Bluetooth headphone problem with miix 2 8"

I used to listen internet radio preferred by bluetooth headphones via Wi-Fi home network. The sound however is like "underground" and intermitted. With wired and RF headphones sound is clear and steady.
I have tested the bluetooth headphones with my desktop computer and Lumia. Both of them works very well, no interruptions or bad sound.
I have checked all sound and BT drivers, all Ok. What can I do, buy a new tablet?
Solved!
Go to Solution.

Full Windows recovery and everything OK

Similar Messages

Experiencing problems with connecting my iPhone 6plus to my Hyundai sonata phone kit via Bluetooth, Experiencing problems with connecting my iPhone 6plus to my Hyundai sonata phone kit via Bluetooth

Experiencing problems with connecting my iPhone 6plus to my Hyundai sonata phone kit via Bluetooth, Experiencing problems with connecting my iPhone 6plus to my Hyundai sonata phone kit via Bluetooth

Hello NiiTeye,
I'm sorry to hear you are having these issues with your iPhone. If you are having issues connecting to your car stereo via Bluetooth, you may find the troubleshooting steps outlined in the following articles helpful:
Get help using your iPhone, iPad, or iPod touch with your car stereo - Apple Support
iOS: Troubleshooting Bluetooth connections - Apple Support
Sincerely,
- Brenden

Bluetooth Headphone Problem & Quest

Hello,
I just got deli'very of my CB2530/CB2470 Bluetooth headphones and transmitter.
I initially used the batteries supplied and unfortunately the headphone power light will only stay on steady for 30 seconds or so. Then it blinks.
The transmitter appears to connect with Bluetooth and audio DOES reach the headphones but every 20 seconds or so there is an interruption and faint "beep" in the headphones, then after a few minutes they disconnect and the headphones appear to power off. The transmitter then shows a solid blue bluetooth LED.
According to the manual the LED is supposed to blink when power is low and then disconnect after 0 minutes. But the problem is I have repeated the test with FRESH batteries from three different sources as well as a freshly recharged set of NiMH batteries as well as another set of NiCads in case the 2530 is not designed for NiMH. Anyway, regardless of batteries the behavior is the same. Same behavior if I do NOT use the 2470 but connect directly with my laptop via the laptop's Bluetooth interface using the A2DP profile.
What is wrong with my new headphones?
Regards,
Walt

Send it to the service center. Bluetooth headphones are still in its infant stages.
MSI had released models for use but customers often say there are quite a lot of distortions due to interference. They sold quite a lot in Hong Kong.

Logitech V470 bluetooth mouse problems with new macbook pro.

Got a Logitech V470 bluetooth mouse to use with my recent 2011 macbook pro running 10.6.7. There appear to be several problems with this combination.
1. If the mouse is not moved for a few seconds and I move it, the pointer does not respond immediately, and when it does, the pointer motion stutters and jerks across the screen for a few seconds before it starts moving smoothly. I don't see any spike in CPU usage when this happens.
2. When I shutdown/reboot or sometimes even put the macbook pro to sleep and wake it up, the machine fails to communicate with the mouse, nothing happens even if I reset/restart the mouse or click, scroll or move it around. The only fix is to go to the bluetooth settings and set it up as a new device.
I suspected a hardware problem on either the mouse or the mac, but (a) the mouse works perfectly fine on an older Sony Vaio laptop and (b) the apple wireless keyboard works pretty fine with none of these problems with my macbook. Would getting an apple magic mouse magically solve this problem?
Has anyone else faced this situation, and could it be fixed?

Any issues you are having with a "Logitech" product, should be dealt with their tech/customer support department.

Magic Mouse Bluetooth connection problems with Mac OS X Lion

I've a problem with my Magic Mouse on bluetooth since I've updated my Mac to Lion, it's disconnecting too often. How to fix it ?

It might be a physical battery connection problem. The solution was already described by this article:http://macs.about.com/od/tipstricks/qt/Fix-Magic-Mouse-Disconnects.htm
Placing a trimmed piece on paper that was cut from a business card between the batteries and the battery-enclosure lid helps hold the batteries down firmly. This eliminates the tiny freeplay that allows a physical battery terminal disconnect when the mouse is jolted.

Bluetooth Connection Problems with Acura MDX

My DroidX has been connecting for almost 2 months now just fine to my MDX. Today it won't connect at all. It sees it but it just won't connect. I tried rebooting the DroidX. That didn't help. I have no idea what changed. Any thoughts would be appreciated.

