Sim not recognize after 3.0

im with fido in canada, phone is working fine with 3.0 but cant sync to itunes , it says "the sim card in this iphone does not appear to be supported" , everythin worked fine hours ago until the 3.0 update
please help me!

I am having the same problem on a Rogers iPhone 3G. iTunes only shows the sim incompatibility error when connected. The only thing I thought of was that I updated and am currently using the iPhone outside of Canada, and assumed the error might be related to that.

Similar Messages

  • My phone says SIM not valid after ios 5 update, Why and how do I fix it?

    Why does my iPhone 4 say SIM not valid after I updated to ios 5? Also, is there anything I can do to fix it?

    Sounds like your phone was software unlocked, or hacked/jailbroken, to work with any carrier. Updating the phone restored the original carrier lock. All you can do now is contact the carrier it is locked to and see if they have an unlocking policy.
    Good luck.

  • Sim Not Provisioned after doing iOS6 update

    I recently restored my iPhone 3GS to factory settings and updated my phone to iOS6. All my data/apps/etc came over just fine after syncing but now my phone shows No Service and 'SIM Not Provisioned' when I went into Settings > General > About > Network. It was working normally previously. Data/3G was working just fine. Not sure If I need to contact AT&T to get them to adjust some account settings or verify somehow but it's odd that It'd do that after the update when I had done nothing different with the phone. I've gone though the standard troubleshooting (restarting, removing sim & reinserting, resetting network settings,etc) Any help/insite/suggestions would be appreciated. 

    It's possible the SIM failed during the update. It's not common, but it's not unheard of. Stop in an AT&T store and get a replacement SIM.

  • SIM not Valid after factory reset using a non-US SIM card

    I bought an unlocked iPhone 5 at a US apple store.  It worked fine for two years until factory-resetting it.  Now, during the setup process I get a "SIM not valid" message. I tried an iTunes restore to no avail.  I called Apple support and was escalated to two different "experts".  I got two very different answers:
    Expert 1: an unlocked iPhone can be used internationally but can only go through a factory reset with a US SIM card.  Since you don't have one you will have to come back to the US, get an American SIM card, finish the setup process and then you can get back to using it internationally.  There is nothing we can do here at Apple to bypass this procedure.
    Expert 2: Our database shows that your phone is indeed unlocked and is available for use with an Israeli carrier (which is the carrier I am using now).  Either the SIM card is defective or there is a problem with the hardware of the phone.  Please ask for a replacement SIM card from your carrier and if this does not solve the problem you can send it to the US for repair. The repair will be costly.
    Obviously neither of them is solving my problem.  Is there another solution?  Is it time to make the switch to an Android device?

    Sorry if you have already tried this
    Any chance you can ask for a different / new SIM from your carrier?
    or even better see if one of your friends / family has a working phone with a nano SIM
    Try that temporarily in your phone
    If it works = corrupt SIM most likely
    If it does not - please let us know and we can brainstorm further

  • Jawbone UP band not recognize after lollipop upgrade

    Hi all !
    Since the upgrade of my xperia Z1 in lollipop version, my jawbone UP band is not recognize anymore. I have a message like "headset unsupported'.
    Everything went well before the upgrade.
    Anyone had the same issue and knows how to solve it ?
    I wrote a message to Sony support.
    Have a nice day

    An example
    http://forums.jawbone.com/t5/TROUBLESHOOTING-UP24/Android-5-0-Lollipop-issues-and-Up24/td-p/150211
    "I'd rather be hated for who I am, than loved for who I am not." Kurt Cobain (1967-1994)

  • Sim not valid after update to IOS 8.1.1

    Hello,
    I have an iPhone 5 and I have update it yesterday from iOS 6 to iOS 8.1.1 and after update I can`t activate it.
    My iPhone has been purchased from SFR France and has been sim locked by SFR.
    I have official unlock it last month and it worked well on Orange Romania until yesterday.
    On all servers it look like unlocked but I can`t activate it.
    iTunes say that sim card is not compatible.
    Now It have iOS 8.1.
    Please help me.

