Daqmx read.vi timestamp incorrect problem (storing the timestamp from start task)

Question

Hello,
I have a state machine with 1st state: configure DAQ where i have [daqmx create channel.vi --> daqmx timing sample clock--> DAQmx start trigger--> daqmx start trigger] connected in order
sample clock in continuous mode, 10000 samples to read and sample rate 1000 Hz ,
start trigger has rising edge selected with a dev1/PFI0 from a daq board.
next state of SM is read channels which has daqmx read.vi set to 1d waveform  Nchan Nsamp.
and the program first configures and goes to read channels state and is just waiting for the true value on PFI0,
but the time stamp is not updated to current time/ when daqmx read starts instead it is getting the initial t0 from the time when it was in configure DAQ state of my SM in other words it stores the starting time when strart task.vi was run and then updates from then on.
so in effect i am not getting the exact time stamp values while i am running the vi.
i tried to build waveform by inputting the actual current time but the chart doesnot scroll and shows only few values each reading, when i tried to input the t0 from the waveform given out by read daqmx. vi, it then behaves normally..
option #1 from this link says
http://forums.ni.com/ni/board/message?board.id=250&thread.id=47648&view=by_date_ascending&page=2
Try and do exactly what the driver does.  This
will require you to do exactly what you are doing in the posted
example.  Call the current system time immediately prior to calling the
DAQmx Read and subtract dt * x where x is the number of samples already
acquired.  This will require you to know exactly how many samples have
been acquired.  This can be found by calling the Total Samples Per
Channel Acquired property immediately prior to the DAQmx Read.  This
introduces some points of innaccuracy.  For example, you're system time
is already innaccurate to some amount.  In addition, it takes some time
between calling system time, calling the total samples acquired, and
calling the DAQmx read.  If 2 samples are acquired between calling the
system time and total samples acquired, you could be off by a few
samples.  For slower clock rates, you will have more accuracy. 
but there are no samples that are acquired until the rising edge, so the number of samples is always zero before the read operation
http://digital.ni.com/public.nsf/allkb/5D42CCB17A70A06686256DBA007C5EEA 
this link says that
and the number of samples in my waveform is constantly changing around 20-40, so i cannot really input the current time to build the waveform, thats what i can figure out for now..
can somebody tell me why this is happening or is there any fix around this, how to get the current time into my daqmx read.viso it displays the currect time on my waveform chart
Thanks,

Answer 1

thanks,
im using LV 8.6, daqmx driver 8.9.5.
yes the program u posted get the currect time. but see attached program thats what i have in my program exactly
if you took out the time to using the get waveform components using the waveform  from daqmx read. i still have the timestamp as the application start time. plz see attached code 8.2v and FP
the waveform time x axis is not current, it is starting from the application start time.
PS: samples to read = 10,000 and sample rate = 1000
plz help..
Attachments:
daqmx read problemp.png ‏8 KB
daqmx read problem.vi ‏36 KB