Iphone cannot work after plugged into griffin itrip auto

My iphone was working up until 12:30, when i plugged it in to a Griffin itripauto.  Now it is permanently off and i cannot use it at all.

Just a guess here, as I've read about this problem before, with no apparent solution. The new iphones with voice control now come with headphones with a built in mic. Could be that with the software update, when you plug the phone into the aux port the software is telling the phone that headphones with built in mic are attached, thus your mute problem since you're not using headphones. My only suggestion is to google for an adapter that has a built in mic.
You could also try a reset, reset all settings-you'll have to re-enter passwords for wifi & settings.
Also check & see if there is a speck of dirt in the headphone jack. Doesn't take much, use low pressure air or putting your headphones in & out a few times.

Similar Messages

  • TS2634 My iPad Charger has stopped working after plugging into MacBook Air?

    Hello there,
    I have owned my iPad Mini for about 2 months now, and the charger has stopped working. It sometimes works on my MacBook Air, but often I get a popup on my computer saying, "To prevent damaging your computer, the USB device drawing too much power has been disabled. Other devices may have also been disabled. When you disconnect the device drawing too much power, your other USB devices will be enabled again." I have tried plugging my iPad into a wall charger, but it still does not charge. There is a small hole and the first part of the cable from the iPad is a bit twisted. Is there any way of fixing this, or do I have to buy another?

    Computer USB ports often do not provide enough power to charge an iPad efficiently. The best way to charge an iPad is with the charger that came with the iPad.
    Sounds like your cable is damaged too and needs to be replaced. My suggestion would be to buy two so that you have a backup. If your iPad has a lightning connector be sure to buy a name brand cable, either Apple or another well known brand. Do not buy cheap knockoff cables on eBay and they may not be certified to work with an iPad and you'll get an error message about that when you try to use them.

  • Is it common that iPhone would make buzzing sound after plugged into a charger?

    Hi, I have recently noticed that my iPhone would make buzzing sound through the headphone jack after plugged into a charger. I am not sure if this is common among other iPhones.

    Yeah it is. Also tried with computer, dock, etc.

  • Griffin itrip auto pilot and 3g iphone

    i have a griffin itrip auto pilot transmiter/charger for my 2g iphone, will this work with iphone 3g?
    thanks
    d

    i have just got a 3G iphone (which is awesome btw )
    and i also have a griffin itrip, which when i plug it in, i also get the incompatible warning, but it works and plays fine!
    will this damage or hurt my iphone in any way please?
    thanks!

  • HT4528 itunes is not recognizing my new iphone 5c when i plug into my lap top

    my new iphone 5c is not recognized by itunes when i connect with a cable to my win 7 laptop. when i plugged in a new ipod itunes immediately asked me to register it with itunes. no iphone icone when i plug into itunes??? any ideas

    See: http://support.apple.com/kb/TS1538
    The iPhone communcates differently from iPods, so the fact that an iPod connects is no guarantee that everything is working.

  • My unlocked iphone 4 just says plug into itunes when i insert my Etisalat (UAE) sim

    My unlocked iphone 4 just says plug into itunes when i insert my Etisalat (UAE) sim. it then says restore. i have restored the phone a few times.still the same problem. my sim works in my samsung.

    Hi marissacav,
    Welcome to the Support Communities!
    The following article will provide some troubleshooting steps for this issue:
    iPhone, iPad or iPod touch: Not responding or does not turn on
    http://support.apple.com/kb/TS3281?viewlocale=en_US
    Cheers,
    - Judy

  • IPod only works while plugged into computer!

    Help! My 2Gb iPod nano went through the washing machine, and after a few days of drying out, it only works while plugged into the computer. As soon as I take it out, the screen goes blank. I can access all my music, podcasts and photos while it's plugged in. I have tried the 5 Rs to no avail. Anybody have any ideas?

    I also sent my nano through the wash and I found that if you get an ac adapter and plug it in for a few hours you will have battery life. This made me very happy however I have noticed that I can not turn the ipod off unless the hold button is on. Battery life is also not as long but long enough for me. Hope this helps

  • HT1430 my iPhone4 will not turn on or show that is working at all, i have tried to charge it so that the screen will light up but it won't work, when plugged into the computer iTunes does not show any sign it is plugged in, what do i do?

    my iPhone4 will not turn on or show that is working at all, i have tried to charge it so that the screen will light up but it won't work, when plugged into the computer iTunes does not show any sign it is plugged in, what do i do?

    There is a hardware problem.  Whether it's worth it to you to have no working phone for 2 months until you can update vs paying for replacement/repair now is a question only you can answer.

  • My Ipod touch will only work when plugged into a itouch radio.  When I take it out, it goes blank.  Why can I do?

    My Ipod touch will only work when plugged into an Itouch radio.  When I take it out of the charger, it goes blank.  The battery shows fully charged.  It appears that the battery is no longer charging.  What should I do?

    Try a reset: Hold the home and power buttons at the same time until the Apple boot logo appears. No data will be lost. If that fails, the battery may have gone kaput.

  • I plug my computer into my stereo and use the remote app on my iPhone to control it. How can I control my wires iPad with the remote app on my iphone when it is plugged into the stereo? they are different iTunes accounts.

    I plug my computer into my stereo and use the remote app on my iPhone to control it. How can I control my wires iPad with the remote app on my iphone when it is plugged into the stereo? they are different iTunes accounts.