    I haven't contacted SFR directly, I have used a service like "apple official unlock. com/ apple-official-imei-iphone-unlock" to do that and I verified the simlock status on other site like this. I think that site contacted SFR for unlock.
    The iPhone has been unlocked after I connected it to iTunes and I think that is official unlocked.

  • External Hard Drive not recognize after not ejecting properly

    i have Macbook Pro 2011 8GB RAM, 1 TB Hard drive OSX Mavrick. i recently ejected my back up drive but it was not a properly ejected now when i plug in the computer it doesnt come up as hard drive. it shows up in the disk utlity but it doesnt open any one know how to solve this issue please its my backup drive and i dont want to loose m data
    Thanks

    1. press command + space (or click on your spotlight search button near the top right corner)
    2. Search and Open Disk Utility
    3. Plug in your external drive
    4. Click on the drive in the left panel
    5. Click the repair button near the bottom right of the window
    6. Wait for the disk to be verified and repaired
    7. Eject the external drive
    8. Unplug and replug the drive back in and then see if it is then accessible.
    9. If still not accessible repeat steps 2-4 then hit the mount button in the toolbar of the window. It will be in between the burn and the eject button.
    Regards
    Noahwhite2014

  • Sim not active after changing to 4G

    This new 4G sim is active with a temporary number but I need my old number working. The old sim still works songs been using that. This is taking too long. What should I do EE?

    I am having the same issue it should take up to 24 hours. Now 48 hours and still waiting for it to migrate over. Very annoying.

  • Turn iPhone 4s into iPod Touch - will not recognize sim card

    My iPhone 4s will no longer recognize a sim card. I didn't trade it in b/c the Apple salesperson said I could still use it as an iPod touch. (I want to use it at home to play Pandora/iTunes/Sirius over wifi to bluetooth speaker.) The salesperson did not warn me not to reset the phone.
    After completing the reset, it will not allow me get past the "no sim card" message. How can I bypass this in order to use the phone as an iPod?

    Yes - I took it to ATT and they put in 2 different new sim cards. It will not recognize them at all. I took it to Apple and they said it was hardware (though after reading other discussions here, I am more suspicious of iOS 7).
    They offered a trade in but I asked if I could still use it as an iPod touch. The genius dude said yes, but did not not tell me I could never reset it. Very frustrated.

  • Iphone 5s will not recognize sim card

    After updating to 8.1.1 iphone will not recognize sim card. Gives no service. Did reset all from the iphone since I couldn't use itune. Will appreciate assistance. This thing is driving me crazy

    Hello hnajee,
    The article linked below details a number of additional troubleshooting steps that may help restore your iPhone's ability to connect to your carrier's network.
    If you see No Service in the status bar of your iPhone or iPad
    http://support.apple.com/en-us/TS4429
    Cheers,
    Allen

  • My 5S does not recognize the SIM card although the card is recognized by another phone

    I bought a new SIM card in Brazil for my 5S after it was blocked because I had lost it for about six weeks.
    The phone did not recognize the SIM card. Thinking it was a hardware problem i took it to an Apple store in the US where the assistant showed that her sim card was recognized by my phone. However my SIM card continued not to work in Brazil. A colleague's SIM will not work either in my phone but my SIM card will work in her phone. What could be the problem?

    What is the EXACT message you get?

  • I have a Sony radio in my car.   With IOS  4 on my IPhone I could use the docking plug to the usb input on the radio and stream ESPN radio or pandora to the radio.  After upgrading to IOS 5 on the phone the Sony radio will not recognize the phone .  Any t

    I have a Sony radio in my car.   With IOS  4 on my IPhone I could use the docking plug to the usb input on the radio and stream ESPN radio or pandora to the radio.  After upgrading to IOS 5 on the phone the Sony radio will not recognize the phone .  Any thoughts.

    I am reading on this site about the error I am getting and it wants me to change some files that I am not comfortable messing with. Mainly because it is like a foreign language. Will the store do this for me or tell me if it is neccessary?

  • After I updated lion to 10.7.4, app store does not recognize my ID APPLE and it unable to connect me to app store in order to update/download apps? What have I to do? I have the same problem with mac mini e mac book air. Please help me!

    After I updated lion to 10.7.4, app store does not recognize my ID APPLE and it unable to connect me to app store in order to update/download apps? What have I to do? I have the same problem with mac mini e mac book air. Please help me!

