Called party cannot hear when iPhone 4 in speaker mode. cleaned earbud socket but think have sw problem. How do I reload os.
Called party cannot hear when iphone 4 in speaker mode. Have cleaned earbud contact but think this is sw problem and would like to reload os 5.1.1. Not sure how to do this as all attempts result in "software is up to date" message.
http://ww2.cs.fsu.edu/~rosentha/linux/2.6.26.5/docs/DocBook/libata/ch07.html#excatATAbusErr wrote:
ATA bus error means that data corruption occurred during transmission over ATA bus (SATA or PATA). This type of errors can be indicated by
ICRC or ABRT error as described in the section called “ATA/ATAPI device error (non-NCQ / non-CHECK CONDITION)”.
Controller-specific error completion with error information indicating transmission error.
On some controllers, command timeout. In this case, there may be a mechanism to determine that the timeout is due to transmission error.
Unknown/random errors, timeouts and all sorts of weirdities.
As described above, transmission errors can cause wide variety of symptoms ranging from device ICRC error to random device lockup, and, for many cases, there is no way to tell if an error condition is due to transmission error or not; therefore, it's necessary to employ some kind of heuristic when dealing with errors and timeouts. For example, encountering repetitive ABRT errors for known supported command is likely to indicate ATA bus error.
Once it's determined that ATA bus errors have possibly occurred, lowering ATA bus transmission speed is one of actions which may alleviate the problem.
I'd also add; make sure you have good backups when ATA errors are frequent
Similar Messages
-
I have just bought this expensive phone. I tried connecting to Bluetooth car kit. It gets connected but only incoming voice can be heard. No voice goes out from Iphone.
I also tried connecting to Samsung Bluetooth but the problem is same. There is only in coming communication and no out going.. But both the Blue tooth devices works fine with my Samsung SII.
A working solution help will be very juch appreciated. Thanks in advance.I'm having the same problem. I had a plantronics 975 (which I lost, sadly). When connected, the ringer would always be routed through the bluetooth and the iPhone's external speaker. When in silent mode, the iPhone would only vibrate, but I could still hear the ringer in the bluetooth.
I just bought a new Plantronics Voyager+. Now when it's connected, all sounds are routed to the earpiece - including the taps, etc. The iPhone's speaker doesn't ring at all, unless the bluetooth is disconnected or powered off. I'd really like to be able to hear both, like I was before. This is an iPhone 3G running iOS 4 (latest version, not sure what it is exactly). Haven't updated software/firmware in between bluetooths, just changed the earpiece. -
When I make or receive calls on my iphone 4S the receiving party cannot hear me unless I use earlphones is there a fix for this?
Hello Fred91
Start your troubleshooting with the article below to go through and help isolate the issue with your iPhone.
iPhone: Microphone issues
http://support.apple.com/kb/ts5183
Regards,
-Norm G. -
The other party cannot hear me talking when i make a call on my i-phone 4s
the other party cannot hear me talking when i make a call on my i-phone 4s but can hear me if i use the ear piece
http://support.apple.com/kb/TS2802
-
Blue tooth operation and lock up. After i connect my bluetooth it works fine foe a few calls. Then if i place an outgoing call, I cannot hear the reciving party but they can hear me. Other times i can hear them but they cant hear me. After rebooting the phine it works again for a few calls. This is consistent with 2 diferent blue tooth devices?
Sorry about the delay, I have been away from my computer for a couple of days.
Since you are able to use Siri and dictate notes, that indicates the mic itself is working.
I would suggest fully quiting the Phone app and resetting the iPhone.
Double click the Home button (bottom center of the display with square icon on it) to get the fast switcher. Press and hold on one of the icons so they start "shivering" and the red "-" icons. locate the Phone icon and press the red "-" on it. Then press the Home button again to stop the "shivering".
Then Reset the iPhone, press and hold the Home and Sleep/power (top right edge of iPhone) buttons until you get the Apple logo. Wait for it to finish restarting and then test again. -
iPhone 6. While talking on the phone, email interferes w/audio for other party. Email message pops-up on the screen and the other party cannot hear me until I click "close" & remove the message. Ideas??
Alex, thanks for the reply but it did not answer my question. I only want to turn off notifications & interruptions while I am on the phone. For this desired result, the only way the Do Not Disturb feature would help is if I manually turned it on before each phone conversation. Since my phone rings at random times, this is not possible. Basically, I just want to "opt out" of call-waiting. When I had a landline I never had call waiting. I don't want to be interrupted. But beyond that, even if I am being interrupted why are these notifications preventing the other party from hearing my voice?
-
When I make a call I cannot hear anyone talking. But they can hear me?
When I make a call I cannot hear anyone talking. But they can hear me?
Hey there mahmoud.qaadan,
It sounds like you are making calls or receiving them but the other party cannot hear you even though the microphones work in other apps on your phone. I would start by quitting all the running apps on your device:
iOS: Force an app to close
http://support.apple.com/kb/ht5137
Double-click the Home button.
