Interface Range during reload produces errors

Question

Hello,
I have a 6506, 12.2.33(SXI) IOS, with 6748-SFP LAN modules. Upon initial setup, a config file is loaded into the start config and the switch is reloaded. Upon reload, each interface command following the "interface range" command is not run due to an unknown command:
Here is a section of the config file whose commands do not run:
interface range GigabitEthernet2/3 - 42
description *DISABLED*
switchport
switchport access vlan 666
switchport mode access
switchport port-security
switchport port-security mac-address sticky
shutdown
no cdp enable
spanning-tree portfast
spanning-tree bpduguard enable
FOR EXAMPLE (and this is for all those commands above:
switchport (unknown command)
          ^
switchport (unknown command)
          ^
YET: If I run the same sequence of commands on the switch itself, they work.
Any help would be greatly appreciated.
Thank you.
Antonio

Answer 1

Are you using the oracle thin client ...?? Try using the full client install.
Is it working with OCI_DEFAULT or OCI_THREADED alone ???
Please note the following points in WINDOWS Platform.;
1)Try always a fresh installation for Oracle and VS products.Preferably a clean install of the OS.
2)If don't want to remove OS , do a clean UNINSTALL (This should include a complete clean up in the Registry and file systems).
3)Always reboot the system before and after installations and try your code.
If the above sequences are followed most of the DLL/LIB problem are solved for me.