I have a bright white screen on my Gen 4 ipod nano. I can still see text if I look hard enough, and it still plays music and stuff, but it's really hard to see.
As described above, my screen is bright white, but it still plays music. It's really hard to see, and I've tried everything. I manually restarted it like 20 times, I updated software and reset it, and I've just waited. It's happened once before, but after I waited 20 minutes it worked, and that was 6 months ago. But this time, it seems to just stay with a white screen.
If anybody knows what to do to solve this, and what caused this, please answer.
Water damage is not covered, and I guess Apple tech will find out about it as soon as they open the device.
But you can try this: How to fix a wet iPod or iPhone
Similar Messages
-
I have a bright white screen when turning on my nano 7th gen. Have tried resetting and restoring settings - no change. Any ideas please?
Hello pipworms,
I would be concerned too if my iPod nano's was just showing a white screen. I recommend following the steps below:
Display shows a white screen
Try putting the iPod into disk mode:
Reset the device (Reset the device by pressing the Sleep and Home buttons simultaneously until the display shows the Apple logo. This should take about eight seconds).
When the Apple logo appears, press and hold the Volume Down and Volume Up buttons simultaneously until the device enters Disk Mode.
While the device is in disk mode, sync it to iTunes and try to restore.
I got this information from the following article for the 6th generation iPod nano. The steps are the same, except I updated the reset steps with the reset for the 7th generation iPod nano:
iPod nano (6th generation): Hardware troubleshooting
http://support.apple.com/kb/ts3474
How to reset iPod
http://support.apple.com/kb/ht1320
Putting iPod into Disk Mode
http://support.apple.com/kb/HT1363
Thank you for using Apple Support Communities.
Best,
Sheila M. -
Help to Diagnose Blank, White Screen for 4th Gen iPod
Can you help me diagnose my problem? Fully charged Ipod Gen 4 syncs and plays music, but I can’t navigate due to blank, white screen. Reset to original factory settings from iTunes, re synced with no improvement. Doesn’t even show apple or battery icon when charging. Any advice?
So you basically cannot see anything on the screen, because it is all white.
Since it can play music, connect your earphones and let it play continuously until it runs out of power and turns off. Keep trying to turn it back on and playing music until it will no longer turn on. Then let it sit disconnected for at least 24 hours.
You are trying to make the battery dead so that the iPod is completely unpowered.
Then connect it to the computer or the power adapter and see if the screen is working again.
Alternately, if you know how to open the iPod with the plastic tools, you can simply disconnect the battery for a few minutes and then reconnect.
There is always the possibility that your iPod's screen has become defective. -
I lost rather a lot of photos on a corrupted external storage device. I have many of those photos on my iPod. How can I import those
photos into my MacBook Pro without the iTunes synchronization function kicking in and effectively deleting those photos I want to
import from that iPod? Any assistance would be greatly appreciated as those photos now only reside on that iPod...The photos you synced to your iPod through iTunes are no longer in their full resolution, but instead are scaled down thumbnails of those photos. So if you do manage to get them off your iPod, they will be quite small in size compared to the original ones you lost.
In order to get them off of your iPod, you'll need the help of some sort of 3rd party software. Here is one option.
http://www.macroplant.com/podtopc/
B-rock -
Mountain lion really bright white screen on boot?
Since I installed Mountain Lion I can't seem to get rid of the really bright white screen with Apple logo at bootup.
I RESET the PRAM and it will work for one boot and then go back to the really bright screen burning my irises out.
It can't be the battery because my computer keeps the time and date correctly.
I have also checked the STARTUP Disc and that is working right too. I even tried redoing permissions through Disk Utility and that didn't help.
Anyone have any ideas on this one?
Thanks.Anyone have a answer to this?
-
My Ipod Nano was working fine. I turned it off, and went to bed. The next morning I got up and turned it on. All that showed was a bright white screen. I reset it a couple of times, I pluged it up to the USB port, and I let it die completely. None of those things helped to fix my Ipod. It was not dropped and it did not get wet. All I did was set it down. When plugged up to the computer the computer will recognize it, but then it won't, yet after that it accepts it again. Does anybody have any words of wisdom? Does anybody think Apple will fix it?