Swipe left or right until you have located the app you wish to close.
Swipe the app up to close it.
When you have done that and restart the device and test the issue again:
iOS: Turning off and on (restarting) and resetting
http://support.apple.com/kb/ht1430
If it persists, I would next backup your device to iTunes with this article:
iOS: How to back up and restore your content
http://support.apple.com/kb/HT1766
And restore it from your backup with this article:
Use iTunes to restore your iOS device to factory settings
http://support.apple.com/kb/ht1414
Thank you for using Apple Support Communities.
All the very best,
Sterling -
My Iphone 5 voice speaker is not working.I'm not able to hear the voice of the person calling.But when I put my iphone 5 on speaker mode, things seem ok.Please provide me some suggestions.
Hello rizvijunaid,
Thank you for providing the details of the issue you are experiencing with calls on your iPhone. I recommend following the steps in the article below for the issue you described:
iPhone: Receiver and call audio quality issues
http://support.apple.com/kb/ts5196
Thank you for using Apple Support Communities.
Best,
Sheila M. -
When i call, i cannot hear them and they cannot hear me
when i call, i cannot hear them and they cannot hear me
I'm having the same problem in the last 2 days, Can that fixed?
-
When I make call I cannot hear the sound from the built in speaker. I need to switch on the loudspeaker or I have to plug in the headphone. Due to this I cannot even use Siri, Voice message recorder or even Tom Cat applications. What is the solution?
http://support.apple.com/kb/TS1630
-
My iphone, the other party cannot hear
Can i get the feature fixed? the other party cannot hear on this phone
I have te same issue. It started after upgrading to iOS 5 on my iPhone 4. I tried to restore, same problem after restore.
-
Cannot Hear When Placing A Call
For the past two hours whenever I place a call I cannot hear anything unless I am on speaker. I tryed to restore the phone but it did not help. Is there anything else I can do?
Odds are you recently had headphones in it. When you took them out, it failed to pick up on that fact....so all sounds are being sent to the jack (where there are no headphones). Plug in and out your headphones a few times. When out, try to play music. If you hear it, then it fixed itself. If it didn't, repeat.
-
Hi I have a iPhone 4 and I seem to have a problem during calls. If I make or receive a call I can hear the person who is on the line with me but the other person can't hear me. This problem has occurred 1 week ago so please get back thank you
You use Restore to get the latest firmware build, not the Update button. You can only use the Update button, if there is an iOS update, say iOS 5.1.
this link talks about updating to 9A406 to fix the "No Service" issue with iPhone 4S:
http://iphone-and-i.blogspot.com/2011/12/fixing-iphone-4s-signal-problem.html -
IOS7 installed OK to my iPhone 4S and worked OK for a while but I have somehow managed to completely jam my iPhone 4s. The touch screen won't work except for up and down gestures (some of the time). I can't make or answer calls, I can't even power if off. I can't access the hardward ID which Apple support seems to require for Chat.
It might have happened when I was accessing my camera bypassing the lock screen!
All I know is that the thing is now useless and it looks like I will have to wait for the battery to run down to see if powering it back up afterwards will solve the problem.I have since discovered the "hold down home key and power button" together for a few seconds and this seems to have worked .... phew!
-
Is it all the data on the iphone is deleted when iphone is in Recovery Mode?
is it all the data on the iphone from the past is deleted when iphone is in Recovery Mode? or is there anyway i can manage the data from the past when my iphone is in Recovery Mode? or is it when my iphone is in Recovery Mode, all the data from the past is clear and its all fresh disk like the new iphone? is there anyway i can still acess the old data on iphone in recovery mode?
Depends. There is no supported method, from Apple, to exit recovery mode, other than restoring your phone. That, of course, means that all data on your phone gets erased. There are third-party utilities, like RecBoot, that claim to be able to get an iPhone in/out of recovery mode with the push of a button. You can search for these yourself.
Maybe you are looking for
-
My Windows Vista is Not Working
I was using my Vista side of my iMac a few days ago when i was prompted to install an update now every time I click on the icon I get an Error message saying that parallels has quit unexpectedly I hit the RELAUNCH button but it just comes back to the
-
How do I extract a substring when I know what become before and after it
I am able to get the HTML source of a web page and I want to get certain information from it. I am trying to extract a 1 or 2 digit number but sometimes it is not there but I know that this comes exactly before the number if it exists or not "</td>
-
Event handling in scrollpane and graphics programming concept
I am still unclear about what to do to refresh a canvas inside a scrollpane? what should i do with "repaint()" method of scrollpane?? clearly i have to update the drawing on the graphics g of the canvas, according to the viewport of the scrollpane so
-
***** that You Can not remove/Hide apps removed from Iphone 5
Kinda ***** that iphone 5 won't let you hide app purchases uninstalled on your Phone. Thought this was supposed to be a smart phone?
-
Can i import raw files in the organizer pse13
how do I import raw into pse13 or can i