Please can some one tell me how I can remove an ex boyfriends account from my iPad ? I want it update my updates but his email address always comes up and not mine

Press and hold any of the apps on your iPad's homescreen and after a couple of seconds or so they should start to shake. Then press the 'x' in the top left corner to delete the ones that you don't want, and when you've finished deleting press the home button so as to stop the shaking. If you don't get the 'x' on any of the apps that you've downloaded then check that Settings > General > Restrictions > Deleting Apps isn't set 'off'.
Note that deleting an app will delete all of its content as well

Similar Messages

Please please can some one tell me how do you charge ur ipad with ur laptop. it doesn't chage wen I put use the wire. only charges when I plug the socket in.

please please can some one tell me how do you charge ur ipad with ur laptop. it doesn't chage wen I put use the wire. only charges when I plug the socket in. Iv never used an ipad b4 so don't really know much. Hope some one knowz.

The quickest way (and really the only way) to charge your iPad is with the included 10W or 12W USB Power Adapter. iPad will also charge, although more slowly, when attached to a computer with a high-power USB port (many recent Mac computers) or with an iPhone Power Adapter (5W). When attached to a computer via a standard USB port (2.5W, most PCs or older Mac computers) iPad will charge very slowly (but iPad indicates not charging). Make sure your computer is on while charging iPad via USB. If iPad is connected to a computer that’s turned off or is in sleep or standby mode, the iPad battery will continue to drain.
Apple recommends that once a month you let the iPad fully discharge & then recharge to 100%.
How to Calibrate Your Mac, iPhone, or iPad Battery
http://www.macblend.com/how-to-calibrate-your-mac-iphone-or-ipad-battery/
At this link http://www.tomshardware.com/reviews/galaxy-tab-android-tablet,3014-11.html , tests show that the iPad 2 battery (25 watt-hours) will charge to 90% in 3 hours 1 minute. It will charge to 100% in 4 hours 2 minutes. The new iPad has a larger capacity battery (42 watt-hours), so using the 10W charger will obviously take longer. If you are using your iPad while charging, it will take even longer. It's best to turn your new iPad OFF and charge over night. Also look at The iPad's charging challenge explained http://www.macworld.com/article/1150356/ipadcharging.html
Also, if you have a 3rd generation iPad, look at
Apple: iPad Battery Nothing to Get Charged Up About
http://allthingsd.com/20120327/apple-ipad-battery-nothing-to-get-charged-up-abou t/
Apple Explains New iPad's Continued Charging Beyond 100% Battery Level
http://www.macrumors.com/2012/03/27/apple-explains-new-ipads-continued-charging- beyond-100-battery-level/
New iPad Takes Much Longer to Charge Than iPad 2
http://www.iphonehacks.com/2012/03/new-ipad-takes-much-longer-to-charge-than-ipa d-2.html
Apple Batteries - iPad http://www.apple.com/batteries/ipad.html
Extend iPad Battery Life (Look at pjl123 comment)
https://discussions.apple.com/thread/3921324?tstart=30
New iPad Slow to Recharge, Barely Charges During Use
http://www.pcworld.com/article/252326/new_ipad_slow_to_recharge_barely_charges_d uring_use.html
Tips About Charging for New iPad 3
http://goodscool-electronics.blogspot.com/2012/04/tips-about-charging-for-new-ip ad-3.html
How to Save and Prolong the battery life of your new ipad
https://discussions.apple.com/thread/4480944?tstart=0
Prolong battery lifespan for iPad / iPad 2 / iPad 3: charging tips
http://thehowto.wikidot.com/prolong-battery-lifespan-for-ipad
iPhone, iPod, Using the iPad Charger
http://support.apple.com/kb/HT4327
Install and use Battery Doctor HD
http://itunes.apple.com/tw/app/battery-doctor-hd/id459702901?mt=8
To Extend a Device’s Battery Life, Get to Know It Better
http://tinyurl.com/b67c7xz
iPad Battery Replacement
http://www.apple.com/batteries/replacements.html
In rare instances when using the Camera Connection Kit, you may notice that iPad does not charge after using the Camera Connection Kit. Disconnecting and reconnecting the iPad from the charger will resolve this issue.
 Cheers, Tom

I got error 3295 when doing software update to 4.3.4 on my iphone4.. can some one tell me how skip this error?? I'm new to apple products..!?

I got error 3295 when doing software update to 4.3.4 on my iphone4.. can some one tell me how skip this error?? I'm new to apple products..!

anyone????

God morning can some one tell me how to delete app from the iphone4?

cAN SOME ONE TELL ME HOW TO DELETE APP FORM THE IPHONE4??

If it is an App you have Downloaded and there is no X when it Wiggles...
Perhaps this Assistant can Help you:
http://www.apple.com/support/iphone/assistant/application/

Can some body tell me how i can get the music i put on my old ipod to my new ipod

can someone tell me how i can get the music i put on my ipod from my music collection to my new ipod please

Import the music into your iTunes libary
To import music into your iTunes library on the computer go to iTunes>Help>iTunes Help>Add items to iTunes and follow the instructions
And then sync to your iPod
iTunes: Syncing media content to iOS devices and iPod

Can any one tell me how to change OS of Lenovo T 500 from Vista to XP

Hello,
Thank you in advance for your help.
I have just bought a T500 from lenovo, I just want to use Vista instead of XP. I do not mind using both of them but I surely want the XP. Is there any way to do it.
Can any one help
Regards,
Faisal
Message Edited by ffaisalb on 10-15-2008 03:47 AM

SELECT COUNT (1)
FROM SYSADM.OHR_PERS_CURR PC
, SYSADM.OHR_JOB_CURR JC
WHERE PC.EMPL_ID = JC.EMPL_ID
AND EXISTS (
SELECT null
FROM SYSADM.HU_SCRTY_JOB HS, ODSHR.OHR_SCRTY_USER_CFG OS
WHERE HS.HU_SCRTY_CFG_ID = OS.HU_SCRTY_CFG_ID
AND OS.DB_LOGIN = USER
AND HS.EMPL_ID = JS.EMPL_ID AND HS.EMPL_RCD = JC.EMPL_RCD)
But why ?
Rgds.

