SLD bridge error, unable RZ70

Question

Hi
I have installed WAS Java Only system, the SLD supplier is able to push the data into SLD using HTTP SLD Supplier of Visual Admin.
But now I would like to push an ABAP system's data over, so I try to configure the Data Supplier Bridge in SLD, but hit the following error, so unable to RZ70 as well:
Please advise.
Thanks
Jack
#54 04/19/2006 22:38:37.134 [JCO.ServerThread-9] ERROR com.sap.lcr.sagent.SAPProxyServer: JCO Server exception raised: Server startup failed at Wed Apr 19 22:38:37 GMT+08:00 2006.
This is caused by either a) erroneous server settings, b) the backend system has been shutdown, c) network problems. Will try next startup in 1 seconds.
Could not start server: Connect to SAP gateway failed
Connect_PM TPNAME=SLD_NUC, GWHOST=lpc1, GWSERV=sapgw54
ERROR partner not reached (host 192.168.1.10, service sapgw54)
TIME Wed Apr 19 22:38:37 2006
RELEASE 640
COMPONENT NI (network interface)
VERSION 37
RC -10
MODULE nixxi_r.cpp
LINE 8579
DETAIL NiPConnect2
SYSTEM CALL SiPeekPendConn
ERRNO 10061
ERRNO TEXT WSAECONNREFUSED: Connection refused
COUNTER 1
Thrown:
com.sap.mw.jco.JCO$Exception: (129) JCO_ERROR_SERVER_STARTUP: Server startup failed at Wed Apr 19 22:38:37 GMT+08:00 2006.
This is caused by either a) erroneous server settings, b) the backend system has been shutdown, c) network problems. Will try next startup in 1 seconds.
Could not start server: Connect to SAP gateway failed
Connect_PM TPNAME=SLD_NUC, GWHOST=lpc1, GWSERV=sapgw54

Answer 1

Hi JackLim
You had better check RFC Destination by SM59,
and JCo RFC Provider by Visual Admin .
1:Check whether Program ID is matching.
2:Check ABAP System is Unicode or Non-Unicode,
  and collect settings.
  ->if ABAP System is Non-Unicode System,
    Check off the Unicode Flag of JCo RFC Provider.
regards.
Yuki Fujioka