My ipod touch 8gb will not sync ,computer is recognising camera wizard when i plug in but not for itunes,i have tried to de install then re install but to no avail this is a replacement ipod but the last one i had was ok syncing with the same computer
my ipod touch will not sync to itunes when i plug it in to my pc it is recognising the camera wizard but not showing up in itunes i have tried de installing and re installing but to no avail it is a replacement ipod but the last one was ok with syncing on the same usb connections can anyone help me out please
Try to disable the camera notification: http://support.apple.com/kb/TS1500
and make sure that Apple Mobile Device Service is active on your computer: http://support.apple.com/kb/TS1567
Similar Messages
-
My Ipod touch 8gb will not turn back on no matter what i do i have tried just the power button, the power button and home button, and connecting it to the computer and the battery wasn't close to being dead non of them work what do i do?
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try another cable
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
My ipod will not connect to my home wifi, it can see it and asks for a password but will not connect. I have tried it at another location and it will connect to other wifi connections. I have another ipod that is connecting just fine to my home wifi.
- Reset the iPod. nothing is lost
Reset iPod touch: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Power off and then back on your router
- Reset network settings: Settings>General>Reset>Reset Network Settings
- iOS: Troubleshooting Wi-Fi networks and connections -
A message cannot be seen on my incoming emails. I can only view the message if I click on reply. Also any links attached to email will not open. I have tried everything to solve the problem but not able to.
Try closing the Mail app completely and see if it works properly when you re-open the app : from the home screen (i.e. not with the Mail app 'open' on-screen) double-click the home button to bring up the taskbar, then press and hold any of the apps on the taskbar for a couple of seconds or so until they start shaking, then press the '-' in the top left of the Mail app to close it, and touch any part of the screen above the taskbar so as to stop the shaking and close the taskbar.
If that doesn't work also do a reset : press and hold both the sleep and home buttons for about 10 to 15 seconds (ignore the red slider), after which the Apple logo should appear - you won't lose any content, it's the iPad equivalent of a reboot. -
Hi my wife has a 2008 iPod Touch which she has not used for approximately 5 years. It will not charge and I have tried to carry out a Device Firmware Upgrade to no effect. Can anyone please help?
Try disabling the computer's antivirus and firewall.
- Next try the manual install method of:
iDevice Troubleshooting 101 :: iPhone, iPad, iPod touch
Place the iPod in recovery mode after the firmware download is complete and then restore using the instructions in the article. Sometimes recovery mode timeouts and returns to disabled before the firmware download is complete.
- Then try on another computer -
Okay so about four days ago my ipad says it has apps to update but whenever i go to the update apps page it will not load and i have tried rebooting signing out but nothing will work, any suggestions?
If you are getting the blank app update screen, many, many people are having this problem over the last couple of days. It is a problem that Apple must fix now.
According to Fly150 in another discussion, this will work.
If you want to update the Apps while waiting for Apple to fix Updates:
1. Go to App Store
2. Select Purchased
3. Select All
4. Scroll down to find the Apps showing update
5. Select update on the Apps
This should update the Apps and get rid of the update count in App Store. Apple needs to fix this. It is a workaround only until then. -
Hello Everyone,
This is my first time using the forum. My macbook battery will not charge. I have tried unplugging and doing an SMC reset but it did not seem to change. I have yet to try another magsafe charger. The charger has a dim green light while plugged into the computer. What should my next steps be, besides trying a new charger as well as being the most cost effective?
Thanks
-TBHi ..
The battery may need replacing.
Check the battery maximum cycle count > Mac notebooks: Determining battery cycle count
And check the adapter > Apple Portables: Troubleshooting MagSafe adapters -
my iphone will not charge. I have tried everything and it just wont charge
Did you try connecting to a pc or man?
If no then try it. -
I interrupted a software update and my macbook pro will not boot. I have tried to reboot using the startup disc, I have tried to verify the disc, and repair the disc. It tells me I need to erase and reformat the hard drive then reinstall the operating system. I do not have a back up of all my applications, my garageband music and other things. I also do not have time capsule set up on this machine, but I do have a 2 TB time capsule.