Hi,
This has happened with all my android phones (Eris,Ally, DroidX) with my JagXF. Sometimes rebooting the phone helps, other times I have to delete the phone from my car and re-pair the devices. I really think Android has a problem with bluetooth though as it didn't happen with my Samsung Omnia and since it happened with 3 different droid phones, what u think? Hope this helps!!

Anybody experienced headphones problem with Lumia ...

Sometimes when I connect the headphones jack, the audio still came from loudspeaker, not the headphones. To resolved this I have to plug in and out the jack several times. this happen to me 2 times ; first with the standard headphones supplied with lumia 2nd time with my monster headphone. I wondered if anyone expereince this problem. I haven't visit the nokia care yet because the problem is rarely occured.

it happened to me 2 times...every time I went to the official support center they just reset it and it works again...but on my home nor sw nor hw reset (soft and hard) will fix this issue...I'm starting to be so worried, because it happened me again few mins ago and they need 15-20 days to fix this I cannot stay without phone so much....any further info?

Headphone Problems with Audigy 2

I am having significant problems with a Logitech USB headset and my Soundblaster Audigy 2 ZS. I have all the latest updates and drivers, but my headset has a 'swooshing' sound when plugged in.
My view is that the soundcard is not recognising the headset audio correctly and doesn't assign the sound to the channels properly. I have tried manually changing this in the control panel, but no change.
I have uninstalled the hardware, and software (nightmare!) and now the 'Creative Volume Control' doesn't even work, right or double-left click.
In short when the headset is out, the card seems to perform correctly. Additionally, I have removed the USB Audio Device from the PC, and then re-installed it, but again didn't work.
Any advice would be really appreciated...

burnsdh,
Just in case you did not read those reply from Jeremy in another one of your post. The USB headset work independently and it's not linked with the Audigy 2 ZS sound card. USB headset is basically an individual USB sound card.
Jason

Bluetooth connection problems with TomTom Go910

Although my TomTom Go910 finds my 5800 it keeps saying that there is no answer from phone 'look at your phone'. Anyone got any ideas what's wrong as my previous Nokia had no such problems?

I have the same problem with both our TomTom 500 and 530. Really annoying as our olf Nokia 6300 worked with both including SMS. The 5800 often has to be 're-booted' to connect and then most of the time does not work.

Possible solution for headphone problems with Mac Mini

A month or two ago, I posted a question about problems I was having with getting earphones and earbuds to work with my mid-2010 Mac Mini. I just wanted to share the (quite simple) solution that solved my problem.
My problem: I couldn't get any earphones or earbuds to work with my Mini, despite my trying several different sets. Finally I took my Mini into the local Apple store.
Solution: Though it was not stated in any Apple support literature or postings online, the solution was to push the mini-jack into the audio out port until the mini-jack clicked. I was just being too cautious. I was pushing the mini-jacks into the port (which were in the back of the Mini, so I couldn't get a good handle on what I was doing, since the Mini's back was facing away from me). I wrongly thought I'd pushed as far as the jack(s) should go. Not so. I should have pushed harder until there was a 'click' and the mini-jack was all the way in. Once that was done, no problem.
Chalk it up to my stupidity or to a lack of detail in Apple's support and help literature, but that was the solution. I hope this helps others with similar audio out issues.

Thanks for the response but I think maybe you missed part of my post. The keyboard works fine with my mac book and with my son's macbook. The keyboard is actually working right now. It has been a problem with shut down and then strart up. I think that I went through all those other SMC and PRAM efforts with Apple support and actually many others and they were completely stumped. I think that this is a complicated problem for which there may only be a work around but I am hopeful that the next time I shut down, it will work. I appreciate ideas but if my 4 or 5 hours with Apple support cannot help, I do not believe this is going to be a simple solution but if someone has encountered this or something similar, I would welcome their ideas. I have gone to the Apple Store in Madison, WI on several occasions and unfortunately I often know more than the people that help me so I am reluctant to go there and to trust the staff at the genius bar. For example, I recently purchased and Apple watch and the first person that helped me did not know how to turn it on and the second person did not know it came with two different length bands, and I once bought a case for my iphone and the person who helped me was more interested in the color than in the functionality of the case. I could go on but I am not confident in the competence of the staff there so I am hoping that someone in the support community can help me.