    I think this is probably a sign that your network could be better than it is.
    Intermittent problems are often a result of interference. Interference can be caused by other networks in the neighbourhood or from household electrical items.
    You can download and install iStumbler (NetStumbler for windows users) to help you see which channels are used by neighbouring networks so that you can avoid them, but iStumbler will not see household items.
    Refer to your router manual for instructions on changing your wifi channel or adjusting your multicast rate.
    There are other types of problems that can affect networks, but this is by far the most common, hence worth mentioning first.

  • My iPad won't charge after plugging into my computer and after holding down the power and home button at same time for 10 seconds- Can anybody help? Has IOS7.0 but the most up-to-date version

    My iPad won't charge after plugging into my computer and after holding down the power and home button at same time for 10 seconds… Can anybody help? Has IOS7.0 but not the most up-to-date version

    It's just the battery sign - nothing else. I've tried to reboot by holding down both power and home key for 10+ seconds, waiting for the apple logo - but nothing happens. It's plugged into the imac at the moment. I tried to recharge it overnight using the normal charger - but no luck. It went dead during a Skype call with a friend - even though it was powered into the mains - albeit at a low battery level at the time

  • I am going to japan with an Ipod nano and Iphone 4. Do I need a converter? or does the one the iphone comes with that plugs into the wall enough?

    I am going to japan with an Ipod nano and Iphone 4. Do I need a converter? or does the one the iphone comes with that plugs into the wall enough? I know i wont need an adapter because it will fit into the wall outlet, but voltage wise, will i need a converter? Japan runs on 100 V. I am so confused on all of this...

    As long as the adapter is 2 pronged, then you should be able to use it without any problems.
    B-rock

  • It rained in my window last night, on my power strip.  My macbook adaptor (charger) and iphone adaptor were both plugged into the strip.  The power strip is dead.  Iphone is fine.  Macbook will not boot up and charger light doesn't go on.

    It rained in my window last night, on my power strip.  My macbook adaptor (charger) and iphone adaptor were both plugged into the strip.  The power strip is dead.  Iphone is fine.  Macbook will not boot up and charger light doesn't go on. I borrowed another charger and still no luck.  What should I do?  (Charger wasn't plugged into Macbook until I dried it off.)

    Spill Cleaning
    And, don't think that just because it was two teaspoons and not a glassful that there is a difference.
    Some liquid has just spilled into your Mac. What should you do?
    Do
    Immediately shut down the computer and unplug the power cord.
    Remove the computer's battery (if you can)
    Disconnect any peripherals (printers, iPods, scanners, cameras, etc.)
    Lay the computer upside down on paper towels to get as much liquid as possible to drip out.
    Note what was spilled on your Mac.
    Bring the computer into an Apple store or AASP as soon as possible.
    Don't
    Don't try to turn it back on. Liquids can help electrical current move about the components of your Mac in destructive ways.
    Don't shake the computer (this will only spread the liquid around).
    Don't use a hair dryer on it (even at a low setting a hair dryer will damage sensitive components).
    Do not put in a bag of rice in as much as rice will get into the ports and optical drive and do further damage.

  • I am trying to import my cd's onto itunes on a new macbook pro. i can import the cd fine but can not get track names or album art work. after going into advanced it is just coming up with "CDDB information not available"

    i can import the cd fine but can not get track names or album art work. after going into advanced it is just coming up with "CDDB information not available"
    thank you

    Use the trackpad to scroll, thats what it was designed for. The scroll bars automatically disappear when not being used and will appear if you scroll up or down using the trackpad.
    This is a user-to-user forum and most people will post on here if they have problems. You very rarely get people posting to say there update went smooth. The fact is the vast majority of Mountain Lion users will not be experiencing any major problems with the OS, or maybe with apps which are not compatible, but thats hardly Apple's fault if developers don't update their apps.

  • Notifications on iphone stopped working after purchasing ipad

    My notifications on the iphone stopped working after purchasing ipad. Now only my iPad receives the notifications. Please let me know if there is a way to have both receive.

    I turned off notifications. Turned off my phone. Turned on my phone. Turned on notifications. And now it started sending them again it seems... Have to go check the ipad later if it still is receiving as well...

Maybe you are looking for

  • Replaced an asset and now project won't open

    I was finishing up some subtitles when I noticed an audio problem that needed to be corrected. So I saved my DVDSP4 project, quit the program, then made a quick audio cut in FCP. The amount of audio cut was less than a second. And because I cut my au

  • Makepkg fails on custom kernel.

    Hi. I'm trying to compile the arch kernel with a few added patches to increase battery life. What I have done is: Installed abs, and ran ABS as root. Then I made a directory called kernel, copied the kernel26 from ABS to that directory (so kernel had

  • Post-installation glitch with ORAEVRUS10.DLL - pls help

    Hi I've installed 10g Express edition and everything is fine, except that the Windows 2003 Server event log is returning errors like this: The description for Event ID ( 5 ) in Source ( Oracle.xe ) cannot be found. The local computer may not have the

  • Can't find adobe reader on computer - download won't work - says already downloaded

    can't find adobe reader on computer - download won't work - it says it's already downloaded!

  • Extra characters embedded into messages

    I have had an intermittent problem in e-mails sent from Safari, and Mail 2.1 (my default reader). These charaters are & # 1 0 ; > embedded (without spaces) into messages I send ; I don't know if every recipient gets the extra characters but they are