Message was edited by: brillant_egomaniacTry this:
When your iPod comes up with the white screen, hold the center and menu buttons simultaneously until the screen goes black, then immediately hold the center and left (rewind) buttons. A menu should come up that shows you a few options. If this menu comes up, it might just mean that your internal storage is dead. If nothing comes up, then you might have a total hardware failure. If it is just the storage, the repair should cost less than buying a new nano or having an Apple Genius go in and repair multiple components. You might be able to attempt the repair yourself, but I really do not recommend that.
TheMacKid -
IPhone frozen/no brightness/white screen
So yesterday it start with my iphone telling me that I needed to connect to iTunes and restore because I couldn't make or receive calls. I reset it, and seemed OK. I later tried to play doodle jump, which crashed upon opening, so I reinstalled it to no avail. I discovered this morning that wasn't just doodle jump, but all 3rd party apps. It also went through stages of not turning on, telling me to restore it, and still having an image on the screen but there was absolutely no brightness to it, and instead of the screen going black when I press the sleep button on top, I would get a bright white screen. Giving up on resets, I came home from school and restored it, and it worked perfectly. Now it's 5.5 hours later and it just froze, unfroze, and had no brightness. I reset it, and now it wont turn on.
Any suggestions? ThanksHPGuelpher, welcome to the forum.
When requesting help, you should always include the make/model of the computer and/or monitor. This information is necessary for us to review the specifications of them.
Depending on the age of the computer, you could have a failed power supply unit (PSU). Here is a guide to help you troubleshoot the problem.
Please click "Accept as Solution" if your problem is solved.
Signature:
HP TouchPad - 1.2 GHz; 1 GB memory; 32 GB storage; WebOS/CyanogenMod 11(Kit Kat)
HP 10 Plus; Android-Kit Kat; 1.0 GHz Allwinner A31 ARM Cortex A7 Quad Core Processor ; 2GB RAM Memory Long: 2 GB DDR3L SDRAM (1600MHz); 16GB disable eMMC 16GB v4.51
HP Omen; i7-4710QH; 8 GB memory; 256 GB San Disk SSD; Win 8.1
HP Photosmart 7520 AIO
++++++++++++++++++
**Click the Thumbs Up+ to say 'Thanks' and the 'Accept as Solution' if I have solved your problem.**
Intelligence is God given; Wisdom is the sum of our mistakes!
I am not an HP employee. -
Each time i press the power button i just have a blank white screen, and intermittent sounds/tone. No apple logo, or spinning circle.
I used to install the rEFIt to boot with win7. When I deleted win7, I didn't uninstall rEFIt. Nothing wrong with it. One day after I watched movie in full screen,I pressed esc to quit. Then I found the touchpad didn't work. I can't turn off air. I just pressed power button for a little while. It rebooted, then my nightmare just began...
I have tried everything, PRAM, command+R, literally everything. No change.
But when I plug a CD-ROM with USB, I can only here one BONG, just once, then white screen, Like waiting for something...
I took it to a service center in China, they told me the CPU had broken. SInce it's one month out of warranty, they wanted to charge me for like $250....
I really don't think that's CPU's problem. I checked the history, it seems like somebody else also had the problem before.
Can anyone give me some hints??? Thanks!!!!!! Or I have to take it back to America to check....Impossible, there are zero, as in none, zip, nadda viruses for OS X. If you have viruses on it they are for MS Windows and will not affect OS X. I suspect the hard disk has crashed, if you have backup then it's not a big deal to have it changed, just take it into your local Apple Store or AASP for service. If you have not been backing it up you may be in for a painful lesson on why backup is critical.
-
My 17" laptop has a bright white screen and nothing works
My 17 inch MacBook Pro (6 years old) has a bright white screen when I turn it on and nothing works. Is there a fix?
Have you tried to boot from installation disc one that came with your computer?
