you have installed?
With iTunes open, from the menu bar click iTunes > About iTunes
The latest version is 10.5.2 -
Have been using the Mac Pro since 2008. Changed to a Radeon 4870 card early this year. Everything was fine.
Running an old KDS monitor from minidisplay port to VGA and a 1400x1050 projector from DVI out. Have used the
two mirrored the entire time with no trouble.
The old kDS monitor looked like it was starting to go bad so I got another monitor. Don't have much room
so it's a 14inchwith widescreen 1328x768 display. Hooked that to minidisplay port as it only has a VGA input.
Immediately the LCD display took over and restricted the output to the projector.
If I turn off mirroring, I can get projector back to normal. But this makes running programs a lot more difficult.
It worked fine with mirroring on before the monitor change. Except going back to old monitor,
now it is affecting things. I pull up display preferences. If the displays are mirrored, even setting the projector
to 1400x1050, it says "usuable resolution 1280x1024." It didn't use to do this at all.
Tried reseting NVRAM - no result.
Any suggestions would be helpful. Just looking at the image on the projector, I don't see any difference from
before.UPDATE:
As noted in the first post, both of these newer USB DAC work fine at 24/96 on my wife's iMac, so it's clear that they didn't both become defective when I connected them to the Macbook Pro at the same time.
Resetting the Macbook Pro PRAM didn't help, so I removed the hard shell laptop case to get to the battery and remove it, then reset the SMC. After that I could use the original DAC at 24/96 again, but only IF it was plugged into the rear USB port. If I plugged it into the front USB port then the sound was garbled and filled with noise. This was a vast improvement over no sound at all.
Then I switched to the replacement/updated DAC, but I got no sound at all from either USB port at any bit-rate. And returning to the original DAC again now results in no sound again.
Sigh... I will reset the PRAM and SMC again, and see how far I can get with this. I'd still love some help. Thanks! -
firefox wont update the mailbox to inform you you have new mail.
preivious version was ok.
all settings are correct .
tried starting new and still the sameSorry, that "mail" thing isn't a standard part of Firefox. Seek support from the developer of the add-on you have installed that added that feature to Firefox. Support contact information should be on the download page for that extension.
-
When I send a group txt and one of the reciepients replies it creates a new message. How do I keep all the replies in the same message?
If you think getting your web pages to appear OK in all the major browsers is tricky then dealing with email clients is way worse. There are so many of them.
If you want to bulk email yourself, there are apps for it and their templates will work in most cases...
http://www.iwebformusicians.com/Website-Email-Marketing/EBlast.html
This one will create the form, database and send out the emails...
http://www.iwebformusicians.com/Website-Email-Marketing/MailShoot.html
The alternative is to use a marketing service if your business can justify the cost. Their templates are tested in all the common email clients...
http://www.iwebformusicians.com/Website-Email-Marketing/Email-Marketing-Service. html
"I may receive some form of compensation, financial or otherwise, from my recommendation or link." -
When filling out forms or needing to give my g-mail address on Firefox, my address is always rejected. It comes up as an non valid address. I then have to switch to Safari to complete all forms. :(
You don't download apps from the iTunes app store with Safari.
-
I then have to reboot the computer. Now I generally use Safari, which is much smaller and has fewer options. If this problem is as wide spread as other sites indicate, why hasn't Firefox fixed it?
Start Firefox in <u>[[Safe Mode]]</u> to check if one of the extensions or if hardware acceleration is causing the problem (switch to the DEFAULT theme: Firefox (Tools) > Add-ons > Appearance/Themes).
*Don't make any changes on the Safe mode start window.
*https://support.mozilla.org/kb/Safe+Mode
See:
*http://kb.mozillazine.org/Firefox_crashes
*https://support.mozilla.org/kb/Firefox+crashes
Maybe you are looking for
-
Application Registration Question
I have an htmldb application which was successfully implemented using my old PC. I've just unpacked by new PC and now when I attempt to run my htmldb application I am getting the following error. Can anyone help me correct this? Thanks Error in porta
-
How do I change the default folder that opens when uploading a file to the internet from my mac? (at the moment it automatically defaults to 'Downloads' folder) For example... I am on a webiste and wish to upload a photo. I click on select file on th
-
Problem with file.listFiles() of File class??
Hi all friends, Iam facing with one peculiar problem,Iam using [file.listfiles()] method of File class in my program and this method of file class introduced in Java2.Now when Iam runing on Mac OS classic(8 to 9)[it is my client requirement they can'
-
Networksetup ARD Unix command - Joining AirPort loop
Hi, I'm attempting to mass-set a bunch of iBooks to join a specific AirPort network with a WEP key. My understanding is with ARD, I can run the following unix command en masse: 808:/ root# /System/Library/CoreServices/RemoteManagement/ARDAgent.app/Co
-
CE Trial Visual Composer Missing Kit
Hi, We have installed the CE Trial 7.1 and everything worked well. But when we try to start the Visual Composer we got 271 errors in the "Layout Editor Kit" it seems that something is missing. Has anyone received this error too? What have you done? B