Bluetooth connection problems with Jabra

Eversince I bought the Jabra Revo wireless headphones I had problems connecting them to my Macbook 15 Retina. When I get it connected it doesn't play the sound. When I disconnect it I get this message
https://www.dropbox.com/s/e6kj8bdticdq7p1/Screenshot%202014-05-05%2013.34.49.png
The same happens with my Jabra solemate speaker. Most of the times it doesn't work but sometimes it connects and plays perfectly
I updated the Jabra firmware on both devices. They work flawlwssly with my Iphone 5s and with the Ipad Air.
Is there any way to update/repair the bluetooth drivers on my mac? I'm on OSX Mountain Lion.
Thank you!!

There are no "bluetooth drivers."
Try resetting the PRAM and SMC - might help, cannot hurt.
I would also contact the third-party device manufacturer (since the problem seems to be related to their devices).
Barry

HP Officejet100 Mobile L411a intermittent Bluetooth printing problems with PDF files

Hello,
Our company provides computer-hosted medical devices controlled by an application running on Windows7 computers we supply. We are currently using the HP Officejet 100 as a Bluetooth printer. In some of our customer offices, we experience printing problems using the printer in Bluetooth mode (there are never problems if the printer is connected by a USB cable.)
The printing problems typically affect PDF files printed through Adobe Reader 10, and the symptom is one of the following:
Send a print job to the printer. It doesn't print and eventually the print queue shows an "Error Printing" message. If any print jobs are removed and the printer is power-cycled, the problem goes away for the time being.
2. Same as above but power-cycling does not cure the problem and nothing will print, even a test page.
In either of these cases there are no problems if a USB cable is used.
The PDF files we are trying to print are typically 5 pages with 3 of the pages having a lot of graphics and the remainder being text only.
Has anyone seen this behavior and is there anything we can do about it?
Thanks.

I don't anything about this printer, but I do know that bluetooth is really flaky with large files since it's got a crappy transfer rate, could be that the transfer is dropping and freezing the printer up. Does it have encryption turned on?

Headphones problem with MacBook Pro?

I recently purchased some new headphones, but only 1 earpiece works on a mac. There's nothing wrong with the headphone because both the ear cups work on everything els. He headphones are super super loud ( louder then dr dre beats ) and have the same base.

you would usually get this problem if you have your headphones socket broken or you have not plugged it properly - all the way.
Have you tried other headphones on your Mac?

Same headphone problem with Zen Micro Pho

I had 2 Zen Micros before. They both had the headphone where you can't hear anything unless you move it in the right position. My second Micro took a while to break and I cashed in my rebate at Best Buy.
I got the new Micro Photo since they ran out of regular ones. Do you think I should get the rebate? Does the Micro Photo have headphone jack problems too?

Snoweagle wrote:
So far mine doesn't and i've not heard news that the ZMP is suffering the same headphone jack issue as the Micro.
Yep, there has been no known headphone jack problem involving the MicroPhoto on this forum, and this should be compared to new threads every week concerning the original Micro as well as the old 00-pages discussion thread. More people have supposedly bought the original and it has existed for a longer time, but the ZMP has been out for over 6 months in the US and fo quite a while in Europe, well beyond the time it takes for many Micro users to discover this problem (my first broke after two days...). Considering this, I'll presume it has been fixed with the ZMP.

Headphone problem with 6300

Hi, hope someone can help me....
I've purchased an adapter from 2.5mm to 3.5mm so that I can use my "normal" headphones. However, when I put the 2.5mm jack in the phone, I can still hear music from the phone itself; nothing at all from the headphones I've connected.
Do I need to change something on the phone? I've looked at "Enhancements" but doesn't have an option for headphones
Any ideas pleeeeeeeeease!?

I had this problem on an Imate and the reason is the plugs are wired differently. If you look at the plug you will see little black rings, it has to do with how these rings are layed out on the plug. The adapter rings need to be reversed.
This time when I bought my wife a 6300 I also bought her a set of blue tooth stereo headphones BH501 and they work a treat, they also will switch off the music and accept a voice call then they resume the music once the call has finished.
The added bonus is she can use them on her pc as well or any other blue tooth device.
Graeme

Bluetooth headphone problem with miix 2 8"

Similar Messages

Maybe you are looking for