Ive just replaced lcd on the iphone 3gs and now the screen is just blank
i have just replaced my broken lcd on my iphone 3gs and when i switched it back on it just lights up blank any ideas please
The replacement you used is bad, you hooked something up wrong, or you broke something when you did it.
Find a competent repair shop or sell it for parts and buy a new phone.
Similar Messages
-
Just synced my iphone 3GS and now many of my app's won't open on my phone. This was with version 4.3.2. I tried a reboot on my iphone but that didn't help. Any ideas?
this happened to me with my iPhone 4. I researched the problem and found this :
"The reason this happens is because every time a downloaded app is opened it checks for your itunes password for validation that you are authorized to open that app (as it may contain personal info). From time to time the iphone 'forgets' your itunes password. You can fix the missing password by syncing the iphone with itunes or downloading an app from the app store and entering your password that way.”
And to fix it, all I did was download a new app, or delete a current one, I used Facebook, and re-download it.
Hope this helps -
HT1766 i have restored my iphone 3gs and now it wont activiate
i restored my iphone 3gs and now it wont activate
it was given to me and yes you are right it was jailbroken. is there anyway to get around that or is the phone garbage?
-
Please i need help i updated my iphone 3gs and now its not activating
i need help i updated my iphone 3gs and now its not activating
What happens when you try to activate the iPhone?
If there is an error message, what is the exact wording of that message? -
i want to use my iphone 3gs and i had restored it and successful with that other than there is no more speaker sounds, what do i need to do to get that back
Hey BurnOff.int,
Welcome to Apple Support Communities, and thanks for the question. There's an article that goes over troubleshooting steps if your can't hear sound from your iPhone 3GS speaker. Check it out here:
iPhone: No ring or sound from built-in speaker
http://support.apple.com/kb/TS1205
Have a good one,
David -
I've just upgraded to iOS4 on my iPhone 3GS and the iPhoto images are blurred? WHY?
They were fine before...so now my screen saver is blurred and looks low res...all my images are crap quality...what is going on Apple?
Checked the photos on my laptop and they are crystal clear...anyone else have the same problem?
I wish I'd stuck with the old software now.I also had the same issue. I upgraded my iPhone 3Gs to the new software about a week ago. Yesterday the photos on my phone were blurry. I "googled" the issue and ended up here. Synced my phone and now all is well! thanks for the help.
amy -
i dropped my iPhone 3GS whilst playing out and now the home button doesnt work, i even had the protective case on, please can someone suggest what to do, i am 12 years old and can't afford to pay the £150 to repair it :'(
thanks but im kind of stuck now coz everything else works fine except the following:
When connected to a USB cable to the COMPUTER nothing happens
When i press the home button nothing happens :/ -
Ok, so I downloaded OS 5 to my iPhone 3GS about a week ago and I was trying to figure out iCloud, but then I realized my computer, an older MacBook, is only running 10.6.8 so it can't work with iCloud. So I've deactivated most of the syncing options for iCloud on my phone, but now when I sync my phone with my computer the events from my iCal, 4.0.4, sync to my phone, but the events on my phone will not show up in my iCal.
I've had the same basic problem ever since I purchased the iPhone 4 and enabled iCloud. If I create an event on the phone the event does not show up in iCal, but if I create an event in iCal it shows up on the phone. I have looked at several other threads and it seems I have all the calendar options correctly selected in the settings under calendar and iCloud. What's just as strange is that if I delete the event on my phone that I created in iCal it remains in iCal. I don't use mobileme so I know that isn't part of the problem. Should I turn off calendars in the iCloud settings menu on the phone? Is there another sync menu I dont know about on the phone or within iCal?
-
As stated I live in italy, a year ago have purchased an iphone 3gs from vodafone company. I now have purchased an Iphone 4 and have moved that cip in the new phone.
In the old Iphone 3gs I have placed another cip from a different company here in Italy TIM and now cannot make calls nor send text messages since I get the following error message "error in pdp authentication". Can anyone help me in understanding what do I need to do??
Thank you
MarcoHello Notahappycamper1962
Let's get that S5 up and running! I want you to love the S5! Is the old device powered off? What zip code are you in?
I look forward to hearing from you and getting this addressed.
JoeL_VZW
Follow us on Twitter @VZWSupport -
i updated my i pad with ease then updated my i phone and now apple does not recognise the i phone and then says there is no sim in the phone when there is one installed, can anyone help
See Here > http://support.apple.com/kb/HT1808
You may need to try this More than Once...
