Getting the signaling ip of outbound leg using TCL iVR 2.0

Question

Hello all
I am using cisco TCL IVR 2.0 and Free Radius 1.1. I am trying to send signalling ip as an extra attribute to radius from the NAS in the accounting request packet using h323-ivr-out. The problem is I am not able to retrive the signaling ip of the out bound leg( I even tried the same for the inbound leg but still no luck). I am retriving the signaling ip using the info tag infotag get leg_remote_signaling_ip_address leg_outgoing. But I am getting a empty string
This is my code where I retrive the signaling ip
proc act_Cleanup { } {
set signalip [infotag get leg_remote_signaling_ip_address leg_outgoing]
set avsend(h323-ivr-out,0) "billingid:$signalip"
aaa accounting update leg_outgoing -a avsend
call close
This is the procedure that's get called when the call ends. I even tried using this code snippet when the call is established but I am still unable to read the signaling ip. I am accounting at stop only.
In the accounting request there is one attribute h323-remote-address which gives me the signaling ip but how do I retrive it in my tcl ivr script.
Please guys help me out
Thanks
Vignesh

Answer 1

I dont get why it is not working.
I used the simple tcl (the one that i've sent with your setup, and its gettin the ip addresses.
here is my ipipgw configuration.
dial-peer voice 1 voip
description INCOMING
huntstop
service ipipgw
incoming called-number 4#T
codec transparent
no vad
dial-peer voice 2 voip
description OUTGOING
translation-profile outgoing outgoing
huntstop
destination-pattern 4#T
session target ipv4:x.x.x.x
codec transparent
no vad
and i am using IOS version 124-7.bin.
Its very strange. it is not giving error or sth like that.it is just gettin an emty ip address.