Clinton -
I have a blank white screen with a flashing file folder
What do I do if I have a blank white screen with a flashing file folder?
That folder with the question mark icon means that the MacBook can't find the boot directory. That can either mean it can't find the hard drive or the hard drive data is somehow corrupted.
Put your install DVD into the drive and reboot. As soon as you hear the boot chime, hold down the "c" key on your keyboard (or the Option key until the Install Disk shows up). That will force your MacBook to boot from the install disk in the optical drive.
Once it has finished booting and you are at the Install screen launch Disk Utility from the Utilities menu. Is your Hard Drive in the list on the left?
If it is then select the First Aid Tab run Repair Disk and if that repairs any problems run it again until the green OK appears and then run Repair Permissions.
If your hard drive isn’t recognized in Disk Utility then your hard drive is probably dead. -
I need to know how to fix my iphone4 I was playing one of my games and a up date poped up I pushed on the up date when it restarted all I have is a white screen with four black dots and all the driffent laughes and a i with a blue circle around it I can not make any calls or get any calls or any thing
I don't have apps on my phone so i can;t do anything
-
I have a 25" 2.8 GHz Intel core 2 Duo working on OS X 10.8.4, within past 2 days we've had the black screen and the white screen, we are up and kicking again but I can leave the computer playing music from iTunes, but within 10 minutes the screen is back, yet the music is still playing in the background. I can't get rid of the black screen unless I force quit the computer, then it starts ok. Then the process starts all over again.
I have a 25" 2.8 GHz Intel core 2 Duo working on OS X 10.8.4, within past 2 days we've had the black screen and the white screen, we are up and kicking again but I can leave the computer playing music from iTunes, but within 10 minutes the screen is back, yet the music is still playing in the background. I can't get rid of the black screen unless I force quit the computer, then it starts ok. Then the process starts all over again.
-
My battery died and started to charge n all o have is a white screen
my battery died and started to charge n all i have is a white screen
I don't have apps on my phone so i can;t do anything
-
Bright white screen when video is paused.
Hello All,
I've looked everywhere for a solution to this problem and there has been no previous discussion. Basically, whenever the Video is paused, instead of the paused frame being shown, there is a bright white screen. It is worth nothing that this issue happens when I use the Darwin Streaming server. If I serve the video using IIS, the issue is not present.
This issue using the Quicktime plugin is present in Chrome, Firefox, Safari, and IE.
If someone could push me in the right direction, it would be greatly appreciated.
Thanks.Hi Brendon,
What has she done to set up AIM on her end ?
Has she enabled it though her XP firewall ?
Has she enable the ports AIM needs in her modem ?
8:38 PM Tuesday; December 19, 2006 -
My iPod touch only has a bright whit screen restrain doesn't fix it
My ipod touch only has a bright white screen .Restoring doesnt fix it
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar
Maybe you are looking for
-
Getting a request in a non English character
Hi , In an attempt to solve a problem of getting a request in a non English character , i use the code , taken from O'Reilly's "Java Servlet programing" First edition: import javax.servlet.*; import javax.servlet.http.*; import java.io.*; public clas
-
Cannot load Design mode flash builder 4 preminum trail version
Hi I installed flash builder4 premium trail version .After creating project when i click on the design mode . It displays an alert box containg the message like cannot load design mode with title as outof memory . How can slove this problem. Here i
-
Hi all, Based on the article here (Designate a System Photo Library in Photos - Apple Support) has anyone tried to bring both an iPhoto and Aperture library into iCloud Photo Library so that both libraries are available as one in iCloud and form the
-
Certificates CNAME or Host (A) Record?
We just installed Exch 2013 but have not put it into production yet. We are confused about what domains to include in our certificate request. Our ISP host our email and Network Solutions host our domain and we would like to keep it that way. We have
-
Hi, I bought this laptop two months back and I am very disappointed with the overall quality of the laptop. First of all when received my laptop it was not fitted properly and keyboard was detached from right side. Although I managed to press and fix