Is there anyway to back up this corrupted drive so I can restore my applications later?There's an old saying. If you don't have a backup disc, then there must be nothing important to backup. That's just lesson #1. Lesson #2 is to never interrupt a software update. Not a good thing.
OK, I'm sure you know this. It just upsets me to read your story, knowing you have a lot of important stuff on your hard drive, and didn't use time machine.
You're pretty much in a bad place. My only hope for you is to boot to your Installation Disc, then using disk utility see if you can save the internal hard drive (by fixing what can be fixed). You might be able to see your user folder and some of your apps. I wouldn't even consider copying the library, because who knows what's been corrupted in there.
Good luck. -
My Macbook Pro will not charge. I have tried other charges and nothing. Can the MagSafe port go bad? Is that expensive to repair?
The port can fail. Internal boards can fail. Batteries can fail. All with the result that no charging occurs.
You can try Resetting the System Management Controller and you can try Troubleshooting MagSafe adapters.
But usually you will have to take the mac in to a service place for testing. It can get expensive, although occasionally it is not.
charlie -
just bought a new pc and itunes will not open. I have tried thto repair and reinstall but still no itunes
Best route here is to uninstall iTunes completely using the Windows Control Panel.
Make sure you know exactly which version of Win 7 you're running.
Restart your computer from cold (with no iTunes).
Go to Apple website and download the correct version for your operating system. Install following Apple prompts.
Once installed, close iTunes.
Restart your computer from cold (with new iTunes).
Start iTunes - all should be operating well! Good luck ... -
My 3GS will not charge. I have tried it from my computer and from a wall socket. I also have tried another computer and a different cable with no luck. My computer doesnt see the device either. I havent had any issues until now. Any ideas?
bring it to Apple for battery diagnostics.
-
My iPhone 4 will not charge. I have tried 3 different chargers and nothing. Any suggestions?
Your phone needs repair, or you can try changing the cable you're using.
-
My iPod touch will not come on , i have the 4th gn and 8gb . And i also dont know how to reset it ,,, Can anybody HELP me !!!!!!!!!!!! please please please please !!!!!!!!!!!!!!!!!???
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try another cable
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
My send button in iMessage does not function. I have tried it in every position ie rotated the screen 90 degrees each time but still will not send the message. Any ideas or sugestions?
Try this:
First you can try signing out messages and then back in.
Make sure IOS is updated to latest version
Reboot device by pressing both the home button and sleep/wake (power) buttons at the same time for 10-15 seconds until the apple logo appears on the screen, then let go.
If that doesn't work then reset the device by going to settings/general/reset/reset all settings
Maybe you are looking for
-
Error when adding a Title to a Graph in Excel
I am trying to automate adding a graph to Excel. The Easy Graph.vi is too simple for what I would like to do. I recorded a macro of what I wanted to do, and then I copied it in LabVIEW basically. My program is erroring out every time I try to modify
-
IWorks 09 Crash under OD Network Home Folder
Hi, We have a Mac Pro running Lion Server and a few iMacs running Lion. We are trying to setup network home folders for our users. The server is the OD master, and each user is configured with the correct network home folder path. User can login with
-
Where can I buy a replacement screen for macbook pro
my screen broke and i want to know if i can have the screen replaced
-
Workflow using FCPX and AVCHD.
Hi All, I'm about to start on a new series of projects, and just wanted some clarification from people cleverer than I about the proposed workflow from the client (who knows as little about this as I do!). The footage is to be recorded 1080i (Sony hx
-
Generate IBAN without having the bank informations on the database
Hi all, I want to generate an IBAN from the bank details and the other way around. But in my case the bank details are not in the database yet. The fm CONVERT_BANK_ACCOUNT_2_IBAN uses the fm READ_BANK_ADDRESS. This one checks if the bank exists in th