Spoll I/O Error on job program

Question

Hi people,
Im havaing a problem in a update program.
Here's what happens.
Im doing a program that update some tables directly trught the update command, one program for each table and I put them into a job(one job for each program, and then run one after te other), because is a lot o lines to update.
Every program runed correctly, but the program that updates de table QMEL gimme a error message.
The message is SPOOL_I/O_ERROR
I saw the log of the job and the error occurs on the WRITE command, I think that is because it will show a lot o lines that it updated and then the spool blasts, but in some tables bigger than QMEL the job runed without problems.
What may be happening and what can i do?
There is some routine to clean the spool before I print the report?
Each job has its spool or they share the same?
    WRITE : 'TABLA : ', p_tabla,
        20  'Seq. : ',p_seq.
    ULINE.
*....+....1....+....2....+....3....+....4....+....5....+....6....+....7....+....8....+....9....+....1
*Número de aviso   Material             Gr antes    Gr Despues
*999999999999      999999999999999999   999999999   999999999
    WRITE:  /01  'Número de aviso',
             19  'Material',
             40  'Gr antes',
             52  'Gr Despues'.
    ULINE.
    SORT ts_out BY qmnum.
    LOOP AT ts_out.
      WRITE :  /01  ts_out-qmnum,
                19  ts_out-matnr,
                40  ts_out-matkl,
                52  ts_out-gran.
Thanks

Answer 1

What hard drive is it? What does the error say, and when do you see it?
- Peter