    Your advice did not help me. I also installed 10.7.4 combo but the situation is the same.
    my internet connection is ok, mail is ok, but app store after 3 resets does not recognize my ID and it says "connection is not possible". Why? I have the same problem in both my mac mini late 2009 and mac book air 2010? Is it a problem of 10.7.4 update? I have to solve this problem and how can i return to 10.7.3 if my last backup was not with 10.7.3???thank you for your kind collaboration...

  • After sleep, retina MacBook Pro (Mid 2014) does not recognize usb connected mouse movement

    After sleep, retina MacBook Pro (Mid 2014, on 10.9.4) does not recognize usb connected mouse movement. I have tried a generic usb mouse and my Razer Deathadder usb mouse. Both mice work before sleep; but after sleep, the computer no longer recognizes mouse movement while still recognizing the mouse buttons when pressed. Any idea why this is occurring?

    Hello, chocotac0.  
    Thank you for visiting Apple Support Communities.
    Here are some troubleshooting steps that I would recommend when experiencing this issue.
    OS X Mavericks: Reset your computer’s PRAM
    http://support.apple.com/kb/ph14222
    Intel-based Macs: Resetting the System Management Controller (SMC)
    http://support.apple.com/kb/ht3964
    OS X Mavericks: If a USB device isn’t working
    http://support.apple.com/kb/PH13876
    Cheers,
    Jason H.

  • My itunes will not recognize my ipod shuffle after installing Mcafee

    My itunes will not recognize my Ipod shuffle, I have tried almost everything Itunes has suggested including uninstalling and installing Itunes.  I am at a loss, the computer recognizes the ipod and assigns a drive to it.  When I click on the drive there are flies in it.  I have disabled the firewall, checked all firewall settings as suggested in previous forums.  I have tried deleting the temp files but that keeps getting hung up on a file that says it is in use.  I can stll use my ipod because it charges but I can not update songs etc.
    I contacted Mcafee but all they did was turn the firewall off (I could have done that myself).
    If there is any help I would appreciate it!
    Thanks,
    Nadine

    The first thing I did in the morning was contact McAfee they turned the firewall off it didnt work so they said it wasnt their problem.  I attempted several other things using ITunes help but none of the solutions worked.  I would say it is something in my computer but the drive shows up in my files so the computer is reading the USB port.  I tried changing the drive but that didnt help.
    I cannot find a universal "OFF switch" in McAfee But I have turned the firewall off several times after many different attempts.
    I do not find an area where I can tell Itunes where the Ipod is in Windows Explorer, that would be helpful at least it could try to locate it then. You would think this feature would be available since Itunes would like us to purchase music through them to load on our equipment.  Since my computer does not recognize my Ipod there is no need for me to purchase music.
    Do I sound frusturated - I AM But I appreciate your trying to help.

Maybe you are looking for

  • How to read the contents of Uploaded File Data?

    Dear Experts, I want to develop one webdynpro application in which the iview contains the FileUpload option.and after uploading i need to read the contents of the file. Can you plz guide me how to achieve this? its very much helpfull if u have any sa

  • Problem with JDOM and schemas

    I'm trying to parse (and validate) an XML document with JDOM. My root element is declared in the schaema whixh is asociated to the document. But during parsing, an exception saying that my root element is not declared is thrown. Can someone axplain t

  • Programmatically trigger method TreeCell.startEdit() to be invoked

    If a TreeView is assigned a cell factory that creates a TreeCell with edit capabilities, is it possible to programmatically trigger method TreeCell.startEdit() to be invoked to put a selected tree item in edit mode? Currently a user can edit the name

  • DTS, how can I make it work?

    Hello there, I need a help to add a dts audio file to my project in Encore 2.0. Always I try, a message like this appear: "The software that´s used to decode the meia is not available on this system. Installing the correct decoders for the files you

  • How many versions do I need?

    Hi, please help. I am a regular Windows XP user without any technical knowledge. My computer has a number of Java versions under C:\Program Files\Java\ which, in total, use almost 0,50 GB. I wonder if I need all of them. If not, do I keep only the la