HT1366 My MacBook OS X version 10.6.8 is not going to sleep, keeps loading, then when turned on a blank screen appears, I shut it and the main menu comes up and then it takes awhile for the cursor to operate. Thanks
My MacBook wouldn't go to sleep, it keeps loading, so I have to turn it off. When I turn it on a blank screen comes on, I shut the lid and open it and the main menu screen comes up but the cursor won't work for awhile. Then, eventually, the cursor will work and everything is fine. Hmmm?
Just in case it still didn't work...I copied and pasted the information below...
Battery Information:
Model Information:
Serial Number: D86052301B8DCMDAG
Manufacturer: SMP
Device Name: bq20z451
Pack Lot Code: 0000
PCB Lot Code: 0000
Firmware Version: 0301
Hardware Revision: 000a
Cell Revision: 0173
Charge Information:
Charge Remaining (mAh): 3638
Fully Charged: No
Charging: No
Full Charge Capacity (mAh): 4196
Health Information:
Cycle Count: 631
Condition: Normal
Battery Installed: Yes
Amperage (mA): 0
Voltage (mV): 8103
System Power Settings:
AC Power:
System Sleep Timer (Minutes): 10
Disk Sleep Timer (Minutes): 10
Display Sleep Timer (Minutes): 10
Wake on AC Change: No
Wake on Clamshell Open: Yes
Wake on LAN: Yes
Current Power Source: Yes
Display Sleep Uses Dim: Yes
Standby Delay: 4200
Standby Enabled: 1
Battery Power:
System Sleep Timer (Minutes): 62
Disk Sleep Timer (Minutes): 10
Display Sleep Timer (Minutes): 62
Wake on AC Change: No
Wake on Clamshell Open: Yes
Display Sleep Uses Dim: Yes
Reduce Brightness: Yes
Standby Delay: 4200
Standby Enabled: 1
Hardware Configuration:
UPS Installed: No
AC Charger Information:
Connected: Yes
ID: 0x0100
Wattage (W): 60
Revision: 0x0000
Family: 0x0085
Serial Number: 0x000979a4
Charging: No
Similar Messages
-
My iPad mini displays i0S 6 and won't bring up the main menu. How do I get it to show the menu?
My iPad mini displays iOS 6 and won't bring up the main menu. How do you get it to access the main menu?
Reboot your iPad and see if that lets it start up properly.
Reboot the iPad by holding down on the sleep and home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider if it appears on the screen - let go of the buttons. Let the iPad start up.
If this doesn't work, you may have to restore your iPad using iTunes on your computer. -
Right now my ipod classic is set on 'music'. When I push the munu button, it will not go back to the main menus, but it will still go forward and select and play music normally. I tried resetting it by holding the menu and center buttons until the apple logo appeared, but the problem is still there.
If your battery level is low, recharge it first for at least 2 hours, preferably 4 hours.
After the Apple Logo, you release the buttons, what do you see on the iPod screen? (language selection?)
Have a nice day! -
When I'm scrolling the main song list, "T" shows up as a letter for "The"
For example:
Aaaa
Abababab
The Acacac
Adadad
You know how when you scroll down, it shows the first letter of the song you're on so you can get to a specific letter? Well, if the first word of the song is "The", that "The" is disregarded, and put where the next word is, like in the AAA abab thing I posted. However when I scroll down, whenever I pass a "The", it shows the letter as "T", then it'll go to whatever the real letter is once I get past the "The's".
Any ideas? Note: I haven't been able to completely sync, explained here: http://discussions.apple.com/thread.jspa?threadID=881538
That might be part of the problem (By the way, if you can help with the thing I linked to, please do)This is a new feature of iTunes 7.1 called "sort". It appears in the get info section, and allows artists/albums such as "The Beatles" to appear in the 'B' section rather than 'T' in your library when sorting alphabetically, just as it does on your iPod.
To change this click on the file in question and get info. In the sort tab you will see two columns, on the right is the one you need. For example on the left it should show "The Sweet Escape" and on the right under sort ablums "Sweet Escape". But "the" back in front and it will go back into the 'T' section of your library.
As of yet I haven't found any way of doing this with multiple files, or automating this process as I spent several hours doing this manually last night.
Good luck -
I just purchased Apple Tv 2. Hooked it up and everything is set on Home Sharing. When i attempt to play itunes through my tv the song will only play for approx. 45-60 seconds and then the Main Menu comes on and the song quits. Same goes for when I put my photos on.