But... if the Device has been Modified... this will Not necessarily work. -
I have just restored my iphone 3gs and now it will not activate on itunes
I updated my phone to latest 6.1.3 and it would not start up so i restored back to previous version and now it will not activate in i tunes
what do i do now i've tried with / without sim
really not happydon't know if cydia on as cannot see any apps without it being activated can i ?
getting a 02 sim tomorrow as i only have a micro sim from them at moment in my iphone 4
i know it worked on orange as well so not sure if it was unlocked or jail broken
if i put a o2 sim in do you think it will work? -
Help, i unlocked my iphone 3gs and now have restored now won't work
Help, I have unlocked my iphone 3gs to get 3rd party apps. Problem is I couldn't ever get it to go on silent. so I restored it back to not be unlocked and its stuck at the apple screen, will not turn on. I did a hard reset, pushing both the buttons on the iphone at the same time, the one on the top and on the bottom of the screen at the same time and it restarts, but then is stuck at the apple screen. What should I do? It's still under warranty. Will apple replace it since I was trying to restore it?
It's still under warranty. Will apple replace it since I was trying to restore it?
No it is not. Jailbreaking, unauthorized unlocking, etc. void the warranty (and can be detected by Apple). Also, support for hacked iPhones is prohibited here by the forum Terms of Use. -
Hi Guys
I recently upgraded my iphone 3GS to the new ioS 5.1. After I did this and synced my phone, it won't let me play any audio from apps, itunes or music. It will allow the phone to ring but that is all. When I use viber I have to press this button and change it from docking to iphone. I take it that the phone thinks I'm permanently on a docking system.
It also will not sync my music back to my phone. My music is on itunes but it won't let it sync.
I have restored my phone twice and it still won't work - HELP!! Please???Your device is broken. If you want a device that works better than the one you have now, then you'll either need to bring your phone into Apple for out of warranty exchange ($149), or find a 3rd party repair shop in your area and see what they can do, if anything at all.
-
i have recently upgraded my my iphone 3gs to ios 5.0.1 and now my computer doesnt recognise it as a camera. is there any way i can access my photos stored on my phone from my computer? i also dont have wifi so i cant use the icloud option.
Hi Amy,
I have exactly the same problem. Before the update to 5.0.1 whenever I connected my 3GS to my MacBook Image Capture used to open. Now nothing happens. When I opened Image Capture or iPhoto, either program recognized my device as the iPhone, but no pictures showed up on the screen.
I emailed the photo's from the iPhone to myself and that worked OK.
Have no idea why the computer doesn't recognize the iPhone as a camera anymore.
You haven't had any answers on your question, so no solution yet.
Hope someone can help us. -
First of all im from Estonia so im sorry about my bad english. The thing is that i wanted to sell my iphone 3gs, but when i erased all content and settings my battery went so low it shut down. So i tryed to turn iphone on while it was charging and only thing i saw was apple logo loading. Then, when it was loaded it restarted and came apple logo without loading and then again with loading and so on. Then i thought i can update my iphone or something with itunes and i plugged in to my computer and itunes cant find it either. And i thought maybe it needs to load for a long time so i left it to load for about 18 hrs. And its still loading ... So people please help me! Thank you.
http://www.iclarified.com/entry/index.php?enid=1034
Maybe you are looking for
-
Adobe Configurator and deprecated Flash-based panel support in Adobe CC products
Does Configurator 4.0 (or Configurator 3) support the creation of HTML5-based panels? I received the following email from Adobe: Photoshop CC, starting in the middle of 2014, will remove support for Flash-based extensions. All other Creative Cloud p
-
i have only a single texbox.i want to display<big style="margin:0px;padding:0px;border:0px;color:#111111;font-family:'Segoe UI', Arial, sans-serif;line-height:normal;"> names , date,priortiy </big>in the same textbox <big style="margin:0px;padding:0p
-
Is there a maximum size in either Flex, AMF or ColdFusion
I wish there was an AMF forum. I have CF version 8,0,0,176276, Flex 3.0.214193, and Oracle 10g. I am trying to build an application in Flex, using RemoteObject access to a ColdFusion .cfc via the AMF channel. The application has several comment field
-
How to mirror display...
I need to mirror my display. In other words, I need everything to be backwards, but still right-side-up. I found the "rotate" option, but this is no good, becuase I need to flip the display horizontally, not merely rotate it. This is for a telepro
-
Hi all, We have an Internationalization issue . We modified the Caption xml files to incorporate Japanese language for Custom Column headers. We have some dummy columns, in the sense Column header and the Formula column reads the same thing (Ex: Colu