SBS 2011 VM and Server 2012 R2 Hyper-V host. After rebuilding the host image, no email is received, EMC states "You don't have sufficient permissions to view this data" when looking at organization config. Server config not shown on EMC.

Question

Hyper-V Host Server 2012 R2 x64 drive c:
All VMs, including SBS 2011 Standard x64 are on drive d:
I replaced my motherboard and defined a Marvell RAID 1 Mirror for my boot drive C:.  My drive D: containing all of my Hyper V machines remained untouched since the new MB had Intel Matrix Controller with RAID 5, as did the old MB.
Since the C: drives are a few bytes smaller after configured as a RAID 1, I was unable to restore drive C from the image copy, so I rebuilt a new Hyper-V Host identical as possible using Server 2012 R2 x64.  I had to redefine the Hyper-V machines on
the host, and the 1st time I brought it all (host and VMs) I had to reconfigure the NICs due to new MAC addresses, and verifying SBS 2011 DNS and DHCP for all physical and Hyper-V machines. Otherwise my Hyper-V SBS 2011 x(64) wasn't touched.
Now the SBS Exchange 2010 is not receiving mail.  In the Exchange Management Console clicking on the Organization config gives me a highlighted error "You don't have sufficient permissions to view this data".  The Server
Config is no longer on the EMC.  The Recipient Config looks fine.
Outlook 2013 x64 connects to the Exchange Server, but no new mail appeared.  There were just a few older messages that came in since the last time I opened Outlook.  My public DNS on GoDaddy was not changed.  I did not change sending mail
through my ISP Sonic.net.  The SBS internal DNS doesn't have an MX record, but I'm not sure it ever did since my GoDaddy public DNS has an MX record.
I tried restoring to an earlier Image Copy, but that made no difference.  I'm using the Windows Backup from SBS 2011 for my daily image copy backups.
- Michael Faklis

Answer 1

Hi Michael,
à
After more research and running the Best Practices report from the EMC, I am missing a slew of ManagementRolesAndRoleGroups from the RBAC container.
Based on your description, it seems that you have find the cause of this issue. On current situation, I still
suggest that you should run
SBS 2011 BPA and then check if can find some relevant errors. Just for a confirmation.
Meanwhile, please refer to following articles and check if can help you.
Apply
missing Exchange 2010 RBAC Management Roles and Policies
RBAC Manager
(Exchange 2010 SP2)
Hope this helps.
Best regards,
Justin Gu