I just purchased Apple Tv 2. Hooked it up and everything is set on Home Sharing. When i attempt to play itunes through my tv the song will only play for approx. 45-60 seconds and then the Main Menu comes on and the song quits. Same goes for when I put my photos on.
-
Hello out there!
Im trying to create a magic iDVD and I have some difficulty navigating my options. Some of my video's that I'd like to add are very short clips and I'd like view them back to back without having to go back to the main menu everytime after every short video clip. For example: a 1:08 minute video of my daughter's birthday and then a 3 minute video of her bithday...how do I make it so the 1:08 minute video automatically transitions to the 3 minute video without me having to go back to the main menu to manually select the next video?
Please advise! Thank you so much
cituleYou can't. But (there's always a but) if you have enough room (i.e. playing time) available in the project you can create a slideshow in iDVD
and add all of the videos to it.
If you do that set the Slide Duration time to anything except Manual or Set to Music. Also do not select an transition.
When you click on the Create Project button in Magic Movie you'll be able to use the "+" button to add the slideshow to the top menu.
OT -
hey how are you guys listen i have an iphone 4s the one i use with the H20 CARRIEr and i trying to enable the option call forwarding and when i type tho number i go back and i notice to the call forwarding it turning off as soon i back to the main menu ?
There are a lot of posts in the forums today with people having problems with iMessage. There was also a published outage yesterday, so it's possible there are still some issues that may be impacting you both.
I would just wait it out - I'm sure it will be sorted out soon. -
Remote Menu button: to the chapter menu or the main menu?
Using DVD Pro (version 4.2.1) for the first time, and I've discovered a lot of fun elements. Here is a question about the remote control settings.
I want people to be able to return to the +main menu+ if they want while playing the track, by pressing 'menu' (and I've found the resume feature, too). However, the track has chapters, which are assigned to 3 chapter menus. So, when they are playing a particular chapter, i want them to be able to return from it to the +chapter menu+ it came from, by pressing the 'menu' button.
However, this doesn't work: when playing the video track, pressing the 'menu' button takes me to the chapter menu assigned to that particular chapter, not the main menu that I assigned to the track.
Well, I see in the handbook that the marker remote setting takes precedence over the track setting ... so which would you find preferable:
1. when the viewer is playing the video, the menu button: goes back to the main menu.... then when the viewer is watching a particular chapter, pressing 'menu' also goes back to the main menu, instead of the chapter menu, so viewer has to navigate back into the 'scenes' menu
or
2 when watching the whole video, pressing 'menu' takes the viewer to the chapter menu and then has to 'up' to the Main menu.... and therefore when watching a chapter only, 'menu' button returns to the particular chapter's menu, which is fine.
I thought I would have the 'menu' button return to the chapter menu:: up button for faster/easier access to the main menu, for viewers just watching the video, and convenience for viewers watching a chapter.
What is the more experienced opinion?
thank you
ElizabethHal MacLean wrote:... 'Stories'. If you are playing the track from your main menu, then the menu call for the track should take you back to the main menu. If you are on a chapter menu and start playback then instead of going to the chapter marker, go to a story that contains the chapter marker instead. The story can also have a menu call and end jump set.
Ahh!
The thing is, if you start a chapter playing, do you want the footage to continue to the end of the track, ....
Yes, that's exactly what i want, and as above, for the chapter in the chapter menu to return to that chapter menu
If the former, put all of your markers into a single story and set the menu call to go back to the chapter menu.
Thank you!
I had already created stories from the second track on the dvd, with each one having an end jump back to the story menu and as no one had replied to this post, i had decided to make the chapters in the main track into stories too, but wanted them to continue into the next chapter. In fact i'd already created these 11 stories, some with 2 chapters in them, when I read your post.
So i did as you said and put all the chapter markers into one story, with no end jump for the chapters, but a menu call from the story to the 'chapter' menu instead of the main menu. Much cleaner than the way i had started to do.
And it works just the way i want it to : track's menu call is to the main menu, 'chapter' menu calls are to the chapter menu. Thank you so much!
Elizabeth -
Product: iMac, OS X 10.9.5 (13F34)
Processor: 3.5 GHz Intel Core i7
Memory: 32 GB 160 MHz DDr3
Storage: 3.12 TB Fusion Drive
PROBLEMS:
1. When clicking on the Finder icon in the dock, the main menu grays out and the window with documents, applications etc., does not pop up.