Can some one tell me how to get this imessage (i think thats what it is they are in blue) off my flippin phone because they are going to other ppl as well as ppl intended and i keep recieving msgs from randoms grrr please help

i recently went from a iphone 3 to a 4 and when i send messages they are going to other ppl as well as the ppl they are intended for this did happen once with the iphone 3 but now its all the time i have been in settings but it's not high lighted so dont know how to get the **** thing off so i can just send normal msgs, please advise

i didnt have any on but i disabled it then enabled lol dunno how but i have done it i think thanks for your help there is tooooo many settings on the phone for me i was ok with the 3GS just flicking through settings again and my face time as dissapeared lol any ideas

When I open my safari it will no longer go directly to my yahoo home page, says..Safari cannot open page because too many redirects occurred, Can some one tell me how to fix this, I have tried bookmark but won't open from there.

when I open my safari it will no longer go directly to my yahoo home page, says.. Safari cannot open page because too many redirects accured, how do I fix this.

Clear the cache in Safari and have another try
Cheers!

Can any one tell me how to pull out a sealed management pack key token

Hi All,
Can any one tell me how to pull out a sealed management pack key token. I want to add dependencies to a management pointing towards a sealed management pack for which a "management pack key token" is required which i need to add in the XML File
of the management pack. Can any one please tell me how to fetch that information.

Hi Gautam,
If you need to reference one management pack in another management pack, then you will need to know what the public key token is. When referencing a Microsoft management pack, it is easy as Microsoft always have the same key which is 31bf3856ad364e35 but
if you need publickey token for other then MS management pack then you can simply run a SQL querry in your OperationManagerDB.
select * from dbo.ManagementPack where MPName = 'Type your ManagementPackID'
ManagementPackID will be present of the properties of the Management Pack.
In that case the management pack should be imported in your SCOM environment.
And you will get Public key token only for sealed Management packs not for unsealed.

Can any one tell me how to change the current row header in FB1LN tcode

Hi,
can any one tell me how to change the current row header in FB1LN tcode.
I want to show input date also in the layout.
Regards
Mave

Hi
I know two ways:
- transaction obvu: here you can insert new fields, but only if these fields are included in certain table (like BKPF, BSEG, BSIS.....
- if your field isn't included in those table, you have to modify the structure RFPOS and manage it in the BTE 1650. After updating RFPOS you have to run the program RFPOSXEXTEND to update the structure RFPOSXEXT.
Max

HT1338 i have apps to be updated but when i try to update them a message pops out saying "You have updates for other accounts, please sigh in with the other id". Can some one help me how can i still update the same with the new apple id ive created.

i have apps to be updated but when i try to update them a message pops out saying "You have updates for other accounts, please sigh in with the other id". Can some one help me how can i still update the same with the new apple id ive created. As i dont have the access to the earlier id anymore.

You cannot. The apps are assigned to that Apple ID and there is nothing you can do to change that. You could choose to download them again with the new Apple ID, any paid apps will need to be purchased again.
Hope that helps.

Can any one tell me how to include the company logo and some poictures into the Teststand report

1. Can any one tell me how to include the company logo and some pictures into the Teststand report?
2. How to include the waveforms into the report?

http://zone.ni.com/devzone/cda/epd/p/id/3619
jigg
CTA, CLA
teststandhelp.com
~Will work for kudos and/or BBQ~

Can any one tell me how to talk between two controller.....

Hi,
Can any one tell me how to talk between two controller.....
Help will be awarded.
Regards,
Gurprit Bhatia

Hi Gurpit,
If you want to share data between 2 controllers then you can simply do that by providing a data link between the controllers in your data modeler.
If you want to use some methods of one controller in another then you can do it using
wdThis.wdget<controller name>().<method name>();
If your question is something different than this then please elaborate your requirement.
Regards,
Murtuza

I am switchning from iphone 3gs to iphone 4. can some one guide me how to transfer all my data to iphone 4?

i am switching from iphone 3gs to iphone 4. can some one guide me how to transfer all my data to iphone 4?
i have a back up in my itunes account .can anyone suggest please ????

http://support.apple.com/kb/ht2109

Can any one tell me how to send one PO to mutilple mail ids in vendor maste

Hi Experts,
Can any one tell me how to send one PO as a mail to multiple vendors who are all maintained in my vendor master record
Suppose I have 3 mail ids in my Vendor master record and I created a PO with that vendor, will that PO goes to all the three mail ids maintained in the vendor master record or only to one ?
Inorder to send to multiple mail ids, Do we need to do any configure any thing in SPRO settings functionally, if so where we have to maintain?
Or shall an Abaper needs to maintain a code for that.?
Please suggest me, I would appreciate your feed back.
Best Regards,
Sairam

Go to XK02 enter the vendor code
go to the communication tab
Email will be there press the ---> button
you can add many Emails in the list.
Please ensure that the message output is configured by
the SAP BASIS team
No need of any configuration
G.Ganesh Kumar

Please can some one tell me how I can remove an ex boyfriends account from my iPad ? I want it update my updates but his email address always comes up and not mine

Similar Messages

Maybe you are looking for