2. iMac is not showing up in iCloud.com and, not syncing with my MacBook Pro, iPad Mini and iPhone.
This situation seemed to appear after doing updates on my iMac.
TROUBLESHOOTING I'VE TRIED:
1. rebooted,
2. repaired permissions,
3. booted in safe-mode and let the basic tests run then rebooted to normal mode. Afterwards, the problem seemed to be corrected, however, it re-appeared shortly thereafter and still exists.Go to the Finder's General preference pane and reset the New Finder windows show: option. Try changing it to some other folder, try it and then back again.
If that doesn't jump start it try moving the com.apple.finder.plist file from your Home/Library/Preferences folder to the Desktop, reboot and then reset the Finder preferences.
For Mavericks and Yosemite go to your Home folder and use the View ➙ Show View Options menu to bring the this window: -
Don't wanna album artworks keep floating on the main menu
Is there any way to disable album artworks keep floating on the main menu of iPod classic?
I think Apple should give us a choice to disable this function with next iPod firmware update.
Some album artworks I don't want to show up there. And the key point is, the resolution of all my album artworks are 200 x 200. It is really enough for my 5G iPod video. But for my new iPod classic, all artworks would be force to enlarge the size for floating on the main menu like screensaver, and they look really crap.
And I think those new default icons on iPod classic are really nice and that's what I prefer to showGiven the resolution you've got them at, the other occurances of them in the UI - like CoverFlow and album art when a track is playing - also probably look not great.
Turn of the option of synching them completely via the Music tab for the iPod in iTunes. Gets rid of the issue completely - and as you say leaves more useful icons in some places. -
How to display all the under menus options when pressing the main menu on adobe muse?
How to display all the under menus options when pressing the main menu on adobe muse?
How to display all the under menus options when pressing the main menu on adobe muse?
-
My Iphone 4 just updated to the iOS6. I've connected it to my computer for the first time since then, and wanted to back up my photos in iPhoto. However, although Iphoto recognized my phone, it shows no photos to upload or backup. It lists my phone in the "devices" category on the left bar, but no longer shows any of my photos.
Does anyone have any suggestions?I've reread your question several times and am not sure I understand it.
Are you trying to basically start over, as if you just took your iPhone out of the box? If so, do:
Settings > General > Reset > Erase all content and settings -
Can I use a plug in USB camera reader to have a load of movies etc on an external hard drive and then plug and play so to speak? I'm off on holiday and haven't got the capacity on the iPad to have everything on that I'd like for the kids.
So basically I want a hard drive with X amount of films etc on. Can I then watch them on my iPad?
Hope this makes sense.External HDD won't work.
You need something like this:
http://www.seagate.com/goflexsatellite/ -
If I purchase one song from an albumn in iTunes, but later want to purchase the entire albumn, does iTunes give credit for the single song purchased, or will I be charged once for the single song, and then the regular full price for the albumn?
Welcome to the Apple Support Communities
You'll purchase the rest of the album, so you'll pay the same as the cost of the album but without the cost of the previously purchased song
Maybe you are looking for
-
Disclaimer: I do not know how to script, but am willing to learn and am looking for advice. I need to replace the text in a smart object from a data list then save the updated file using the smart object text. Is there an existing script that will do
-
Single User Mode - mount external drive and make it r/w
How can I access a USB disk and make it read/write? I can't +mount -uw /Volumes/"Time Machine Backups"+ because it says that the disk is a special type. Can I just use chmod because the disk is automounted? When I attempt to chmod my USB disk, I get
-
Hi Experts I am getting the request through HTTP which i want to split using BPM and send each splitted message to synchronous step and get the response for each splitted message I have gone through the following blog /people/sudharshan.aravamudan/bl
-
I reciently downloaded the PPC version of Flash player 9 from: http://www.adobe.com/shockwave/download/index.cgi?P1ProdVersion=ShockwaveFlash However, whenever I navigate to a page with Flash content, I see a faded QuickTime logo with a '?' over it.
-
PO Stylesheet How to remove space between two tables
Hi I am building a rtf template for PO output for communication report in r12,there is a terms and conditions part and total amount part which comes at bottom of every page of the report. I have created that as a template and i call it in the footer.